VBVáclav Beránek

Václav Beránek

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Václav Beránek has a total of 23 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Very Large Difference Between Real and Declared Volumes of PV Panel Recycling: Economic Motivation for Environmental Sustainability

    by Vladislav Poulek, Martin Kozelka, Václav Beránek

    Technical recyclability does not ensure that decommissioned photovoltaic (PV) modules enter recycling. A published estimate of approximately 10% global PV waste recycling provides context rather than a new global inventory. In this study, economic incentives for increasing actual PV module recycling are examined. Three treatment routes are compared using published experimental and industrial data: room-temperature delamination of double-glass modules with soft polydimethylsiloxane (PDMS), milling of ethylene-vinyl acetate (EVA) modules with polymer backsheets, and hot-knife separation of the same EVA construction. In a mass-based cost-and-revenue scenario, an assumed gross processing rate of USD 0.65/kg is applied to the 37 kg PDMS and 24 kg EVA reference modules. With stated material credits and a common USD 3.5 aluminum frame credit, the respective NET BALANCES are approximately +USD 6.8, −USD 12.1, and −USD 10.8 per module. The technical basis is the preservation of two intact glass sheets (approximately 30 kg) and a separately recovered silicone fraction (approximately 3.0 kg). After cleaning and verification, suitable recovered sheets may serve as rear glass in compatible new PV modules. Direct glass reuse avoids remelting, whereas nonincinerating PDMS delamination avoids direct encapsulant-combustion emissions. The positive scenario balance suggests that preserving reusable components can strengthen economic incentives for recycling, supporting circular material use and environmental sustainability.

  • Open Access

    Repowering Without Removal: Field-Verified Multi-Year Outdoor Storage of Damaged Photovoltaic Modules on Agricultural Land in Czechia

    by Martin Kozelka, Vladislav Poulek, Václav Beránek, Tomáš Finsterle

    Ground-mounted photovoltaic (PV) plants generate discrete end-of-life waste streams during repowering/revamping, yet damaged modules do not always leave the site. We document two field-verified case studies from Czechia, in which damaged PV modules remained stored outdoors on agricultural land after repowering/revamping. The two sites are treated as illustrative, field-verified cases rather than as a statistically representative sample of PV plants in Czechia or Europe. The sites were first identified during field visits in summer 2025, and a retrospective review of public CUZK orthophoto time series was then used to reconstruct when the stockpiles first became visible and whether they were still present in the latest available imagery. The stored module piles first became visible in 2022 and 2021 at the two sites, and were still present in summer 2025, corresponding to a minimum confirmed persistence of about 3 and 4 years, respectively. Orthophoto-based GIS supported by field photographs was used to quantify the land parcel area (19,560 and 22,100 m2), PV plan-view area (4960 and 5080 m2), storage footprint (109 and 100 m2), approximate stored module count (~1800 and ~2000), and stored mass (39.6 and 36.0 t). Using site-specific module footprints and a representative 30-module stack, the local stack-based pressures were calculated to be 3.92 and 3.26 kPa, respectively. Soil chemistry, leachate, and groundwater were not measured; therefore, the environmental implications should be interpreted as precautionary risk and as a need for monitoring, not as measured contamination at the two sites. The study shows that repowering/revamping can create a multi-year gap between module replacement and actual site clearance, during which recycling and final disposal are effectively delayed.


  • Open Access

    Dry Pass, Wet Fail: Ground Impedance Testing of Field-Aged PV Modules—Implications for Repowering/Revamping Within 5–10 Years and for Environmental Sustainability

    by Vladislav Poulek, Vaclav Beranek, Tomas Finsterle, Martin Kozelka

    The ground impedance (insulation resistance Risol) of photovoltaic (PV) modules is usually measured only in the dry state, even though arrays frequently operate under dew-wet or rain-wet conditions, when leakage paths can change. We measured dry insulation resistance Rdry and IEC 61215 MQT 15 wet leakage resistance Rwet for N = 37 field-aged crystalline-silicon modules from utility-scale plants and related the results to the IEC 40 MΩ·m2 criterion (Rwet × A ≥ 40). The measurements used 1000 V DC and a 2 min dwell; Rwet was obtained in a salted bath with a solution resistivity < 3500 Ω·cm. The median Rdry was 42.4 GΩ, whereas the median Rwet was 462.5 MΩ, resulting in a median Rdry/Rwet ratio of ~110×. Three modules (8.1%) failed the 40 MΩ·m2 limit already in the dry state, whereas eight modules (21.6%) failed under IEC-wet conditions; five were dry-pass/wet-fail cases that would have passed dry screening. For a representative area A = 1.8 m2, a practical conservative dry triage threshold of approximately 55.5 GΩ identifies modules needing IEC-wet verification rather than serving as a stand-alone limit. Overall, combining dry and IEC-wet measurements improves safety and supports sustainability through resource-efficient repowering/revamping and end-of-life decisions in large PV fleets, particularly in hot climates.


  • Open Access

    PV Modules Stored on Farmlands after Repowering: Sustainability and Environmental Impact

    by Martin Kozelka, Jiří Marcan, Vladislav Poulek, Václav Beránek, Tomáš Finsterle, Agnieszka Klimek-Kopyra, Marcin Kopyra, Martin Libra, František Kumhála

    Ground‑mounted photovoltaics, including agrivoltaic concepts, are increasingly deployed on agricultural land. In practice, damaged modules from repowering modules are sometimes stored on‑site for prolonged periods, creating localized vegetation suppression and land‑stewardship concerns that are rarely quantified. We present two anonymized case studies from Czechia (nominal capacities of 0.861 and 1.109 MWp; commissioned 2010 and 2009; repowered 2022 and 2021), where cracked backsheets and/or broken front‑glass modules were stacked and stored directly on grasslands within PV parcels. Using GIS delineation on orthophotos supported by field photographs, we quantified the land area (19,560 and 22,100 m²), PV panel area (plan‑ view; 4,960 and 5,080 m²), and stored PV module area (plan‑ view storage footprint; 109 and 100 m²). Stored module counts were estimated from visible stacks (≈1800 and ≈2000 modules). Using a conservative mass range of 18–25 kg/module, the stored masses were ~32–45 t and ~36–50 t, respectively. Although the storage footprints constitute Astore (m²), Nstore (pcs), Mstore (t), storage duration, condition class, and storage interface.

  • Open Access

    When “Dry” Passes but “Wet” Fails: IEC 61215 MQT 15 Wet Ground Impedance of Field-Aged PV Modules and Implications for Repowering/Revamping within 5–10 Years and for Environmental Sustainability

    by Vladislav Poulek, Vaclav Beranek, Tomas Finsterle, Martin Kozelka

    The ground impedance (insulation resistance Risol) of photovoltaic (PV) modules is usually measured only in the dry state, even though arrays frequently operate under dew-wet or rain-wet conditions, when leakage paths can change. We measured dry insulation resistance Rdry and IEC 61215 MQT 15 wet leakage resistance Rwet for N = 37 field-aged crystalline-silicon modules from utility-scale plants and related the results to the IEC 40 MΩ·m² criterion (Rwet·A ≥ 40). The measurements used 1000 V DC and a 2 min dwell; Rwet was obtained in a salted bath with a solution resistivity < 3500 Ω·cm. The median Rdry was 42.4 GΩ, whereas the median Rwet was 462.5 MΩ, resulting in a median Rdry/Rwet ratio of ~110×. Three modules (8.1%) failed the 40 MΩ·m² limit already in the dry state, whereas eight modules (21.6%) failed under IEC-wet conditions; five were dry-pass/wet-fail cases that would have passed dry screening. For a representative area A = 1.8 m², a practical conservative dry triage threshold of approximately 55.5 GΩ identifies modules needing IEC-wet verification rather than serving as a stand-alone limit. Overall, combining dry and IEC-wet measurements improves safety and supports sustainability through resource-efficient repowering/revamping and end-of-life decisions in large PV fleets, particularly in hot climates.

  • Open Access

    Environmentally Sustainable Recycling of Photovoltaic Panels Laminated with Soft Polysiloxane Gels: Promoting the Circular Economy and Reducing the Carbon Footprint

    by Vladislav Poulek, Vaclav Beranek, Martin Kozelka, Tomas Finsterle

    This article presents an innovative and highly sustainable method for recycling photovoltaic (PV) panels laminated with very soft polydimethylsiloxane (PDMS) gels. This approach eliminates energy-intensive and environmentally harmful processes such as burning and chemical etching due to simple and clean mechanical delamination at room temperature via polyethylene wedges. This technology significantly contributes to environmental sustainability by facilitating the direct reuse of materials, reducing the amount of hazardous waste, and minimizing energy consumption during recycling. PDMS panels achieve extremely low annual degradation rates (0.15–0.22%) and excellent recycling efficiencies (95–98%) compared to conventional EVA/POE laminated panels, with up to 81% of the panel weight being directly reused. This has led to a drastic reduction in the overall carbon footprint and is in line with the principles of circular economy and sustainable development goals (SDGs). The synergistic combination of long service life and efficient end-of-life processing makes this technology a cornerstone of sustainability in the photovoltaic industry. It addresses pressing environmental and socioeconomic challenges by promoting resource efficiency, reducing photovoltaic waste by up to 114 times, and enabling policies and practices that support the global energy transition.


  • Open Access

    Environmentally Sustainable Recycling of Photovoltaic Panels Laminated with Soft Polysiloxane Gels: Promoting the Circular Economy and Reducing the Carbon Footprint

    by Vladislav Poulek, Václav Beránek, Martin Kozelka, Tomáš Finsterle

    This article presents an innovative and highly sustainable method for recycling photovoltaic (PV) panels laminated with very soft polydimethylsiloxane (PDMS) gels. Owing to simple and clean mechanical delamination at room temperature via polyethylene wedges, this approach eliminates energy-intensive and environmentally harmful processes such as burning and chemical etching. This technology contributes significantly to environmental sustainability by facilitating the direct reuse of materials, reducing the amount of hazardous waste, and minimizing energy consumption during recycling. Compared with conventional EVA/POE laminated panels, PDMS panels achieve extremely low annual degradation rates (0.15–0.22%) and excellent recycling efficiencies (95–98%), with up to 81% of the panel weight being directly reused. This has led to a drastic reduction in the overall carbon footprint and is in line with the principles of the circular economy and sustainable development goals (SDGs). The synergistic combination of long service life and efficient end-of-life processing makes this technology a cornerstone of sustainability in the photovoltaic industry. It addresses pressing environmental and socioeconomic challenges by promoting resource efficiency, reducing photovoltaic waste by up to 114 times, and enabling policies and practices that support the global energy transition.


  • Open Access

    Photovoltaic Generators Encapsulated in Soft Polysiloxane Gels—Very Low Degradation & New Effective Recycling Method

    by Vladislav Poulek, Martin Kozelka, Václav Beránek

    Photovoltaic (PV) generators/panels are based on photovoltaic sensor (photodiode) technology. In fact, PV panels and PV power plants are often used not only as power generators but also as large-area sensors of the intensity of solar radiation worldwide. Therefore, data concerning photovoltaic panels/generators (i.e., sensors) degradation and encapsulation (reliability) are very important and useful. Concerning PV panel encapsulation technology, both the beginning-of-life (BOL) low degradation and the end-of-life (EOL) recycling parameters are the main challenges. Lamination of PV panels by very soft polydimethylsiloxane (PDMS) gels could result in the right solution. In addition to a longer lifetime, the very low annual degradation rate of laminated PDMS PV panels enables a reduction in the quantity of PV panels recycled in a given year by at least 3 times. Owing to the unique synergistic combination of a low degradation rate (reduced PV waste production) and a new very effective recycling method, PV waste production can be greatly reduced (~20 times) when soft gel PDMS lamination PV technology is used.

  • Open Access

    Reliability characteristics of first-tier photovoltaic panels for agrivoltaic systems – practical consequences

    by Vladislav Poulek, Zdeněk Aleš, Tomáš Finsterle, Martin Libra, Václav Beránek, Lucie Severová, Radek Belza, Jaroslav Mrázek, Martin Kozelka, Roman Svoboda

    A vast majority of PV panel suppliers declare a PV panel lifetime in the range of 20-30 years (typically 25 years). Our data from long-term monitoring of many PV power plants indicate that first-tier PV panels at many PV power plants, in moderate climate, start to fail after about 10-12 years....


  • Open Access

    Agrivoltaics: dual usage of agricultural land for sustainable development

    by Martin Libra, Martin Kozelka, Jana Šafránková, Radek Belza, Vladislav Poulek, Václav Beránek, Jan Sedláček, Maxim Zholobov, Tomáš Šubrt, Lucie Severová

    In connection with renewable energy sources, the courtyards of the buildings provide space for the installation of agrivoltaics for sustainable development. This paper proposes the use of courtyards of low-rise buildings for agrivoltaics. This will increase the area for installing photovoltaic...