Sandra Schorderet Weber
Research Subjects
Sandra Schorderet Weber has a total of 53 co-authors. Here are the top co-authors by number of shared publications:
Adrian Stan
PMI R&D, Philip Morris Products S.A., Neuchatel, Switzerland
1 shared publication- Adrian Stan
PMI R&D, Philip Morris Products S.A., Neuchatel, Switzerland
1 shared publication Alexandra Laurent
PMI R&D, Philip Morris Products S.A., Neuchatel, Switzerland
1 shared publication- Alexandre Bergounioux
PMI R&D, Philip Morris Products S.A., Quai Jeanrenaud 5, CH-2000 Neuchâtel, Switzerland
1 shared publication Andreas Hogg
Coat-X SA, La Chaux-de-Fonds, Switzerland
1 shared publication- Andreas Hogg
Coat-X SA, Eplatures-Grise 17, 2300 La Chaux-de-Fonds, Switzerland
1 shared publication
Latest Publications
- Open Access
- 30 June 2023
- Published by Springer Nature in Archives of Microbiology
- Vol. 205 (7) , 1-9
Inactivation of SARS-CoV-2 on salt-coated surfaces: an in vitro study
In the COVID-19 pandemic, caused by the severe acute respiratory syndrome coronavirus 2 (SARS-CoV-2), face masks have become a very important safety measure against the main route of transmission of the virus: droplets and aerosols. Concerns that masks contaminated with SARS-CoV-2 infectious particles could be a risk for self-contamination have emerged early in the pandemic as well as solutions to mitigate this risk. The coating of masks with sodium chloride, an antiviral and non-hazardous to health chemical, could be an option for reusable masks. To assess the antiviral properties of salt coatings deposited onto common fabrics by spraying and dipping, the present study established an in vitro bioassay using three-dimensional airway epithelial cell cultures and SARS-CoV-2 virus. Virus particles were given directly on salt-coated material, collected, and added to the cell cultures. Infectious virus particles were measured by plaque forming unit assay and in parallel viral genome copies were quantified over time. Relative to noncoated material, the sodium chloride coating significantly reduced virus replication, confirming the effectiveness of the method to prevent fomite contamination with SARS-CoV-2. In addition, the lung epithelia bioassay proved to be suitable for future evaluation of novel antiviral coatings.
- 30 June 2023
- Published by Springer Nature in Archives of Microbiology
- Vol. 205 (7) , 1-9
Open AccessInactivation of SARS-CoV-2 on salt-coated surfaces: an in vitro study
In the COVID-19 pandemic, caused by the severe acute respiratory syndrome coronavirus 2 (SARS-CoV-2), face masks have become a very important safety measure against the main route of transmission of the virus: droplets and aerosols. Concerns that masks contaminated with SARS-CoV-2 infectious particles could be a risk for self-contamination have emerged early in the pandemic as well as solutions to mitigate this risk. The coating of masks with sodium chloride, an antiviral and non-hazardous to health chemical, could be an option for reusable masks. To assess the antiviral properties of salt coatings deposited onto common fabrics by spraying and dipping, the present study established an in vitro bioassay using three-dimensional airway epithelial cell cultures and SARS-CoV-2 virus. Virus particles were given directly on salt-coated material, collected, and added to the cell cultures. Infectious virus particles were measured by plaque forming unit assay and in parallel viral genome copies were quantified over time. Relative to noncoated material, the sodium chloride coating significantly reduced virus replication, confirming the effectiveness of the method to prevent fomite contamination with SARS-CoV-2. In addition, the lung epithelia bioassay proved to be suitable for future evaluation of novel antiviral coatings.
- Open Access
Fractionation and Extraction Optimization of Potentially Valuable Compounds and Their Profiling in Six Varieties of Two Nicotiana Species
There is an increasingly urgent call to shift industrial processes from fossil fuel feedstock to sustainable bio-based resources. This change becomes of high importance considering new budget requirements for a carbon-neutral economy. Such a transformation can be driven by traditionally used plants that are able to produce large amounts of valuable biologically relevant secondary metabolites. Tobacco plants can play a leading role in providing value-added products in remote areas of the world. In this study, we propose a non-exhaustive list of compounds with potential economic interest that can be sourced from the tobacco plant. In order to optimize extraction methodologies, we first analyzed their physico-chemical properties using rapid solubility tests and high-resolution microfractionation techniques. Next, to identify an optimal extraction for a selected list of compounds, we compared 13 different extraction method–solvent combinations. We proceeded with profiling some of these compounds in a total of six varieties from Nicotiana tabacum and Nicotiana rustica species, identifying the optimal variety for each. The estimated expected yields for each of these compounds demonstrate that tobacco plants can be a superior source of valuable compounds with diverse applications beyond nicotine. Among the most interesting results, we found high variability of anatabine content between species and varieties, ranging from 287 to 1699 µg/g. In addition, we found that CGA (1305 µg/g) and rutin (7910 µg/g) content are orders of magnitude lower in the Burley variety as compared to all others.
Open AccessFractionation and Extraction Optimization of Potentially Valuable Compounds and Their Profiling in Six Varieties of Two Nicotiana Species
There is an increasingly urgent call to shift industrial processes from fossil fuel feedstock to sustainable bio-based resources. This change becomes of high importance considering new budget requirements for a carbon-neutral economy. Such a transformation can be driven by traditionally used plants that are able to produce large amounts of valuable biologically relevant secondary metabolites. Tobacco plants can play a leading role in providing value-added products in remote areas of the world. In this study, we propose a non-exhaustive list of compounds with potential economic interest that can be sourced from the tobacco plant. In order to optimize extraction methodologies, we first analyzed their physico-chemical properties using rapid solubility tests and high-resolution microfractionation techniques. Next, to identify an optimal extraction for a selected list of compounds, we compared 13 different extraction method–solvent combinations. We proceeded with profiling some of these compounds in a total of six varieties from Nicotiana tabacum and Nicotiana rustica species, identifying the optimal variety for each. The estimated expected yields for each of these compounds demonstrate that tobacco plants can be a superior source of valuable compounds with diverse applications beyond nicotine. Among the most interesting results, we found high variability of anatabine content between species and varieties, ranging from 287 to 1699 µg/g. In addition, we found that CGA (1305 µg/g) and rutin (7910 µg/g) content are orders of magnitude lower in the Burley variety as compared to all others.
- Open Access
- 11 October 2022
- Published by Springer Nature in Scientific Reports
- Vol. 12 (1) , 1-13
In vitro testing of salt coating of fabrics as a potential antiviral agent in reusable face masks
During the coronavirus disease (COVID-19) pandemic, wearing face masks in public spaces became mandatory in most countries. The risk of self-contamination when handling face masks, which was one of the earliest concerns, can be mitigated by adding antiviral coatings to the masks. In the present study, we evaluated the antiviral effectiveness of sodium chloride deposited on a fabric suitable for the manufacturing of reusable cloth masks using techniques adapted to the home environment. We tested eight coating conditions, involving both spraying and dipping methods and three salt dilutions. Influenza A H3N2 virus particles were incubated directly on the salt-coated materials, collected, and added to human 3D airway epithelial cultures. Live virus replication in the epithelia was quantified over time in collected apical washes. Relative to the non-coated material, salt deposits at or above 4.3 mg/cm2 markedly reduced viral replication. However, even for larger quantities of salt, the effectiveness of the coating remained dependent on the crystal size and distribution, which in turn depended on the coating technique. These findings confirm the suitability of salt coating as antiviral protection on cloth masks, but also emphasize that particular attention should be paid to the coating protocol when developing consumer solutions.
- 11 October 2022
- Published by Springer Nature in Scientific Reports
- Vol. 12 (1) , 1-13
Open AccessIn vitro testing of salt coating of fabrics as a potential antiviral agent in reusable face masks
During the coronavirus disease (COVID-19) pandemic, wearing face masks in public spaces became mandatory in most countries. The risk of self-contamination when handling face masks, which was one of the earliest concerns, can be mitigated by adding antiviral coatings to the masks. In the present study, we evaluated the antiviral effectiveness of sodium chloride deposited on a fabric suitable for the manufacturing of reusable cloth masks using techniques adapted to the home environment. We tested eight coating conditions, involving both spraying and dipping methods and three salt dilutions. Influenza A H3N2 virus particles were incubated directly on the salt-coated materials, collected, and added to human 3D airway epithelial cultures. Live virus replication in the epithelia was quantified over time in collected apical washes. Relative to the non-coated material, salt deposits at or above 4.3 mg/cm2 markedly reduced viral replication. However, even for larger quantities of salt, the effectiveness of the coating remained dependent on the crystal size and distribution, which in turn depended on the coating technique. These findings confirm the suitability of salt coating as antiviral protection on cloth masks, but also emphasize that particular attention should be paid to the coating protocol when developing consumer solutions.
- Open Access
- 1 April 2017
- Published by Elsevier in International Journal for Parasitology: Drugs and Drug Resistance
- Vol. 7 (1) , 90-109
Blocking transmission of vector-borne diseases
- 1 April 2017
- Published by Elsevier in International Journal for Parasitology: Drugs and Drug Resistance
- Vol. 7 (1) , 90-109
Open AccessBlocking transmission of vector-borne diseases
- Open Access
- 24 February 2015
- Published by Springer Nature in Parasites & Vectors
- Vol. 8 (1) , 119-12
Vaccination with recombinant paramyosin against the bovine lungworm Dictyocaulus viviparus considerably reduces worm burden and larvae shedding
The lungworm Dictyocaulus viviparus, causing parasitic bronchitis in cattle, induces a temporary protective immunity that prevents clinical disease. A radiation-attenuated larvae based vaccine is commercially available in a few European countries, but has the disadvantages of a live vaccine. As a recombinant subunit vaccine would overcome these disadvantages, the parasite’s muscle protein paramyosin (PMY) was tested as a recombinant vaccine antigen. D. viviparus-PMY was recombinantly expressed in Escherichia coli as a glutathione-S-transferase (GST)-fused protein. Emulsified in adjuvant Saponin Quil A, the protein was given intramuscularly into calves. Two independent recombinant PMY (rPMY) vaccination trials with negative control groups (first trial: adjuvant only; second trial: non-fused GST) as well as an additional positive control group in the second trial, using the Bovilis©Dictol live vaccine to verify vaccination results, were performed. To determine the vaccination success, shedding of larvae as well as worm burden and worm sizes were analyzed. Additionally, ELISA-based determination of development of immunglobulins IgM, IgA, IgE, IgG as well as the subclasses IgG1 and IgG2 was performed. To analyze PMY localization in the bovine lungworm, immunohistochemical staining of adult worms was carried out. Immunohistochemical staining revealed that PMY is part of the bovine lungworm’s pharyngeal and body wall muscles. Vaccination with rPMY resulted in 47% [geometric mean: 67%] and 57% (geometric mean: 71%) reduction of larvae shedding in the first and second vaccination trial, respectively. Worm burden was reduced by 54% (geometric mean: 86%) and 31% (geometric mean: 68%), respectively, and worms of rPMY-vaccinated cattle were significantly shorter in both trials. Furthermore, ELISAs showed a clear antibody response towards rPMY with exception of IgE for which titers could not be detected. After challenge infection, rPMY antibodies were only exceptionally elevated among study animals indicating PMY to be a hidden antigen. Even though vaccination with the attenuated live vaccine was with 94% (geometric mean: 95%) reduction in larvae shedding and 93% (geometric mean: 94%) reduction in worm burden superior to rPMY vaccination, results using the latter are promising and show the potential for further development of a recombinant PMY-based vaccine against the bovine lungworm.
- 24 February 2015
- Published by Springer Nature in Parasites & Vectors
- Vol. 8 (1) , 119-12
Open AccessVaccination with recombinant paramyosin against the bovine lungworm Dictyocaulus viviparus considerably reduces worm burden and larvae shedding
The lungworm Dictyocaulus viviparus, causing parasitic bronchitis in cattle, induces a temporary protective immunity that prevents clinical disease. A radiation-attenuated larvae based vaccine is commercially available in a few European countries, but has the disadvantages of a live vaccine. As a recombinant subunit vaccine would overcome these disadvantages, the parasite’s muscle protein paramyosin (PMY) was tested as a recombinant vaccine antigen. D. viviparus-PMY was recombinantly expressed in Escherichia coli as a glutathione-S-transferase (GST)-fused protein. Emulsified in adjuvant Saponin Quil A, the protein was given intramuscularly into calves. Two independent recombinant PMY (rPMY) vaccination trials with negative control groups (first trial: adjuvant only; second trial: non-fused GST) as well as an additional positive control group in the second trial, using the Bovilis©Dictol live vaccine to verify vaccination results, were performed. To determine the vaccination success, shedding of larvae as well as worm burden and worm sizes were analyzed. Additionally, ELISA-based determination of development of immunglobulins IgM, IgA, IgE, IgG as well as the subclasses IgG1 and IgG2 was performed. To analyze PMY localization in the bovine lungworm, immunohistochemical staining of adult worms was carried out. Immunohistochemical staining revealed that PMY is part of the bovine lungworm’s pharyngeal and body wall muscles. Vaccination with rPMY resulted in 47% [geometric mean: 67%] and 57% (geometric mean: 71%) reduction of larvae shedding in the first and second vaccination trial, respectively. Worm burden was reduced by 54% (geometric mean: 86%) and 31% (geometric mean: 68%), respectively, and worms of rPMY-vaccinated cattle were significantly shorter in both trials. Furthermore, ELISAs showed a clear antibody response towards rPMY with exception of IgE for which titers could not be detected. After challenge infection, rPMY antibodies were only exceptionally elevated among study animals indicating PMY to be a hidden antigen. Even though vaccination with the attenuated live vaccine was with 94% (geometric mean: 95%) reduction in larvae shedding and 93% (geometric mean: 94%) reduction in worm burden superior to rPMY vaccination, results using the latter are promising and show the potential for further development of a recombinant PMY-based vaccine against the bovine lungworm.