Yu Zhou
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Yu Zhou has a total of 84 co-authors. Here are the top co-authors by number of shared publications:
- Dewei Fan
Center for Turbulence Control, Harbin Institute of Technology, Shenzhen 518055, China
8 shared publications - Bingfu Zhang
School of Robotics and Advanced Manufacture, Harbin Institute of Technology, Shenzhen, Shenzhen, China
7 shared publications - Bernd R. Noack
College of Mechatronics and Control Engineering, Shenzhen University , Canghai campus , Shenzhen 518060 , People’s Republic of China
6 shared publications - Zhi Wu
Harbin Institute of Technology
5 shared publications - Arun Kumar Perumal
Department of Aerospace Engineering, Indian Institute of Technology Kanpur, Kanpur, India
3 shared publications B. F. Zhang
Harbin Institute of Technology
3 shared publications
Latest Publications
- 1 August 2026
- Published by AIP Publishing in Physics of Fluids
- Vol. 38 (8)
Control of flow separation from a curved ramp using multiple unsteady jets
Turbulent boundary layers subjected to an adverse pressure gradient are prone to separation, resulting in increased drag and noise, along with deteriorated aerodynamic efficiency. Active flow control strategies have been shown to effectively suppress flow separation, but often at the cost of significant energy consumption. In this study, an experimental investigation is conducted to evaluate the performance of genetic algorithm-optimized unsteady jets for the control of flow separation from a curved ramp at Reθ = 5700, where Reθ is the momentum thickness-based Reynolds number. Three spanwise slit jets are deployed; a total of nine independent control parameters are optimized, including their driving pressures, duty cycles, excitation frequency, and phase differences. The cost function is designed so that separation suppression and actuation energy are compromised. Particle image velocimetry and a pressure scanner are used to characterize the controlled flows. The optimized control eliminates the recirculation region while reducing energy consumption by 76.9% relative to its steady counterpart. Furthermore, the optimization identifies the key mechanism for enhancing control effectiveness. These results demonstrate that the distributed unsteady jets offer a promising pathway toward highly efficient turbulent flow separation control.
- 1 August 2026
- Published by AIP Publishing in Physics of Fluids
- Vol. 38 (8)
Control of flow separation from a curved ramp using multiple unsteady jets
Turbulent boundary layers subjected to an adverse pressure gradient are prone to separation, resulting in increased drag and noise, along with deteriorated aerodynamic efficiency. Active flow control strategies have been shown to effectively suppress flow separation, but often at the cost of significant energy consumption. In this study, an experimental investigation is conducted to evaluate the performance of genetic algorithm-optimized unsteady jets for the control of flow separation from a curved ramp at Reθ = 5700, where Reθ is the momentum thickness-based Reynolds number. Three spanwise slit jets are deployed; a total of nine independent control parameters are optimized, including their driving pressures, duty cycles, excitation frequency, and phase differences. The cost function is designed so that separation suppression and actuation energy are compromised. Particle image velocimetry and a pressure scanner are used to characterize the controlled flows. The optimized control eliminates the recirculation region while reducing energy consumption by 76.9% relative to its steady counterpart. Furthermore, the optimization identifies the key mechanism for enhancing control effectiveness. These results demonstrate that the distributed unsteady jets offer a promising pathway toward highly efficient turbulent flow separation control.
- 29 December 2025
- Published by American Institute of Aeronautics and Astronautics (AIAA) in AIAA Journal
- p. 1-12
Supersonic Jet Entrainment Manipulation and Scaling Using Multiple Steady Minijets
In this study, we investigate the influence of [ ], [ ], and [ ] on the entrainment of a supersonic jet of [ ], controlled using 1–6 minijets, and its scaling. Here, [ ] and [ ] denote the nozzle-exit diameters of the main jet and each minijet, respectively; [ ] is the minijet number; [ ] is the mass flow rate ratio of each minijet to the main jet; and [ ] is the design Mach number. Experimental diagnostics include pressure-field measurements and schlieren flow visualizations. It is shown that, as a measure of the near-field jet entrainment, the supersonic jet core length [ ] strongly depends on all the above parameters. Highly significantly, the present experiment and scaling analysis demonstrate that an originally complex relationship [ ] can be reduced to a single-variable function of [ ] with [ ]. Here, [ ] is the scaling factor, [ ] is the momentum ratio of each individual minijet to the main jet, [ ] is the main-jet fully expanded Mach number, [ ] is the main-jet exit pressure, [ ] is the atmospheric pressure, and [ ] is the specific heat ratio, while [ ] and [ ] represent the fully expanded [ ] and [ ], respectively. The scaling law is discussed in detail, along with the physical meanings of [ ], [ ], and [ ].
- 29 December 2025
- Published by American Institute of Aeronautics and Astronautics (AIAA) in AIAA Journal
- p. 1-12
Supersonic Jet Entrainment Manipulation and Scaling Using Multiple Steady Minijets
In this study, we investigate the influence of [ ], [ ], and [ ] on the entrainment of a supersonic jet of [ ], controlled using 1–6 minijets, and its scaling. Here, [ ] and [ ] denote the nozzle-exit diameters of the main jet and each minijet, respectively; [ ] is the minijet number; [ ] is the mass flow rate ratio of each minijet to the main jet; and [ ] is the design Mach number. Experimental diagnostics include pressure-field measurements and schlieren flow visualizations. It is shown that, as a measure of the near-field jet entrainment, the supersonic jet core length [ ] strongly depends on all the above parameters. Highly significantly, the present experiment and scaling analysis demonstrate that an originally complex relationship [ ] can be reduced to a single-variable function of [ ] with [ ]. Here, [ ] is the scaling factor, [ ] is the momentum ratio of each individual minijet to the main jet, [ ] is the main-jet fully expanded Mach number, [ ] is the main-jet exit pressure, [ ] is the atmospheric pressure, and [ ] is the specific heat ratio, while [ ] and [ ] represent the fully expanded [ ] and [ ], respectively. The scaling law is discussed in detail, along with the physical meanings of [ ], [ ], and [ ].
- 1 September 2025
- Published by AIP Publishing in Physics of Fluids
- Vol. 37 (9)
Interactions between adjacent synthetic-jet-generated vortices of high Strouhal number
This experimental study characterizes the development and interaction of vortices generated by the synthetic jets of the Strouhal numbers (St) from 0.17 to 0.92, issuing from either single, dual, or triple rectangular orifices. Particle image velocimetry is used for flow measurements. A synthetic jet results from the periodic motion of diaphragm mounted beneath each orifice plate, generating counter-rotating vortex pairs. It has been found that, if St is sufficiently high, these paired vortices are confined near the orifice by the suction stroke, forming the near-wall fluid oscillation or confined oscillatory flow; otherwise, a traditional-jet-like flow forms. In dual high-St synthetic jets, when a phase difference (θ) exists between the driving waveforms of adjacent jets, the confined vortex dynamics change, inducing a cross-stream motion toward the phase-leading jet. This effect occurs most strongly at θ = 0.5π. For three adjacent synthetic jets also with θ = 0.5π, the cross-stream motion is substantially enhanced. These findings are significant for the application of high-St synthetic jet arrays in flow control, particularly for the manipulation of the turbulent boundary layer.
- 1 September 2025
- Published by AIP Publishing in Physics of Fluids
- Vol. 37 (9)
Interactions between adjacent synthetic-jet-generated vortices of high Strouhal number
This experimental study characterizes the development and interaction of vortices generated by the synthetic jets of the Strouhal numbers (St) from 0.17 to 0.92, issuing from either single, dual, or triple rectangular orifices. Particle image velocimetry is used for flow measurements. A synthetic jet results from the periodic motion of diaphragm mounted beneath each orifice plate, generating counter-rotating vortex pairs. It has been found that, if St is sufficiently high, these paired vortices are confined near the orifice by the suction stroke, forming the near-wall fluid oscillation or confined oscillatory flow; otherwise, a traditional-jet-like flow forms. In dual high-St synthetic jets, when a phase difference (θ) exists between the driving waveforms of adjacent jets, the confined vortex dynamics change, inducing a cross-stream motion toward the phase-leading jet. This effect occurs most strongly at θ = 0.5π. For three adjacent synthetic jets also with θ = 0.5π, the cross-stream motion is substantially enhanced. These findings are significant for the application of high-St synthetic jet arrays in flow control, particularly for the manipulation of the turbulent boundary layer.
- 1 March 2025
- Published by AIP Publishing in Physics of Fluids
- Vol. 37 (3)
An alternative outer velocity scale for adverse-pressure-gradient turbulent boundary layer
It is widely recognized that the Zagarola–Smits velocity scale UZS serves as a suitable outer velocity scale for adverse-pressure-gradient (APG) turbulent boundary layers (TBLs). In this paper, a relationship between UZS, the edge velocity Ue of the boundary layer, and the skin friction coefficient Cf is established. An alternative outer velocity scale, denoted as Uf, is proposed for APG TBLs based on Ue and Cf. This proposition is validated based on several high-quality databases from the literature, along with the presently obtained experimental APG database. As UZS, the Uf-normalized mean-velocity-defect distributions collapse well together at small to moderate values of the Clauser pressure-gradient parameter. As such, a new and simply empirical method is proposed to determine Cf, or equivalently the friction velocity, for APG TBLs.
- 1 March 2025
- Published by AIP Publishing in Physics of Fluids
- Vol. 37 (3)
An alternative outer velocity scale for adverse-pressure-gradient turbulent boundary layer
It is widely recognized that the Zagarola–Smits velocity scale UZS serves as a suitable outer velocity scale for adverse-pressure-gradient (APG) turbulent boundary layers (TBLs). In this paper, a relationship between UZS, the edge velocity Ue of the boundary layer, and the skin friction coefficient Cf is established. An alternative outer velocity scale, denoted as Uf, is proposed for APG TBLs based on Ue and Cf. This proposition is validated based on several high-quality databases from the literature, along with the presently obtained experimental APG database. As UZS, the Uf-normalized mean-velocity-defect distributions collapse well together at small to moderate values of the Clauser pressure-gradient parameter. As such, a new and simply empirical method is proposed to determine Cf, or equivalently the friction velocity, for APG TBLs.
- 1 November 2024
- Published by AIP Publishing in Physics of Fluids
- Vol. 36 (11)
Artificial intelligence control of flow separation from a curved ramp
This work aims to control flow separation from a two-dimensional curved ramp. The Reynolds number examined is Reθ = 5700 based on the momentum thickness of the turbulent boundary layer right before the ramp. Three steady jets, blowing tangentially along the ramp from three spanwise slits, are deployed at the most likely flow separation position, upstream and downstream of this position, respectively. Three different control modes are investigated, i.e., a single jet, multiple jets, and genetic algorithm-optimized blowing rates of three jets. The single jet placed at the time-averaged flow separation position is found to be most effective and efficient in eliminating flow separation among the first and second control modes. However, it is the third control mode that may not only eliminate the separation bubble completely but also cut down the energy consumption, by up to 30%, compared to the single jet blowing at the flow separation position. The flow physics underlying the control modes is also discussed.
- 1 November 2024
- Published by AIP Publishing in Physics of Fluids
- Vol. 36 (11)
Artificial intelligence control of flow separation from a curved ramp
This work aims to control flow separation from a two-dimensional curved ramp. The Reynolds number examined is Reθ = 5700 based on the momentum thickness of the turbulent boundary layer right before the ramp. Three steady jets, blowing tangentially along the ramp from three spanwise slits, are deployed at the most likely flow separation position, upstream and downstream of this position, respectively. Three different control modes are investigated, i.e., a single jet, multiple jets, and genetic algorithm-optimized blowing rates of three jets. The single jet placed at the time-averaged flow separation position is found to be most effective and efficient in eliminating flow separation among the first and second control modes. However, it is the third control mode that may not only eliminate the separation bubble completely but also cut down the energy consumption, by up to 30%, compared to the single jet blowing at the flow separation position. The flow physics underlying the control modes is also discussed.
- 18 September 2024
- Published by Springer Nature
- p. 85-90
Direct Numerical Simulation of Skin-Friction Reduction Using Steady and Periodic Blowing Through Streamwise Slits
- 18 September 2024
- Published by Springer Nature
- p. 85-90
Direct Numerical Simulation of Skin-Friction Reduction Using Steady and Periodic Blowing Through Streamwise Slits
- 18 September 2024
- Published by Springer Nature
- p. 25-30
Scaling of Skin-Friction Reduction Based on Plasma-Generated Streamwise Vortices
- 18 September 2024
- Published by Springer Nature
- p. 25-30
Scaling of Skin-Friction Reduction Based on Plasma-Generated Streamwise Vortices
- 18 September 2024
- Published by Springer Nature
- p. 247-252
Artificial Intelligence Control of Turbulent Boundary Layer Based on Distributed Synthetic Jets
- 18 September 2024
- Published by Springer Nature
- p. 247-252
Artificial Intelligence Control of Turbulent Boundary Layer Based on Distributed Synthetic Jets
- 18 September 2024
- Published by Springer Nature
- p. 267-272
Surrogate-model-based Active Drag Reduction of High Speed Trains
- 18 September 2024
- Published by Springer Nature
- p. 267-272
Surrogate-model-based Active Drag Reduction of High Speed Trains
- 18 September 2024
- Published by Springer Nature
- p. 73-78
AI-Based Drag Reduction of a High-Speed Train Using Distributed Jets
- 18 September 2024
- Published by Springer Nature
- p. 73-78
AI-Based Drag Reduction of a High-Speed Train Using Distributed Jets