Hirotsugu Sugiura
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Hirotsugu Sugiura has a total of 20 co-authors. Here are the top co-authors by number of shared publications:
- Hiroki Kondo
Nagoya University
9 shared publications Masaru Hori
8 shared publications- Kenji Ishikawa
Nagoya University
7 shared publications Takayoshi Tsutsumi
6 shared publicationsKeigo Takeda
5 shared publicationsMakoto Sekine
5 shared publications
Latest Publications
- 18 February 2019
- Published by IOP Publishing in Journal of Physics D: Applied Physics
- Vol. 52 (17) , 175301
Facile synthesis of SnO 2 -graphene composites employing nonthermal plasma and SnO 2 nanoparticles-dispersed ethanol
The tin oxide (SnO 2 )-graphene composite was synthesized by the in-liquid plasma method using SnO 2 nanoparticles (average diameter ~30 nm) dispersed ethanol as a precursor without providing external heat. As observed from scanning electron microscopy (SEM) and transmission electron microscopy (TEM), the SnO 2 nanoparticles were distributed uniformly on flaky graphene sheets. The formation of SnO 2 and high crystalline graphene was supported by the Raman analysis and x-ray diffraction (XRD) studies. A facile, low-cost method operating at atmospheric pressure based on the in-liquid plasma technology can be utilized to fabricate SnO 2 -graphene composite using minimum precursors for future applications such as gas sensing devices and fuel cells.
- 18 February 2019
- Published by IOP Publishing in Journal of Physics D: Applied Physics
- Vol. 52 (17) , 175301
Facile synthesis of SnO 2 -graphene composites employing nonthermal plasma and SnO 2 nanoparticles-dispersed ethanol
The tin oxide (SnO 2 )-graphene composite was synthesized by the in-liquid plasma method using SnO 2 nanoparticles (average diameter ~30 nm) dispersed ethanol as a precursor without providing external heat. As observed from scanning electron microscopy (SEM) and transmission electron microscopy (TEM), the SnO 2 nanoparticles were distributed uniformly on flaky graphene sheets. The formation of SnO 2 and high crystalline graphene was supported by the Raman analysis and x-ray diffraction (XRD) studies. A facile, low-cost method operating at atmospheric pressure based on the in-liquid plasma technology can be utilized to fabricate SnO 2 -graphene composite using minimum precursors for future applications such as gas sensing devices and fuel cells.
- 13 February 2019
- Published by IOP Publishing in Japanese Journal of Applied Physics
- Vol. 58 (3) , 030912
Control of sp 2 -C cluster incorporation of amorphous carbon films grown by H-radical-injection CH 4 /H 2 plasma-enhanced chemical vapor deposition
Amorphous carbon (a-C) thin films were deposited under the control of C 2 radical density using radical-injection plasma-enhanced chemical vapor deposition (RI-PECVD) with CH 4 /H 2 plasma. By actinometric monitoring of C 2 emission intensities, the plasma parameters were precisely controlled by changing in CH 4 -containing plasma excitation power independent of H 2 plasma excitation. The control of the incorporation of sp 2 -C clusters in the a-C films during the a-C film depositions is demonstrated by tailoring Raman positions vs. full widths at half maxima for the G band around 1580 cm –1 to the RI-PECVD parameters.
- 13 February 2019
- Published by IOP Publishing in Japanese Journal of Applied Physics
- Vol. 58 (3) , 030912
Control of sp 2 -C cluster incorporation of amorphous carbon films grown by H-radical-injection CH 4 /H 2 plasma-enhanced chemical vapor deposition
Amorphous carbon (a-C) thin films were deposited under the control of C 2 radical density using radical-injection plasma-enhanced chemical vapor deposition (RI-PECVD) with CH 4 /H 2 plasma. By actinometric monitoring of C 2 emission intensities, the plasma parameters were precisely controlled by changing in CH 4 -containing plasma excitation power independent of H 2 plasma excitation. The control of the incorporation of sp 2 -C clusters in the a-C films during the a-C film depositions is demonstrated by tailoring Raman positions vs. full widths at half maxima for the G band around 1580 cm –1 to the RI-PECVD parameters.
- 1 February 2019
- Published by American Chemical Society (ACS) in ACS Applied Nano Materials
- Vol. 2 (2) , 649-654
Single-Step, Low-Temperature Simultaneous Formations and in Situ Binding of Tin Oxide Nanoparticles to Graphene Nanosheets by In-Liquid Plasma for Potential Applications in Gas Sensing and Lithium-Ion Batteries
- 1 February 2019
- Published by American Chemical Society (ACS) in ACS Applied Nano Materials
- Vol. 2 (2) , 649-654
Single-Step, Low-Temperature Simultaneous Formations and in Situ Binding of Tin Oxide Nanoparticles to Graphene Nanosheets by In-Liquid Plasma for Potential Applications in Gas Sensing and Lithium-Ion Batteries
- Open Access
Effects of Ion Bombardment Energy Flux on Chemical Compositions and Structures of Hydrogenated Amorphous Carbon Films Grown by a Radical-Injection Plasma-Enhanced Chemical Vapor Deposition
Hydrogenated amorphous carbon (a-C:H) films have attracted much attention, because of their excellent physical and chemical properties, such as high mechanical hardness, chemical robustness, a wide variety of optical bandgaps, and so forth. Although an ion bombardment energy has been regarded as essential in the well-know subplantation model, it alone is inadequate especially in complicated reactions of a plasma-enhanced chemical vapor deposition process. In this study, an ion bombardment energy flux (ΓEi) was proposed as a crucial factor to determine chemical compositions and structures of a-C:H films. To obtain the amounts of ΓEi, electron densities, hydrogen (H) excitation temperatures, and negative direct current (DC) self-bias voltage (-VDC) were measured. The deposition rate increased, and sp2-C clusters incorporation was induced by the ΓEi. With increasing ΓEi, photoluminescence (PL) backgrounds in Raman spectra decreased, while spin densities in electron spin resonance (ESR) measurements increased. These results suggested the H content of a-C:H film decreased depending on the amount of ΓEi. The ΓEi is one of the crucial factors to determine the properties of the a-C:H films.
Open AccessEffects of Ion Bombardment Energy Flux on Chemical Compositions and Structures of Hydrogenated Amorphous Carbon Films Grown by a Radical-Injection Plasma-Enhanced Chemical Vapor Deposition
Hydrogenated amorphous carbon (a-C:H) films have attracted much attention, because of their excellent physical and chemical properties, such as high mechanical hardness, chemical robustness, a wide variety of optical bandgaps, and so forth. Although an ion bombardment energy has been regarded as essential in the well-know subplantation model, it alone is inadequate especially in complicated reactions of a plasma-enhanced chemical vapor deposition process. In this study, an ion bombardment energy flux (ΓEi) was proposed as a crucial factor to determine chemical compositions and structures of a-C:H films. To obtain the amounts of ΓEi, electron densities, hydrogen (H) excitation temperatures, and negative direct current (DC) self-bias voltage (-VDC) were measured. The deposition rate increased, and sp2-C clusters incorporation was induced by the ΓEi. With increasing ΓEi, photoluminescence (PL) backgrounds in Raman spectra decreased, while spin densities in electron spin resonance (ESR) measurements increased. These results suggested the H content of a-C:H film decreased depending on the amount of ΓEi. The ΓEi is one of the crucial factors to determine the properties of the a-C:H films.
- 7 January 2019
- Published by IOP Publishing in Japanese Journal of Applied Physics
- Vol. 58 (SA) , SAAC07
Modifications of surface and bulk properties of magnetron-sputtered carbon films employing a post-treatment of atmospheric pressure plasma
Control of the bonding structure in carbon materials is achieved by a post-treatment of atmospheric pressure plasma (APP) for magnetron-sputtered carbon films. The APP post-treatment changes the films morphologically owing to the removal and modification of sp 2 bonds on the basis of the near edge X-ray absorption fine structure analysis of sp 2 contents. By APP post-treatment, the resulting changes in surface and bulk properties modify the optical and electrical properties of the carbon films. The control of the film properties can be utilized for various applications, such as gas sensors and solar cells.
- 7 January 2019
- Published by IOP Publishing in Japanese Journal of Applied Physics
- Vol. 58 (SA) , SAAC07
Modifications of surface and bulk properties of magnetron-sputtered carbon films employing a post-treatment of atmospheric pressure plasma
Control of the bonding structure in carbon materials is achieved by a post-treatment of atmospheric pressure plasma (APP) for magnetron-sputtered carbon films. The APP post-treatment changes the films morphologically owing to the removal and modification of sp 2 bonds on the basis of the near edge X-ray absorption fine structure analysis of sp 2 contents. By APP post-treatment, the resulting changes in surface and bulk properties modify the optical and electrical properties of the carbon films. The control of the film properties can be utilized for various applications, such as gas sensors and solar cells.
- 25 May 2018
- Published by IOP Publishing in Japanese Journal of Applied Physics
- Vol. 57 (6S2) , 06JE03
Effects of gas residence time of CH 4 /H 2 on sp 2 fraction of amorphous carbon films and dissociated methyl density during radical-injection plasma-enhanced chemical vapor deposition
Quadruple mass spectrometric measurements of CH 3 density during radical-injection plasma-enhanced chemical vapor deposition to consider the sp 2 fraction of amorphous carbon (a-C) films were performed. The sp 2 fraction of the a-C films reached a minimum of 46%, where the CH 3 density was maximum for a residence time of 6 ms. The sp 2 fraction of the a-C films was tailored with the gaseous phase CH 3 density during the deposition. This knowledge is useful for understanding the formation mechanism of bonding structures in the a-C films, which enables the precise control of their electronic properties.
- 25 May 2018
- Published by IOP Publishing in Japanese Journal of Applied Physics
- Vol. 57 (6S2) , 06JE03
Effects of gas residence time of CH 4 /H 2 on sp 2 fraction of amorphous carbon films and dissociated methyl density during radical-injection plasma-enhanced chemical vapor deposition
Quadruple mass spectrometric measurements of CH 3 density during radical-injection plasma-enhanced chemical vapor deposition to consider the sp 2 fraction of amorphous carbon (a-C) films were performed. The sp 2 fraction of the a-C films reached a minimum of 46%, where the CH 3 density was maximum for a residence time of 6 ms. The sp 2 fraction of the a-C films was tailored with the gaseous phase CH 3 density during the deposition. This knowledge is useful for understanding the formation mechanism of bonding structures in the a-C films, which enables the precise control of their electronic properties.
- 29 March 2016
- Published by IOP Publishing in Japanese Journal of Applied Physics
- Vol. 55 (4) , 040305
Effect of gas residence time on near-edge X-ray absorption fine structures of hydrogenated amorphous carbon films grown by plasma-enhanced chemical vapor deposition
In hydrogenated amorphous carbon films, deposited using a radical-injection plasma-enhanced chemical vapor deposition system, the chemical bonding structure was analyzed by near-edge X-ray absorption fine-structure spectroscopy. With a change in the residence times of source gases in a reactor, whereby total gas flow rates of H2/CH4 increased from 50 to 400 sccm, sp2-C fractions showed the minimum value at 150 sccm, while H concentration negligibly changed according to the results of secondary ion mass spectroscopy. On the other hand, widths of σ* C–C peaks increased with decreasing gas residence time, which indicates an increase in the fluctuation of bonding structures.
- 29 March 2016
- Published by IOP Publishing in Japanese Journal of Applied Physics
- Vol. 55 (4) , 040305
Effect of gas residence time on near-edge X-ray absorption fine structures of hydrogenated amorphous carbon films grown by plasma-enhanced chemical vapor deposition
In hydrogenated amorphous carbon films, deposited using a radical-injection plasma-enhanced chemical vapor deposition system, the chemical bonding structure was analyzed by near-edge X-ray absorption fine-structure spectroscopy. With a change in the residence times of source gases in a reactor, whereby total gas flow rates of H2/CH4 increased from 50 to 400 sccm, sp2-C fractions showed the minimum value at 150 sccm, while H concentration negligibly changed according to the results of secondary ion mass spectroscopy. On the other hand, widths of σ* C–C peaks increased with decreasing gas residence time, which indicates an increase in the fluctuation of bonding structures.
- 16 February 2016
- Published by Wiley in Plasma Processes and Polymers
- Vol. 13 (7) , 730-736
Effects of Radical Species on Structural and Electronic Properties of Amorphous Carbon Films Deposited by Radical-Injection Plasma-Enhanced Chemical Vapor Deposition
- 16 February 2016
- Published by Wiley in Plasma Processes and Polymers
- Vol. 13 (7) , 730-736
Effects of Radical Species on Structural and Electronic Properties of Amorphous Carbon Films Deposited by Radical-Injection Plasma-Enhanced Chemical Vapor Deposition