Adersh Asok
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Adersh Asok has a total of 56 co-authors. Here are the top co-authors by number of shared publications:
Animesh M. Ramachandran
5 shared publicationsMayuri N. Gandhi
Centre for Research in Nanotechnology and Science, Indian Institute of Technology Bombay, Mumbai 400076, India
5 shared publications- Ajit R. Kulkarni
Department of Metallurgical Engineering and Materials Science, Indian Institute of Technology Bombay, Powai, Mumbai, India
4 shared publications Devika Mahesh
3 shared publicationsAdhithya S. Thampi
CSIR-National Institute for Interdisciplinary Science and Technology
2 shared publications- D. Manisha2 shared publications
Latest Publications
- 30 October 2026
- Published by Elsevier in Renewable Energy
- Vol. 279
Beyond daily average irradiance: Instantaneous homogeneous light distribution unlocks higher productivity in fixed-tilt agrivoltaics
- 30 October 2026
- Published by Elsevier in Renewable Energy
- Vol. 279
Beyond daily average irradiance: Instantaneous homogeneous light distribution unlocks higher productivity in fixed-tilt agrivoltaics
- Open Access
- 6 August 2026
- Published by Elsevier in SSRN Electronic Journal
Beyond Daily Average Irradiance: Instantaneous Homogeneous Light Distribution Unlocks Higher Productivity in Fixed-Tilt Agrivoltaics
Agrivoltaic (AV) systems integrate photovoltaic electricity generation with agriculture, enabling dual land use. However, conventional fixed-tilt AV systems often reduce crop productivity because opaque photovoltaic (PV) modules create non-uniform irradiance beneath the array. To overcome this limitation, this study presents an Even Solar Sharing Agrivoltaic (ESS-AV) system that employs linear-diverging Fresnel optics to continuously redistribute transmitted sunlight into shaded regions, generating a more homogeneous instantaneous light distribution than the conventional Checkerboard-AV layout. A 1.1 kWp rooftop ESS-AV pilot plant was developed by replacing 50% of the PV modules with diverging optics and benchmarked against a Checkerboard-AV system with the same PV coverage and open-field cultivation. While Checkerboard-AV exhibited pronounced spatial variability in irradiance, ESS-AV maintained a uniform light environment throughout the day. The three-day average photosynthetic photon flux density (PPFD) was 831, 246, and 231 μmol m⁻² s⁻¹ for the open field, Checkerboard-AV, and ESS-AV, respectively. Spearmint (Mentha spicata) was cultivated to evaluate microclimate, growth, morphology, metabolite profiles, and essential oil composition. ESS-AV increased crop yield by 13% over Checkerboard-AV despite comparable daily average PPFD, demonstrating the importance of instantaneous homogeneous light distribution. The land equivalent ratio reached 1.81 relative to full rooftop PV and 2.04 relative to ground-mounted PV. These findings establish that instantaneous light uniformity should be considered alongside daily average irradiance as a key design criterion for fixed-tilt agrivoltaics and demonstrate that linear-diverging Fresnel optics improve crop productivity, land-use efficiency, and renewable energy generation.
- 6 August 2026
- Published by Elsevier in SSRN Electronic Journal
Open AccessBeyond Daily Average Irradiance: Instantaneous Homogeneous Light Distribution Unlocks Higher Productivity in Fixed-Tilt Agrivoltaics
Agrivoltaic (AV) systems integrate photovoltaic electricity generation with agriculture, enabling dual land use. However, conventional fixed-tilt AV systems often reduce crop productivity because opaque photovoltaic (PV) modules create non-uniform irradiance beneath the array. To overcome this limitation, this study presents an Even Solar Sharing Agrivoltaic (ESS-AV) system that employs linear-diverging Fresnel optics to continuously redistribute transmitted sunlight into shaded regions, generating a more homogeneous instantaneous light distribution than the conventional Checkerboard-AV layout. A 1.1 kWp rooftop ESS-AV pilot plant was developed by replacing 50% of the PV modules with diverging optics and benchmarked against a Checkerboard-AV system with the same PV coverage and open-field cultivation. While Checkerboard-AV exhibited pronounced spatial variability in irradiance, ESS-AV maintained a uniform light environment throughout the day. The three-day average photosynthetic photon flux density (PPFD) was 831, 246, and 231 μmol m⁻² s⁻¹ for the open field, Checkerboard-AV, and ESS-AV, respectively. Spearmint (Mentha spicata) was cultivated to evaluate microclimate, growth, morphology, metabolite profiles, and essential oil composition. ESS-AV increased crop yield by 13% over Checkerboard-AV despite comparable daily average PPFD, demonstrating the importance of instantaneous homogeneous light distribution. The land equivalent ratio reached 1.81 relative to full rooftop PV and 2.04 relative to ground-mounted PV. These findings establish that instantaneous light uniformity should be considered alongside daily average irradiance as a key design criterion for fixed-tilt agrivoltaics and demonstrate that linear-diverging Fresnel optics improve crop productivity, land-use efficiency, and renewable energy generation.
- 10 October 2025
- Published by Springer Nature
- p. 529-573
Geometric Optics-Based Solar Light Management Strategies
- 10 October 2025
- Published by Springer Nature
- p. 529-573
Geometric Optics-Based Solar Light Management Strategies
- Open Access
- 17 September 2024
- Published by Elsevier in Results in Engineering
- Vol. 24
Single elemental planar light concentrator using skewed V-groove optics
- 17 September 2024
- Published by Elsevier in Results in Engineering
- Vol. 24
Open AccessSingle elemental planar light concentrator using skewed V-groove optics
- Open Access
- 3 October 2022
- Published by Elsevier in Results in Engineering
- Vol. 16
A comprehensive review on optics and optical materials for planar waveguide-based compact concentrated solar photovoltaics
- 3 October 2022
- Published by Elsevier in Results in Engineering
- Vol. 16
Open AccessA comprehensive review on optics and optical materials for planar waveguide-based compact concentrated solar photovoltaics
- 22 April 2021
- Published by American Chemical Society (ACS) in ACS Applied Bio Materials
- Vol. 4 (5) , 4373-4383
Hydrophilic 3D Interconnected Network of Bacterial Nanocellulose/Black Titania Photothermal Foams as an Efficient Interfacial Solar Evaporator
The design and development of scalable, efficient photothermal evaporator systems that reduce microplastic pollution are highly desirable. Herein, a sustainable bacterial nanocellulose (BNC)-based self-floating bilayer photothermal foam (PTFb) is designed that eases the effective confinement of solar light for efficient freshwater production via interfacial heating. The sandwich nanoarchitectured porous bilayer solar evaporator consists of a top solar-harvesting blackbody layer composed of broad-spectrum active black titania (BT) nanoparticles embedded in the BNC matrix and a thick bottom layer of pristine BNC for agile thermal management, the efficient wicking of bulk water, and staying afloat. A decisive advantage of the BNC network is that it enables the fabrication of a lightweight photothermal foam with reduced thermal conductivity and high wet strength. Additionally, the hydrophilic three-dimensional (3D) interconnected porous network of BNC contributes to the fast evaporation of water under ambient solar conditions with reduced vaporization enthalpy by virtue of intermediated water generated via a BNC–water interaction. The fabricated PTFb is found to yield a water evaporation efficiency of 84.3% (under 1054 W m–2) with 4 wt % BT loading. Furthermore, scalable PTFb realized a water production rate of 1.26 L m–2 h–1 under real-time conditions. The developed eco-friendly BNC-supported BT foams could be used in applications such as solar desalination, contaminated water purification, extraction of water from moisture, etc., and thus could address one of the major present-day global concerns of drinking water scarcity.
- 22 April 2021
- Published by American Chemical Society (ACS) in ACS Applied Bio Materials
- Vol. 4 (5) , 4373-4383
Hydrophilic 3D Interconnected Network of Bacterial Nanocellulose/Black Titania Photothermal Foams as an Efficient Interfacial Solar Evaporator
The design and development of scalable, efficient photothermal evaporator systems that reduce microplastic pollution are highly desirable. Herein, a sustainable bacterial nanocellulose (BNC)-based self-floating bilayer photothermal foam (PTFb) is designed that eases the effective confinement of solar light for efficient freshwater production via interfacial heating. The sandwich nanoarchitectured porous bilayer solar evaporator consists of a top solar-harvesting blackbody layer composed of broad-spectrum active black titania (BT) nanoparticles embedded in the BNC matrix and a thick bottom layer of pristine BNC for agile thermal management, the efficient wicking of bulk water, and staying afloat. A decisive advantage of the BNC network is that it enables the fabrication of a lightweight photothermal foam with reduced thermal conductivity and high wet strength. Additionally, the hydrophilic three-dimensional (3D) interconnected porous network of BNC contributes to the fast evaporation of water under ambient solar conditions with reduced vaporization enthalpy by virtue of intermediated water generated via a BNC–water interaction. The fabricated PTFb is found to yield a water evaporation efficiency of 84.3% (under 1054 W m–2) with 4 wt % BT loading. Furthermore, scalable PTFb realized a water production rate of 1.26 L m–2 h–1 under real-time conditions. The developed eco-friendly BNC-supported BT foams could be used in applications such as solar desalination, contaminated water purification, extraction of water from moisture, etc., and thus could address one of the major present-day global concerns of drinking water scarcity.
- 15 June 2020
- Published by American Chemical Society (ACS) in ACS Applied Nano Materials
- Vol. 3 (7) , 6827-6835
Clean Water from Air Utilizing Black TiO2-Based Photothermal Nanocomposite Sheets
- 15 June 2020
- Published by American Chemical Society (ACS) in ACS Applied Nano Materials
- Vol. 3 (7) , 6827-6835
Clean Water from Air Utilizing Black TiO2-Based Photothermal Nanocomposite Sheets
- 1 March 2019
- Published by Elsevier in Solar Energy
- Vol. 180, 501-509
Surface engineering of CdTe quantum dots using ethanol as a co-solvent for enhanced current conversion efficiency in QDSSC
- 1 March 2019
- Published by Elsevier in Solar Energy
- Vol. 180, 501-509
Surface engineering of CdTe quantum dots using ethanol as a co-solvent for enhanced current conversion efficiency in QDSSC
- Open Access
- 4 July 2018
- Published by Wiley in Global Challenges
- Vol. 2 (11) , 1800025
Multifunctional Photostable Nanocomplex of ZnO Quantum Dots and Avobenzone via the Promotion of Enolate Tautomer
Ideal multifunctional ultraviolet radiation (UVR) absorbents with excellent photostability, high molar absorptivity, broadband UVR screening, and desired skin sensorial properties remain a significant challenge for the sunscreen industry. The potential of the nanocomplex (NCx) formed by microwave synthesis of ZnO quantum dots (QDs) in the presence of Avobenzone (Av) for achieving these goals is reported. The NCx exhibits unique synergy between ZnO QD and Av components, which enhances the photostability and molar absorptivity, extends UVA filtering range, and provides a visible emission that matches the typical human in vivo skin emission color. Density functional theory (DFT) and time‐dependent DFT calculations of ZnO‐Av hybrid structures and comparison of their spectroscopic features with experiments suggest that ZnO QDs catalyze the formation of highly photostable surface enolate species via aldol condensation reaction. The combination of experiments and computations used in this study can advance the science and technology of photoprotection.
- 4 July 2018
- Published by Wiley in Global Challenges
- Vol. 2 (11) , 1800025
Open AccessMultifunctional Photostable Nanocomplex of ZnO Quantum Dots and Avobenzone via the Promotion of Enolate Tautomer
Ideal multifunctional ultraviolet radiation (UVR) absorbents with excellent photostability, high molar absorptivity, broadband UVR screening, and desired skin sensorial properties remain a significant challenge for the sunscreen industry. The potential of the nanocomplex (NCx) formed by microwave synthesis of ZnO quantum dots (QDs) in the presence of Avobenzone (Av) for achieving these goals is reported. The NCx exhibits unique synergy between ZnO QD and Av components, which enhances the photostability and molar absorptivity, extends UVA filtering range, and provides a visible emission that matches the typical human in vivo skin emission color. Density functional theory (DFT) and time‐dependent DFT calculations of ZnO‐Av hybrid structures and comparison of their spectroscopic features with experiments suggest that ZnO QDs catalyze the formation of highly photostable surface enolate species via aldol condensation reaction. The combination of experiments and computations used in this study can advance the science and technology of photoprotection.