SHSeth Martin Hubbard

Seth Martin Hubbard

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Seth Martin Hubbard has a total of 172 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Demonstration of GaAs‐Based Photovoltaics on Acoustically Spalled Surfaces Grown by MOCVD

    by Elijah Sacchitella, Brandon Bogner, Stephen Polly, Andrew Sindermann, Pablo Coll, Mariana Bertoni, Seth Hubbard

    This study demonstrates the potential of sonic lift‐off (SLO) technology for repeatable substrate reuse in gallium arsenide (GaAs)–based photovoltaics (PVs), offering a pathway toward cost effective production for terrestrial PV applications. Single‐junction GaAs solar cells fabricated on acoustically spalled substrates achieved performance metrics comparable with those grown on standard commercial substrates, exhibiting short‐circuit current densities () of approximately 26.2–26.4 mA/cm 2 , open‐circuit voltages () around 1001 mV, fill factors (FFs) of 84%, and AM1.5G efficiencies near 22%. These results confirm that one reuse cycle can be realized without a performance penalty, offering a direct pathway to reducing substrate cost in fabrication. However, subsequent reuse of the substrates highlighted critical challenges, as devices fabricated from reused substrates showed significant degradation in performance ( of 15.5 mA/cm 2 , of 748 mV, FF of 72%, and efficiency of 8%), primarily due to degradation of the epitaxial structure resulting from repeated spalling cycles.

  • Impact of superlattice size on quantum efficiency and polarization in MOCVD-grown strained GaAs/GaAsP photocathodes

    by Adam Masters, Greg Blume, Sushil Poudel, Joseph Michael Grames, Matt Poelker, Marcy Stutzman, Stephen Polly, Seth M. Hubbard, Sylvain Marsillac, Matt Grau

    Strained superlattice GaAs photocathodes are crucial for providing high photocurrent beams of spin-polarized electrons at several accelerator facilities including the Continuous Electron Beam Accelerator Facility at Thomas Jefferson National Accelerator Facility and the future Electron–Ion Collider at Brookhaven National Laboratory. In this work, we study the effects of varying the number of superlattice pairs on the polarization and photocurrent of the photocathodes. We observe a saturation in quantum efficiency beyond 30 pairs, with additional layers yielding minimal photocurrent improvement while noticeably reducing the polarization of the beam.

  • Demonstration of a Monolithically Integrated Hybrid Device for Simultaneous Power Generation and Data Modulation

    by Emily Kessler-Lewis, Stephen J. Polly, Elijah Sacchitella, Seth M. Hubbard, Raymond Hoheisel

    A three-terminal, monolithically integrated InP photovoltaic (PV) device with an InGaAs/InAlAs electroabsorption modulator for simultaneous power generation and data modulation has been designed and experimentally validated. A discrete modulator with a data rate approaching 1 Mbps with an on / off ratio of 1.20 was demonstrated. The InP power generating junction of the monolithic device attained an AM0 efficiency of 14.1% for a 0.25 cm 2 area, with the efficiency loss primarily coming from the expected loss in the lateral conduction layer that was designed to minimize fractional power loss in the PV device and to minimize insertion loss at 1.55 $\mu$ m. The monolithically integrated device demonstrated the potential for data modulation up to 0.5 Mbps at 1.55 $\mu$ m. Simultaneous power generation and data modulation were observed in this monolithic device, and the device has application in areas such as low size, weight, power (SWaP) satellites, debris tagging, medical applications, and high altitude, long endurance unmanned aerial systems.


  • Open Access

    Development of MOVPE grown GaSb-on-GaAs interfacial misfit solar cells

    by Emily S. Kessler-Lewis, Stephen J. Polly, George T. Nelson, Michael A. Slocum, Nikhil Pokharel, Phil Ahrenkiel, Seth M. Hubbard

    GaSb grown on GaAs through interfacial misfit (IMF) arrays grown via molecular beam epitaxy has been heavily studied; there is limited research, however, on IMF growth through metal-organic vapor phase epitaxy. To demonstrate viability for integration in a multijunction solar cell for terrestrial use, it is imperative to demonstrate high quality GaSb grown on GaAs through metal-organic vapor phase epitaxy. The preferred gallium precursors for n-type and p-type GaSb for longest minority carrier diffusion length were determined to be trimethylgallium and triethylgallium, respectively. A heteroepitaxial GaSb-on-GaAs device attained an open-circuit voltage of 190 mV and an efficiency of 2.2%. Extracted threading dislocation density from the minority carrier lifetime for the heteroepitaxial GaSb-on-GaAs device was determined to be 7.5×106cm−2. In a modeled multijunction solar cell, this device attributes to an overall efficiency of 33.1% under AM1.5g illumination.


  • AM0 Optimized Dual Junction Quantum Well Solar Cells-Investigation of Radiation Tolerance Designs and Voc Retention at EOL

    by Brandon M. Bogner, Stephen J. Polly, Seth M. Hubbard, Mitsuru Imaizumi, Roger E. Welser

    Dual junction upright solar cells composed of a homojunction GaInP top cell and a heterojunction GaInP/GaAs bottom cell incorporating 50 layers of Ga 0.9 In 0.1 As quantum wells (QWs) with GaAs 0.9 P 0.1 barriers and a 12-pair Al 0.9 Ga 0.1 As/Al 0.1 Ga 0.9 As distributed Bragg reflector were designed for operation under AM0 and grown by MOVPE. Performance degradation was investigated after irradiance of 1 MeV electrons at a fluence of 1 x 10 15 cm −2 , revealing a Jsc remaining factor of 0.933 in the device with 50 pairs of QWs compared to 0.854 in the 0 QW control. In addition to a 1.7% absolute AM0 efficiency increase in the QW device relative to the control, Voc and fill factor remaining factors were held above 0.86 in both devices, producing equivalent EOL efficiencies of 18%. Modifications to layer and interface designs surrounding the quantum well region will be investigated in an effort to improve EOL V oc and FF in the quantum well device. IV performance under AM0 illumination, layer-specific current collection degradation in the GaAs sub-cell, and sub-cell saturation current densities will be investigated. The device design presented in this work is compatible with the current state-of-the-art GaInP/GaAs/Ge triple-junction architecture. With continued optimization of both subcells, a path to 2J efficiency under AM0 surpassing 27% BOL and 21% EOL may be realized.

  • Open Access

    Impact of Well Number on High-Efficiency Strain-Balanced Quantum-Well Solar Cells

    by Roger E. Welser, Stephen J. Polly, Brandon M. Bogner, Seth M. Hubbard

    The addition of lower energy-gap InGaAs quantum wells to the depletion region of GaAs solar cells is an established approach to enhance photovoltaic performance by extending infrared collection. However, maintaining a high open-circuit voltage ( V oc ) when including quantum wells has proven more challenging. In this article, we report on high-efficiency ( η > 23.5% AM0) strain-balanced quantum well (SBQW) solar cells with increased current output and efficiency while maintaining the same high open-circuit voltage of baseline devices without quantum wells ( V oc > 1.02 V). The single-junction GaAs-based device structures discussed herein employ a radiation-tolerant, n-i-p front-junction architecture and include both an InGaP heterojunction (HJ) emitter and in most cases an underlying AlGaAs distributed Bragg reflector. The impact of well number on photovoltaic device characteristics is described using an analytical model that assumes current collection, radiative recombination, and nonradiative recombination all increase with well number and are additive to the baseline cell. The highest V oc and efficiency SBQW devices employ shallow 9.2 nm In 0.07 Ga 0.93 As quantum wells and 11.5 nm GaAs 0.90 P 0.10 barrier layers to maintain strain balancing. Increasing the indium composition in the wells from 7% to 10% to form deeper wells requires a thicker strain-balancing barrier layer and results in an apparent increase in radiative recombination and decreased V oc . Single-junction high-efficiency SBQW device performance is also demonstrated in thinner base-layer structures with graded HJs—device structures suitable for inclusion in radiation-tolerant multi-junction structures.


  • Open Access

    Zinc–Acetate–Amine Complexes as Precursors to ZnO and the Effect of the Amine on Nanoparticle Morphology, Size, and Photocatalytic Activity

    by Jerry D. Harris, Emily A. Wade, Emmaline G. Ellison, Cecelia C. Pena, Stephen C. Bryant, Nicholas L. McKibben, Allison J. Christy, Kevin O. Laughlin, Ashley E. Harris, Kenrik V. Goettsche, et al.

    Zinc oxide is an environmentally friendly and readily synthesized semiconductor with many industrial applications. ZnO powders were prepared by alkali precipitation using different [Zn(acetate)2(amine)x] compounds to alter the particle size and aspect ratio. Slow precipitations from 95 °C solutions produced micron-scale particles with morphologies of hexagonal plates, rods, and needles, depending on the precursor used. Powders prepared at 65 °C with rapid precipitation yielded particles with minimal morphology differences, but particle size was dependent on the precursor used. The smallest particles were produced using precursors that yielded crystals with low aspect ratios during high-temperature synthesis. Particles produced during rapid synthesis had sizes ranging from 21–45 nm. The materials were characterized by scanning electron microscopy, transmission electron microscopy, X-ray diffraction, thermogravimetric analysis, BET, and diffuse reflectance. The materials prepared using precursors with less-volatile amines were found to retain more organic material than ZnO produced using precursors with more volatile amines. The amount of organic material associated with the nanoparticles influenced the photocatalytic activity of the ZnO, with powders containing less organic material producing faster rate constants for the decolorizing of malachite green solutions under ultraviolet illumination, independent of particle size. [Zn(acetate)2(hydrazine)2] produced ZnO with the fastest rate constant and was recycled five times for dye degradation studies that revealed minimal to no reduction in catalytic efficiency.


  • Electron radiation effects on carrier relaxation in molecular beam and vapor deposition grown GaAs test structures

    by Andrew Hudson, Seth Hubbard, Bor-Chau Juang, Baolai Liang, Mukul Debnath, William Lotshaw

    We exposed a series of AlGaAs/GaAs double heterostructure test articles grown by molecular beam epitaxy and metalorganic chemical vapor deposition to electron radiation. The active regions of the test articles were doped p-type, n-type, or unintentionally. Above bandgap steady state and time-resolved photoluminescence spectroscopy were used to characterize radiation-induced changes in the band structure and carrier dynamics of the test articles. The effects of 1 MeV electron radiation on the low temperature steady state photoluminescence and room temperature carrier lifetime varied with dopant type and concentration. The doping dependence of the lifetime damage coefficient indicates that dopants can mitigate the impact of radiation-induced non-radiative carrier recombination processes.