Yingnan Guo
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Yingnan Guo has a total of 33 co-authors. Here are the top co-authors by number of shared publications:
- Baolai Liang
Department of Electrical and Computer Engineering, California NanoSystems Institute University of California ‐ Los Angeles Los Angeles California USA
5 shared publications - Morgan E. Ware
University of Arkansas
4 shared publications - Gregory J. Salamo
Institute for Nanoscience and Engineering, University of Arkansas 1 , Fayetteville, Arkansas 72701
3 shared publications - Yuriy I. Mazur
Institute for Nanoscience and Engineering, University of Arkansas 1 , Fayetteville, Arkansas 72701
3 shared publications Guangsheng Fu
Hebei Key Laboratory of Optic-electronic Information and Materials, College of Physics Science & Technology, Hebei University 1 , Baoding 071002, People's Republic of China
2 shared publications- Shufang Wang
Hebei University
2 shared publications
Latest Publications
- 25 August 2025
- Published by The Electrochemical Society in ECS Journal of Solid State Science and Technology
- Vol. 14 (9)
Influence of Finely Tuning Power and Oxygen Flux Ratio on Optoelectronic Properties of Sputtered Amorphous Gallium Oxide Thin Films
Amorphous gallium oxide (a-GaOx) thin films for use as a solar-bind photodetector material have been prepared by radio-frequency magnetron sputtering technique on quartzes. The influence of sputtering power and oxygen flux ratio on optical and electrical properties of a-GaOx thin films and photodetectors were systematically investigated. The optical bandgap, band tail states, and work function are affected by a combination of oxygen vacancies and structure disorder. Decreasing sputtering power and increasing oxygen flux ratio reduce the oxygen deficiencies of these materials. The structure order could monotonically increase with decreasing oxygen flux ratio and first increase and then decrease with increasing sputtering power. The photoelectrical properties are sensitive to the deposition parameters. The photodetectors based on a-GaOx deposited with 210 W and 0.4% O2 flux ratio has the highest photo current and lowest dark current due to the moderate defect density and contact barrier height. Although the photo current is only less than 100 μA, the dark current is as low as a few tenth pA resulting in the largest PDCR of about 106.
- 25 August 2025
- Published by The Electrochemical Society in ECS Journal of Solid State Science and Technology
- Vol. 14 (9)
Influence of Finely Tuning Power and Oxygen Flux Ratio on Optoelectronic Properties of Sputtered Amorphous Gallium Oxide Thin Films
Amorphous gallium oxide (a-GaOx) thin films for use as a solar-bind photodetector material have been prepared by radio-frequency magnetron sputtering technique on quartzes. The influence of sputtering power and oxygen flux ratio on optical and electrical properties of a-GaOx thin films and photodetectors were systematically investigated. The optical bandgap, band tail states, and work function are affected by a combination of oxygen vacancies and structure disorder. Decreasing sputtering power and increasing oxygen flux ratio reduce the oxygen deficiencies of these materials. The structure order could monotonically increase with decreasing oxygen flux ratio and first increase and then decrease with increasing sputtering power. The photoelectrical properties are sensitive to the deposition parameters. The photodetectors based on a-GaOx deposited with 210 W and 0.4% O2 flux ratio has the highest photo current and lowest dark current due to the moderate defect density and contact barrier height. Although the photo current is only less than 100 μA, the dark current is as low as a few tenth pA resulting in the largest PDCR of about 106.
- 28 October 2024
- Published by AIP Publishing in Applied Physics Letters
- Vol. 125 (18)
Manipulating formation of different InGaAs/GaAs nanostructures via tailoring As4 flux
This research provides a flexible approach to manipulate formation of InGaAs nanostructures on the GaAs (100) surface by varying arsenic (As4) beam equivalent pressure (BEP). By selecting the As4/(In+Ga) BEP ratio to be 4, 8, 20, 50 and 100, we were able to obtain different quantum structures from quantum well (QW) to quantum dots (QDs), then to spatially ordered quantum dot chains (QD-chains), and finally to quantum wires (QWRs), respectively. This transformation of nanostructures was explained by anisotropic surface diffusion coupled with the strain relieving Stranski–Krastanov growth mode, while the anisotropy was modulated by increasing As4 flux and subsequently enhanced by multilayer-stacking growth with a suitable spacer thickness. Photoluminescence characteristics show correlation to the nanostructure morphology for each sample. In particular, the formation of QD-chains and QWRs results in anisotropic features that offer potential device applications.
- 28 October 2024
- Published by AIP Publishing in Applied Physics Letters
- Vol. 125 (18)
Manipulating formation of different InGaAs/GaAs nanostructures via tailoring As4 flux
This research provides a flexible approach to manipulate formation of InGaAs nanostructures on the GaAs (100) surface by varying arsenic (As4) beam equivalent pressure (BEP). By selecting the As4/(In+Ga) BEP ratio to be 4, 8, 20, 50 and 100, we were able to obtain different quantum structures from quantum well (QW) to quantum dots (QDs), then to spatially ordered quantum dot chains (QD-chains), and finally to quantum wires (QWRs), respectively. This transformation of nanostructures was explained by anisotropic surface diffusion coupled with the strain relieving Stranski–Krastanov growth mode, while the anisotropy was modulated by increasing As4 flux and subsequently enhanced by multilayer-stacking growth with a suitable spacer thickness. Photoluminescence characteristics show correlation to the nanostructure morphology for each sample. In particular, the formation of QD-chains and QWRs results in anisotropic features that offer potential device applications.
- Open Access
- 24 April 2023
- Published by AIP Publishing in Applied Physics Letters
- Vol. 122 (17)
Complex exciton dynamics with elevated temperature in a GaAsSb/GaAs quantum well heterostructure
Exciton dynamics in a GaAsSb/GaAs quantum well (QW) heterostructure were investigated via both steady state and transient photoluminescence. The measurements at 10 K demonstrated the coexistence of localized excitons (LEs) and free excitons (FEs), while a blue-shift resulting from increased excitation intensity indicated their spatially indirect transition (IT) characteristics due to the type-II band alignment. With increasing temperature from 10 K, the LEs and FEs redistribute, with the LEs becoming less intense at relatively higher temperature. With increasing temperature to above 80 K, electrons in GaAs are able to overcome the small band offset to enter inside GaAsSb and recombine with holes; thus, a spatially direct transition (DT) appeared. Hence, we are able to reveal complex carrier recombination dynamics for the GaAsSb/GaAs QW heterostructure, in which the “S” shape behavior is generated not only by the carrier localization but also by the transformation from IT to DT with elevated temperature.
- 24 April 2023
- Published by AIP Publishing in Applied Physics Letters
- Vol. 122 (17)
Open AccessComplex exciton dynamics with elevated temperature in a GaAsSb/GaAs quantum well heterostructure
Exciton dynamics in a GaAsSb/GaAs quantum well (QW) heterostructure were investigated via both steady state and transient photoluminescence. The measurements at 10 K demonstrated the coexistence of localized excitons (LEs) and free excitons (FEs), while a blue-shift resulting from increased excitation intensity indicated their spatially indirect transition (IT) characteristics due to the type-II band alignment. With increasing temperature from 10 K, the LEs and FEs redistribute, with the LEs becoming less intense at relatively higher temperature. With increasing temperature to above 80 K, electrons in GaAs are able to overcome the small band offset to enter inside GaAsSb and recombine with holes; thus, a spatially direct transition (DT) appeared. Hence, we are able to reveal complex carrier recombination dynamics for the GaAsSb/GaAs QW heterostructure, in which the “S” shape behavior is generated not only by the carrier localization but also by the transformation from IT to DT with elevated temperature.
- Open Access
Trapped Carrier Recombination in Sb2Se3 Polycrystalline Film
Sb2Se3 has recently emerged as a promising material for optic-electronic applications. In this work, trapped carrier recombination in Sb2Se3 was investigated by joint use of time-resolved microwave conductivity (TRMC) and photoluminescence (PL) spectroscopy. trapped carrier thermal excitation into the continuous band was observed in TRMC kinetics. Based on the exponential band tail model, the depth of the trap state, where trapped carriers are released into a continuous band, was estimated to range from 33.0 meV to 110.0 meV at room temperature. Temperature-varying TRMC and PL were further employed to study the influence of temperature on the trapped carrier recombination. Negative thermal quenchings of PL intensity and quantity of thermal emission carriers were observed and can be well explained by the thermal excitation of deep trapped carriers into shallow trap states and the continuous band. Two thermal activation energies of 12.5 meV and 304.0 meV were also revealed. This work is helpful for understanding the trapped carrier recombination process in polycrystalline Sb2Se3 film.
Open AccessTrapped Carrier Recombination in Sb2Se3 Polycrystalline Film
Sb2Se3 has recently emerged as a promising material for optic-electronic applications. In this work, trapped carrier recombination in Sb2Se3 was investigated by joint use of time-resolved microwave conductivity (TRMC) and photoluminescence (PL) spectroscopy. trapped carrier thermal excitation into the continuous band was observed in TRMC kinetics. Based on the exponential band tail model, the depth of the trap state, where trapped carriers are released into a continuous band, was estimated to range from 33.0 meV to 110.0 meV at room temperature. Temperature-varying TRMC and PL were further employed to study the influence of temperature on the trapped carrier recombination. Negative thermal quenchings of PL intensity and quantity of thermal emission carriers were observed and can be well explained by the thermal excitation of deep trapped carriers into shallow trap states and the continuous band. Two thermal activation energies of 12.5 meV and 304.0 meV were also revealed. This work is helpful for understanding the trapped carrier recombination process in polycrystalline Sb2Se3 film.
- 23 August 2018
- Published by Optica Publishing Group in Optics Express
- Vol. 26 (18) , 23107-23118
Correlation between photoluminescence and morphology for single layer self-assembled InGaAs/GaAs quantum dots
Single layer self-assembled InGaAs quantum dots (QDs) are manipulated by using different arsenic species on GaAs (100) surface. The As4 molecules are experimentally observed to be more promising than As2 to promote the formation of one-dimensionally-aligned QD-chain arrays. The lateral alignment of QDs and the corresponding formation of dot chains are explained by the anisotropic surface kinetics in combination with the different reactivities of the two molecules with bonding sites on the GaAs (100) surface. Photoluminescence (PL) measurements demonstrate that the spectra of the QD-chains broaden to higher energy and increases in intensity with increasing excitation laser power. The PL band of the QD-chains also exhibits a 9 meV reduction in linewidth as temperature increases starting from 8 K. These observations confirm an efficient lateral coupling between neighboring QDs and thereafter polarized QD emission, whereas the randomly distributed QDs grown with As2 show no preferential polarization. Such QD-chains exhibiting anisotropic properties have the potential for nanophotonics applications like electro-optic modulators with very low drive voltage and ultra-wide bandwidth operation.
- 23 August 2018
- Published by Optica Publishing Group in Optics Express
- Vol. 26 (18) , 23107-23118
Correlation between photoluminescence and morphology for single layer self-assembled InGaAs/GaAs quantum dots
Single layer self-assembled InGaAs quantum dots (QDs) are manipulated by using different arsenic species on GaAs (100) surface. The As4 molecules are experimentally observed to be more promising than As2 to promote the formation of one-dimensionally-aligned QD-chain arrays. The lateral alignment of QDs and the corresponding formation of dot chains are explained by the anisotropic surface kinetics in combination with the different reactivities of the two molecules with bonding sites on the GaAs (100) surface. Photoluminescence (PL) measurements demonstrate that the spectra of the QD-chains broaden to higher energy and increases in intensity with increasing excitation laser power. The PL band of the QD-chains also exhibits a 9 meV reduction in linewidth as temperature increases starting from 8 K. These observations confirm an efficient lateral coupling between neighboring QDs and thereafter polarized QD emission, whereas the randomly distributed QDs grown with As2 show no preferential polarization. Such QD-chains exhibiting anisotropic properties have the potential for nanophotonics applications like electro-optic modulators with very low drive voltage and ultra-wide bandwidth operation.
- 6 November 2017
- Published by AIP Publishing in Applied Physics Letters
- Vol. 111 (19)
Carrier dynamics of InAs quantum dots with GaAs1−xSbx barrier layers
Photoluminescence properties of InAs/GaAs1−xSbx quantum dots (QDs) are investigated with respect to the Sb-composition of x = 0, 0.15, and 0.25. The QDs demonstrate a type-II band alignment for x = 0.15 and 0.25. In contrast, with well-defined InAs/GaAs QDs, the InAs/GaAs1−xSbx QDs exhibit overlapping spectral features with increasing laser excitation intensity, which are determined to be the result of different carrier recombination routes, including both type-I and type-II pathways. Our investigation indicates that the optical behavior and the carrier dynamics in these InAs/GaAs1−xSbx QDs are much more complicated than in the InAs/GaAs QD counterparts. It provides very useful information for understanding the band structure and carrier dynamics of type-II InAs/GaAs1−xSbx QDs.
- 6 November 2017
- Published by AIP Publishing in Applied Physics Letters
- Vol. 111 (19)
Carrier dynamics of InAs quantum dots with GaAs1−xSbx barrier layers
Photoluminescence properties of InAs/GaAs1−xSbx quantum dots (QDs) are investigated with respect to the Sb-composition of x = 0, 0.15, and 0.25. The QDs demonstrate a type-II band alignment for x = 0.15 and 0.25. In contrast, with well-defined InAs/GaAs QDs, the InAs/GaAs1−xSbx QDs exhibit overlapping spectral features with increasing laser excitation intensity, which are determined to be the result of different carrier recombination routes, including both type-I and type-II pathways. Our investigation indicates that the optical behavior and the carrier dynamics in these InAs/GaAs1−xSbx QDs are much more complicated than in the InAs/GaAs QD counterparts. It provides very useful information for understanding the band structure and carrier dynamics of type-II InAs/GaAs1−xSbx QDs.