Badr-Eddine Benkelfat
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Badr-Eddine Benkelfat has a total of 15 co-authors. Here are the top co-authors by number of shared publications:
- Abderrahim Ramdane
Lab. de Photonique et de Nanostructures, Centre National de La Recherche Scientifique, Marcoussis, Essonne France 91460
2 shared publications Qin Zou
Inst. Nat. Des Telecommun., Evry
2 shared publications- Yaneck Gottesman
Samovar, Télécom SudParis, Institut Polytechnique de Paris, Palaiseau, France
2 shared publications Abderezzaq Halassi
Université 8 mai 1945 Guelma, Laboratoire des Télécommunications, BP 401, Guelma 24000, Algeria
1 shared publication- Guillaume Huyet
Tyndall National Institute, 261183 Cork, Cork Ireland
1 shared publication - Kamel Merghem
CNRS, Laboratory for Photonics and Nanostructures, Route de Nozay, 91460 Marcoussis, France
1 shared publication
Latest Publications
- 1 January 2022
- Published by Optica Publishing Group
- p. JW5B.15
Tunable all-optical time-to-frequency mapping based on XPM using parabolic pump pulses
Time-to-frequency mapping is induced on an arbitrary optical pulse by XPM using a parabolic pump pulse. The new derived condition of the peak pump pulse allows the conversion of the input pulses having different durations.
- 1 January 2022
- Published by Optica Publishing Group
- p. JW5B.15
Tunable all-optical time-to-frequency mapping based on XPM using parabolic pump pulses
Time-to-frequency mapping is induced on an arbitrary optical pulse by XPM using a parabolic pump pulse. The new derived condition of the peak pump pulse allows the conversion of the input pulses having different durations.
- Open Access
- 31 May 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Photonics Journal
- Vol. 10 (3) , 1-7
Fast-Recovery of the Amplitude and Phase of Short Optical Pulses Using a Frequency-Swept Source Based Heterodyne Measurement
We propose a very fast heterodyne technique to recover the amplitude and phase of short optical pulses generated e.g. by a mode-locked laser. A linearly swept frequency source is used to scan the entire optical spectrum of the mode-locked laser in a single continuous sweep. The beat signal is recorded on a fast oscilloscope and then digitally processed allowing the simultaneous recovery of the amplitude and the phase. This measurement is extremely fast and requires no prior spectral information about the signal under test.
- 31 May 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Photonics Journal
- Vol. 10 (3) , 1-7
Open AccessFast-Recovery of the Amplitude and Phase of Short Optical Pulses Using a Frequency-Swept Source Based Heterodyne Measurement
We propose a very fast heterodyne technique to recover the amplitude and phase of short optical pulses generated e.g. by a mode-locked laser. A linearly swept frequency source is used to scan the entire optical spectrum of the mode-locked laser in a single continuous sweep. The beat signal is recorded on a fast oscilloscope and then digitally processed allowing the simultaneous recovery of the amplitude and the phase. This measurement is extremely fast and requires no prior spectral information about the signal under test.
- 9 July 2007
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Lightwave Technology
- Vol. 25 (7) , 1819-1825
Erbium-Doped-Fiber Characterization: Dynamic Study of Laser Ring Cavity Based on a General Model
In this paper, we propose and demonstrate an original exploitation of relaxation oscillations of erbium-doped-fiber laser ring resonators based on a general model for Er cross-sectional characterization. Its main advantage as compared to other existing exploitations relies on the fact that only weak approximations relative to spatial light distribution in the laser are imposed. It is therefore applicable to various resonator configurations, i.e., independent of the active-media length and losses encountered during the single-pass loop propagation. An experimental demonstration is finally presented by comparing the extracted erbium parameters (intrinsic saturation power and absorption) to those obtained with other methods.
- 9 July 2007
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Lightwave Technology
- Vol. 25 (7) , 1819-1825
Erbium-Doped-Fiber Characterization: Dynamic Study of Laser Ring Cavity Based on a General Model
In this paper, we propose and demonstrate an original exploitation of relaxation oscillations of erbium-doped-fiber laser ring resonators based on a general model for Er cross-sectional characterization. Its main advantage as compared to other existing exploitations relies on the fact that only weak approximations relative to spatial light distribution in the laser are imposed. It is therefore applicable to various resonator configurations, i.e., independent of the active-media length and losses encountered during the single-pass loop propagation. An experimental demonstration is finally presented by comparing the extracted erbium parameters (intrinsic saturation power and absorption) to those obtained with other methods.
- 15 September 2004
- Published by SPIE-Intl Soc Optical Eng
- Vol. 5450, 465-473
Spontaneous emission in emitting-layer-embedded one-dimensional photonic bandgap structures
We show that the spontaneous-emission behavior of an emitter-embedded periodic photonic band-gap (PBG) stack, described in general on the basis of the approximation of dipole emission, can be considerably modified if the macroscopic features of the emitter are considered. We have developed a model which takes into account the optical thickness of the emitter in the usual formalism. The extended model is presented in comparison with the classical dipole-emission model. Some numerical results are given and discussed, by using GaAs-embedded SiO2 / TiO2-coated quarter-wave stacks as a specific configuration. Our model provides quantitative arguments for optimization of spontaneous-emission power in terms of radiation frequency and emitter localization. It can be directly applied to optimum design of more complex systems, such as multi-emitter-embedded periodic stacks and any other passive structure.
- 15 September 2004
- Published by SPIE-Intl Soc Optical Eng
- Vol. 5450, 465-473
Spontaneous emission in emitting-layer-embedded one-dimensional photonic bandgap structures
We show that the spontaneous-emission behavior of an emitter-embedded periodic photonic band-gap (PBG) stack, described in general on the basis of the approximation of dipole emission, can be considerably modified if the macroscopic features of the emitter are considered. We have developed a model which takes into account the optical thickness of the emitter in the usual formalism. The extended model is presented in comparison with the classical dipole-emission model. Some numerical results are given and discussed, by using GaAs-embedded SiO2 / TiO2-coated quarter-wave stacks as a specific configuration. Our model provides quantitative arguments for optimization of spontaneous-emission power in terms of radiation frequency and emitter localization. It can be directly applied to optimum design of more complex systems, such as multi-emitter-embedded periodic stacks and any other passive structure.