Thorsten Rissom
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Thorsten Rissom has a total of 137 co-authors. Here are the top co-authors by number of shared publications:
- Christian Alexander Kaufmann
Competence Centre Photovoltaics Berlin (PVcomB) Helmholtz‐Zentrum Berlin für Materialien und Energie GmbH Berlin Germany
17 shared publications - Raquel Caballero
Universidad Autónoma de Madrid, Departamento de Física Aplicada, C/ Francisco Tomás y Valiente 7, 28049 Madrid, Spain
8 shared publications - Thomas Unold
Helmholtz-Zentrum Berlin, Department Structure and Dynamics of Energy Materials, Hahn-Meitner Platz 1, 14109 Berlin, Germany
8 shared publications - Carsten Ronning
Institute of Solid State Physics, Friedrich Schiller University Jena, Max-Wien-Platz 1, 07743 Jena, Germany
6 shared publications Daniel Abou-Ras
4 shared publicationsH. Metzner
4 shared publications
Latest Publications
- 1 October 2016
- Published by Elsevier in Acta Materialia
- Vol. 118, 244-252
Grain-boundary character distribution and correlations with electrical and optoelectronic properties of CuInSe2 thin films
- 1 October 2016
- Published by Elsevier in Acta Materialia
- Vol. 118, 244-252
Grain-boundary character distribution and correlations with electrical and optoelectronic properties of CuInSe2 thin films
- 11 March 2014
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 115 (10) , 103507
Origins of electrostatic potential wells at dislocations in polycrystalline Cu(In,Ga)Se2 thin films
Thin-film solar cells based on Cu(In,Ga)Se2 (CIGSe) reach high power-conversion efficiencies in spite of large dislocation densities of up to 1010–1011 cm−2. The present work gives insight into the structural and compositional properties of dislocations in CIGSe thin films, which are embedded in a complete solar cell stack. These properties are related to the average electrical potential distributions obtained by means of inline electron holography. At a part of the dislocations studied, the average electrostatic potential shows local minima, all with depths of about −1.4 V. The measured average electrostatic potential distributions were modeled in order to reveal possible influences from strain fields, excess charge, and also compositional changes at the dislocation core. Cu depletion around the dislocation core, as evidenced by atom-probe tomography, explains best the measured potential wells. Their influences of the strain field around the dislocation core and of excess charge at the dislocation core are small. A structural model of dislocations in CIGSe thin films is provided which includes a Cu-depleted region around the dislocation core and gives a possible explanation for why decent photovoltaic performances are possible in the presence of rather large dislocation densities.
- 11 March 2014
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 115 (10) , 103507
Origins of electrostatic potential wells at dislocations in polycrystalline Cu(In,Ga)Se2 thin films
Thin-film solar cells based on Cu(In,Ga)Se2 (CIGSe) reach high power-conversion efficiencies in spite of large dislocation densities of up to 1010–1011 cm−2. The present work gives insight into the structural and compositional properties of dislocations in CIGSe thin films, which are embedded in a complete solar cell stack. These properties are related to the average electrical potential distributions obtained by means of inline electron holography. At a part of the dislocations studied, the average electrostatic potential shows local minima, all with depths of about −1.4 V. The measured average electrostatic potential distributions were modeled in order to reveal possible influences from strain fields, excess charge, and also compositional changes at the dislocation core. Cu depletion around the dislocation core, as evidenced by atom-probe tomography, explains best the measured potential wells. Their influences of the strain field around the dislocation core and of excess charge at the dislocation core are small. A structural model of dislocations in CIGSe thin films is provided which includes a Cu-depleted region around the dislocation core and gives a possible explanation for why decent photovoltaic performances are possible in the presence of rather large dislocation densities.
- 1 March 2014
- Published by Elsevier in Journal of Alloys and Compounds
- Vol. 588, 644-647
Real-time observation of the phase transformations and microstructural changes during the incorporation of In into a thin Cu film at 770 K
- 1 March 2014
- Published by Elsevier in Journal of Alloys and Compounds
- Vol. 588, 644-647
Real-time observation of the phase transformations and microstructural changes during the incorporation of In into a thin Cu film at 770 K
- 13 January 2014
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 115 (2) , 023514
Symmetry dependent optoelectronic properties of grain boundaries in polycrystalline Cu(In,Ga)Se2 thin films
In a correlative study applying electron backscatter diffraction as well as spatially and spectrally resolved cathodoluminescence spectroscopy at low temperatures of about 5 K, the symmetry-dependent optoelectronic properties of grain boundaries in Cu(In,Ga)Se2 thin films have been investigated. We find that grain boundaries with lower symmetries tend to show a distinct spectral red shift of about 10 meV and a weak influence on the emission intensity. These behaviors are not detected at high-symmetry Σ3 grain boundaries, or at least in a strongly reduced way. The investigations in the present work help to clarify the ambivalent properties reported for grain boundaries in Cu(In,Ga)Se2.
- 13 January 2014
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 115 (2) , 023514
Symmetry dependent optoelectronic properties of grain boundaries in polycrystalline Cu(In,Ga)Se2 thin films
In a correlative study applying electron backscatter diffraction as well as spatially and spectrally resolved cathodoluminescence spectroscopy at low temperatures of about 5 K, the symmetry-dependent optoelectronic properties of grain boundaries in Cu(In,Ga)Se2 thin films have been investigated. We find that grain boundaries with lower symmetries tend to show a distinct spectral red shift of about 10 meV and a weak influence on the emission intensity. These behaviors are not detected at high-symmetry Σ3 grain boundaries, or at least in a strongly reduced way. The investigations in the present work help to clarify the ambivalent properties reported for grain boundaries in Cu(In,Ga)Se2.
- 7 January 2014
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 115 (1) , 014504
Electron-beam-induced current at absorber back surfaces of Cu(In,Ga)Se2 thin-film solar cells
The present work reports on investigations of the influence of the microstructure on electronic properties of Cu(In,Ga)Se2 (CIGSe) thin-film solar cells. For this purpose, ZnO/CdS/CIGSe stacks of these solar cells were lifted off the Mo-coated glass substrates. The exposed CIGSe backsides of these stacks were investigated by means of electron-beam-induced current (EBIC) and cathodoluminescence (CL) measurements as well as by electron backscattered diffraction (EBSD). EBIC and CL profiles across grain boundaries (GBs), which were identified by EBSD, do not show any significant changes at Σ3 GBs. Across non-Σ3 GBs, on the other hand, the CL signals exhibit local minima with varying peak values, while by means of EBIC, decreased and also increased short-circuit current values are measured. Overall, EBIC and CL signals change across non-Σ3 GBs always differently. This complex situation was found in various CIGSe thin films with different [Ga]/([In]+[Ga]) and [Cu]/([In]+[Ga]) ratios. A part of the EBIC profiles exhibiting reduced signals across non-Σ3 GBs can be approximated by a simple model based on diffusion of generated charge carriers to the GBs.
- 7 January 2014
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 115 (1) , 014504
Electron-beam-induced current at absorber back surfaces of Cu(In,Ga)Se2 thin-film solar cells
The present work reports on investigations of the influence of the microstructure on electronic properties of Cu(In,Ga)Se2 (CIGSe) thin-film solar cells. For this purpose, ZnO/CdS/CIGSe stacks of these solar cells were lifted off the Mo-coated glass substrates. The exposed CIGSe backsides of these stacks were investigated by means of electron-beam-induced current (EBIC) and cathodoluminescence (CL) measurements as well as by electron backscattered diffraction (EBSD). EBIC and CL profiles across grain boundaries (GBs), which were identified by EBSD, do not show any significant changes at Σ3 GBs. Across non-Σ3 GBs, on the other hand, the CL signals exhibit local minima with varying peak values, while by means of EBIC, decreased and also increased short-circuit current values are measured. Overall, EBIC and CL signals change across non-Σ3 GBs always differently. This complex situation was found in various CIGSe thin films with different [Ga]/([In]+[Ga]) and [Cu]/([In]+[Ga]) ratios. A part of the EBIC profiles exhibiting reduced signals across non-Σ3 GBs can be approximated by a simple model based on diffusion of generated charge carriers to the GBs.
- Open Access
- 28 November 2013
- Published by Wiley in Progress in Photovoltaics: Research and Applications
- Vol. 22 (2) , 161-165
Junction formation by Zn(O,S) sputtering yields CIGSe-based cells with efficiencies exceeding 18%
- 28 November 2013
- Published by Wiley in Progress in Photovoltaics: Research and Applications
- Vol. 22 (2) , 161-165
Open AccessJunction formation by Zn(O,S) sputtering yields CIGSe-based cells with efficiencies exceeding 18%
- 1 September 2013
- Published by Elsevier in Solar Energy Materials and Solar Cells
- Vol. 116, 43-48
Buffer-free Cu(In,Ga)Se2-solar cells by near-surface ion implantation
- 1 September 2013
- Published by Elsevier in Solar Energy Materials and Solar Cells
- Vol. 116, 43-48
Buffer-free Cu(In,Ga)Se2-solar cells by near-surface ion implantation
- 26 June 2013
- Published by Wiley in Advanced Energy Materials
- Vol. 3 (10) , 1381-1387
Formation of CuInSe2 and CuGaSe2 Thin‐Films Deposited by Three‐Stage Thermal Co‐Evaporation: A Real‐Time X‐Ray Diffraction and Fluorescence Study
Thin film solar cells based on co‐evaporated Cu(In,Ga)Se2 absorber films present the highest efficiencies among current polycrystalline thin‐film technologies. Thanks to the development of a novel experimental setup for in situ growth studies, it was possible to follow the formation of the crystalline phases during such deposition processes for the first time. This synchrotron‐based energy‐dispersive X‐ray diffraction and fluorescence setup is suited for real‐time studies of thin film vapor deposition processes. Focusing on the growth of CuInSe2 and CuGaSe2 fabricated by three‐stage processing, we find that the phase transitions in the Cu‐In‐Se system follow the reported pseudo‐binary In2Se3‐Cu2Se phase diagram. This requires a transformation of the Se sublattice during the incorporation of Cu‐Se into the In2Se3 precursor film from the first process stage. In the Cu‐Ga‐Se system, besides an increase in the lattice spacings, we observe no transformation of the Se sublattice. Furthermore, the structural defects of the Ga‐Se precursor film are preserved until the CuGaSe2 stoichiometry is reached. By means of model calculations of the fluorescence signals, we confirm in both systems the segregation of Cu2Se at the surface near a concentration of 25 at.% Cu shortly after the recrystallization of the films. The modeling also reveals that Cu2Se penetrates into the CuInSe2 film, whereas it remains at the surface of the CuGaSe2 film.
- 26 June 2013
- Published by Wiley in Advanced Energy Materials
- Vol. 3 (10) , 1381-1387
Formation of CuInSe2 and CuGaSe2 Thin‐Films Deposited by Three‐Stage Thermal Co‐Evaporation: A Real‐Time X‐Ray Diffraction and Fluorescence Study
Thin film solar cells based on co‐evaporated Cu(In,Ga)Se2 absorber films present the highest efficiencies among current polycrystalline thin‐film technologies. Thanks to the development of a novel experimental setup for in situ growth studies, it was possible to follow the formation of the crystalline phases during such deposition processes for the first time. This synchrotron‐based energy‐dispersive X‐ray diffraction and fluorescence setup is suited for real‐time studies of thin film vapor deposition processes. Focusing on the growth of CuInSe2 and CuGaSe2 fabricated by three‐stage processing, we find that the phase transitions in the Cu‐In‐Se system follow the reported pseudo‐binary In2Se3‐Cu2Se phase diagram. This requires a transformation of the Se sublattice during the incorporation of Cu‐Se into the In2Se3 precursor film from the first process stage. In the Cu‐Ga‐Se system, besides an increase in the lattice spacings, we observe no transformation of the Se sublattice. Furthermore, the structural defects of the Ga‐Se precursor film are preserved until the CuGaSe2 stoichiometry is reached. By means of model calculations of the fluorescence signals, we confirm in both systems the segregation of Cu2Se at the surface near a concentration of 25 at.% Cu shortly after the recrystallization of the films. The modeling also reveals that Cu2Se penetrates into the CuInSe2 film, whereas it remains at the surface of the CuGaSe2 film.
- 1 May 2013
- Published by Elsevier in Thin Solid Films
- Vol. 535, 340-342
Metastability of solar cells based on evaporated chalcopyrite absorber layers prepared with varying selenium flux
- 1 May 2013
- Published by Elsevier in Thin Solid Films
- Vol. 535, 340-342
Metastability of solar cells based on evaporated chalcopyrite absorber layers prepared with varying selenium flux