Jaime Plazas-Tuttle
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Jaime Plazas-Tuttle has a total of 24 co-authors. Here are the top co-authors by number of shared publications:
- Juan Saldarriaga
Universidad de los Andes
2 shared publications - Laura González
Universidad de los Andes
2 shared publications - Lewis Stetson Rowles
Department of Civil Engineering and Construction, Georgia Southern University, Statesboro, USA
2 shared publications Ali Ahmad
Department of Civil and Environmental Engineering, Rutgers, The State University of New Jersey, Piscataway, New Jersey 08854, United States
1 shared publication- Angélica Montaña Contreras
Department of Civil and Environmental Engineering, Universidad de Los Andes, Bogotá, Colombia
1 shared publication - Bright C. Elijah
Department of Civil Engineering and Construction, Georgia Southern University, Statesboro, Georgia 30458, United States
1 shared publication
Latest Publications
- Open Access
- 17 September 2026
- Published by Wiley in Water Environment Research
- Vol. 98 (9) , e70580
Waste‐Derived Fine‐Milled Bone Char for Apparent Cr (VI) Removal From Water and Preliminary Asphalt‐Compatible Processing of the Recovered Residue
Chromium adsorption transfers contamination to a solid residual that still requires management. This proof‐of‐concept study evaluated fine‐milled bone char (BC; D50 = 5.52 μm) for apparent aqueous Cr (VI) removal from acidic synthetic water and examined asphalt‐compatible processing of the recovered residue. Contact‐time screening showed > 97% apparent Cr (VI) removal within 30 min; 120 min was retained only as a standardized operational contact time because later archived residual concentrations were very low, the assay lacked independent replication, and the sample‐equivalent lower calibration bound could not be reconstructed from the available records. Observed apparent aqueous‐depletion‐based uptake reached 4.39 mg g −1 in one screening condition. Nonlinear Langmuir, Freundlich, Sips, and Redlich–Peterson models empirically described the refined 120‐min dose–response dataset, with Freundlich receiving the greatest Akaike information criterion (AICc) support. Drying the acidified BC/Cr system produced 22.65 g of unresolved additional dry material beyond the initial BC and nominal Cr input, most of which was water‐soluble upon rehydration. The resulting process‐derived residue was incorporated into asphalt binder at 3 and 6 wt.% without large descriptive shifts in binder or mortar master curves. An adapted nonstandard mortar‐cylinder cyclic recovery test showed higher mean recovery with increasing residue dosage, but these descriptive values are not directly comparable with standard binder MSCR results. Leaching, chromium speciation, residue characterization, and independent replication are required before reuse or containment claims.
- 17 September 2026
- Published by Wiley in Water Environment Research
- Vol. 98 (9) , e70580
Open AccessWaste‐Derived Fine‐Milled Bone Char for Apparent Cr (VI) Removal From Water and Preliminary Asphalt‐Compatible Processing of the Recovered Residue
Chromium adsorption transfers contamination to a solid residual that still requires management. This proof‐of‐concept study evaluated fine‐milled bone char (BC; D50 = 5.52 μm) for apparent aqueous Cr (VI) removal from acidic synthetic water and examined asphalt‐compatible processing of the recovered residue. Contact‐time screening showed > 97% apparent Cr (VI) removal within 30 min; 120 min was retained only as a standardized operational contact time because later archived residual concentrations were very low, the assay lacked independent replication, and the sample‐equivalent lower calibration bound could not be reconstructed from the available records. Observed apparent aqueous‐depletion‐based uptake reached 4.39 mg g −1 in one screening condition. Nonlinear Langmuir, Freundlich, Sips, and Redlich–Peterson models empirically described the refined 120‐min dose–response dataset, with Freundlich receiving the greatest Akaike information criterion (AICc) support. Drying the acidified BC/Cr system produced 22.65 g of unresolved additional dry material beyond the initial BC and nominal Cr input, most of which was water‐soluble upon rehydration. The resulting process‐derived residue was incorporated into asphalt binder at 3 and 6 wt.% without large descriptive shifts in binder or mortar master curves. An adapted nonstandard mortar‐cylinder cyclic recovery test showed higher mean recovery with increasing residue dosage, but these descriptive values are not directly comparable with standard binder MSCR results. Leaching, chromium speciation, residue characterization, and independent replication are required before reuse or containment claims.
- 14 September 2026
- Published by Springer Nature in Water, Air, & Soil Pollution
- Vol. 237 (22) , 1262
Sugarcane Bagasse-Derived Silica Nanoparticles Functionalized with Cetyltrimethylammonium Bromide: Synthesis, Characterization, and Antibacterial Activity
- 14 September 2026
- Published by Springer Nature in Water, Air, & Soil Pollution
- Vol. 237 (22) , 1262
Sugarcane Bagasse-Derived Silica Nanoparticles Functionalized with Cetyltrimethylammonium Bromide: Synthesis, Characterization, and Antibacterial Activity
- 13 April 2026
- Published by Taylor & Francis in Urban Water Journal
- Vol. 23 (9) , 1444-1473
Water distribution systems: a review of water quality modeling for management and contamination warning systems
- 13 April 2026
- Published by Taylor & Francis in Urban Water Journal
- Vol. 23 (9) , 1444-1473
Water distribution systems: a review of water quality modeling for management and contamination warning systems
- Open Access
- 1 January 2025
- Published by KEAI Publishing in Water Cycle
- Vol. 6, 473-484
Examining green and chemical methods for zero-valent iron nanoparticle synthesis in heavy metal adsorption
- 1 January 2025
- Published by KEAI Publishing in Water Cycle
- Vol. 6, 473-484
Open AccessExamining green and chemical methods for zero-valent iron nanoparticle synthesis in heavy metal adsorption
- Open Access
- 12 March 2024
- Published by American Chemical Society (ACS) in ChemRxiv
Assessing the relative sustainability of point-of-use water disinfection technologies for off-grid communities
Point-of-use (POU) water disinfection technologies can be adopted to provide access to safe drinking water by treating water at the household level; however, navigating various POU disinfection technologies can be difficult. While numerous conventional POU devices exist, emerging technologies using novel materials or advanced processes have been under development and claimed to be of lower cost with higher treatment capacity. However, it is unclear if these claims are substantiated and how novel technologies compare to conventional ones in terms of cost and environmental impacts when providing the same service (i.e., achieving a necessary level of disinfection for safe drinking water). This research assessed the sustainability of four different POU technologies (chlorination using sodium hypochlorite, silver nanoparticle-enabled ceramic water filter, ultraviolet mercury lamps, and ultraviolet light-emitting diodes). Leveraging open-source Python packages (QSDsan and EXPOsan), the cost and environmental impacts of these POU technologies were assessed using techno-economic analysis and life cycle assessment as per capita cost (USD∙cap-1∙yr-1) and global warming potential (kg CO2 eq∙cap-1∙yr-1). Impacts of water quality parameters (e.g., turbidity, hardness) were quantified for both surface and ground water, and uncertainty and sensitivity analyses were used to identify which assumptions influence outcomes. All technologies were further evaluated across ranges of adoption time, and contextual analysis was performed to evaluate the implications of technology deployment across the world. Results of this study can potentially provide valuable insights for decision-makers, non-profit organizations, and future researchers in developing sustainable approaches for ensuring access to safe drinking water through POU technologies.
- 12 March 2024
- Published by American Chemical Society (ACS) in ChemRxiv
Open AccessAssessing the relative sustainability of point-of-use water disinfection technologies for off-grid communities
Point-of-use (POU) water disinfection technologies can be adopted to provide access to safe drinking water by treating water at the household level; however, navigating various POU disinfection technologies can be difficult. While numerous conventional POU devices exist, emerging technologies using novel materials or advanced processes have been under development and claimed to be of lower cost with higher treatment capacity. However, it is unclear if these claims are substantiated and how novel technologies compare to conventional ones in terms of cost and environmental impacts when providing the same service (i.e., achieving a necessary level of disinfection for safe drinking water). This research assessed the sustainability of four different POU technologies (chlorination using sodium hypochlorite, silver nanoparticle-enabled ceramic water filter, ultraviolet mercury lamps, and ultraviolet light-emitting diodes). Leveraging open-source Python packages (QSDsan and EXPOsan), the cost and environmental impacts of these POU technologies were assessed using techno-economic analysis and life cycle assessment as per capita cost (USD∙cap-1∙yr-1) and global warming potential (kg CO2 eq∙cap-1∙yr-1). Impacts of water quality parameters (e.g., turbidity, hardness) were quantified for both surface and ground water, and uncertainty and sensitivity analyses were used to identify which assumptions influence outcomes. All technologies were further evaluated across ranges of adoption time, and contextual analysis was performed to evaluate the implications of technology deployment across the world. Results of this study can potentially provide valuable insights for decision-makers, non-profit organizations, and future researchers in developing sustainable approaches for ensuring access to safe drinking water through POU technologies.
- 9 November 2017
- Published by Royal Society of Chemistry (RSC) in Environmental Science: Nano
- Vol. 5 (1) , 72-82
Harnessing the power of microwaves for inactivatingPseudomonas aeruginosawith nanohybrids
Due to the position of microwave (MW) radiation in the electromagnetic spectrum, it has not yet been successfully utilized to inactivate waterborne microorganisms at a reasonable (energy) cost. Exceptional properties at the nano-scale, namely MW absorption-abilities of carbon nanotubes and excellent spectral conversion-capabilities of lanthanide series metal oxides in concert, hold promise to overcome the energetic barrier of this widely used and affordable technology. This study reports the synthesis of a nano-heterostructure that combines carbon nanotubes' and erbium oxide's properties to generate reactive oxygen species (ROS) and inactivate Pseudomonas aeruginosa. Detailed characterization of the synthesized nanohybrid (NH) material with electron microscopy, X-ray techniques, and thermal gravimetric analysis confirms effective hybridization. At least one log unit of microbial inactivation was achieved via ROS generation with only 20 s of MW irradiation at 110 W (0.0006 kW h energy use), using a conventional MW oven. Inactivation studies with ROS scavenger molecules prove that the generated oxygen species played the dominant role in bacterial inactivation. These breakthrough results hold promise to enable an unintended use (i.e., disinfection) of MW technology, which is diffused deep into the global societal fabric.
- 9 November 2017
- Published by Royal Society of Chemistry (RSC) in Environmental Science: Nano
- Vol. 5 (1) , 72-82
Harnessing the power of microwaves for inactivatingPseudomonas aeruginosawith nanohybrids
Due to the position of microwave (MW) radiation in the electromagnetic spectrum, it has not yet been successfully utilized to inactivate waterborne microorganisms at a reasonable (energy) cost. Exceptional properties at the nano-scale, namely MW absorption-abilities of carbon nanotubes and excellent spectral conversion-capabilities of lanthanide series metal oxides in concert, hold promise to overcome the energetic barrier of this widely used and affordable technology. This study reports the synthesis of a nano-heterostructure that combines carbon nanotubes' and erbium oxide's properties to generate reactive oxygen species (ROS) and inactivate Pseudomonas aeruginosa. Detailed characterization of the synthesized nanohybrid (NH) material with electron microscopy, X-ray techniques, and thermal gravimetric analysis confirms effective hybridization. At least one log unit of microbial inactivation was achieved via ROS generation with only 20 s of MW irradiation at 110 W (0.0006 kW h energy use), using a conventional MW oven. Inactivation studies with ROS scavenger molecules prove that the generated oxygen species played the dominant role in bacterial inactivation. These breakthrough results hold promise to enable an unintended use (i.e., disinfection) of MW technology, which is diffused deep into the global societal fabric.