Yun-Teng Liu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Yun-Teng Liu has a total of 11 co-authors. Here are the top co-authors by number of shared publications:
- Cainian Jing
School of Materials Science and Engineering, Shandong Jianzhu University, Jinan, China
1 shared publication Changwen Tian
Advanced Materials Institute, Shandong Academy of Sciences
1 shared publicationDi Zhang
Shandong Jianzhu University
1 shared publicationJixue Zhou
Advanced Materials Institute, Shandong Academy of Sciences
1 shared publication- Jixue Zhou
Shandong Key Laboratory of Aluminum Alloy Materials Preparation and Forming, Qilu University of Technology (Shandong Academy of Sciences), Jinan 250014, China
1 shared publication - Lin-Lin Zhang
Department of Light-weight and High Strength Metal Materials , Qilu University of Technology (Shandong Academy of Sciences) , Advanced Materials Institute , Shandong Key Laboratory of High Strength Lightweight Metallic Materials , Jinan 250014 , China
1 shared publication
Latest Publications
- Open Access
- 1 January 2020
- Published by Walter de Gruyter GmbH in High Temperature Materials and Processes
- Vol. 39 (1) , 200-208
Improving mechanical properties of ZK60 magnesium alloy by cryogenic treatment before hot extrusion
Few studies of cryogenic treatment were focused on nonferrous alloys, such as magnesium alloy. In this work, the effect of cryogenic treatment (77 K) before extrusion on microstructure and mechanical properties of ZK60 alloy was investigated. The results showed that many fine G.P. zones were formed during the cryogenic treatment and then grew to short fineprecipitates when heating before extrusion. These precipitates pinned dynamic recrystallized grain boundaries in the subsequent extrusion, resulting in fine gains and dispersed spherical precipitates. By the cryogenic treatment before extrusion, the extruded ZK60 alloy showed good tensile strength and elongation balance. Especially, elongation was improved by 29%. - 1 January 2020
- Published by Walter de Gruyter GmbH in High Temperature Materials and Processes
- Vol. 39 (1) , 200-208
Open AccessImproving mechanical properties of ZK60 magnesium alloy by cryogenic treatment before hot extrusion
Few studies of cryogenic treatment were focused on nonferrous alloys, such as magnesium alloy. In this work, the effect of cryogenic treatment (77 K) before extrusion on microstructure and mechanical properties of ZK60 alloy was investigated. The results showed that many fine G.P. zones were formed during the cryogenic treatment and then grew to short fineprecipitates when heating before extrusion. These precipitates pinned dynamic recrystallized grain boundaries in the subsequent extrusion, resulting in fine gains and dispersed spherical precipitates. By the cryogenic treatment before extrusion, the extruded ZK60 alloy showed good tensile strength and elongation balance. Especially, elongation was improved by 29%. - 18 April 2018
- Published by Springer Nature
- p. 175-181
Influence of Initial Microstructure on the Hot Working Flow Stress of ZK60 Mg Alloy
- 18 April 2018
- Published by Springer Nature
- p. 175-181
Influence of Initial Microstructure on the Hot Working Flow Stress of ZK60 Mg Alloy