HLHong Li

Hong Li

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Hong Li has a total of 13 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Performance Analysis and Selection of Chinese Solar Greenhouses in Xinjiang Desert Area

    by Xiao Wu, Hong Li, Siyu Sang, Anhui He, Yimei Re, Hongjun Xu

    This study aims to provide information and theoretical support for the development planning of facility agriculture in desert areas. Using sensor monitoring, USB cable, and computer connection record, we measured the temperature, humidity, and heat transfer distribution of ordinary brick wall greenhouse (G1), composite wall greenhouse (G2), and assembled solar greenhouse (G3) in the Aksu desert area of Xinjiang. The results showed that G3 had the highest average temperature among the three types of greenhouses in the cold season; no difference was detected between G1 and G2 in the night temperature, while G3 has the characteristics of fast heating and cooling. On a sunny day, the heating rate of G1, G2, and G3 is 3.62, 4.4, and 4.77 °C/h, respectively. The cooling rate for G1 is 2.66 °C/h; 2.96 °C/h for G2; and 3.93 °C/h for G3. The heating rate for each greenhouse is nearly identical when it is cloudy outside, and the cooling rate of G1, G2, and G3 is 2.71, 4.2, and 4.34 °C/h, respectively. Moreover, the G3 north wall’s thermal insulation performance has clear advantages. Its wall surface can reach a temperature of 59.1 °C (G1 is 42.7 °C and G2 is 41.6 °C). This study showed that G3 possesses the virtues of effective thermal insulation; the rear wall has a small footprint and preserves the arable land; it also achieves the necessary environmental conditions for crop growth without the use of auxiliary heating.


  • Performance evaluation of breast cancer diagnosis with mammography, ultrasonography and magnetic resonance imaging

    by Hang Sun, Hong Li, Shuang Si, Shouliang Qi, Wei Zhang, He Ma, Siqi Liu, Li Yingxue, Wei Qian

    OBJECTIVE: Various imaging modalities have been used to diagnose suspicious breast lesions. Purpose of this study is to compare the diagnostic accuracy for breast cancer using mammography, ultrasonography and magnetic resonance imaging (MRI). METHODS: Total 107 patients aged from 19 to 62 years are included in this retrospective study. Mammography, ultrasonography and MRI scans were performed for each patient detected with suspected breast tumor within a month. In addition, the tumor diversity (10 types of benign and 5 types of malignant) was confirmed by pathological findings of tumor biopsy. To compare the diagnosis performance of the three imaging modalities, the overall fraction correct (accuracy), positive predict value (PPV), negative predict value (NPV), sensitivity and specificity were calculated. Meanwhile, the receiver operating characteristic (ROC) analysis was also performed. RESULTS: The diagnostic accuracy ranged from 78.5% to 86.9% among three imaging modalities. All modalities yielded a PPV lower than 77.8% and a NPV higher than 90.0% in identifying the presence of malignant tumors. MRI presented a diagnostic accuracy of 86.9%, as well as a sensitivity of 95.5% and an area under curve (AUC) of 0.948, which are higher than mammography and ultrasonography. CONCLUSION: By using a diverse dataset and comparing the diagnostic accuracy of three imaging modalities commonly used in breast cancer detection and diagnosis, this study also demonstrated that mammography, ultrasonography and MRI had different diagnostic performance in breast tumor identification. Among them, MRI yielded the highest performance even though the unexpected specificity may lead to over-diagnosis, and ultrosonography is slightly better than mammography.