Raden Sanggar Dewanto
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Raden Sanggar Dewanto has a total of 7 co-authors. Here are the top co-authors by number of shared publications:
- Dadet Pramadihanto
Politeknik Elektronika Negeri Surabaya
3 shared publications Adytia Darmawan
Politeknik Elektronika Negeri Surabaya
1 shared publication- Adytia Darmawan
Electronic Engineering Polytechnic Institute of Surabaya
1 shared publication - Dimas Pristovani Riananda
Politeknik Elektronika Negeri Surabaya
1 shared publication - Khairurizal Alfathdyanto
Politeknik Elektronika Negeri Surabaya
1 shared publication - Wahyu Agung Dwi Prasetyo1 shared publication
Latest Publications
- Open Access
- 30 April 2025
- Published by STMIK Indonesia Padang in The Indonesian Journal of Computer Science
- Vol. 14 (2)
Development of Sensor System based on Air Pressure for Robot Leg Contact Detection
Legged robot is preferred choice for travesing uneven terrain. Robot leg can be positioned dynamically to achieve better locmotion. Detection of the leg contact point became more of essential part for the unpredictable course. The common method by deploying resistive force sensor provides a binary condition of whether the leg has touches surface. This paper explores the possibility of implementing air pressure sensor on a sensor system to provide more information at robot leg contact point. Air pressure sensor can provide a more wide and continuous range of value that fluctuates along the contact rate of the leg. Verification of the study uses single leg part of dog-type quardruped. The sensor testing gave the output value with average error of 1,3%. The pressure sensor provides readings at around ± 40ms with maximum readable pressure of 1,5 kPa.
- 30 April 2025
- Published by STMIK Indonesia Padang in The Indonesian Journal of Computer Science
- Vol. 14 (2)
Open AccessDevelopment of Sensor System based on Air Pressure for Robot Leg Contact Detection
Legged robot is preferred choice for travesing uneven terrain. Robot leg can be positioned dynamically to achieve better locmotion. Detection of the leg contact point became more of essential part for the unpredictable course. The common method by deploying resistive force sensor provides a binary condition of whether the leg has touches surface. This paper explores the possibility of implementing air pressure sensor on a sensor system to provide more information at robot leg contact point. Air pressure sensor can provide a more wide and continuous range of value that fluctuates along the contact rate of the leg. Verification of the study uses single leg part of dog-type quardruped. The sensor testing gave the output value with average error of 1,3%. The pressure sensor provides readings at around ± 40ms with maximum readable pressure of 1,5 kPa.
- Open Access
- 1 December 2020
- Published by EMITTER International Journal of Engineering Technology in EMITTER International Journal of Engineering Technology
- Vol. 8 (2) , 372-388
Implementation and Integration of Fuzzy Algorithms for Descending Stair of KMEI Humanoid Robot
Locomotion of humanoid robot depends on the mechanical characteristic of the robot. Walking on descending stairs with integrated control systems for the humanoid robot is proposed. The analysis of trajectory for descending stairs is calculated by the constrains of step length stair using fuzzy algorithm. The established humanoid robot on dynamically balance on this matter of zero moment point has been pretended to be consisting of single support phase and double support phase. Walking transition from single support phase to double support phase is needed for a smooth transition cycle. To accomplish the problem, integrated motion and controller are divided into two conditions: motion working on offline planning and controller working online walking gait generation. To solve the defect during locomotion of the humanoid robot, it is directly controlled by the fuzzy logic controller. This paper verified the simulation and the experiment for descending stair of KMEI humanoid robot.
- 1 December 2020
- Published by EMITTER International Journal of Engineering Technology in EMITTER International Journal of Engineering Technology
- Vol. 8 (2) , 372-388
Open AccessImplementation and Integration of Fuzzy Algorithms for Descending Stair of KMEI Humanoid Robot
Locomotion of humanoid robot depends on the mechanical characteristic of the robot. Walking on descending stairs with integrated control systems for the humanoid robot is proposed. The analysis of trajectory for descending stairs is calculated by the constrains of step length stair using fuzzy algorithm. The established humanoid robot on dynamically balance on this matter of zero moment point has been pretended to be consisting of single support phase and double support phase. Walking transition from single support phase to double support phase is needed for a smooth transition cycle. To accomplish the problem, integrated motion and controller are divided into two conditions: motion working on offline planning and controller working online walking gait generation. To solve the defect during locomotion of the humanoid robot, it is directly controlled by the fuzzy logic controller. This paper verified the simulation and the experiment for descending stair of KMEI humanoid robot.
- Open Access
- 30 April 2018
- Published by IOP Publishing in Journal of Physics: Conference Series
- Vol. 1007 (1) , 012068
Implementation of Push Recovery Strategy Using Triple Linear Inverted Pendulum Model in “T-FloW” Humanoid Robot
Push recovery is one of humanbehaviorwhich is a strategy to defend the body from anexternal force in any environment. This paper describes push recovery strategy which usesMIMO decoupled control system method. The dynamics system uses aquasi-dynamic system based on triple linear inverted pendulum model (TLIPM). The analysis of TLIPMuses zero moment point (ZMP) calculation from ZMP simplification in last research. By using this simplification of dynamics system, the control design can be simplified into 3 serial SISOwith known and uncertain disturbance models in each inverted pendulum. Each pendulum has different plan to damp the external force effect. In this experiment, PID controller (closed- loop)is used to arrange the damp characteristic.The experiment result shows thatwhen using push recovery control strategy (closed-loop control) is about 85.71% whilewithout using push recovery control strategy (open-loop control) it is about 28.57%.
- 30 April 2018
- Published by IOP Publishing in Journal of Physics: Conference Series
- Vol. 1007 (1) , 012068
Open AccessImplementation of Push Recovery Strategy Using Triple Linear Inverted Pendulum Model in “T-FloW” Humanoid Robot
Push recovery is one of humanbehaviorwhich is a strategy to defend the body from anexternal force in any environment. This paper describes push recovery strategy which usesMIMO decoupled control system method. The dynamics system uses aquasi-dynamic system based on triple linear inverted pendulum model (TLIPM). The analysis of TLIPMuses zero moment point (ZMP) calculation from ZMP simplification in last research. By using this simplification of dynamics system, the control design can be simplified into 3 serial SISOwith known and uncertain disturbance models in each inverted pendulum. Each pendulum has different plan to damp the external force effect. In this experiment, PID controller (closed- loop)is used to arrange the damp characteristic.The experiment result shows thatwhen using push recovery control strategy (closed-loop control) is about 85.71% whilewithout using push recovery control strategy (open-loop control) it is about 28.57%.
- Open Access
- 15 December 2016
- Published by EMITTER International Journal of Engineering Technology in EMITTER International Journal of Engineering Technology
- Vol. 4 (2)
An Implementation of Error Minimization Position Estimate in Wireless Inertial Measurement Unit using Modification ZUPT
Position estimation using WIMU (Wireless Inertial Measurement Unit) is one of emerging technology in the field of indoor positioning systems. WIMU can detect movement and does not depend on GPS signals. The position is then estimated using a modified ZUPT (Zero Velocity Update) method that was using Filter Magnitude Acceleration (FMA), Variance Magnitude Acceleration (VMA) and Angular Rate (AR) estimation. Performance of this method was justified on a six-legged robot navigation system. Experimental result shows that the combination of VMA-AR gives the best position estimation.
- 15 December 2016
- Published by EMITTER International Journal of Engineering Technology in EMITTER International Journal of Engineering Technology
- Vol. 4 (2)
Open AccessAn Implementation of Error Minimization Position Estimate in Wireless Inertial Measurement Unit using Modification ZUPT
Position estimation using WIMU (Wireless Inertial Measurement Unit) is one of emerging technology in the field of indoor positioning systems. WIMU can detect movement and does not depend on GPS signals. The position is then estimated using a modified ZUPT (Zero Velocity Update) method that was using Filter Magnitude Acceleration (FMA), Variance Magnitude Acceleration (VMA) and Angular Rate (AR) estimation. Performance of this method was justified on a six-legged robot navigation system. Experimental result shows that the combination of VMA-AR gives the best position estimation.