MIMichael Ioelovich

Michael Ioelovich

*This is an algorithmically generated author record based on publicly available information.

Michael Ioelovich has a total of 11 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Effects of cre1 modification in the white-rot fungus Pleurotus ostreatus PC9: altering substrate preference during biological pretreatment

    by Shahar Yoav, Tomer M. Salame, Daria Feldman, Dana Levinson, Michael Ioelovich, Ely Morag, Oded Yarden, Edward A. Bayer, Yitzhak Hadar

    During the process of bioethanol production, cellulose is hydrolyzed into its monomeric soluble units. For efficient hydrolysis, a chemical and/or mechanical pretreatment step is required. Such pretreatment is designed to increase enzymatic digestibility of the cellulose chains inter alia by de-crystallization of the cellulose chains and by removing barriers, such as lignin from the plant cell wall. Biological pretreatment, in which lignin is decomposed or modified by white-rot fungi, has also been considered. One disadvantage in biological pretreatment, however, is the consumption of the cellulose by the fungus. Thus, fungal species that attack lignin with only minimal cellulose loss are advantageous. The secretomes of white-rot fungi contain carbohydrate-active enzymes (CAZymes) including lignin-modifying enzymes. Thus, modification of secretome composition can alter the ratio of lignin/cellulose degradation. Pleurotus ostreatus PC9 was genetically modified to either overexpress or eliminate (by gene replacement) the transcriptional regulator CRE1, known to act as a repressor in the process of carbon catabolite repression. The cre1-overexpressing transformant demonstrated lower secreted cellulolytic activity and slightly increased selectivity (based on the chemical composition of pretreated wheat straw), whereas the knockout transformant demonstrated increased cellulolytic activity and significantly reduced residual cellulose, thereby displaying lower selectivity. Pretreatment of wheat straw using the wild-type PC9 resulted in 2.8-fold higher yields of soluble sugar compared to untreated wheat straw. The overexpression transformant showed similar yields (2.6-fold), but the knockout transformant exhibited lower yields (1.2-fold) of soluble sugar. Based on proteomic secretome analysis, production of numerous CAZymes was affected by modification of the expression level of cre1. The gene cre1 functions as a regulator for expression of fungal CAZymes active against plant cell wall lignocelluloses, hence altering the substrate preference of the fungi tested. While the cre1 knockout resulted in a less efficient biological pretreatment, i.e., less saccharification of the treated biomass, the converse manipulation of cre1 (overexpression) failed to improve efficiency. Despite the inverse nature of the two genetic alterations, the expected "mirror image" (i.e., opposite regulatory response) was not observed, indicating that the secretion level of CAZymes, was not exclusively dependent on CRE1 activity.


  • Peculiarity of Phase Transition CI into CII for Nanocrystallites of Cellulose

    by M. Ioelovich

    In this paper, using a method of wide-angle X-ray diffraction, sizes of cellulose nanoscale crystallites were determined and phase transition of nanosized crystallites CI into CII was studied after...


  • Open Access

    СРАВНЕНИЕ МЕТОДОВ РАСЧЕТА ТЕПЛОТЫ СГОРАНИЯ БИОПОЛИМЕРОВ

    by Michael (Михаил) Yacob (Яковлевич) Ioelovich (Иоелович)

    В данной работе были проанализированы различные методы расчета высшей (Q) и низшей (q) теплоты сгорания для биополимеров растений (лигнин, целлюлоза, гемицеллюлозы, крахмал, пектин, белки) и некоторых других компонентов биомассы (смоляные кислоты, липиды и др.). Результаты исследований показали, что расчеты с использованием Еq-параметра (т.е. энергии сгорания, приходящейся на 1 г О2) дают отклонение от экспериментальных значений около 4% для Q и более чем 7% для q. В случае расчетов, основанных на вкладе структурных групп полимеров, отклонение составляет в среднем 3%. Самое низкое отклонение от экспериментальных данных, около 0,5% для Q и менее 1% для q, было получено с использованием усовершенствованного способа расчета, который основан на определении элементного состава биополимеров и других компонентов биомассы. Расчеты теплот сгорания для образцов биомассы с помощью предлагаемого усовершенствованного метода были очень близки к экспериментальным значениям теплотворной способности. Было установлено, что наиболее предпочтительным способом утилизации отходов является сжигание гранул, состоящих из отходов растительной биомассы и полиолефинов, поскольку такой способ сжигания обеспечивает более высокую теплотворную способность и повышенную плотность тепловой энергии, чем отдельное сжигание лишь биомассы, и сопровождается меньшим количеством углекислого газа по сравнению с отдельным сжиганием лишь отходов полиолефинов.


  • Open Access

    ОСОБЕННОСТИ ФАЗОВОГО ПЕРЕХОДА НАНОКРИСТАЛЛИТОВ СI В CII

    by Михаил (Michael) Яковлевич (Yacob) Иоелович (Ioelovich)

    В данной работе методом рентгенографии были определены размеры нанокристаллитов целлюлозы и изучен фазовый переход наноразмерных кристаллитов СI в модификацию CII после обработки образцов целлюлозы растворами гидроксида натрия различной концентрации от 5 до 20% (от 1,3 до 6,1 M). Было показано, что этот фазовый переход осуществляется в определенном интервале концентраций гидроксида, причем средняя концентрация этого интервала (С) коррелирует со средними поперечными размерами (D) кристаллитов целлюлозы. Использование методов химической термодинамики нанофаз позволило получить уравнение для зависимости концентрации гидроксида, необходимой для осуществления фазового перехода СI в CII, от поперечных размеров нанокристаллитов СI (D): lnC = lnCo - KD-1, где Co – концентрация гидроксида, необходимая для фазового перехода крупных кристаллитов СI. Таким образом, снижение концентрации гидроксида для осуществления фазового перехода CI в CII объясняется уменьшением поперечных размеров нанокристаллитов CI. На основе полученного уравнения были определены минимальные, средние и максимальные поперечные размеры нанокристаллитов CI и изучена их полидисперсность по поперечным размерам для разных образцов целлюлозы. Показано, что наиболее однородными по размерам являются кристаллиты органосольвентных целлюлоз, а наиболее неоднородными – агрегированные кристаллиты целлюлоз, изолированных методом Крафт делигификации.


  • Recent findings and the energetic potential of plant biomass as a renewable source of biofuels - A review

    by Michael Ioelovich

    Nowadays the main sources of energy are petroleum, coal, and natural gas. However, these fossil sources are not reproduced in nature; on a human timescale their reserves are exhausted permanently and run down. Considerable attention in recent years has been given to plant biomass, which in contrast to the fossil sources is continuously renewed in nature. In this critical review the use of non-edible plant biomass for production of various kinds of biofuels is considered. To generate energy, plant biomass either can be burned directly or it can be used after its conversion into carbonized solid fuel (e.g. biochar), liquid fuels (bioethanol, biodiesel, bio-oil), or gases (biogas). Among various biofuels, production of bioethanol has potential to be the most attractive if recent technological advances become implemented, such that the co-production of ethanol and valuable byproducts can be combined together with recycling of solid and liquid wastes. A comparative analysis of energetic potential of biomass and various kinds of biofuels revealed that the most efficient way to produce energy is by direct burning of the plant biomass in a pelletized form, while the burning of such amount of the solid, liquid, or gaseous biofuel, which can be obtained from the plant material, gives a much smaller energetic effect. Novel types of pellets, as well as solid/liquid biofuels, having improved fuel characteristics are described.


  • Open Access

    Study of Cellulose Interaction with Concentrated Solutions of Sulfuric Acid

    by Michael Ioelovich

    The effect of the concentration of sulfuric acid (SA) and temperature on structure and properties of cellulose (MCC) had been studied. Investigations showed that solubility of the initial sample at the room temperature increased gradually in the range of the acid concentration from 50 to 60 wt.% SA. When SA concentration reached 65 wt.%, then MCC sample dissolved completely. Cellulose regenerated from 65 wt.% SA had an amorphized structure and was characterized by high enzymatic digestibility. At increased temperature, 45°C, solubility of MCC in SA was raised, while yield and DP decreased. After treatment of MCC with hot 50–60 wt.% SA, the crystallinity degree of the obtained cellulose samples changed slightly, and these samples retained mainly the CI crystalline polymorph. However, when SA concentration reached 65 wt.%, then regenerated cellulose had CII crystalline polymorph, reduced crystallinity degree, and low DP. Using optimal conditions of the acidic treatment (57–60 wt.% SA,T= 45°C;t=1 h) in combination with the high-power disintegration permitted obtaining the CI nanocrystalline cellulose particles (NCP) having sizes 150–200 × 10–20 nm with the heightened yield (65–70%). These NCP can be used, for example, as reinforcing nanofillers for various composites.


  • Open Access

    STUDY OF ENZYMATIC HYDROLYSIS OF PRETREATED BIOMASS AT INCREASED SOLIDS LOADING

    by Michael Ioelovich, Ely Morag

    STUDY OF ENZYMATIC HYDROLYSIS OF PRETREATED BIOMASS AT INCREASED SOLIDS LOADING