Gi-Hwan Kim
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Gi-Hwan Kim has a total of 19 co-authors. Here are the top co-authors by number of shared publications:
- Jin Young Kim
School of Energy and Chemical Engineering, Ulsan National Institute of Science and Technology (UNIST), Ulsan 44919, Republic of Korea
4 shared publications - Dong Suk Kim
Korea KIER-UNIST Advanced Center for Energy, Korea Institute of Energy Research (KIER), Ulsan 44919, South Korea
1 shared publication - Hak-Beom Kim
Perovtronics Research Center and Department of Energy Engineering, Ulsan National Institute of Science and Technology (UNIST), Ulsan 44919, South Korea
1 shared publication - Han Young Woo
Department of Chemistry, Korea University, Seoul, Republic of Korea
1 shared publication - Hongsuk Suh
Department of Chemistry and Chemistry Institute for Functional Materials, Pusan National University (PNU), Busan 46241, Republic of Korea
1 shared publication - Hyun-Kon Song
School of Energy and Chemical Engineering, UNIST, Ulsan 44919, Korea
1 shared publication
Latest Publications
- 24 September 2018
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry A
- Vol. 6 (41) , 20138-20144
The introduction of a perovskite seed layer for high performance perovskite solar cells
Processing for obtaining compact and uniform perovskite photoactive layers has been intensively studied over the last few years to achieve high power conversion efficiencies (PCEs) in solar cells. Particularly, high quality crystal growth of perovskite layers is critical to enhance device performance. We demonstrate an easy and effective new process for high efficiency p–i–n planar heterojunction structures of perovskite solar cells (PeSCs) by using a compact seed perovskite layer (CSPL). The CSPL assists vertical growth of perovskite crystals and obtains the highly crystalline perovskite photoactive layer, which leads to the reduction in the charge transfer resistance and a longer photoluminescence lifetime. The PeSC device with a CSPL shows a remarkably improved PCE, from 15.07% to 19.25%, with a record open circuit voltage (VOC) of 1.16 V in the p–i–n structure with pure crystal perovskite and negligible current density–voltage hysteresis. Additionally, a PCE of 20.37% was achieved in CSPL assisted n–i–p structure PeSCs.
- 24 September 2018
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry A
- Vol. 6 (41) , 20138-20144
The introduction of a perovskite seed layer for high performance perovskite solar cells
Processing for obtaining compact and uniform perovskite photoactive layers has been intensively studied over the last few years to achieve high power conversion efficiencies (PCEs) in solar cells. Particularly, high quality crystal growth of perovskite layers is critical to enhance device performance. We demonstrate an easy and effective new process for high efficiency p–i–n planar heterojunction structures of perovskite solar cells (PeSCs) by using a compact seed perovskite layer (CSPL). The CSPL assists vertical growth of perovskite crystals and obtains the highly crystalline perovskite photoactive layer, which leads to the reduction in the charge transfer resistance and a longer photoluminescence lifetime. The PeSC device with a CSPL shows a remarkably improved PCE, from 15.07% to 19.25%, with a record open circuit voltage (VOC) of 1.16 V in the p–i–n structure with pure crystal perovskite and negligible current density–voltage hysteresis. Additionally, a PCE of 20.37% was achieved in CSPL assisted n–i–p structure PeSCs.
- 24 August 2012
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry
- Vol. 22 (39) , 21238-21241
Observation of ambipolar field-effect behavior in donor–acceptor conjugated copolymers
Although donor (D)–acceptor (A) conjugated copolymers possess an electron deficient unit, most D–A copolymers exhibit only hole transport properties (p-type). While there are some D–A copolymers that show ambipolarity, n-type behaviour is highly dependent on the type of acceptor used. In this work, ambipolar field-effect behaviour was derived from general D–A conjugated copolymers, believed to be a typical p-type material, by introducing a functional passivation layer between gate dielectric and active layers using polypropylene-co-1-butene (PPcB). The PPcB layer effectively covered the hydroxyl groups and induced a reduction in the energetic disorder at the semiconductor–insulator interface. As a result, the FET devices fabricated using D–A conjugated copolymers, such as PCDTBT, PTBT and Si-PCPDTBT, showed clear ambipolar properties.
- 24 August 2012
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry
- Vol. 22 (39) , 21238-21241
Observation of ambipolar field-effect behavior in donor–acceptor conjugated copolymers
Although donor (D)–acceptor (A) conjugated copolymers possess an electron deficient unit, most D–A copolymers exhibit only hole transport properties (p-type). While there are some D–A copolymers that show ambipolarity, n-type behaviour is highly dependent on the type of acceptor used. In this work, ambipolar field-effect behaviour was derived from general D–A conjugated copolymers, believed to be a typical p-type material, by introducing a functional passivation layer between gate dielectric and active layers using polypropylene-co-1-butene (PPcB). The PPcB layer effectively covered the hydroxyl groups and induced a reduction in the energetic disorder at the semiconductor–insulator interface. As a result, the FET devices fabricated using D–A conjugated copolymers, such as PCDTBT, PTBT and Si-PCPDTBT, showed clear ambipolar properties.
- 20 June 2011
- Published by Wiley in Journal of Polymer Science Part A: Polymer Chemistry
- Vol. 49 (17) , 3751-3758
Synthesis and photovoltaic properties of conjugated copolymers based on benzimidazole and various thiophene
- 20 June 2011
- Published by Wiley in Journal of Polymer Science Part A: Polymer Chemistry
- Vol. 49 (17) , 3751-3758
Synthesis and photovoltaic properties of conjugated copolymers based on benzimidazole and various thiophene
- 30 April 2011
- Published by Elsevier in Solar Energy Materials and Solar Cells
- Vol. 95 (4) , 1119-1122
The effect of introducing a buffer layer to polymer solar cells on cell efficiency
- 30 April 2011
- Published by Elsevier in Solar Energy Materials and Solar Cells
- Vol. 95 (4) , 1119-1122
The effect of introducing a buffer layer to polymer solar cells on cell efficiency