Saadah Abdul Rahman
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Saadah Abdul Rahman has a total of 140 co-authors. Here are the top co-authors by number of shared publications:
- Boon Tong Goh
Low Dimensional Materials Research Center, Department of Physics, Faculty of Science, Universiti Malaya, Kuala Lumpur, Malaysia
32 shared publications Muhamad Rasat Muhamad
Chancellery Office, Multimedia University, Jalan Multimedia, 63100 Cyberjaya, Selangor, Malaysia
21 shared publications- Chang Fu Dee
National yang Ming Chiao Tung University
15 shared publications - Richard Ritikos
Low Dimensional Materials Research Centre, Department of Physics, Faculty of Science, University of Malaya, Kuala Lumpur, Malaysia
15 shared publications - Su Kong Chong
Low Dimensional Materials Research Centre, Department of Physics, University of Malaya, 50603 Kuala Lumpur, Malaysia
13 shared publications Zarina Aspanut
Low Dimensional Materials Research Centre, Department of Physics, Faculty of Science, University of Malaya, 50603 Kuala Lumpur, Malaysia
12 shared publications
Latest Publications
- 1 September 2019
- Published by Elsevier in Thin Solid Films
- Vol. 685, 335-342
Growth of plasma-enhanced chemical vapour deposition and hot filament plasma-enhanced chemical vapour deposition transfer-free graphene using a nickel catalyst
- 1 September 2019
- Published by Elsevier in Thin Solid Films
- Vol. 685, 335-342
Growth of plasma-enhanced chemical vapour deposition and hot filament plasma-enhanced chemical vapour deposition transfer-free graphene using a nickel catalyst
- Open Access
- 14 November 2017
- Published by Wiley in Journal of Nanomaterials
- Vol. 2017, 1-11
SnO2 Nanoparticles Decorated 2D Wavy Hierarchical Carbon Nanowalls with Enhanced Photoelectrochemical Performance
Two-dimensional carbon nanowall (2D-CNW) structures were prepared by hot wire assisted plasma enhanced chemical vapor deposition (hw-PECVD) system on silicon substrates. Controlled variations in the film structure were observed with increase in applied rf power during deposition which has been established to increase the rate of dissociation of precursor gases. The structural changes resulted in the formation of wavy-like features on the 2D-CNW, thus further enhancing the surface area of the nanostructures. The FESEM results confirmed the morphology transformation and conclusively showed the evolution of the 2D-CNW novel structures while Raman results revealed increase in ratio indicating increase in the presence of disordered domains due to the presence of open edges on the 2D-CNW structures. Subsequently, the best 2D-CNW based on the morphology and structural properties was functionalized with tin oxide (SnO2) nanoparticles and used as a working electrode in a photoelectrochemical (PEC) measurement system. Intriguingly, the SnO2 functionalized 2D-CNW showed enhancement in both Mott-Schottky profiles and LSV properties which suggested that these hierarchical networks showed promising potential application as effective charge-trapping medium in PEC systems.- 14 November 2017
- Published by Wiley in Journal of Nanomaterials
- Vol. 2017, 1-11
Open AccessSnO2 Nanoparticles Decorated 2D Wavy Hierarchical Carbon Nanowalls with Enhanced Photoelectrochemical Performance
Two-dimensional carbon nanowall (2D-CNW) structures were prepared by hot wire assisted plasma enhanced chemical vapor deposition (hw-PECVD) system on silicon substrates. Controlled variations in the film structure were observed with increase in applied rf power during deposition which has been established to increase the rate of dissociation of precursor gases. The structural changes resulted in the formation of wavy-like features on the 2D-CNW, thus further enhancing the surface area of the nanostructures. The FESEM results confirmed the morphology transformation and conclusively showed the evolution of the 2D-CNW novel structures while Raman results revealed increase in ratio indicating increase in the presence of disordered domains due to the presence of open edges on the 2D-CNW structures. Subsequently, the best 2D-CNW based on the morphology and structural properties was functionalized with tin oxide (SnO2) nanoparticles and used as a working electrode in a photoelectrochemical (PEC) measurement system. Intriguingly, the SnO2 functionalized 2D-CNW showed enhancement in both Mott-Schottky profiles and LSV properties which suggested that these hierarchical networks showed promising potential application as effective charge-trapping medium in PEC systems. - 1 October 2017
- Published by Elsevier in Materials Characterization
- Vol. 132, 187-198
Growth of high density NiSi/SiC core-shell nanowires by hot-wire chemical vapour deposition for electrochemical applications
- 1 October 2017
- Published by Elsevier in Materials Characterization
- Vol. 132, 187-198
Growth of high density NiSi/SiC core-shell nanowires by hot-wire chemical vapour deposition for electrochemical applications
- 1 June 2017
- Published by Elsevier in Materials Characterization
- Vol. 128, 134-141
Understanding the effect of plasmonic enhancement on photocatalytic activity of TiO 2 nanotube arrays
- 1 June 2017
- Published by Elsevier in Materials Characterization
- Vol. 128, 134-141
Understanding the effect of plasmonic enhancement on photocatalytic activity of TiO 2 nanotube arrays
- 1 June 2017
- Published by Elsevier in Journal of Alloys and Compounds
- Vol. 706, 629-636
Correlation between indium content in monolithic InGaN/GaN multi quantum well structures on photoelectrochemical activity for water splitting
- 1 June 2017
- Published by Elsevier in Journal of Alloys and Compounds
- Vol. 706, 629-636
Correlation between indium content in monolithic InGaN/GaN multi quantum well structures on photoelectrochemical activity for water splitting
- 6 February 2017
- Published by Springer Nature in Journal of Materials Science
- Vol. 52 (11) , 6280-6290
Nitrogen-doped multiwalled carbon nanotubes decorated with copper(I) oxide nanoparticles with enhanced capacitive properties
- 6 February 2017
- Published by Springer Nature in Journal of Materials Science
- Vol. 52 (11) , 6280-6290
Nitrogen-doped multiwalled carbon nanotubes decorated with copper(I) oxide nanoparticles with enhanced capacitive properties
- Open Access
Investigations on the Role of N2:(N2 + CH4) Ratio on the Growth of Hydrophobic Nanostructured Hydrogenated Carbon Nitride Thin Films by Plasma Enhanced Chemical Vapor Deposition at Low Temperature
Nanostructured hydrogenated carbon nitride (CNx:H) thin films were synthesized on a crystal silicon substrate at low deposition temperature by radio-frequency plasma-enhanced chemical vapor deposition (PECVD). Methane and nitrogen were the precursor gases used in this deposition process. The effects of N2 to the total gas flow rate ratio on the formation of CNx:H nanostructures were investigated. Field-emission scanning electron microscopy (FESEM), Auger electron spectroscopy (AES), Raman scattering, and Fourier transform of infrared spectroscopies (FTIR) were used to characterize the films. The atomic nitrogen to carbon ratio and sp2 bonds in the film structure showed a strong influence on its growth rate, and its overall structure is strongly influenced by even small changes in the N2:(N2 + CH4) ratio. The formation of fibrous CNx:H nanorod structures occurs at ratios of 0.7 and 0.75, which also shows improved surface hydrophobic characteristic. Analysis showed that significant presence of isonitrile bonds in a more ordered film structure were important criteria contributing to the formation of vertically-aligned nanorods. The hydrophobicity of the CNx:H surface improved with the enhancement in the vertical alignment and uniformity in the distribution of the fibrous nanorod structures.
Open AccessInvestigations on the Role of N2:(N2 + CH4) Ratio on the Growth of Hydrophobic Nanostructured Hydrogenated Carbon Nitride Thin Films by Plasma Enhanced Chemical Vapor Deposition at Low Temperature
Nanostructured hydrogenated carbon nitride (CNx:H) thin films were synthesized on a crystal silicon substrate at low deposition temperature by radio-frequency plasma-enhanced chemical vapor deposition (PECVD). Methane and nitrogen were the precursor gases used in this deposition process. The effects of N2 to the total gas flow rate ratio on the formation of CNx:H nanostructures were investigated. Field-emission scanning electron microscopy (FESEM), Auger electron spectroscopy (AES), Raman scattering, and Fourier transform of infrared spectroscopies (FTIR) were used to characterize the films. The atomic nitrogen to carbon ratio and sp2 bonds in the film structure showed a strong influence on its growth rate, and its overall structure is strongly influenced by even small changes in the N2:(N2 + CH4) ratio. The formation of fibrous CNx:H nanorod structures occurs at ratios of 0.7 and 0.75, which also shows improved surface hydrophobic characteristic. Analysis showed that significant presence of isonitrile bonds in a more ordered film structure were important criteria contributing to the formation of vertically-aligned nanorods. The hydrophobicity of the CNx:H surface improved with the enhancement in the vertical alignment and uniformity in the distribution of the fibrous nanorod structures.
- 11 May 2016
- Published by Royal Society of Chemistry (RSC) in CrystEngComm
- Vol. 18 (25) , 4720-4732
Structural- and optical-properties analysis of single crystalline hematite (α-Fe2O3) nanocubes prepared by one-pot hydrothermal approach
Time-dependent morphological evolution analysis shows high quality crystalline α-Fe2O3 nanocubes can be precisely tuned and synthesized by a facile, green, yet straightforward strategy via a hydrothermal method.
- 11 May 2016
- Published by Royal Society of Chemistry (RSC) in CrystEngComm
- Vol. 18 (25) , 4720-4732
Structural- and optical-properties analysis of single crystalline hematite (α-Fe2O3) nanocubes prepared by one-pot hydrothermal approach
Time-dependent morphological evolution analysis shows high quality crystalline α-Fe2O3 nanocubes can be precisely tuned and synthesized by a facile, green, yet straightforward strategy via a hydrothermal method.