BIBenjamin Iniguez

Benjamin Iniguez

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Benjamin Iniguez has a total of 152 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Fully Liquid-Metal-Printed SnO₂ Thin-Film Transistors With Al₂O₃ Dielectrics

    by Runtong Guo, Yu Song, Annan Du, Jean-Pierre Raskin, Denis Flandre, Benjamin Iñiguez, Lei Liao, Guoli Li

    In this work, we present the first demonstration of fully printed thin-film transistors (TFTs) using the liquid-metal printing (LMP) technique for both the SnO2 channel and Al2O3 dielectric layers and investigate annealing impact on the microstructure of LMP-SnO2 films and electrical behavior of LMP-based SnO2 TFTs. Through experimental characterization and TCAD simulations, we find that the overall device performance initially degrades below $310~^{\circ }$ C due to increased oxygen vacancy ( ${V}_{O}$ ) concentration but recovers at higher temperatures owing to the reduction in ${V}_{O}$ concentration and crystallization-induced suppression of interface defects. The LMP-SnO2 TFTs on SiO2/p+-Si substrate annealed at $600~^{\circ }$ C achieve a field-effect mobility of 10.35 cm ${}^{{2}} \cdot $ V ${}^{\text {-1}} \cdot $ s ${}^{\text {-1}}$ . The performance is further improved by implementing the LMP-Al2O3 gate dielectric, yielding a subthreshold swing (SS) of 654mV/dec and a threshold voltage of 0.95 V. Finally, a functional zero- $V$ GS-load nMOS inverter unit, comprising both depletion and enhancement mode SnO2 TFTs, demonstrates the potential application of this LMP technique for integrated circuits. This work establishes a novel strategy for fabricating high-performance metal–oxide TFTs and circuits via fully LMP-based manufacturing.


  • Open Access

    Review of DC and AC core compact models and device performance in organic transistors

    by Monideepa Dutta, Nikhil Ranjan Das, Benjamin Iñiguez, Alexander Kloes, Ghader Darbandy

    Organic transistors offer lightweight, flexible, and low-cost platforms for large-area electronics, making them particularly attractive for applications in wearables and biosensing. Their effective use requires detailed characterization and accurate simulation, with compact models providing the foundation for predicting device behavior and enabling reliable circuit-level design. Yet, the diversity of organic semiconductors and the complexity of charge transport demand multiple core modeling approaches, each built on distinct physical assumptions. This review first summarizes reported lateral and vertical organic transistor architectures, outlining their structural principles and material implementations. It then considers core compact physics-based models for both DC and AC operation, emphasizing their formulations, underlying assumptions, and the physical effects they incorporate. Finally, it reviews reported DC and AC characteristics across diverse material systems, with particular attention to bias-normalized parameters that enable consistent and meaningful cross-study comparisons. By exploring existing core models and performance analyses, this review highlights the fundamental physical principles incorporated into reported compact models and bridges device-level physics with application-oriented circuit design. It offers a comparative perspective on modeling strategies suitable for flexible and biointegrated electronics, while identifying key overlaps in the literature and providing a foundational framework for efficient future model development. Additionally, the review underscores the importance of harmonized terminology to accelerate the development of next-generation models and enhance consistency across studies.


  • Compact I – V Model for Double-Gated MoS 2 FETs Including Short-Channel Effects

    by Ahmed Mounir, François Lime, Alexander Kloes, Alexandros Provias, Theresia Knobloch, K. P. O'BRien, Tibor Grasser, Benjamin Iñiguez

    This article presents a physics-based analytical compact model for double-gated molybdenum disulfide ( $\text{MoS}_{{2}}$ ) field effect transistors (FETs), incorporating key physical and short-channel effects (SCEs), such as mobility degradation and velocity saturation. The model is developed from a unified charge control model by evaluating the charge density within the 2-D $\text{MoS}_{{2}}$ layer, represented using the Lambert W function, which provides an analytical expression valid and continuous from the subthreshold to the above threshold regime. The drain current is then derived from this unified charge control model, and as a function of closed-form equations for the charge densities at the source and drain ends of the channel. Despite its simplicity, the model shows excellent agreement with experimental data for channel lengths down to 60 nm, making it a powerful tool for accurately predicting the performance of downscaled devices. By including SCEs, this work extends previous modeling efforts and provides a more comprehensive framework for the simulation and optimization of 2-D material-based FETs in circuit design.


  • Open Access

    A DC Compact Model of an Organic Electrochemical Transistor Based on a Semiconductor Physics and Thermodynamic Approach

    by Ermias Telahun Teka, Yeohoon Yoon, Laura Teuerle, Tommy Meier, Hans Kleemann, Ghader Darbandy, Benjamin Iniguez

    Recent progress in printable electronics and biointerfaces has driven a growing interest in organic electronics for biosensor and neuromorphic applications, offering a valuable complement to traditional silicon technologies. Among organic electronics, organic electrochemical transistors (OECTs) have garnered significant attention for their high transconductance, biocompatibility, and dual ionic‒electronic charge transport capabilities. While OECTs show strong promise, their variability due to fabrication and material inconsistencies, limited insight into charge transport, and absence of standard models hinder their integration. A robust, physics‐based compact model can bridge these gaps and facilitate broader adoption of this device technology. This work presents a physics‐based DC compact model for OECTs, integrating electrochemical interactions using the Nernst equation in the above threshold regime with drain bias‐dependent diffusive charge transport in the subthreshold regime, unified by a hyperbolic tangent transition. It integrates the threshold voltage roll‐off effect and the drain voltage‐dependence of the hole mobility using the Poole‒Frenkel mobility model. The model is validated against experimental data from four distinct geometries of p‐type poly(3,4‐ethylenedioxythiophene):polystyrene sulfonate (PEDOT: PSS) OECTs, which show excellent agreement with the measurements. The model reliably captures DC characteristics, making it suitable for incorporation into circuit simulation tools to support broader application development.


  • A Direct Method for Series Resistance Extraction in Organic Thin-Film Transistors

    by Amer Zaibi, Lina Kadura, Benjamin Iñiguez

    This work presents the application of a direct method for determining the source and drain series resistances (Rds) of organic thin-film transistors (OTFTs). The approach uses experimentally measured currentvoltage (IV) data and direct techniques for extracting key parameters. With this method, the consistent values for the series resistances that depend on gate voltage are obtained. Using this method, we can extract a common value of Rds to be used across different channel lengths. In our case, we tested this approach with three different channel lengths 5, 10, and 20 μm. We then applied this Rds value in the unified model extraction method (UMEM) compact model to fit both the transfer and output characteristics of our devices, achieving good agreement with measured data. This consistency in Rds extraction simplifies modeling and confirms the method’s robustness across different device geometries.


  • Physical Compact Model for Source-Gated Transistors for DC Application

    by Patryk Golec, Eva Bestelink, Radu A. Sporea, Benjamin Iñiguez

    We present the first physical compact model for an amorphous silicon source-gated transistor (SGT) with variable Schottky barrier height. The previously published empirical compact model and TCAD model of an SGT are used to identify dominant effects present. The compact model is then validated on real device measurements. The compact model aims to operate under common conditions and typically desirable regimes of operation for an SGT, such as the flat saturation regime occurring at a particularly low saturation voltage. The dominant injection mechanisms occur through thermionic and thermionic field emission, which are the contact effects present in an SGT. Thermionic emission tends to be dominant under most common conditions. The model is suitably accurate to be used as a representation of an SGT in a SPICE simulation. This can be seen as a first step toward analog circuit design with SGTs as compact models enable circuit designers to utilize new and unique devices.


  • A Unified Physics-Based Model for analyzing Hysteresis in Organic Thin Film Transistors

    by Amer Zaibi, A. M. Abdelmoneam, Patryk Golec, M. Estrada, A. Cerdeira, Lina Kadura, Laurie E. Calvet, Benjamin Iñiguez

    Hysteresis effects are often observed in voltage sweeps of organic field-effect transistors (OTFTs), resulting in threshold voltage shifts. While commonly associated with bias stress effects, the origins of hysteresis are diverse, with limited scientific studies providing a complete understanding of hysteresis in OFETs. Here we use a physics-based model for Organic Thin Film to investigate hysteresis effects in OTFTS. Unlike many previous studies, our model allows for a more in-depth investigation of this phenomenon. Our method demonstrates a strong agreement between measurement and the model using parameter values obtained through the extraction process given by the Unified Modelling and Extraction Method (UMEM). In our quantitative analysis, we examined the hysteresis behavior in transistors of different channel lengths. For a transistor with a channel length of 200 μm, the threshold voltage shift (ΔV T ) between backward and forward sweeps was 0.15 V. In contrast, for a transistor with a channel length of 5 μm, ΔV T was observed to be 0.3 V. Additionally, we observed that the characteristics temperature ( T 0 ) of the Density of States (DOS) increases, which impacts the trapping behavior


  • Open Access

    Roadmap for Schottky barrier transistors

    by Eva Bestelink, Giulio Galderisi, Patryk Golec, Yi Han, Benjamin Iniguez, Alexander Kloes, Joachim Knoch, Hiroyuki Matsui, Thomas Mikolajick, Kham M Niang, et al.

    In this roadmap we consider the status and challenges of technologies that use the properties of a rectifying metal-semiconductor interface, known as a Schottky barrier (SB), as an asset for device functionality. We discuss source gated transistors, which allow for excellent electronic characteristics for low power, low frequency environmentally friendly circuits. We also consider reconfigurable field effect transistors. In such devices, two or more independent gate electrodes can be used to program different functionalities at the device level, enabling ultra-secure embedded devices. Both types of transistors can be used for neuromorphic systems, notably by combining them with ferroelectric SB transistors which enable a large number of analog states. At cryogenic temperatures SB transistors can advantageously serve for the control electronics in quantum computing devices. If the source/drain of the metallic contact becomes superconducting, Josephson junctions with a tunable phase can be realized for scalable quantum computing applications. Developing applications using SB devices requires physics-based and compact models that can be used for circuit simulations, which are also discussed. The roadmap reveals that the main challenges for these technologies are improving processing, access to industrial technologies and modeling tools for circuit simulations.


    • 12 November 2024
    • Published by HAL in HAL
    Open Access

    Roadmap for Schottky barrier Transistors

    by Eva Bestelink, Giulio Galderisi, Patryk Golec, Yi Han, Benjamin Iniguez, Alexander Kloes, Joachim Knoch, Hiroyuki Matsui, Thomas Mikolajick, Kham Niang, et al.

    In this roadmap we consider the status and challenges of technologies that use the properties of a rectifying metal-semiconductor interface, known as a Schottky barrier, as an asset for device functionality. We discuss source gated transistors, which allow for excellent electronic characteristics for low power, low frequency environmentally friendly circuits. Also considered are reconfigurable field effect transistors, where the presence of two or more independent gate electrodes can be used to program different functionalities at the device level, providing an important option for ultra-secure embedded devices. Both types of transistors can be used for neuromorphic systems, notably by combining them with ferroelectric Schottky barrier transistors with an increased number analog states. At cryogenic temperatures SB transistors can advantageously serve for the control electronics in quantum computing devices. If the source/drain of the metallic contact becomes superconducting, Josephson junctions with a tunable phase can be realized for scalable quantum computing applications. Developing applications using Schottky barrier devices require physics-based and compact models that can be used for circuit simulations. The roadmap reveals that the main challenges for these technologies are improving processing, access to industrial technologies and modeling tools for circuit simulations.

  • Gaussian DOS Charge-Based DC Compact Modeling of High-Speed Organic Transistors

    by Elahe Rastegar Pashaki, Jakob Leise, Benjamin Iniguez, Hans Kleemann, Alexander Kloes, Ghader Darbandy

    In this article, the Gaussian density of states (DOSs) in organic semiconductors is taken into account in order to derive a charge-based compact model for high-speed organic transistors. This physics-based analytical solution provides a continues current equation from below to above threshold regions with considering the deep and shallow trap densities in the organic material, power-law mobility model, and contact resistances effects. The proposed model is verified with the experimental data of our fabricated organic permeable base transistor (OPBT) and shows good agreement with the measurements. OPBTs are of great interest as vertical organic transistors and stand out due to their excellent performance, such as low-voltage operation and high transit frequency.