MHMohamed Yousry Hassaan

Mohamed Yousry Hassaan

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Mohamed Yousry Hassaan has a total of 112 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Role of TeO2 in the structural, mechanical, and dielectric behavior of (60-x) B2O3-(5+x) TeO2-25Na2O-10Bi2O3 glass-ceramic system

    by Mohammod Hafizur Rahman, A.G. Darwish, Abdelrahman G. Gadallah, M.Y. Hassaan, M.A. Farag

  • Influence of ZrO2 additions on the structural and optical properties of Na-B-Te Glass for Optoelectronic Applications

    by M. Y. Hassaan, A.A Bendary, Mohsen H. Abdel-Wahed, M.R. Atta, A. S. Abdel-Moety

    This study is to estimate the effect of the replacement of TeO2 by ZrO2 on the sodium borotellurite glass. Five samples have been prepared according the chemical formula; 30 mol % Na2CO3- 50 mol % B2O3- (20-x) mol% TeO2- x% ZrO2 where x =0, 2, 4, 6, and 8mol% . The batches were melted using an electric muffle furnace at a temperature of 1200ºC for one hr. Each melt was poured on a brass plate at RT and another brass plate was put on the sample melt to obtain thin plate glass sample. Archimedes principal was used to determine the density of each glass sample. The molar volume of each glass sample was calculated. The results of experimental density and the calculated molar volume showed that the samples density decreased, while the molar volume increased with increasing ZrO2 content. The five glass samples were measured by XRD to confirm their amorphous structure. The FTIR spectra of the studied glass samples were obtained at RT in the range from 4000 to 400 cm-1. The FTIR spectra showed that as Zr ions were increased the BO3 changed to BO4 then the BO4 and the nonbridging oxygen increased. The transmission spectra using UV, Vis. Spectra in the range of 190-1100 nm were measured, then optical parameters could be obtained. The optical measurements results that obtained from UV and visible region and the optical properties that calculated using different equations demonstrated the ability of using these samples for different optoelectronic and energy storage applications.


  • Open Access

    Structural, Electrical, and Electrochemical Properties of a Na2O-V2O5 Ceramic Nanocomposite as an Active Cathode Material for a Na-Ion Battery

    by Ahmed Ibrahim, Satoshi Watanabe, Marta Razum, Luka Pavić, Zoltán Homonnay, Ernő Kuzmann, Mohamed Yousry Hassaan, Shiro Kubuki

    In this paper, a relationship between the structure and the electrical properties of a nanocrystalline composite ceramics xNa2O·(100 − x)V2O5 with ‘x’ of 5, 15, 25, 35, and 45 mol%, abbreviated as xNV, was investigated by X-ray diffractometry (XRD), X-ray absorption spectroscopy (XAS), Cyclic Voltammetry (CV), Electrochemical impedance spectroscopy (EIS), and cathode active performance in Na-ion battery (SIB). For the expected sodium vanadium bronzes (NaxV2O5) precipitation, the preparation of xNV was performed by keeping the system in the molten state at 1200 °C for one hour, followed by a temperature decrease in the electric furnace to room temperature at a cooling rate of 10 °C min−1. XRD patterns of the 15NV ceramic exhibited the formation of Na0.33V2O5 and NaV3O8 crystalline phases. Moreover, the V K-edge XANES showed that the absorption edge energy of ceramics 15NV recorded at 5479 eV is smaller than that of V2O5 at 5481 eV, evidently indicating a partial reduction from V5+ to V4+ due to the precipitation of Na0.33V2O5. In the cyclic voltammetry, reduction peaks of 15NV were observed at 1.12, 1.78 V, and 2.69 V, while the oxidation peak showed up only at 2.36 V. The values of the reduction peaks were related to the NaV3O8 crystalline phase. Moreover, the diffusion coefficient of Na+ (DNa+) gradually decreased from 8.28 × 10−11 cm2 s−1 to 1.23 × 10−12 cm2 s−1 with increasing Na2O content (x) from 5 to 45 mol%. In the evaluation of the active cathode performance of xNV in SIB, ceramics 15NV showed the highest discharge capacity 203 mAh g−1 at a current rate of 50 mA g−1. In the wider voltage range from 0.8 to 3.6 V, the capacity retention was maintained at 50% after 30 cycles, while it was significantly improved to 90% in the narrower voltage range from 1.8 to 4.0 V, although the initial capacity decreased to 56 mAh g−1. It is concluded that the precipitation of the Na0.33V2O5 phase improved the structural and electrical properties of 15NV, which provides a high capacity for the Na-ion battery when incorporated as a cathode active material.


  • Open Access

    Investigation of Role of Tungsten Ions on Structural and Optical Properties of Sodium Borosilicate Germanate Glass for Optoelectronic Applications

    by Mohamed Mundher, Mohammed A. Farag, Ayman A. Bendary, Mohamed Y. Hassaan, Abu Bakr El-Bediwi

    In the current work, the role of tungsten ions on the structural and optical properties of sodium borosilicate germinate glass with the composition [70 Na 2B4O7e15 SiO2e(15-x) (Ge2O3) e x (WO3) while, x ¼ 0,2,4, 6, 8 mol %] were studied. Fast quenching method were used to prepare the glass samples. Experimental and empirical density results confirm the amorphous nature of the prepared samples. Fourier transform infrared, FTIR, results showed N4 decreases as WO3 increases. These results suggest that the decreasing in non-bridging oxygen (NBO), back conversion BO4 to BO3, occur by the increase of WO3. Optical band gap show decreases from 3.3 down to 1.89 eV with increase in refractive index from 1.98 up to 2.35 these results indicate promising application for the prepared glasses in electric and optoelectronic applications.


  • Open Access

    Influence Of Cr+3 Ions Substitution On The Magnetic And Optical Properties Of Ni-Zn-Cr Ferrite/Pva/ Rhodamine Dye Nanocomposite Film

    by Ied M. Mnawer, Osama M. Hemeda, Mohamed Y. Hassaan, Ahmed S. Abdel – Moety, Mohamed M. Salem

    Nanocrystalline nickel-zinc substituted chromium ferrites having the chemical formula Ni0.6Zn0.4CrxFe2-xO4, i.e., NZCrF (where x= 0.0, 0.2, 0.4, 0.6, 0.8 and 1.0 wt.%) have been synthesized by flash auto combustion method. Consequently, preparation and characterization of Ni0.6 Zn0.4Cr0.6 Fe1.4O4 doped Polyvinyl alcohol (PVA)/Rhodamine dye nanocomposites using solvent casting technique have been reported. The X-ray diffraction (XRD) and Fourier-transform infrared spectroscopy (FTIR) studies confirm polymer nanocomposites' formation through the interaction between the nanoparticles and the polymer. Transmission electron microscope (TEM) and scanning electron microscope (SEM) images have investigated surface morphology and particle orientation. The average grain size is estimated to be approximately 51 nm. Images taken with TEM reveal that the composite Ni0.6Zn0.4CrxFe2-xO4/PVA morphology is highly agglomerated, suggesting magnetic nanoparticles are encased in the PVA polymer chains. This may be due to the interaction between the ferrite's oxygen atoms and the PVA's polymer chains. The saturation magnetization (Ms), remnant magnetization (Mr), and coercivity (Hc) measured by VSM have been studied. The modification of PVA/Rhodamine dye nanocomposites with Ni0.6Zn0.4Cr0.6Fe1.4O4 reveals their potential for usage in luminescence applications due to an improvement in the composites' optical characteristics.


  • Open Access

    Mechanical Properties Study of Borosilicate Glass Loaded with Vanadium and Cobalt by Nanoindentation Technique

    by Asmaa S. El-Deeb, Eman O. Taha, Marwa M. Abdel Kader, Hamdy M. Naguib, Mohamed Y. Hassaan

    The nanoindentation test was used to investigate the mechanical properties of borosilicate glass with a composition (mol%) of 40 Na2B4O7-40 SiO2-(20-x) V2O5-x Co2O3, with x = 0, 1, 3, and 5 mol% for samples A, B, C, and D, respectively. Samples were prepared using the melt quenching technique at 1100 °C. A load–displacement curve was plotted and used to extract select mechanical properties of the glass samples. The creep deformation behavior of the glass composition was studied. The maximum creep rate was observed for the sample that contained the highest vanadium oxide content, and the creep rate decreased with a decrease in the vanadium oxide content in the glass samples. The hardness and reduced modulus of elasticity were obtained. The Maxwell–Voigt model was applied to investigate the relaxation kinetics and deformation of the bulk glass.


  • Influence of Cr+3 ions substitution on the magnetic and optical properties of NiZnCr Ferrite/PVA/Rhodamine dye nanocomposite film

    by Ied M. Mnawer, Osama M. Hemeda, Mohamed Y. Hassaan, Ahmed S. Abdel-Moety, Mohamed M. Salem

    Nanocrystalline nickel-zinc substituted chromium ferrites having the chemical formula Ni0.6Zn0.4CrxFe2-xO4, i.e., NZCrF (where x= 0.0, 0.2, 0.4, 0.6, 0.8 and 1.0 wt.%) have been synthesized by flash auto combustion method. Consequently, preparation and characterization of Ni0.6 Zn0.4Cr0.6 Fe1.4O­4 doped Polyvinyl alcohol (PVA)/Rhodamine dye nanocomposites using solvent casting technique have been reported. The X-ray diffraction (XRD) and Fourier-transform infrared spectroscopy (FTIR) studies confirm polymer nanocomposites' formation through the interaction between the nanoparticles and the polymer. Transmission electron microscope (TEM) and scanning electron microscope (SEM) images have investigated surface morphology and particle orientation. The average grain size is estimated to be approximately 51 nm. Images taken with TEM reveal that the composite Ni0.6Zn0.4CrxFe2-xO­4/PVA morphology is highly agglomerated, suggesting magnetic nanoparticles are encased in the PVA polymer chains. This may be due to the interaction between the ferrite's oxygen atoms and the PVA's polymer chains. The saturation magnetization (Ms), remnant magnetization (Mr), and coercivity (Hc) measured by VSM have been studied. The modification of PVA/Rhodamine dye nanocomposites with Ni0.6Zn0.4Cr0.6Fe1.4O4 reveals their potential for usage in luminescence applications due to an improvement in the composites' optical characteristics.

  • Open Access

    Fabrication and Characterization of Nanostructured Rock Wool as a Novel Material for Efficient Water-Splitting Application

    by Sahar A. El-Gharbawy, Mawaheb Al-Dossari, Mohamed Zayed, Heba A. Saudi, Mohamed Y. Hassaan, Nada Alfryyan, Mohamed Shaban

    Rock wool (RW) nanostructures of various sizes and morphologies were prepared using a combination of ball-mill and hydrothermal techniques, followed by an annealing process. Different tools were used to explore the morphologies, structures, chemical compositions and optical characteristics of the samples. The effect of initial particle size on the characteristics and photoelectrochemical performance of RW samples generated hydrothermally was investigated. As the starting particle size of ball-milled natural RW rises, the crystallite size of hydrothermally formed samples drops from 70.1 to 31.7 nm. Starting with larger ball-milled particle sizes, the nanoparticles consolidate and seamlessly combine to form a continuous surface with scattered spherical nanopores. Water splitting was used to generate photoelectrochemical hydrogen using the samples as photocatalysts. The number of hydrogen moles and conversion efficiencies were determined using amperometry and voltammetry experiments. When the monochromatic wavelength of light was increased from 307 to 460 nm for the manufactured RW>0.3 photocatalyst, the photocurrent density values decreased from 0.25 to 0.20 mA/mg. At 307 nm and +1 V, the value of the incoming photon-to-current efficiency was ~9.77%. Due to the stimulation of the H+ ion rate under the temperature impact, the Jph value increased by a factor of 5 when the temperature rose from 40 to 75 °C. As a result of this research, for the first time, a low-cost photoelectrochemical catalytic material is highlighted for effective hydrogen production from water splitting.