Valentin Churkin
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Valentin Churkin has a total of 19 co-authors. Here are the top co-authors by number of shared publications:
- Mikhail Yu. Popov
Prokhorov General Physics Institute of the Russian Academy of Sciences Moscow Russia
6 shared publications - Boris A. Kulnitskiy
National Research Centre «Kurchatov Institute», Centralnaya Str. 7a, Troitsk 108840, Russia
5 shared publications - Igor A. Perezhogin
Technological Institute for Superhard and Novel Carbon Materials
3 shared publications - Vladimir D. Blank
Технологический институт сверхтвердых и новых углеродных материалов
3 shared publications - Alexey N. Kirichenko
Institution “Project Center ITER”, 123182 Moscow, Russia
2 shared publications - Danila A. Ovsyannikov
Технологический институт сверхтвердых и новых углеродных материалов
2 shared publications
Latest Publications
- Open Access
- 10 February 2023
- Published by MDPI AG in Nanomaterials
- Vol. 13 (4) , 696
Surface Tamm States of 2–5 nm Nanodiamond via Raman Spectroscopy
We observed resonance effects in the Raman scattering of nanodiamonds with an average size of 2–5 nm excited at a wavelength of 1064 nm (1.16 eV). The resonant Raman spectrum of the 2–5 nm nanodiamonds consists of bands at wavelengths of 1325 and 1600 cm−1, a band at 1100–1250 cm−1, and a plateau in the range from 1420 to 1630 cm−1. When excited away from the resonance (at a wavelength of 405 nm, 3.1 eV), the Raman spectrum consists of only three bands at 1325, 1500, and 1600 cm−1. It is important to note that the additional lines (1500 and 1600 cm−1) belong to the sp3-hybridized carbon bonds. The phonon density of states for the nanodiamonds (~1 nm) was calculated using moment tensor potentials (MTP), a class of machine-learning interatomic potentials. The presence of these modes in agreement with the lattice dynamics indicates the existence of bonds with force constants higher than in single-crystal diamonds. The observed resonant phenomena of the Raman scattering and the increase in the bulk modulus are explained by the presence of Tamm states with an energy of electronic transitions of approximately 1 eV, previously observed on the surface of single-crystal diamonds.
- 10 February 2023
- Published by MDPI AG in Nanomaterials
- Vol. 13 (4) , 696
Open AccessSurface Tamm States of 2–5 nm Nanodiamond via Raman Spectroscopy
We observed resonance effects in the Raman scattering of nanodiamonds with an average size of 2–5 nm excited at a wavelength of 1064 nm (1.16 eV). The resonant Raman spectrum of the 2–5 nm nanodiamonds consists of bands at wavelengths of 1325 and 1600 cm−1, a band at 1100–1250 cm−1, and a plateau in the range from 1420 to 1630 cm−1. When excited away from the resonance (at a wavelength of 405 nm, 3.1 eV), the Raman spectrum consists of only three bands at 1325, 1500, and 1600 cm−1. It is important to note that the additional lines (1500 and 1600 cm−1) belong to the sp3-hybridized carbon bonds. The phonon density of states for the nanodiamonds (~1 nm) was calculated using moment tensor potentials (MTP), a class of machine-learning interatomic potentials. The presence of these modes in agreement with the lattice dynamics indicates the existence of bonds with force constants higher than in single-crystal diamonds. The observed resonant phenomena of the Raman scattering and the increase in the bulk modulus are explained by the presence of Tamm states with an energy of electronic transitions of approximately 1 eV, previously observed on the surface of single-crystal diamonds.
- Open Access
- 24 March 2021
- Published by MDPI AG in Nanomaterials
- Vol. 11 (4) , 828
The Effect of Shear Deformation on C-N Structure under Pressure up to 80 GPa
We studythe effect of shear deformation on graphitic g-C3N4 under pressures of up to 80 GPa at room temperature. g-C3N4 samples are transformed from initial amorphous flakes into onion-like structures, in which the nitrogen content in the quenched samples decreases with increasing pressure (from 42% in the initial conditions to 1% at 80 GPa). The concentration of the sp2 bonds also decreases from 1 (the initial sample) to 0.62 with increasing pressure to 80 GPa. This transformation of the sample is due to the fact that in the pressure range of 55–115 GPa, the equilibrium phase is not a diamond, but instead, carbon onions cross-linked by sp3 bonds, which are denser than diamonds. The results of our study show that the presence of nitrogen in sp3-bonded structures at pressures of higher than 55 GPa reduces the density and, accordingly, carbon structures without nitrogen become thermodynamically favorable.
- 24 March 2021
- Published by MDPI AG in Nanomaterials
- Vol. 11 (4) , 828
Open AccessThe Effect of Shear Deformation on C-N Structure under Pressure up to 80 GPa
We studythe effect of shear deformation on graphitic g-C3N4 under pressures of up to 80 GPa at room temperature. g-C3N4 samples are transformed from initial amorphous flakes into onion-like structures, in which the nitrogen content in the quenched samples decreases with increasing pressure (from 42% in the initial conditions to 1% at 80 GPa). The concentration of the sp2 bonds also decreases from 1 (the initial sample) to 0.62 with increasing pressure to 80 GPa. This transformation of the sample is due to the fact that in the pressure range of 55–115 GPa, the equilibrium phase is not a diamond, but instead, carbon onions cross-linked by sp3 bonds, which are denser than diamonds. The results of our study show that the presence of nitrogen in sp3-bonded structures at pressures of higher than 55 GPa reduces the density and, accordingly, carbon structures without nitrogen become thermodynamically favorable.
- 1 January 2021
- Published by Ivanovo State University of Chemistry and Technology in ChemChemTech
- Vol. 64 (12) , 71-75
EFFECT OF THE LASER RADIATION EXPOSURE ON MECHANICAL PROPERTIES OF 3D C60
The effect of hydrostatic pressure up to 80 GPa and laser radiation exposure on the bulk modulus of 3D C-60 three-dimensional polymerized states is investigated. The sample C-60 was loaded in a chamber with diamond anvils surrounded by NaCl, which was used as a pressure transmitting medium. In the process of loading under pressure, Raman spectra were recorded. The 3D polymerization process was observed using Raman spectra, it is characterized by broadening and merging of high-frequency C-60 modes. The 3D C-60 spectrum consists of two wide bands of about 1560 cm(-1) and 600 cm(-1). In our work, the process of 3D C-60 formation was recorded at a pressure of 28 GPa. To study the effect of laser radiation exposure on the structure of 3D C-60 obtained under pressure, two series of experiments were conducted in which C-60 samples were undergone to exposures varying by 15 times at a laser radiation wavelength of 532 nm in the pressure range from 20 to 80 GPa. The effect of exposure on the pressure at which 3D C-60 formation was observed was not detected. It has been experimentally established that the bulk modulus of 3D C-60 decreases from 571 GPa to 454 GPa with an increase in radiation exposure by 15 times. The module was calculated from the dependence of the Raman frequency 1560-1580 cm(-1) 3D C-60 on pressure. Study of the obtained 3D C-60 samples using transmission electron microscopy showed that there is no long-range order in the samples. At the same time, no significant structural features were revealed, which may be associated with the observed difference in the bulk modulus of samples obtained at different exposures at high pressure.
- 1 January 2021
- Published by Ivanovo State University of Chemistry and Technology in ChemChemTech
- Vol. 64 (12) , 71-75
EFFECT OF THE LASER RADIATION EXPOSURE ON MECHANICAL PROPERTIES OF 3D C60
The effect of hydrostatic pressure up to 80 GPa and laser radiation exposure on the bulk modulus of 3D C-60 three-dimensional polymerized states is investigated. The sample C-60 was loaded in a chamber with diamond anvils surrounded by NaCl, which was used as a pressure transmitting medium. In the process of loading under pressure, Raman spectra were recorded. The 3D polymerization process was observed using Raman spectra, it is characterized by broadening and merging of high-frequency C-60 modes. The 3D C-60 spectrum consists of two wide bands of about 1560 cm(-1) and 600 cm(-1). In our work, the process of 3D C-60 formation was recorded at a pressure of 28 GPa. To study the effect of laser radiation exposure on the structure of 3D C-60 obtained under pressure, two series of experiments were conducted in which C-60 samples were undergone to exposures varying by 15 times at a laser radiation wavelength of 532 nm in the pressure range from 20 to 80 GPa. The effect of exposure on the pressure at which 3D C-60 formation was observed was not detected. It has been experimentally established that the bulk modulus of 3D C-60 decreases from 571 GPa to 454 GPa with an increase in radiation exposure by 15 times. The module was calculated from the dependence of the Raman frequency 1560-1580 cm(-1) 3D C-60 on pressure. Study of the obtained 3D C-60 samples using transmission electron microscopy showed that there is no long-range order in the samples. At the same time, no significant structural features were revealed, which may be associated with the observed difference in the bulk modulus of samples obtained at different exposures at high pressure.
- 1 August 2018
- Published by Siberian Federal University in Journal of Siberian Federal University. Mathematics & Physics
- Vol. 11 (4) , 513-518
Formation of Onion-like Structures from Pitch Coke under Pressure
Сибирский федеральный университет (СФУ) входит в топ-15 вузов России. Ведущие научные школы Красноярска. Лучший в России кампус. Мировые индустриальные партнёры
- 1 August 2018
- Published by Siberian Federal University in Journal of Siberian Federal University. Mathematics & Physics
- Vol. 11 (4) , 513-518
Formation of Onion-like Structures from Pitch Coke under Pressure
Сибирский федеральный университет (СФУ) входит в топ-15 вузов России. Ведущие научные школы Красноярска. Лучший в России кампус. Мировые индустриальные партнёры
- Open Access
Pressure-Induced Transformation of Graphite and Diamond to Onions
In this study, we present a number of experiments on the transformation of graphite, diamond, and multiwalled carbon nanotubes under high pressure conditions. The analysis of our results testifies to the instability of diamond in the 55–115 GPa pressure range, at which onion-like structures are formed. The formation of interlayer sp3-bonds in carbon nanostructures with a decrease in their volume has been studied theoretically. It has been found that depending on the structure, the bonds between the layers can be preserved or broken during unloading.
Open AccessPressure-Induced Transformation of Graphite and Diamond to Onions
In this study, we present a number of experiments on the transformation of graphite, diamond, and multiwalled carbon nanotubes under high pressure conditions. The analysis of our results testifies to the instability of diamond in the 55–115 GPa pressure range, at which onion-like structures are formed. The formation of interlayer sp3-bonds in carbon nanostructures with a decrease in their volume has been studied theoretically. It has been found that depending on the structure, the bonds between the layers can be preserved or broken during unloading.
- Open Access
- 10 October 2017
- Published by Springer Nature in Discover Nano
- Vol. 12 (1) , 561
Raman Spectra and Bulk Modulus of Nanodiamond in a Size Interval of 2–5 nm
Nanodiamond in a 2–5-nm size interval (which is typical for an appearance of quantum confinement effect) show Raman spectra composed of 3 bands at 1325, 1600, and 1500 cm−1 (at the 458-nm laser excitation) which shifts to 1630 cm−1 at the 257-nm laser excitation. Contrary to sp2-bonded carbon, relative intensities of the bands do not depend on the 458- and 257-nm excitation wavelengths, and a halfwidth and the intensity of the 1600 cm−1 band does not change visibly under pressure at least up to 50 GPa. Bulk modulus of the 2–5-nm nanodiamond determined from the high-pressure study is around 560 GPa. Studied 2–5-nm nanodiamond was purified from contamination layers and dispersed in Si or NaCl.
- 10 October 2017
- Published by Springer Nature in Discover Nano
- Vol. 12 (1) , 561
Open AccessRaman Spectra and Bulk Modulus of Nanodiamond in a Size Interval of 2–5 nm
Nanodiamond in a 2–5-nm size interval (which is typical for an appearance of quantum confinement effect) show Raman spectra composed of 3 bands at 1325, 1600, and 1500 cm−1 (at the 458-nm laser excitation) which shifts to 1630 cm−1 at the 257-nm laser excitation. Contrary to sp2-bonded carbon, relative intensities of the bands do not depend on the 458- and 257-nm excitation wavelengths, and a halfwidth and the intensity of the 1600 cm−1 band does not change visibly under pressure at least up to 50 GPa. Bulk modulus of the 2–5-nm nanodiamond determined from the high-pressure study is around 560 GPa. Studied 2–5-nm nanodiamond was purified from contamination layers and dispersed in Si or NaCl.