Jianxun Zhu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Jianxun Zhu has a total of 25 co-authors. Here are the top co-authors by number of shared publications:
- Peter R. Kinget
Department of Electrical Engineering, Columbia University, New York, NY, USA
4 shared publications - Binbin Li
General Motors, Warren, MI, USA
1 shared publication - Chengshun Xu
Beijing University of Technology
1 shared publication - Gil Zussman
Columbia University, New York, USA
1 shared publication - Ioannis Kymissis
Department of Electrical Engineering, Columbia University, New York, USA
1 shared publication John Sarik
Electrical Engineering, Columbia University, New York, NY, 10027
1 shared publication
Latest Publications
- 21 November 2022
- Published by Taylor & Francis
- p. 369-375
Risk assessment of building damage caused by undercrossing shield metro construction using Bayesian network
Undercrossing shield tunnels often cause damage to aboveground structures, which are high-risk projects. Reasonable risk assessment is crucial for construction decision-makers and safety managers. In this paper, the risk of building damage caused by an undercrossing Beijing shield metro is assessed using the Bayesian network. The noisy-or model and the Noisy-Max model are used to establish the Bayesian network model. The model is applied to predict the risk probability of building damage induced by the undercrossing shield metro by forwarding reasoning. The results are prepared with the statistical risk probability derived by building settlement monitoring value, which verifies the effectiveness of the model. The key risk factors affecting building safety were diagnosed and analyzed, which can provide a reference for project risk management.
- 21 November 2022
- Published by Taylor & Francis
- p. 369-375
Risk assessment of building damage caused by undercrossing shield metro construction using Bayesian network
Undercrossing shield tunnels often cause damage to aboveground structures, which are high-risk projects. Reasonable risk assessment is crucial for construction decision-makers and safety managers. In this paper, the risk of building damage caused by an undercrossing Beijing shield metro is assessed using the Bayesian network. The noisy-or model and the Noisy-Max model are used to establish the Bayesian network model. The model is applied to predict the risk probability of building damage induced by the undercrossing shield metro by forwarding reasoning. The results are prepared with the statistical risk probability derived by building settlement monitoring value, which verifies the effectiveness of the model. The key risk factors affecting building safety were diagnosed and analyzed, which can provide a reference for project risk management.
- 7 March 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Solid-State Circuits
- Vol. 53 (6) , 1577-1591
A Reconfigurable Architecture Using a Flexible LO Modulator to Unify High-Sensitivity Signal Reception and Compressed-Sampling Wideband Signal Detection
The direct RF-to-information converter unifies high-sensitivity signal reception and compressed-sampling (CS) wideband signal detection into a rapidly reconfigurable and easily scalable architecture occupying 0.56 mm² in 65-nm CMOS. In reception mode, the DRF2IC RF frontend consumes 46.5 mW from 1.15 V and delivers 40-MHz RF bandwidth, 41.5-dB conversion gain, 3.6-dB noise figure, and -2 dBm B1dB. In CS wideband detection mode, 66-dB operational dynamic range, 40-dB instantaneous dynamic range, and 1.43-GHz instantaneous bandwidth are demonstrated, and six interferers each 10 MHz wide scattered over a 1.27-GHz span are detected in 1.2 μs consuming 58.5 mW.
- 7 March 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Solid-State Circuits
- Vol. 53 (6) , 1577-1591
A Reconfigurable Architecture Using a Flexible LO Modulator to Unify High-Sensitivity Signal Reception and Compressed-Sampling Wideband Signal Detection
The direct RF-to-information converter unifies high-sensitivity signal reception and compressed-sampling (CS) wideband signal detection into a rapidly reconfigurable and easily scalable architecture occupying 0.56 mm² in 65-nm CMOS. In reception mode, the DRF2IC RF frontend consumes 46.5 mW from 1.15 V and delivers 40-MHz RF bandwidth, 41.5-dB conversion gain, 3.6-dB noise figure, and -2 dBm B1dB. In CS wideband detection mode, 66-dB operational dynamic range, 40-dB instantaneous dynamic range, and 1.43-GHz instantaneous bandwidth are demonstrated, and six interferers each 10 MHz wide scattered over a 1.27-GHz span are detected in 1.2 μs consuming 58.5 mW.
- 21 December 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Solid-State Circuits
- Vol. 53 (2) , 327-339
A Blocker-Tolerant RF Front End With Harmonic-Rejecting $N$ -Path FilterAn RF front end with a harmonic-rejecting$N$ -path filter is presented. It features tunable narrow-band filtering and high attenuation at the third- and fifth-order local oscillator (LO) harmonics at the LNA output, which improves the blocker tolerance at LO harmonics. The 0.2–1 GHz RF front end is implemented in a 65-nm CMOS process. The blocker 1-dB compression point (B1dB) is −2.4 dBm at a 20-MHz offset, and remains high at the third- and fifth-order LO harmonics. The reverse isolation of the LNA helps keep the LO emission below −90 dBm. A two-stage harmonic rejection approach offers a >51 dB harmonic-rejection ratio at the third- and fifth-order LO harmonics without calibration.- 21 December 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Solid-State Circuits
- Vol. 53 (2) , 327-339
A Blocker-Tolerant RF Front End With Harmonic-Rejecting $N$ -Path FilterAn RF front end with a harmonic-rejecting$N$ -path filter is presented. It features tunable narrow-band filtering and high attenuation at the third- and fifth-order local oscillator (LO) harmonics at the LNA output, which improves the blocker tolerance at LO harmonics. The 0.2–1 GHz RF front end is implemented in a 65-nm CMOS process. The blocker 1-dB compression point (B1dB) is −2.4 dBm at a 20-MHz offset, and remains high at the third- and fifth-order LO harmonics. The reverse isolation of the LNA helps keep the LO emission below −90 dBm. A two-stage harmonic rejection approach offers a >51 dB harmonic-rejection ratio at the third- and fifth-order LO harmonics without calibration.- 25 August 2016
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Solid-State Circuits
- Vol. 51 (12) , 3137-3151
Frequency-Translational Quadrature-Hybrid Receivers for Very-Low-Noise, Frequency-Agile, Scalable Inter-Band Carrier Aggregation
A frequency-translational quadrature-hybrid receiver is proposed that achieves wideband input matching for a reflective low-noise-amplifier input impedance and enables the realization of wideband, concurrent receivers. Frequency-agile, inter-band carrier aggregation is realized from a single antenna through RF signal sharing and quadrature-hybrid-coupler daisy chaining. A 1.1 V 65 nm CMOS prototype chip is demonstrated that has a sub-1 dB minimum NF, a 12 MHz to 70 MHz RF bandwidth, a +8 dBm II P 3 , and a -15 dBm B 1dB and consumes <;58 mW per channel. The prototypes have been integrated into a demonstration system that features 4-band inter-band carrier aggregation with modulated carriers placed between 0.69 and 2.1 GHz and received with an EVM <;2.8%.
- 25 August 2016
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Solid-State Circuits
- Vol. 51 (12) , 3137-3151
Frequency-Translational Quadrature-Hybrid Receivers for Very-Low-Noise, Frequency-Agile, Scalable Inter-Band Carrier Aggregation
A frequency-translational quadrature-hybrid receiver is proposed that achieves wideband input matching for a reflective low-noise-amplifier input impedance and enables the realization of wideband, concurrent receivers. Frequency-agile, inter-band carrier aggregation is realized from a single antenna through RF signal sharing and quadrature-hybrid-coupler daisy chaining. A 1.1 V 65 nm CMOS prototype chip is demonstrated that has a sub-1 dB minimum NF, a 12 MHz to 70 MHz RF bandwidth, a +8 dBm II P 3 , and a -15 dBm B 1dB and consumes <;58 mW per channel. The prototypes have been integrated into a demonstration system that features 4-band inter-band carrier aggregation with modulated carriers placed between 0.69 and 2.1 GHz and received with an EVM <;2.8%.
- 1 April 2013
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 31-32
An adaptive testbed of energy harvesting active networked tags (EnHANTS) prototypes
EnHANTs will be small, flexible, and self-powered devices that will be attached to objects that are traditionally not networked (books, furniture, clothing), thereby enabling various tracking applications (more details are available at enhants.ee.columbia.edu). We demonstrate a small testbed of En- HANTs prototypes. The prototypes communicate using in-house-developed ultra-wide-band impulse radio (UWB-IR) transceivers. They create a multihop network and adapt the topology and communication patterns to the light energy harvested by the solar cells. The testbed includes a unique software-based light control system which enables controlled experiments. This demonstration accompanies [3].
- 1 April 2013
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 31-32
An adaptive testbed of energy harvesting active networked tags (EnHANTS) prototypes
EnHANTs will be small, flexible, and self-powered devices that will be attached to objects that are traditionally not networked (books, furniture, clothing), thereby enabling various tracking applications (more details are available at enhants.ee.columbia.edu). We demonstrate a small testbed of En- HANTs prototypes. The prototypes communicate using in-house-developed ultra-wide-band impulse radio (UWB-IR) transceivers. They create a multihop network and adapt the topology and communication patterns to the light energy harvested by the solar cells. The testbed includes a unique software-based light control system which enables controlled experiments. This demonstration accompanies [3].
- Open Access
- 1 January 2013
- Published by Asian Publication Corporation in Asian Journal of Chemistry
- Vol. 25 (1) , 23-26
Mechanical Properties and Microstructure of 3D 6-Directional Braided SiO2f/SiO2 Composites by Silicasol-Infiltration-Sintering Method
- 1 January 2013
- Published by Asian Publication Corporation in Asian Journal of Chemistry
- Vol. 25 (1) , 23-26
Open AccessMechanical Properties and Microstructure of 3D 6-Directional Braided SiO2f/SiO2 Composites by Silicasol-Infiltration-Sintering Method