ABAlessandro Buscemi

Alessandro Buscemi

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Alessandro Buscemi has a total of 44 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Geothermal–Peltier Hybrid System for Air Cooling and Water Recovery

    by Michele Spagnolo, Paolo Maria Congedo, Alessandro Buscemi, Gianluca Falcicchia Ferrara, Marina Bonomolo, Cristina Baglivo

    This study proposes a new air treatment system that integrates dehumidification, cooling, and water recovery using a Horizontal Air–Ground Heat Exchanger (HAGHE) combined with Peltier cells. The airflow generated by a fan flows through an HAGHE until it meets a septum on which Peltier cells are placed, and then separates into two distinct streams that lap the two surfaces of the Peltier cells: one stream passes through the cold surfaces, undergoing both sensible and latent cooling with dehumidification; the other stream passes through the hot surfaces, increasing its temperature. The two treated air streams may then pass through a mixing chamber, where they are combined in the appropriate proportions to achieve the desired air supply conditions and ensure thermal comfort in the indoor environment. A Computational Fluid Dynamics (CFD) analysis was carried out to simulate the thermal interaction between the HAGHE and the surrounding soil. The simulation focused on a system installed under the subtropical climate conditions of Nairobi, Africa. The simulation results demonstrate that the HAGHE system is capable of reducing the air temperature by several degrees under typical summer conditions, with enhanced performance observed when the soil is moist. Condensation phenomena were triggered when the relative humidity of the inlet air exceeded 60%, contributing additional cooling through latent heat extraction. The proposed HAGHE–Peltier system can be easily powered by renewable energy sources and configured for stand-alone operation, making it particularly suitable for off-grid applications.


  • Open Access

    Design optimization of road thermal collectors: A numerical and experimental study in the Mediterranean

    by Alessandro Buscemi, Stefania Guarino, Alessandro Biondi, Marco Beccali, Valerio Lo Brano


  • Open Access

    Toward a Sustainable Indoor Environment: Coupling Geothermal Cooling with Water Recovery Through EAHX Systems

    by Cristina Baglivo, Alessandro Buscemi, Michele Spagnolo, Marina Bonomolo, Valerio Lo Brano, Paolo Maria Congedo

    This study presents a preliminary analysis of an innovative system that combines indoor air conditioning with water recovery and storage. The device integrates Peltier cells with a horizontal Earth-to-Air Heat Exchanger (EAHX), exploiting the ground stable temperature to enhance cooling and promote condensation. Warm, humid air is pre-cooled via the geothermal pipe, then split by a fan into two streams: one passes over the cold side of the Peltier cells for cooling and dehumidification, while the other flows over the hot side and heats up. The two airstreams are then mixed in a water storage tank, which also serves as a thermal mixing chamber to regulate the final air temperature. The analysis investigates the influence of soil thermal conditions on condensation within the horizontal pipe and the resulting cooling effect in indoor spaces. A hybrid simulation approach was adopted, coupling a 3D model implemented in COMSOL Multiphysics® with a 1D analytical model. Boundary conditions and meteorological data were based on the Typical Meteorological Year (TMY) for Palermo. Two scenarios were considered. In Case A, during the hours when air conditioning is not operating (between 11 p.m. and 9 a.m.), air is circulated in the exchanger to pre-cool the ground and the air leaving the exchanger is rejected into the environment. In Case B, the no air is not circulated in the heat exchanger during non-conditioning periods. Results from the June–August period show that the EAHXs reduced the average outdoor air temperature from 27.81 °C to 25.45 °C, with relative humidity rising from 58.2% to 66.66%, while maintaining nearly constant specific humidity. The system exchanged average powers of 102 W (Case A) and 96 W (Case B), corresponding to energy removals of 225 kWh and 212 kWh, respectively. Case A, which included nighttime soil pre-cooling, showed a 6% increase in efficiency. Condensation water production values range from around 0.005 g/s with one Peltier cell to almost 0.5 g/s with seven Peltier cells. As the number of Peltier cells increases, the cooling effect becomes more pronounced, reducing the output temperature considerably. This solution is scalable and well-suited for implementation in developing countries, where it can be efficiently powered by stand-alone photovoltaic systems.


  • Open Access

    A novel model to assess the energy demand of outdoor swimming pools

    by Alessandro Buscemi, Alessandro Biondi, Pietro Catrini, Stefania Guarino, Valerio Lo Brano


  • Open Access

    Development of Neural Network Prediction Models for the Energy Producibility of a Parabolic Dish: A Comparison with the Analytical Approach

    by Valerio Lo Brano, Stefania Guarino, Alessandro Buscemi, Marina Bonomolo

    Solar energy is one of the most widely exploited renewable/sustainable resources for electricity generation, with photovoltaic and concentrating solar power technologies at the forefront of research. This study focuses on the development of a neural network prediction model aimed at assessing the energy producibility of dish–Stirling systems, testing the methodology and offering a useful tool to support the design and sizing phases of the system at different installation sites. Employing the open-source platform TensorFlow, two different classes of feedforward neural networks were developed and validated (multilayer perceptron and radial basis function). The absolute novelty of this approach is the use of real data for the training phase and not predictions coming from another analytical/numerical model. Several neural networks were investigated by varying the level of depth, the number of neurons, and the computing resources involved for two different sets of input variables. The best of all the tested neural networks resulted in a coefficient of determination of 0.98 by comparing the predicted electrical output power values with those measured experimentally. The results confirmed the high reliability of the neural models, and the use of only open-source IT tools guarantees maximum transparency and replicability of the models.


  • Open Access

    Energy and Environmental Assessment of a Hybrid Dish-Stirling Concentrating Solar Power Plant

    by Stefania Guarino, Alessandro Buscemi, Antonio Messineo, Valerio Lo Brano

    Although the 2019 global pandemic slowed the growing trend of CO2 concentrations in the atmosphere, it has since resumed its rise, prompting world leaders to accelerate the generation of electricity from renewable sources. The study presented in this paper is focused on the evaluation of the energy and environmental benefits corresponding to the hypothesis of hybridizing a dish-Stirling plant installed on the university campus of Palermo (Italy). These analyses were carried out by means of dynamic simulations based on an accurate energy model validated with the experimental data collected during the measurement campaign that occurred during the period of operation of the reference plant. Assuming different scenarios for managing the production period and different fuels, including renewable fuels, it was found that the annual electricity production of the dish-Stirling system operating in solar mode can be increased by between 47% and 78% when hybridized. This would correspond to an increase in generation efficiency ranging from 4% to 16%. Finally, assuming that the dish-Stirling system is hybridized with renewable combustible gases, this would result in avoided CO2 emissions of between approximately 1594 and 3953 tons over the 25-year lifetime of the examined plant.


  • Open Access

    Exergoeconomics as a Cost-Accounting Method in Thermal Grids with the Presence of Renewable Energy Producers

    by Pietro Catrini, Tancredi Testasecca, Alessandro Buscemi, Antonio Piacentino

    Thermal grids are efficient, reliable, and sustainable technologies for satisfying the thermal demands of buildings. The capability to operate at a low temperature allows not only for the integration of heat produced by renewable energy sources but also for the storage of surplus electricity from the grid via “power to heat” technologies. Besides, in the future, heat consumers are expected to behave increasingly as “prosumers”, supplying in some periods heat produced by renewable energy plants on site. In this scenario, it is important to propose a method for the cost allocation among producers connected to the grid. In this regard, this paper proposes Exergoeconomics as a possible tool for rational cost assignment. To show the capabilities of the method, some operating scenarios are compared for a cluster of five buildings of the tertiary sector interconnected by a thermal grid. Based on exergoeconomic indicators, such as the exergy and exergoeconomic unit costs, insights into the cost formation process of the heat consumed by users are provided. Sensitivity analyses of heat unit cost to design and operating variables are also performed. Results show that in the presence of distributed producers, the heat unit cost could be approximately 33% lower than in the case of centralized production, due to the lower amount of irreversibility generated. Capital investment accounts for 20–28% of the heat unit cost.


  • Open Access

    Road Thermal Collector for Building Heating in South Europe: Numerical Modeling and Design of an Experimental Set-Up

    by Antonino D’amico, Giuseppina Ciulla, Alessandro Buscemi, Domenico Panno, Michele Zinzi, Marco Beccali

    The combination/integration of renewable energy and storage systems appears to have significant potential, achieving high-energy results with lower costs and emissions. One way to cover the thermal needs of a building is through solar energy and its seasonal storage in the ground. The SMARTEP project aims to create an experimental area that provides for the construction of a road solar thermal collector directly connected to a seasonal low-temperature geothermal storage with vertical boreholes. The storage can be connected to a ground-to-water heat pump for building acclimatization. This system will meet the requirements of visual impact and reduction of the occupied area. Nevertheless, several constraints related to the radiative properties of the surfaces and the lack of proper thermal insulation have to be addressed. The project includes the study of several configurations and suitable materials, the set-up of a dynamic simulation model and the construction of a small-scale road thermal collector. These phases allowed for an experimental area to be built. Thanks to careful investigation in the field, it will be possible to identify the characteristics and the best operation strategy to maximize the energy management of the whole system in the Mediterranean area.


  • Open Access

    Assessing the Energy-Saving Potential of a Dish-Stirling Con-Centrator Integrated Into Energy Plants in the Tertiary Sector

    by Stefania Guarino, Pietro Catrini, Alessandro Buscemi, Valerio Lo Brano, Antonio Piacentino

    Energy consumed for air conditioning in residential and tertiary sectors accounts for a large share of global use. To reduce the environmental impacts burdening the covering of such demands, the adoption of renewable energy technologies is increasing. In this regard, this paper evaluates the energy and environmental benefits achievable by integrating a dish-Stirling concentrator into energy systems used for meeting the air conditioning demand of an office building. Two typical reference energy plants are assumed: (i) a natural gas boiler for heating purposes and air-cooled chillers for the cooling periods, and (ii) a reversible heat pump for both heating and cooling. For both systems, a dish-Stirling concentrator is assumed to operate first in electric-mode and then in a cogenerative-mode. Detailed models are adopted for plant components and implemented in the TRNSYS environment. Results show that when the concentrator is operating in electric-mode the electricity purchased from the grid decreases by about 72% for the first plant, and 65% for the second plant. Similar reductions are obtained for CO2 emissions. Even better performance may be achieved in the case of the cogenerative-mode. In the first plant, the decrease in natural gas consumption is about 85%. In the second plant, 66.7% is the percentage increase in avoided electricity purchase. The integration of the dish-Stirling system allows promising energy-saving and reduction in CO2 emissions. However, both a reduction in capital cost and financial support are needed to encourage the diffusion of this technology.