AJAnjana Jain

Anjana Jain

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Anjana Jain has a total of 13 co-authors. Here are the top co-authors by number of shared publications:

  • Rajendran Saravanakumar

    Department of EEE, Amrita School of Engineering, Amrita Vishwa Vidyapeetham, Bengaluru, India

    2 shared publications
  • S. Shankar

    Intel Technol India Pvt Ltd, Bengaluru, India

    2 shared publications
  • G. Srilekha

    B.Tech, Deptarment of EEE, Amrita School of Engineering, Amrita Vishwa Vidyapeetham, Bengaluru, India

    1 shared publication
  • Laxmi Kumari

    Amrita School of Engineering, Amrita Vishwa Vidyapeetham,Department of Electrical & Electronics Engineering,Bengaluru,India

    1 shared publication
  • Mayank Singh Chandel

    B.Tech, Deptarment of EEE, Amrita School of Engineering, Amrita Vishwa Vidyapeetham, Bengaluru, India

    1 shared publication
  • R. Saravanakumar

    Amrita Vishwa Vidyapeetham, Amrita Sch Engn, Dept Elect & Elect Engn, Bengaluru, India

    1 shared publication

Latest Publications

  • Intelligent Proportional Integral Terminal Sliding Mode Control for variable speed standalone wind energy conversion system

    by Anjana Jain, Rajendran Saravanakumar

    This study investigates the design of robust nonlinear controller for control of voltage and frequency of variable‐speed standalone Wind Energy Conversion System (WECS). The variation in wind‐speed and load raise the oscillation in terminal‐voltage and frequency. These oscillation need to be minimized for enhancing the power management. To overcome this issue, an Intelligent Proportional Integral Terminal Sliding Mode Controller (iPI‐TSMC) is proposed. Proposed iPI‐TSMC establishes a fast‐finite‐time convergence with minimum steady‐state error. Also this controller is robust against the wind velocity perturbation, load variations, and external disturbances. Closed‐loop stability of the proposed controller is validated using Lyapunov‐stability‐theorem. The cogency of the proposed iPI‐TSMC has been validated through MATLAB/simulink environment for different operating conditions. Also performance of iPI‐TSMC is compared with fractional‐order‐proportional‐integral (FOPI) and conventional integer‐order‐proportional‐integral (IOPI) controllers. The simulation results, signifies the efficacy of iPI‐TSMC as compared to other controllers. Feasibility of proposed iPI‐TSMC controller is verified in real‐time HIL simulator using op4510 platform.Statement of Industrial Relevance: Simulation analysis and the comparative study of iPI‐TSMC with FOPI, and IOPI shows better performance to keep constant terminal‐voltage during different wind‐profiles, load variation, and external disturbance. Also, performance assessment of iPI‐TSMC for different matrices during varying wind‐profiles is found superior than FOPI and IOPI controllers. Performance validation of proposed iPI‐TSMC for varying wind‐velocity and load in real‐time HIL simulator op4510 platform shows the feasibility of the proposed controller, which makes it suitable for real‐time application.


  • Moving Average Filter-PLL-Based Voltage and Frequency Control of Standalone WECS

    by Anjana Jain, R. Saravanakumar, S. Shankar

    Precise and fast estimation of system frequency during distorted voltage has become the main challenge for phase locked loop (PLL) for wind energy conversion system (WECS). In this paper, moving average filter (MAF)-based PLL is proposed to solve this issue for permanent magnet synchronous generator (PMSG)-based WECS. MAF allows suitable measurement of frequency and eliminates dc offset, harmonics, and unbalance in voltage. Also scheme is able to perform harmonics reduction. Model of the proposed system for simulation is prepared in MATLAB/Simulink and its performance analysis is carried through a comparative simulation study with conventional synchronous-reference-frame (SRF) PLL, adaptive-frequency-loop PLL, type-1 PLL, and type-3 PLL. Simulation results verify that the proposed controller extracts the maximum-power from wind and stabilizes the system voltage and frequency during any variable/distorted working conditions. System performs considerably excellent during dynamic and steady-state condition.


  • Slip power recovery drive using Z-source inverter

    by Laxmi Kumari, Anjana Jain

    Voltage Source Inverters (VSI) and Current Source Inverters (CSI) are very widely fit for industry. VSI have limited output AC voltage and requirement of a blanking time whereas Current Source Inverters always boost up the voltage and their use are restricted for drive applications. To overcome these limitations Impedance Network or Z-Source Inverters (ZSI) are utilized. Ideally Z-Source Inverters are the ones which have output voltage ranging from zero to infinity. This Buck-Boost capability along with regeneration in single stage configuration makes these inverters ideally suited for hybrid electric vehicles and drive applications. The rotor side power of an induction generator can be utilized by slip power recovery (SPR) controlled technique based on (ZSI). This paper presents the design of ZSI for improving the voltage level of SPR. The system of ZSI is simulated using MATLAB-Simulink platform and the pulse width modulation (PWM) for the inverter is generated using DSPIC microcontroller.

  • Comparative analysis of fractional order PI and integer order PI based controller for hybrid standalone wind energy conversion system

    by Anjana Jain, Rajendran Saravanakumar

    This article presents a comprehensive analysis of fractional order proportional integral (FOPI) and integer order proportional integral (IOPI) controllers for voltage and frequency control of a variable speed hybrid standalone wind energy conversion system. Variations in wind velocity and load introduce the changes in terminal voltage and frequency. This can be controlled by an appropriate controller with satisfactory response. In this work, FOPI controller is proposed for controlling the terminal voltage and frequency. Dual second order generalized integral phase locked loop (DSOGI‐PLL) is utilized to track the system frequency. Fractional‐order controller is implemented for voltage source converter, which makes it robust due to their fractional characteristics. FOPI (PIλ) provides an additional degree of freedom (λ), along with proportional gain (Kp) and integral gain (Ki). The robustness of the controller is validated through simulations in MATLAB/simulink and its performance is compared with IOPI under various operating conditions. The results show that, FOPI based controller is able to maintain the terminal voltage and frequency constant with improved transient response in comparison to IOPI. Finally, performance assessment of the controllers is carried out using performance metrics.


  • Adaptive SRF-PLL Based Voltage and Frequency Control of Hybrid Standalone WECS with PMSG-BESS

    by Anjana Jain, R. Saravanakumar, S. Shankar, V. Vanitha

    The variable-speed Permanent Magnet Synchronous Generator (PMSG) based Wind Energy Conversion System (WECS) attracts the maximum power from wind, but voltage-regulation and frequency-control of the system in standalone operation is a challenging task A modern-control-based-tracking of power from wind for its best utilization is proposed in this paper for standalone PMSG based hybrid-WECS comprising Battery Energy Storage System (BESS). An Adaptive Synchronous Reference Frame Phase-Locked-Loop (SRF-PLL) based control scheme for load side bi-directional voltage source converter (VSC) is presented for the system. MATLAB/Simulink model is developed for simulation study for the proposed system and the effectiveness of the controller for bi-directional-converter is discussed under different operating conditions: like variable wind-velocity, sudden load variation, and load unbalancing. Converter control scheme enhances the power smoothening, supply-load power-matching. Also it is able to regulate the active & reactive power from PMSG-BESS hybrid system with control of fluctuations in voltage & frequency with respect to varying operating conditions. Proposed controller successfully offers reactive-power-compensation, harmonics-reduction, and power-balancing. The proposed scheme is based on proportional & integral (PI) controller. Also system is experimentally validated in the laboratory-environment and results are presented here.


  • Open Access

    Power Generation Using Permanent MagnetSynchronous Generator (PMSG) BasedVariable Speed Wind Energy ConversionSystem (WECS): An Overview

    by Anjana Jain, S. Shankar, V. Vanitha

    Power Generation Using Permanent Magnet Synchronous Generator (PMSG) Based Variable Speed Wind Energy Conversion System (WECS): An Overview


  • Open Access

    Battery Charging Using Doubly Fed Induction Generator Connected to Variable Speed Wind Turbine

    by Anjana Jain, S.N. Balaji, Mayank Singh Chandel, Sreedhar S., G. Srilekha