LJLu-Yang Ji

Lu-Yang Ji

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Lu-Yang Ji has a total of 42 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • A Transmission-Type Multi-Functional Polarization Converter Based on Liquid Metal Metasurface

    by Lu-Yang Ji, Yifei Han, Ziyang Jiang, Xudong Zhang

    This communication presents a transmission-type liquid metal-based polarization converter with multi-functional capabilities, integrating linear-to-circular polarization conversion and low scattering. The proposed microfluidic structure incorporates a polarization conversion layer that transforms incident TM waves into right-handed circularly polarized (RHCP) waves, and a reflective phase-shifting layer which can achieve Radar Cross Section (RCS) reduction while preserving the polarization conversion functionality. By changing the filling states of the liquid metal, low scattering state can be activated. Its design breakthrough lies in the introduction of the reflective phase shifting stub, which enables the independent control of the transmission and reflection phases. This allows that the polarization conversion function can be achieved even in low radar cross section (RCS) mode. The simulated and measured results indicate that for the polarization conversion mode, the 3 dB axial ratio (AR) bandwidth can be realized in the frequency range of 14.8 - 17.3 GHz (15.6%); for the low RCS mode, the RCS value is reduced by more than 10 dB in the range of 12 - 24 GHz (66.7%) with an enhanced 3 dB AR bandwidth of 12.7 - 17.9 GHz (33.9%).

  • An X-/Ka-Band Shared-Aperture Phased Array Antenna by Structure Reuse Strategy of Embedded Dielectric Resonator

    by Lu-Yang Ji, Qingyu Luo, Xudong Zhang, Jian-Ying Li

    This paper proposes a new topology for a X-/Ka-band shared-aperture phased array to achieve high aperture utilization. The unit cell of the shared-aperture array consists of one X-band element and 3 × 3 Ka-band elements. The Ka-band element is an embedded rectangular dielectric resonator antenna (DRA) with a metasurface etched on its top side. To realize left-handed circularly polarization (LHCP), a cross-slot and a couple of arc-shaped slots are employed in the coupling feed mechanism. The X-band element is a dual-feed magneto-electric dipole antenna (MEDA) with dual CP capabilities. By hollowing out the center and the sides of the dipole antenna, 3 × 3 Ka-band elements can effectively share the same aperture with the X-band element. The idea of structure reuse strategy allows for independent frequency and radiation control for the proposed shared-aperture structure. A shared-aperture array prototype, comprising of 3 × 3 X-band and 10 × 10 Ka-band elements, was fabricated and measured for performance verification. The measured results show that the proposed array can achieve an impedance bandwidth (active VSWR ≤ 2.8) from 7 GHz to 8.5 GHz for the X-band and from 26 GHz to 28 GHz for the Ka-band. Additionally, it can realize ± 45° beam scanning with an axial ratio (AR) variation less than 5 dB for both bands.


  • Low-RCS Frequency-Reconfigurable Fabry–Perot Antenna Based on Liquid Metal Metasurface

    by Lu-Yang Ji, Yifei Han, Xiaoyue Hong

    A frequency reconfigurable Fabry–Perot (F-P) antenna with low radar cross section (RCS) is proposed in this work. A multifunctional liquid metal high impedance surface (HIS) is employed on the ground plane of the feed antenna. By altering the filling states of liquid metal within the HIS cells, the frequency reconfiguration can be achieved. Moreover, among the aforementioned HIS states, 180° phase difference can also be obtained, thus leading to an integrated in-band low RCS property. A liquid metal partially reflective surface is located directly above the feed antenna to reduce the out-of-band RCS according to the phase cancellation theory, as well as enhance the radiation gains. To verify the design method, an antenna prototype is fabricated and measured. The measured results indicate that the operating frequency can be tuned in the range of 8.7 GHz – 10.6 GHz (19.7%). At the same time, the RCS reduction is achieved in 6 GHz – 20 GHz (107.69%).


  • An X-/Ka-Band Shared-Aperture Linear-to-Circular Polarization Converter

    by Wen-Juan Shu, Lu-Yang Ji, Rui-Zi Chen, Jian-Ying Li, Shi-Gang Zhou

    This paper presents a novel design method for a dual-band shared-aperture linear-to-circular polarization (LP-to-CP) converter. High-impedance structures and a band-pass frequency selective surface (FSS) are employed to achieve low interferences between the X- and Ka-band elements. In this paper, a high-impedance structure is incorporated into the X-band element to eliminate high-order modes and prevent phase differences between TE and TM modes. Additionally, a band-pass FSS is employed to mitigate the influence of the high-frequency (HF) element on the low-frequency (LF) element. Based on this method, an X-/Ka-band converter with a two-layer structure is proposed. The X-band element consists of two groups of split rings and cross strips, which are printed on the topmost and bottom layers of the substrate. The Ka-band element comprises a Jerusalem cross printed in the middle layer and a metal strip printed on the same layer as the X-band element. Equivalent circuit model (ECM) is utilized to analyze the response of the converter. An X-/Ka-band LP-to-CP converter prototype is fabricated and integrated with array antennas to validate the design concept. The experimental results indicate that the array antennas integrated with the proposed converter can achieve an overlapped impedance and axial ratio (AR) bandwidths of 11.1% (8.18-9.14 GHz) and 13.6% (25.95 - 29.73 GHz), with maximum gains of 12.8 and 16.4 dBic in two frequency bands, respectively.


  • A 1-Bit Reconfigurable Antenna Array With Radiation and Scattering Modulation

    by Lu-Yang Ji, Xiaoyue Hong, Yifei Han, Qingyu Luo

    This work proposes an electrically tunable reconfigurable antenna array with wideband radiation and scattering modulation using a simpler structure and an easier control mechanism. A ladder-shaped patch is designed as the radiator. By inserting only one PIN diode in the middle of the patch structure, its operation can be modulated between a patch mode and a slot mode, achieving a wideband reflection phase difference of 180°±37°. A 4 × 4 array is formed using the aforementioned element, which can reconfigure its radiation and scattering modes by controlling the states of the PIN diodes. The measured results show that the proposed array exhibits a 10-dB impedance bandwidth of 20.99% with a peak gain of 14.94 dBi in the radiation mode. In the scattering mode, the phase distributions of the elements are optimized by Group Search Optimizer (GSO) algorithm. The radar cross section (RCS) is reduced in the frequency range of 6 - 20 GHz with an average RCS reduction value of 17 dB in the operating band.


  • Multiband Modified Yagi Antenna in a Shared Transverse Aperture

    by Wuyi Huang, Lu-Yang Ji, Shi-Gang Zhou

    This letter presents a multi-band modified Yagi antenna, which can operate at four individual frequency bands (0.87 GHz, 1.53 GHz, 2.32 GHz, and 5.55 GHz). The proposed antenna consists of four groups of Yagi elements cascading in a shared transverse aperture. Each Yagi element has one dipole as the radiator, one or two directors, and one reflector, corresponding to one resonant frequency. In order to realize independent control of each frequency band, a high impedance structure is employed between two adjacent Yagi elements, which can be used to reduce the mutual coupling as well. Therefore, the four groups of Yagi elements can work individually or in combination to achieve single-band, dual-band, tri-band and quad-band Yagi antennas. The measured results show that the proposed antenna can achieve a -10 dB impedance bandwidths of 11.5% (0.82 - 0.92 GHz), 10.5% (1.45 - 1.61 GHz), 17.7% (2.11 - 2.52 GHz) and 16.2% (5.1 - 6 GHz) for the four operating bands. The maximum realized gains for each band are 5.8 dB, 7.9 dB, 6.7 dB, 4.8 dB.


  • An Isolation Enhancement Method for a Circularly Polarized Shared-Aperture Array Using Rotating Feed

    by Wen-Juan Shu, Luyang Ji, Shigang Zhou, Jian-Ying Li

    A novel isolation enhancement method for the shared-aperture antenna is proposed in this letter. When the high-frequency band (HB) antenna is arranged by rotation, the loop current can be excited, which reduces the mutual coupling between the HB antenna and the low-frequency band antenna (LB). Based on this approach, a circularly polarized (CP) shared-aperture antenna array with high cross-band isolation is proposed. It consists of 2×2 cross-shaped patch antennas operating in the LB and 4×4 rectangular printed dipole antennas operating in the HB. The LB and HB antennas are etched on the same substrate. In this work, cross-band isolation in the LB is improved by more than 8.2 dB by an anticlockwise rotating feed for the HB antennas. For validation, an array prototype was designed and fabricated. The measured results demonstrate that the proposed array achieves an operating bandwidth (IBW) of 13.6% (2.6 GHz-2.98 GHz) in S-band and 30.0% (4.72 GHz-6.32GHz) in C-band, respectively. Furthermore, the antenna exhibits cross-band isolation exceeding 19.2 dB and 26.8 dB, along with aperture efficiency of 73.4% and 81.8% in S-/C-band, respectively. The proposed CP shared-aperture array has features of high cross-band isolation and high aperture efficiency with a simple structure.


  • Open Access

    A low radar cross section antenna array based on a liquid metal metasurface

    by Lu‐Yang Ji, Xiaoyue Hong, Rui Yang, Qingyue Liu, Wenhan Zhang

    A low RCS (radar cross section) slot array antenna based on a liquid metal metasurface is proposed. The metasurface consists of 6 × 6 nested ring‐shaped element. The inner ring with a checkerboard distribution can realise 180° ± 37° phase difference, which can effectively reduce the scattering performances for the slot array. The outer and inner ring together can excite more energy from the slot array, thus resulting in increased radiation gains. Therefore, by changing the layout of liquid metal on the metasurface, scattering and radiation enhancement modes can be switched. The measured results show that in the scattering mode, the RCS can be reduced from 8.1 to 17 GHz. While in the radiation enhancement mode, the proposed array with the metasurface can achieve a −10‐dB impedance bandwidth of 9.4–11.2 GHz (17.4%) with a maximum gain of 8.12 dBi. Compared with the slot array without the metasurface, the realised gain is enhanced by 1.2 dBi from 6.9 dBi. The measured results correspond well with the simulated ones.


  • A continuous frequency tuning Fabry–Perot Cavity antenna with stable radiation performance

    by Lu-Yang Ji, Shuai Fu

    This paper presents a continuous frequency tuning Fabry–Perot Cavity (FPC) antenna of which the operating frequency can be varied from 4.87 to 5.84 GHz (18.1%). The cavity of the proposed antenna is excited by a double-layer antenna structure, which is made up of a main square patch and a parasitic one. The superstrate is a frequency-selective surface, consisting of 6 × 6 square-patch-type unit cells. The frequency tuning property is realized by employing 48 phase-changing elements placed around the main patch, which forms a reconfigurable high impedance surface (HIS). By controlling the biasing voltages of the varactors inserted in the HIS element, its capacitances and reflection phases can be varied continuously, which leads to a variation of the operating frequency. An antenna prototype has been fabricated and measured for validation. The measured results are in good agreement with the simulated ones. In the frequency tuning range, the measured realized gains have a smaller variation from 10.2 to 14.1 dBi compared with other reported frequency tuning FPC antennas.


  • A Single-Layer Single-Fed Shorted-Patch Antenna With Broadside Circular Polarization by Using Nondegenerate TM0,1/2 and TM1,1/2 Modes

    by Neng-Wu Liu, Mei-Jiao Sun, Lei Zhu, Zhong-Xun Liu, Lin Yang, Lu-Yang Ji

    A novel design concept to excite and produce the broadside circularly-polarized (CP) radiation is presented in a shorted patch antenna (SPA). Firstly, the far-zone radiated fields of the SPA under radiation of TM $_{0,1/2}$ and TM $_{1,1/2}$ modes are theoretically studied. It demonstrates that the broadside |Eφ| component of its TM0,1/2 mode is generated in yoz-plane. In contrast, the orthogonal |Eθ| component of its TM $_{1,1/2}$ mode is produced in this plane. Then, the resonant frequency of the TM $_{0,1/2}$ mode is gradually pushed up to around that of TM $_{1,1/2}$ mode, aiming to generate the normal CP radiation between these dual modes. After that, a linear slot is etched out on the core radiator so as to counteract the equivalent inductance caused by the loaded pins and feeding probe. Finally, the proposed antenna is fabricated and tested. The measured results reveal that its impedance bandwidth (|S $_{11}$ |<–10 dB) has been widened to about 5.3% or a range of 2.65 - 2.795 GHz. Most importantly, the CP radiation (AR<3 dB) of the antenna at the broadside direction is indeed resonated of around 2.738 GHz, while keeping the reduced length, single-layer, and single-fed properties.