Jaromír Janský
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Jaromír Janský has a total of 69 co-authors. Here are the top co-authors by number of shared publications:
- Jiří Zahradník
Faculty of Mathematics and Physics, Charles University, Prague, Czech Republic
13 shared publications - Vladimír Plicka
Faculty of Mathematics and Physics, Charles University, Prague, Czech Republic
8 shared publications Reviewer J. Vaněk
6 shared publications- Vlastislav Červený
Charles University
6 shared publications E. Sokos
University of Patras, Greece
5 shared publications- Jan Zedník
Acad. Sci. Czech Republic
5 shared publications
Latest Publications
- Open Access
- 31 March 2017
- Published by Springer Nature in Scientific Reports
- Vol. 7 (1) , srep45153
A recent deep earthquake doublet in light of long-term evolution of Nazca subduction
Earthquake faulting at ~600 km depth remains puzzling. Here we present a new kinematic interpretation of two Mw7.6 earthquakes of November 24, 2015. In contrast to teleseismic analysis of this doublet, we use regional seismic data providing robust two-point source models, further validated by regional back-projection and rupture-stop analysis. The doublet represents segmented rupture of a ∼30-year gap in a narrow, deep fault zone, fully consistent with the stress field derived from neighbouring 1976–2015 earthquakes. Seismic observations are interpreted using a geodynamic model of regional subduction, incorporating realistic rheology and major phase transitions, yielding a model slab that is nearly vertical in the deep-earthquake zone but stagnant below 660 km, consistent with tomographic imaging. Geodynamically modelled stresses match the seismically inferred stress field, where the steeply down-dip orientation of compressive stress axes at ∼600 km arises from combined viscous and buoyant forces resisting slab penetration into the lower mantle and deformation associated with slab buckling and stagnation. Observed fault-rupture geometry, demonstrated likelihood of seismic triggering, and high model temperatures in young subducted lithosphere, together favour nanometric crystallisation (and associated grain-boundary sliding) attending high-pressure dehydration as a likely seismogenic mechanism, unless a segment of much older lithosphere is present at depth.
- 31 March 2017
- Published by Springer Nature in Scientific Reports
- Vol. 7 (1) , srep45153
Open AccessA recent deep earthquake doublet in light of long-term evolution of Nazca subduction
Earthquake faulting at ~600 km depth remains puzzling. Here we present a new kinematic interpretation of two Mw7.6 earthquakes of November 24, 2015. In contrast to teleseismic analysis of this doublet, we use regional seismic data providing robust two-point source models, further validated by regional back-projection and rupture-stop analysis. The doublet represents segmented rupture of a ∼30-year gap in a narrow, deep fault zone, fully consistent with the stress field derived from neighbouring 1976–2015 earthquakes. Seismic observations are interpreted using a geodynamic model of regional subduction, incorporating realistic rheology and major phase transitions, yielding a model slab that is nearly vertical in the deep-earthquake zone but stagnant below 660 km, consistent with tomographic imaging. Geodynamically modelled stresses match the seismically inferred stress field, where the steeply down-dip orientation of compressive stress axes at ∼600 km arises from combined viscous and buoyant forces resisting slab penetration into the lower mantle and deformation associated with slab buckling and stagnation. Observed fault-rupture geometry, demonstrated likelihood of seismic triggering, and high model temperatures in young subducted lithosphere, together favour nanometric crystallisation (and associated grain-boundary sliding) attending high-pressure dehydration as a likely seismogenic mechanism, unless a segment of much older lithosphere is present at depth.
- 1 November 2015
- Published by Elsevier in Journal of South American Earth Sciences
- Vol. 63, 323-333
Compromising polarity and waveform constraints in focal-mechanism solutions; the Mara Rosa 2010 Mw 4 central Brazil earthquake revisited
- 1 November 2015
- Published by Elsevier in Journal of South American Earth Sciences
- Vol. 63, 323-333
Compromising polarity and waveform constraints in focal-mechanism solutions; the Mara Rosa 2010 Mw 4 central Brazil earthquake revisited
- 1 August 2015
- Published by Elsevier in Tectonophysics
- Vol. 656, 131-141
Rupture process of the 2014 Cephalonia, Greece, earthquake doublet (Mw6) as inferred from regional and local seismic data
- 1 August 2015
- Published by Elsevier in Tectonophysics
- Vol. 656, 131-141
Rupture process of the 2014 Cephalonia, Greece, earthquake doublet (Mw6) as inferred from regional and local seismic data
- 22 October 2013
- Published by Seismological Society of America (SSA) in Bulletin of the Seismological Society of America
- Vol. 103 (6) , 3164-3178
Fault Process and Broadband Ground-Motion Simulations of the 23 October 2011 Van (Eastern Turkey) Earthquake
- 22 October 2013
- Published by Seismological Society of America (SSA) in Bulletin of the Seismological Society of America
- Vol. 103 (6) , 3164-3178
Fault Process and Broadband Ground-Motion Simulations of the 23 October 2011 Van (Eastern Turkey) Earthquake
- 1 July 2013
- Published by EAGE Publications bv in First Break
- Vol. 31 (7)
Feasibility of jointly locating microseismic events with data from surface and downhole receivers
- 1 July 2013
- Published by EAGE Publications bv in First Break
- Vol. 31 (7)
Feasibility of jointly locating microseismic events with data from surface and downhole receivers
- 1 March 2012
- Published by Elsevier in Tectonophysics
- Vol. 530-531, 299-309
The January 2010 Efpalio earthquake sequence in the western Corinth Gulf (Greece)
- 1 March 2012
- Published by Elsevier in Tectonophysics
- Vol. 530-531, 299-309
The January 2010 Efpalio earthquake sequence in the western Corinth Gulf (Greece)
- 8 December 2011
- Published by Springer Nature in Studia Geophysica et Geodaetica
- Vol. 56 (2) , 553-566
Earthquake location from P-arrival times only: problems and some solutions
- 8 December 2011
- Published by Springer Nature in Studia Geophysica et Geodaetica
- Vol. 56 (2) , 553-566
Earthquake location from P-arrival times only: problems and some solutions
- 2 February 2010
- Published by Wiley in Geophysical Prospecting
- Vol. 58 (2) , 229-234
Feasibility of joint 1D velocity model and event location inversion by the Neighbourhood algorithm
Using a set of synthetic P‐ and S‐wave onsets, computed in a 1D medium model from sources that mimic a distribution of microseismic events induced by hydrofrac treatment to a monitoring geophone array(s), we test the possibility to invert back jointly the model and events location. We use the Neighbourhood algorithm for data inversion to account for non‐linear effects of velocity model and grid search for event location. The velocity model used is composed of homogeneous layers, derived from sonic logging. Results for the case of one and two monitoring wells are compared. These results show that the velocity model can be obtained in the case of two monitoring wells, if they have optimal relative position. The use of one monitoring well fails due to the trade‐off between the velocity model and event locations.
- 2 February 2010
- Published by Wiley in Geophysical Prospecting
- Vol. 58 (2) , 229-234
Feasibility of joint 1D velocity model and event location inversion by the Neighbourhood algorithm
Using a set of synthetic P‐ and S‐wave onsets, computed in a 1D medium model from sources that mimic a distribution of microseismic events induced by hydrofrac treatment to a monitoring geophone array(s), we test the possibility to invert back jointly the model and events location. We use the Neighbourhood algorithm for data inversion to account for non‐linear effects of velocity model and grid search for event location. The velocity model used is composed of homogeneous layers, derived from sonic logging. Results for the case of one and two monitoring wells are compared. These results show that the velocity model can be obtained in the case of two monitoring wells, if they have optimal relative position. The use of one monitoring well fails due to the trade‐off between the velocity model and event locations.
- 1 April 2009
- Published by Springer Nature in Studia Geophysica et Geodaetica
- Vol. 53 (2) , 261-268
Shallow earthquakes: Shallower than expected?
- 1 April 2009
- Published by Springer Nature in Studia Geophysica et Geodaetica
- Vol. 53 (2) , 261-268
Shallow earthquakes: Shallower than expected?
- 1 December 2008
- Published by Seismological Society of America (SSA) in Bulletin of the Seismological Society of America
- Vol. 98 (6) , 2756-2771
Detailed Waveform Inversion for Moment Tensors of M 4 Events: Examples from the Corinth Gulf, Greece
International audienceMoment tensors (MTs) of weak events are often calculated by a single agency (network), thus lacking independent validation. This article investigates how to increase reliability of the single-agency solutions through various multiple checks. It deals with the inversion of complete waveforms for six representative events (Mw 3.4–4.6) in the range of 0.08–0.15 Hz. Several three-station sets at near-regional distances (8–103 km) are used. The MTs are repeatedly calculated for two independent locations: from a regional and local network. The source depth is held fixed at the hypocenter and also grid searched to optimize the waveform match. Initially, large variations (instability) of the MT solution with the approach we used were found for some events. Later, the difficulties were understood and the solutions stabilized. It led to practical recommendations on how to detect or even avoid problematic MT solutions. First, avoid MT solutions for a single fixed depth (hypocenter). Second, optimize MT solutions by the depth grid search below epicenter (or better) for at least two alternative epicenters. Third, carefully analyze: (i) any rapid variation of the solution, (ii) major misfit of the first-motion polarities, (iii) low double-couple percentage (often correlating with [ii]), (iv) low values of the min/max eigenvalue ratio, and (v) departures of the MT-preferred depth from the location-derived depth. The MT-preferred depths, hence also the focal mechanism, may be misleading due to data problems (e.g., long-period disturbances, clipping) hidden in the band-pass waveforms. The location-derived depth may be especially wrong for very shallow earthquakes if the crustal model is inadequate in its shallow part and/or near stations are lacking. On the other hand, near stations (<20 km) should not be used in the waveform inversion together with distant stations; because of their large amplitudes, the inversion can be easily biased due to instrumental data errors and small location errors
- 1 December 2008
- Published by Seismological Society of America (SSA) in Bulletin of the Seismological Society of America
- Vol. 98 (6) , 2756-2771
Detailed Waveform Inversion for Moment Tensors of M 4 Events: Examples from the Corinth Gulf, Greece
International audienceMoment tensors (MTs) of weak events are often calculated by a single agency (network), thus lacking independent validation. This article investigates how to increase reliability of the single-agency solutions through various multiple checks. It deals with the inversion of complete waveforms for six representative events (Mw 3.4–4.6) in the range of 0.08–0.15 Hz. Several three-station sets at near-regional distances (8–103 km) are used. The MTs are repeatedly calculated for two independent locations: from a regional and local network. The source depth is held fixed at the hypocenter and also grid searched to optimize the waveform match. Initially, large variations (instability) of the MT solution with the approach we used were found for some events. Later, the difficulties were understood and the solutions stabilized. It led to practical recommendations on how to detect or even avoid problematic MT solutions. First, avoid MT solutions for a single fixed depth (hypocenter). Second, optimize MT solutions by the depth grid search below epicenter (or better) for at least two alternative epicenters. Third, carefully analyze: (i) any rapid variation of the solution, (ii) major misfit of the first-motion polarities, (iii) low double-couple percentage (often correlating with [ii]), (iv) low values of the min/max eigenvalue ratio, and (v) departures of the MT-preferred depth from the location-derived depth. The MT-preferred depths, hence also the focal mechanism, may be misleading due to data problems (e.g., long-period disturbances, clipping) hidden in the band-pass waveforms. The location-derived depth may be especially wrong for very shallow earthquakes if the crustal model is inadequate in its shallow part and/or near stations are lacking. On the other hand, near stations (<20 km) should not be used in the waveform inversion together with distant stations; because of their large amplitudes, the inversion can be easily biased due to instrumental data errors and small location errors