Weiming Wang
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Weiming Wang has a total of 38 co-authors. Here are the top co-authors by number of shared publications:
Shuai Peng
3 shared publicationsBo Li
2 shared publicationsHao Liu
2 shared publicationsJun Xiong
2 shared publications- Jun Xiong
College of Chemistry and Chemical Engineering Wuhan Textile University Wuhan China
2 shared publications Ming Li
2 shared publications
Latest Publications
- 15 September 2023
- Published by Elsevier in Ceramics International
- Vol. 49 (23) , 38226-38236
Hierarchical porous AlOOH hollow microspheres for efficient CO2 capture
- 15 September 2023
- Published by Elsevier in Ceramics International
- Vol. 49 (23) , 38226-38236
Hierarchical porous AlOOH hollow microspheres for efficient CO2 capture
- Open Access
- 16 March 2022
- Published by MDPI AG in Preprints.org
Polymer-Coated Daikon-Based Sunlight Absorbers for Highly Efficient Interface Solar Steam Generation
Interface solar steam generation (ISSG) are charming for its applications in desalination and wastewater treatment. Biomass is an attractive substrate for utilizing solar vapor evaporators because of its natural pore structure and water transportability. Polymers like polydopamine (PDA) and polypyrrole (PPy) with broadband spectrum absorption are fascinating in photothermal materials (PTMs). Herein, PDA coated daikon-based (PDA-DK) and PPy coated daikon-based (PPy-DK) PTMs have been exploited for solar steam generation. When polyethylene foam (PEF) was used as an insulating layer to limit heat loss from the PTMs to bulk water, the evaporation rate of PDA-DK and PPy-DK was raised from 0.82 kg m–2 h–1 and 0.96 kg m–2 h–1 to 1.50 kg m–2 h–1 and 1.60 kg m–2 h–1, respectively. Meanwhile, the corresponding photothermal conversion efficiency was increased to 89.01% and 98.97%, which was increased by nearly 40% under 1-sun irradiation. In addition, PDA-DK and PPy-DK exhibited remarkable stability for the solar steam generation without significant change through 15 cycles. Furthermore, PDA-DK and PPy-DK could effectively desalt seawater and purify dyeing wastewater. All the results indicate that PDA-DK and PPy-DK have great potential in real-world applications for solar steam generation.
- 16 March 2022
- Published by MDPI AG in Preprints.org
Open AccessPolymer-Coated Daikon-Based Sunlight Absorbers for Highly Efficient Interface Solar Steam Generation
Interface solar steam generation (ISSG) are charming for its applications in desalination and wastewater treatment. Biomass is an attractive substrate for utilizing solar vapor evaporators because of its natural pore structure and water transportability. Polymers like polydopamine (PDA) and polypyrrole (PPy) with broadband spectrum absorption are fascinating in photothermal materials (PTMs). Herein, PDA coated daikon-based (PDA-DK) and PPy coated daikon-based (PPy-DK) PTMs have been exploited for solar steam generation. When polyethylene foam (PEF) was used as an insulating layer to limit heat loss from the PTMs to bulk water, the evaporation rate of PDA-DK and PPy-DK was raised from 0.82 kg m–2 h–1 and 0.96 kg m–2 h–1 to 1.50 kg m–2 h–1 and 1.60 kg m–2 h–1, respectively. Meanwhile, the corresponding photothermal conversion efficiency was increased to 89.01% and 98.97%, which was increased by nearly 40% under 1-sun irradiation. In addition, PDA-DK and PPy-DK exhibited remarkable stability for the solar steam generation without significant change through 15 cycles. Furthermore, PDA-DK and PPy-DK could effectively desalt seawater and purify dyeing wastewater. All the results indicate that PDA-DK and PPy-DK have great potential in real-world applications for solar steam generation.
- Open Access
Synthesis of Methyl Mercaptan on Mesoporous Alumina Prepared with Hydroxysafflor Yellow A as Template: The Synergistic Effect of Potassium and Molybdenum
K-promoted Mo-based catalysts showed great promise for the hydrogenation of CS2 to methyl mercaptan (CH3SH). However, the research on the synergistic effect of K and Mo, and the active site of CS2 hydrogenation to CH3SH were unexplored widely. To solve this problem, the synergistic effect of K and Mo in the K-promoted Mo-based catalysts for CS2 hydrogenation to prepare CH3SH was investigated. The mesoporous alumina was the support and loaded the active components potassium and molybdenum to prepare the catalyst. The results suggested that the active components K and Mo can not only cooperatively regulate the acid-base sites on the catalyst surface, but also stabilize the molybdate species at +5 valence during the reduction process and increase the Mo unsaturated coordination sites. Combined with the results of the catalytic activity evaluation, indicating that the main active site of the catalysts is the weak Lewis acid-base site, and the strong acidic site and strong alkaline site are not conducive to the formation of CH3SH. Moreover, the possible catalytic mechanism of CS2 hydrogenation to CH3SH on the weak Lewis acid-base sites of the catalysts was proposed. The research results of this paper can provide an experimental basis and theoretical guidance for the design of high-performance CH3SH synthesis catalyst and further mechanism research.
Open AccessSynthesis of Methyl Mercaptan on Mesoporous Alumina Prepared with Hydroxysafflor Yellow A as Template: The Synergistic Effect of Potassium and Molybdenum
K-promoted Mo-based catalysts showed great promise for the hydrogenation of CS2 to methyl mercaptan (CH3SH). However, the research on the synergistic effect of K and Mo, and the active site of CS2 hydrogenation to CH3SH were unexplored widely. To solve this problem, the synergistic effect of K and Mo in the K-promoted Mo-based catalysts for CS2 hydrogenation to prepare CH3SH was investigated. The mesoporous alumina was the support and loaded the active components potassium and molybdenum to prepare the catalyst. The results suggested that the active components K and Mo can not only cooperatively regulate the acid-base sites on the catalyst surface, but also stabilize the molybdate species at +5 valence during the reduction process and increase the Mo unsaturated coordination sites. Combined with the results of the catalytic activity evaluation, indicating that the main active site of the catalysts is the weak Lewis acid-base site, and the strong acidic site and strong alkaline site are not conducive to the formation of CH3SH. Moreover, the possible catalytic mechanism of CS2 hydrogenation to CH3SH on the weak Lewis acid-base sites of the catalysts was proposed. The research results of this paper can provide an experimental basis and theoretical guidance for the design of high-performance CH3SH synthesis catalyst and further mechanism research.
- 6 September 2018
- Published by Wiley in ChemistrySelect
- Vol. 3 (33) , 9663-9671
Synthesis of Methanethiol from Methanol and Carbon Disulfide over CoKW/Al 2 O 3 Catalysts: The Possible Reaction Network and Reaction Mechanism
Synthesis of methanethiol from methanol and carbon disulfide was catalyzed by KW/γ‐Al 2 O 3 catalysts under different reaction conditions. A possible reaction network was put forward by investigating the effects of the molar ratio of reactants, the reaction pressure, the reaction temperature, the residence time, and in the presence of water and hydrogen sulfide on the catalytic performance. Furthermore, the relationship between the conversion of CH 3 OH, the yield of CH 3 SH and the surface acid‐base properties was discussed in detail. The catalytic results measured in the laboratory scale (2 ml catalysts) and those obtained in the scaling‐up tests (50 ml original grain catalysts) are well matched. Combined with pyridine adsorption Fourier Transform Infrared (FT‐IR), CO 2 /NH 3 ‐Temperature Programmed Desorption (CO 2 /NH 3 ‐TPD), and the catalytic results, it was found that the conversion of CH 3 OH can be chiefly correlated with weak and moderate acid sites, while the selectivity toward CH 3 SH is mainly related to the weak basic sites, and the possible reaction mechanism was put forward.
- 6 September 2018
- Published by Wiley in ChemistrySelect
- Vol. 3 (33) , 9663-9671
Synthesis of Methanethiol from Methanol and Carbon Disulfide over CoKW/Al 2 O 3 Catalysts: The Possible Reaction Network and Reaction Mechanism
Synthesis of methanethiol from methanol and carbon disulfide was catalyzed by KW/γ‐Al 2 O 3 catalysts under different reaction conditions. A possible reaction network was put forward by investigating the effects of the molar ratio of reactants, the reaction pressure, the reaction temperature, the residence time, and in the presence of water and hydrogen sulfide on the catalytic performance. Furthermore, the relationship between the conversion of CH 3 OH, the yield of CH 3 SH and the surface acid‐base properties was discussed in detail. The catalytic results measured in the laboratory scale (2 ml catalysts) and those obtained in the scaling‐up tests (50 ml original grain catalysts) are well matched. Combined with pyridine adsorption Fourier Transform Infrared (FT‐IR), CO 2 /NH 3 ‐Temperature Programmed Desorption (CO 2 /NH 3 ‐TPD), and the catalytic results, it was found that the conversion of CH 3 OH can be chiefly correlated with weak and moderate acid sites, while the selectivity toward CH 3 SH is mainly related to the weak basic sites, and the possible reaction mechanism was put forward.
- 1 January 2016
- Published by OAIMDD - EcoZone Publishing House in Environmental Engineering and Management Journal
- Vol. 15 (9) , 2119-2126
HETEROGENEOUS PHOTO-FENTON DEGRADATION OF QUINOLINE WITH A NOVEL INTERNAL CIRCULATING FLUIDIZED-BED REACTOR
- 1 January 2016
- Published by OAIMDD - EcoZone Publishing House in Environmental Engineering and Management Journal
- Vol. 15 (9) , 2119-2126
HETEROGENEOUS PHOTO-FENTON DEGRADATION OF QUINOLINE WITH A NOVEL INTERNAL CIRCULATING FLUIDIZED-BED REACTOR
- 1 September 2015
- Published by Elsevier in Catalysis Communications
- Vol. 69, 104-108
Catalytic synthesis of methanethiol from methanol and carbon disulfide over KW/Al2O3 catalysts
- 1 September 2015
- Published by Elsevier in Catalysis Communications
- Vol. 69, 104-108
Catalytic synthesis of methanethiol from methanol and carbon disulfide over KW/Al2O3 catalysts