Fan Zhang
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Fan Zhang has a total of 16 co-authors. Here are the top co-authors by number of shared publications:
- Shuyun Niu
National ITS Research Center, Research Institute of Highway Ministry of Transport, 8 Xi Tucheng Rd., Haidian Dist., Beijing 100088, China
4 shared publications - Jian Gao
National ITS Research Center, Research Institute of Highway Ministry of Transport
3 shared publications - Yanyan Chen
College of Metropolitan Transportation, Beijing University of Technology, Beijing 100124, China
2 shared publications - Honghai Li
Research Institute of Highway Ministry of Transport, Beijing, China
1 shared publication Jian-Ping Liu
Research Institute of Highway Ministry of Transport
1 shared publication- Jisheng Zhang
School of Traffic and Transportation, Beijing Jiaotong University, Beijing 100044, China
1 shared publication
Latest Publications
- 24 March 2020
- Published by Springer Nature in Lecture Notes in Electrical Engineering
- p. 21-29
A Bayesian Recognition Method for Highway Ambiguity Path Identification Based on Digraph
- 24 March 2020
- Published by Springer Nature in Lecture Notes in Electrical Engineering
- p. 21-29
A Bayesian Recognition Method for Highway Ambiguity Path Identification Based on Digraph
- 2 July 2018
- Published by American Society of Civil Engineers (ASCE)
- p. 1352-1359
Research on Urban Road Network Operation Characteristics Using Data Fusion among ETC, FCD, and DSRC Data
Early detection of congestion is essential to traffic management. Conventional loop or microwave detectors provide flow and speed information but involve significant delays and they offer sparse coverage. To improve this situation, other data sources must be used. This paper investigates the potential use of floating car data (FCD) and ETC (electronic toll collection). These are trajectory data along the routes. DSRC (dedicated short-range communication) data is also collected for the same routes. Assuming that the fused data is able to calculate accurate road operation characteristics, the vehicle number (OBU-ID) is used as the key parameter for ETC data and DSRC data fusion. Road speed can also be obtained by the analysis of FCD. These speeds can be analyzed in order to obtain the road link speed of temporal and spatial variation. A pilot location shows that data fusion could help improve the accuracy of road characteristics.
- 2 July 2018
- Published by American Society of Civil Engineers (ASCE)
- p. 1352-1359
Research on Urban Road Network Operation Characteristics Using Data Fusion among ETC, FCD, and DSRC Data
Early detection of congestion is essential to traffic management. Conventional loop or microwave detectors provide flow and speed information but involve significant delays and they offer sparse coverage. To improve this situation, other data sources must be used. This paper investigates the potential use of floating car data (FCD) and ETC (electronic toll collection). These are trajectory data along the routes. DSRC (dedicated short-range communication) data is also collected for the same routes. Assuming that the fused data is able to calculate accurate road operation characteristics, the vehicle number (OBU-ID) is used as the key parameter for ETC data and DSRC data fusion. Road speed can also be obtained by the analysis of FCD. These speeds can be analyzed in order to obtain the road link speed of temporal and spatial variation. A pilot location shows that data fusion could help improve the accuracy of road characteristics.
- 18 January 2018
- Published by American Society of Civil Engineers (ASCE)
- p. 2712-2724
A Study on Highway Corridor Traffic State Identification Based on Data Fusion of DSRC Data and ETC Data
Traffic state identification is an important part in real-time traffic management and intelligent transportation systems (ITS) applications, which is conventionally based on the available single dataset from traffic sensors such as loop detector, microwave detector, video camera, Bluetooth detector, etc. An accurate profile of the traffic state on highway corridor in terms of speed and density is expected to be a critical factor for supporting traffic management measures. Data fusion techniques are nowadays applied to ITS to improve efficiency and safety of highways. As more and more ETC and DSRC data can be obtained, a method of analyzing traffic status with the datasets gained from ETC via DSRC is expected. In this paper, the DSRC was firstly large scaled installed and applied as a traffic detector along Jingcheng Highway, and the data from DSRC based detector and tolling data were used to identify the traffic state along this corridor. A data fusion method was developed in order to consider both space and time effects was proposed. The results indicated that the DSRC detector could be a promising way to collect traffic data and represent the traffic state on the network with ETC data.
- 18 January 2018
- Published by American Society of Civil Engineers (ASCE)
- p. 2712-2724
A Study on Highway Corridor Traffic State Identification Based on Data Fusion of DSRC Data and ETC Data
Traffic state identification is an important part in real-time traffic management and intelligent transportation systems (ITS) applications, which is conventionally based on the available single dataset from traffic sensors such as loop detector, microwave detector, video camera, Bluetooth detector, etc. An accurate profile of the traffic state on highway corridor in terms of speed and density is expected to be a critical factor for supporting traffic management measures. Data fusion techniques are nowadays applied to ITS to improve efficiency and safety of highways. As more and more ETC and DSRC data can be obtained, a method of analyzing traffic status with the datasets gained from ETC via DSRC is expected. In this paper, the DSRC was firstly large scaled installed and applied as a traffic detector along Jingcheng Highway, and the data from DSRC based detector and tolling data were used to identify the traffic state along this corridor. A data fusion method was developed in order to consider both space and time effects was proposed. The results indicated that the DSRC detector could be a promising way to collect traffic data and represent the traffic state on the network with ETC data.
- 18 January 2018
- Published by American Society of Civil Engineers (ASCE)
- p. 914-925
A Novel Control Strategy of Urban Expressway Weaving Area
The weaving of main road and on-ramp traffic in urban expressway is known to lead to congestion under heavy traffic conditions. This is mainly due to the complete lane changing within a limited distance. The interference between vehicles on main road and ramp causes the traffic chaos and ultimately leads to congestion. This study proposed a novel control strategy based on cooperative vehicle infrastructure system (CVIS) to eliminate this interference and improve efficiency and safety. The strategy was divided into three phases. The first was destination oriented lane control which was to reduce conflicts in the weaving area. The second was main carriageway platoon control which was to reduce the interference caused by merging in main road. And, the third was weaving lane platoon control which was to reduce the interference caused by separating from main road. Simulation results showed that both traffic and energy indexes had a significant improvement in the ideal condition, and a test with real smart vehicles in Beijing Proving Ground has been planned.
- 18 January 2018
- Published by American Society of Civil Engineers (ASCE)
- p. 914-925
A Novel Control Strategy of Urban Expressway Weaving Area
The weaving of main road and on-ramp traffic in urban expressway is known to lead to congestion under heavy traffic conditions. This is mainly due to the complete lane changing within a limited distance. The interference between vehicles on main road and ramp causes the traffic chaos and ultimately leads to congestion. This study proposed a novel control strategy based on cooperative vehicle infrastructure system (CVIS) to eliminate this interference and improve efficiency and safety. The strategy was divided into three phases. The first was destination oriented lane control which was to reduce conflicts in the weaving area. The second was main carriageway platoon control which was to reduce the interference caused by merging in main road. And, the third was weaving lane platoon control which was to reduce the interference caused by separating from main road. Simulation results showed that both traffic and energy indexes had a significant improvement in the ideal condition, and a test with real smart vehicles in Beijing Proving Ground has been planned.
- 29 June 2016
- Published by American Society of Civil Engineers (ASCE)
- p. 1204-1216
Evaluating the Operational Status of Freeway Networks Based on DSRC Data
In this paper, the feasibility of evaluating traffic operation status at freeway networks by utilizing dedicated short range communications (DSRC) data is discussed. The method of data processing as well as the data analysis algorithm are proposed. The data analysis and processing method is done based on the DSRC data and the toll dataset of an operational freeway network from 1st to 15th of July 2015. This includes some fundamental pieces of information, such as the penetration rate of electronic toll collection (ETC) vehicle, the ETC vehicle flow analysis, the proportion of missing data, the speed calculation, and the freeway corridor traffic operation index. The analysis shows that it is feasible to evaluate the traffic operation status of freeway networks by DSRC data when the ETC penetration is big enough, and that the outputs of DSRC data can be used for real-time traffic information service.
- 29 June 2016
- Published by American Society of Civil Engineers (ASCE)
- p. 1204-1216
Evaluating the Operational Status of Freeway Networks Based on DSRC Data
In this paper, the feasibility of evaluating traffic operation status at freeway networks by utilizing dedicated short range communications (DSRC) data is discussed. The method of data processing as well as the data analysis algorithm are proposed. The data analysis and processing method is done based on the DSRC data and the toll dataset of an operational freeway network from 1st to 15th of July 2015. This includes some fundamental pieces of information, such as the penetration rate of electronic toll collection (ETC) vehicle, the ETC vehicle flow analysis, the proportion of missing data, the speed calculation, and the freeway corridor traffic operation index. The analysis shows that it is feasible to evaluate the traffic operation status of freeway networks by DSRC data when the ETC penetration is big enough, and that the outputs of DSRC data can be used for real-time traffic information service.
- 13 July 2015
- Published by American Society of Civil Engineers (ASCE)
- p. 2204-2212
Highway Network Critical Segments Identifying Method with Network Dynamic Traffic Characteristics: A Simulation Based Study
The methods on identifying the highway network critical segments associate with the physical structure have been extensively studied in the last decade. Most of them are based on graph theory and network theory and few of them have considered the dynamic traffic characteristics of the network. These method based on static critical segments may not be sufficient under the real traffic condition. It is meaningful to study the network key segments identifying method with dynamic traffic flows. In this paper, a flow based method will be proposed to identify the critical segments, then the results from the simulation study will be compared with the results from the static network characteristics analysis. After that, we will searching the relations of the critical segments from the static network and the dynamic network. Finally, a verification of the new method was conducted with Anhui highway network simulation.
- 13 July 2015
- Published by American Society of Civil Engineers (ASCE)
- p. 2204-2212
Highway Network Critical Segments Identifying Method with Network Dynamic Traffic Characteristics: A Simulation Based Study
The methods on identifying the highway network critical segments associate with the physical structure have been extensively studied in the last decade. Most of them are based on graph theory and network theory and few of them have considered the dynamic traffic characteristics of the network. These method based on static critical segments may not be sufficient under the real traffic condition. It is meaningful to study the network key segments identifying method with dynamic traffic flows. In this paper, a flow based method will be proposed to identify the critical segments, then the results from the simulation study will be compared with the results from the static network characteristics analysis. After that, we will searching the relations of the critical segments from the static network and the dynamic network. Finally, a verification of the new method was conducted with Anhui highway network simulation.
- Open Access
A Space-Time Network-Based Modeling Framework for Dynamic Unmanned Aerial Vehicle Routing in Traffic Incident Monitoring Applications
It is essential for transportation management centers to equip and manage a network of fixed and mobile sensors in order to quickly detect traffic incidents and further monitor the related impact areas, especially for high-impact accidents with dramatic traffic congestion propagation. As emerging small Unmanned Aerial Vehicles (UAVs) start to have a more flexible regulation environment, it is critically important to fully explore the potential for of using UAVs for monitoring recurring and non-recurring traffic conditions and special events on transportation networks. This paper presents a space-time network- based modeling framework for integrated fixed and mobile sensor networks, in order to provide a rapid and systematic road traffic monitoring mechanism. By constructing a discretized space-time network to characterize not only the speed for UAVs but also the time-sensitive impact areas of traffic congestion, we formulate the problem as a linear integer programming model to minimize the detection delay cost and operational cost, subject to feasible flying route constraints. A Lagrangian relaxation solution framework is developed to decompose the original complex problem into a series of computationally efficient time-dependent and least cost path finding sub-problems. Several examples are used to demonstrate the results of proposed models in UAVs’ route planning for small and medium-scale networks.
Open AccessA Space-Time Network-Based Modeling Framework for Dynamic Unmanned Aerial Vehicle Routing in Traffic Incident Monitoring Applications
It is essential for transportation management centers to equip and manage a network of fixed and mobile sensors in order to quickly detect traffic incidents and further monitor the related impact areas, especially for high-impact accidents with dramatic traffic congestion propagation. As emerging small Unmanned Aerial Vehicles (UAVs) start to have a more flexible regulation environment, it is critically important to fully explore the potential for of using UAVs for monitoring recurring and non-recurring traffic conditions and special events on transportation networks. This paper presents a space-time network- based modeling framework for integrated fixed and mobile sensor networks, in order to provide a rapid and systematic road traffic monitoring mechanism. By constructing a discretized space-time network to characterize not only the speed for UAVs but also the time-sensitive impact areas of traffic congestion, we formulate the problem as a linear integer programming model to minimize the detection delay cost and operational cost, subject to feasible flying route constraints. A Lagrangian relaxation solution framework is developed to decompose the original complex problem into a series of computationally efficient time-dependent and least cost path finding sub-problems. Several examples are used to demonstrate the results of proposed models in UAVs’ route planning for small and medium-scale networks.