Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Ayu Wazira Azhari has a total of 55 co-authors. Here are the top co-authors by number of shared publications:

  • Kamaruzzaman Sopian

    Mechanical Engineering Department, Universiti Teknologi Petronas, Seri Iskandar, Malaysia

    7 shared publications
  • Saleem H. Zaidi

    Solar Energy Research Institute, Universiti Kebangsaan Malaysia, Bangi, Selangor, 43650, Malaysia

    7 shared publications
  • Dewi Suriyani Che Halin

    Faculty of Chemical Engineering and Technology, Universiti Malaysia Perlis, 02600, Jalan Kangar-Arau, Perlis, Malaysia

    4 shared publications
  • Adnan Ali

    Department of Physics, Government College University Faisalabad, 38000, Punjab, Pakistan

    3 shared publications
  • M. Khairunaz

    Solar Energy Research Institute, National University of Malaysia, Bangi, Selangor, 43650, Malaysia

    3 shared publications
  • Norasikin Ahmad Ludin

    Solar Energy Research Institute (SERI), Universiti Kebangsaan Malaysia (UKM), Bangi, Selangor, Malaysia

    3 shared publications

Latest Publications

  • Open Access

    Dry desulphurisation of gas streams using KCC-1 mesoporous silica functionalised with deep eutectic solvents

    by Mohd Saiful Adli Azizman, Muhammad Adli Hanif, Naimah Ibrahim, Ayu Wazira Azhari, Wan Khairunnisa Wan Ramli, Aishah Abdul Jalil, Nurul Sahida Hassan, Fazilah Farhana Abdul Aziz, Raja Nazrul Hakim Raja Nazri

    Sulphur dioxide, a toxic gas pollutant, is mainly generated by the combustion of fossil fuels and the smelting of sulphur-bearing mineral ores. Removal of SO2 gas or desulphurisation can be accomplished in industries using a variety of processes; the most efficient is wet flue gas desulphurisation (FGD). However, wet FGD has challenges, such as the requirement for wastewater treatment, excessive water usage, and the necessity for chloride protective coating. Despite having a lesser adsorption capacity than wet FGD, dry FGD can efficiently remove SO2 from the effluent gas stream and avoid the issues associated with wet FGD, provided that the sorbents are modified and regenerable. An alternative dry desulphurisation strategy by using fibrous mesoporous silica (KCC-1) modified with deep eutectic solvents (DES), choline chloride–glycerol (DES1) and choline chloride–ethylene glycol (DES2) is studied in this paper. KCC-1 modified with DES1 is found to increase SO2 adsorption capacity to 4.83 mg g−1, which is 1.73 times greater than unmodified KCC-1 and twice higher than KCC-1 modified with DES2 attributed to the sorbent's high porosity. Increasing reaction temperature and SO2 concentration reduce the adsorption capacity to 1.73 mg g−1 and 2.73 mg g−1, respectively. The Avrami kinetic model and the Toth isotherm model best reflect SO2 adsorption on the modified KCC-1, indicating that SO2 molecules are adsorbed exothermically in multilayer adsorption on a heterogeneous surface through a combination of physical and chemical processes. The higher SO2 adsorption capacity of the modified KCC-1 suggests that choline chloride–glycerol can provide additional sites for SO2 adsorption in dry FGD technology.


  • Open Access

    Mixed cations tin-germanium perovskite: A promising approach for enhanced solar cell applications

    by Mohd Saiful Adli Azizman, Ayu Wazira Azhari, Naimah Ibrahim, Dewi Suriyani Che Halin, Suhaila Sepeai, Norasikin Ahmad Ludin, Mohammad Nuzaihan Md Nor, Li Ngee Ho


  • Open Access

    Numerical Simulation of Lead-Free Tin and Germanium Based All Perovskite Tandem Solar Cell

    by Rae-Ann Lim Jia En, Ayu Wazira Azhari, Dewi Suriyani Che Halin, Suhaila Sepeai, Norasikin Ahmad Ludin

    The ability to customize the materials bandgaps makes perovskite solar cells a promising candidate for hybrid-tandem applications. This allows them to effectively utilize parts of the solar spectrum that silicon-based solar cells cannot efficiently capture, resulting in higher absorption coefficients. However, there is a lack of research on lead-free all-perovskite tandem solar cells, and secondary data on materials is limited. One of the main challenges in previous studies is the high cost and solid structure of traditional silicon-based solar cells, which require significant storage space. Additionally, lead-based perovskite solar cells pose environmental concerns due to their water solubility and potential harmful effects upon consumption. To address these issues, thin-film perovskite solar cells with liquid solvents are employed in the solar cell design. Lead is replaced with germanium and tin-based perovskites, which exhibit comparable photovoltaic performance to silicon. In the present work, the OghmaNano simulation tool was utilized to conduct numerical simulation of the perovskite design. The perovskite solar cell layers were structured as follows: FTO/ZnO/MAGeI3/Spiro-OMeTAD/FAMASnGeI3/Cu2O/Au. The variables considered included optimum layer thicknesses and bandgaps, as well as the most suitable materials for the ETL and HTL, aiming to obtain the highest efficiency. Based on the simulation results, the proposed perovskite structure shows remarkable photovoltaic parameters. The Voc was measured at 0.84 V Jsc of 16.1 mA/cm2, FF of 0.825, and PCE that reached 11.12%. This project contributes to future research on materials for the ETL and HTL of lead-free, tin and germanium based APTSCs.

  • Open Access

    Metal-Doped TiO2 Thin Film as an Electron Transfer Layer for Perovskite Solar Cells: A Review

    by Dewi Suriyani Che Halin, Ayu Wazira Azhari, Mohd Arif Anuar Mohd Salleh, Nur Izzati Muhammad Nadzri, Petrica Vizureanu, Mohd Mustafa Al Bakri Abdullah, Juyana A. Wahab, Andrei Victor Sandu

    The electron transfer layer (ETL) plays a vital role in achieving high-performance perovskite solar cells (PSCs). Titanium dioxide (TiO2) is primarily utilised as the ETL since it is low-cost, chemically stable, and has the simplest thin-film preparation methods. However, TiO2 is not an ideal ETL because it leads to low conductivity, conduction band mismatch, and unfavourable electron mobility. In addition, the exposure of TiO2 to ultraviolet light induces the formation of oxygen vacancies at the surface. To overcome these issues, doping TiO2 with various metal ions is favourable to improve the surface structure properties and electronic properties. This review focuses on the bulk modification of TiO2 via doping with various metal ions concentrations to improve electrical and optical properties, charge carrier density, and interfacial electron–hole recombination, thus contributing to enhancing the power conversion efficiency (PCE) of the PSCs.


  • Open Access

    Microstructure Evolution of Ag/TiO2 Thin Film

    by Dewi Suriyani Che Halin, Kamrosni Abdul Razak, Mohd Arif Anuar Mohd Salleh, Mohd Izrul Izwan Ramli, Mohd Mustafa Al Bakri Abdullah, Ayu Wazira Azhari, Kazuhiro Nogita, Hideyuki Yasuda, Marcin Nabiałek, Jerzy J. Wysłocki

    Ag/TiO2 thin films were prepared using the sol-gel spin coating method. The microstructural growth behaviors of the prepared Ag/TiO2 thin films were elucidated using real-time synchrotron radiation imaging, its structure was determined using grazing incidence X-ray diffraction (GIXRD), its morphology was imaged using the field emission scanning electron microscopy (FESEM), and its surface topography was examined using the atomic force microscope (AFM) in contact mode. The cubical shape was detected and identified as Ag, while the anatase, TiO2 thin film resembled a porous ring-like structure. It was found that each ring that coalesced and formed channels occurred at a low annealing temperature of 280 °C. The energy dispersive X-ray (EDX) result revealed a small amount of Ag presence in the Ag/TiO2 thin films. From the in-situ synchrotron radiation imaging, it was observed that as the annealing time increased, the growth of Ag/TiO2 also increased in terms of area and the number of junctions. The growth rate of Ag/TiO2 at 600 s was 47.26 µm2/s, and after 1200 s it decreased to 11.50 µm2/s and 11.55 µm2/s at 1800 s. Prolonged annealing will further decrease the growth rate to 5.94 µm2/s, 4.12 µm2/s and 4.86 µm2/s at 2400 s, 3000 s and 3600 s, respectively.


  • Open Access

    Unmanned aerial vehicle for eutrophication process monitoring in Timah Tasoh Dam, Perlis, Malaysia

    by L Y Sheng, A W Azhari, A H Ibrahim

    Manual monitoring of the eutrophication status of water bodies such as a dam is a challenging task. Hence, drone technology can be used in assisting the monitoring work of any water bodies. This study was conducted to develop UAV-based remote sensing to derive indicators in lake water bodies. Four sampling points were chosen for testing where the Normalized Difference Vegetation Index (NDVI) and Normalized Difference Turbidity Index (NDTI) were assessed. DJI Phantom 4 Pro drone was used for the aerial data acquisition. Ex-situ data were also acquired, such as nitrate concentration (N) and phosphate concentration (P). The hyperspectral UAV images were ortho-rectified and geo-referenced in Agisoft PhotoScan software and NDVI value estimation in ArcGIS. Results show the correlation between NDVI values and N and P concentration with coefficients values of 0.7079 for P concentration and 0.7004 for N concentration, respectively. This study confirmed the applicability of remote sensing for water resource management using UAVs, characterized as a quick and easy methodology.


  • Open Access

    Tin and germanium substitution in lead free perovskite solar cell: current status and future trends

    by Ayu Wazira Azhari, Faith Shi Xin Then, Dewi Suriyani Che Halin, Suhaila Sepeai, Norasikin Ahmad Ludin

    Tin and germanium-based perovskite solar cell is gaining interest in lead-free perovskite solar cells as it is less toxic as compared to lead but possess almost all the characteristics of a perfect solar cell materials. Within 5 years, the reported efficiency of tin-based solar cells has increased from 6.4% to 9%. Although facing with stability issues as it is easily oxidised in ambient air, several studies have proven that the stability issues can be reduced. One of it is by using cesium as the ‘A’ cation. On the other hand, although studies on germanium-based perovskite solar cells are rarely conducted, promising results are shown when it is alloyed with tin producing narrower bandgaps and better stability owing to the protection of the GeO2 surface layer.


  • Application of experimental soil erosion models (USLE, RUSLE) in Jordan: A review

    by A. A. Ramzi, A. W. Ayu, A. A. Mohm, R. M. Fahmi, O. M. Ibrahim

    In most of the existing models designed for the soil erosion experiment are moderately simplistic, which consistently, have been extensively practiced in many parts of the world. In reality, within the content of this study, the practical occurrences of the Universal Soil Loss Equation (USLE) and that of the Revised Universal Soil Loss Equation (RUSLE) in Jordan were explored. This is obvious as RUSLE portrayed a product adaptation of a significantly enhanced USLE. In Jordan, various research accomplishments were made to decide the nearby values of the USLE components, demonstrating its, potential for use outside its birthplace nation. Entirely, this study found the soil experimental models stand to be mere demonstrating procedures or structures, instead of being the punctual robotic portrayals of the framework, and that perhaps; make no claim of universal comprehensiveness. In any case, with these identified weaknesses, sub-models were found to be utilized in order to give the best practical gauges of the disintegration of the sheet erosion within the Jordanian context. Most often, the spatial index circulation of the soil misfortune of the USLE is viewed as a valuable model that separate regions of high and low disintegration of the erosion potential. In this case, USLE is more generally known and utilized soil erosion condition on the planet. However, no specific model is ever, generally actualized. Although, the USLE model ended to be a promising instrument, as it gives a dynamic way to deal with foreseeing the misfortune of the soil erosion. This study, notwithstanding, perceives there is still a need to further enhanced a check of the RUSLE and USLE outcomes in Jordan. This study sees, by the virtues of hypothetical assessment and affectability in terms of the investigation performed have obviously demonstrated the benefit of the most adaptable and element structure of RUSLE against the strict exact structures of the USLE. Albeit, an exact model could be required to be utilised essentially as screening devices in coordinated reviews, arrive asset appraisals would request expanded precision in the measurement of disintegration rates in a spatial and fleeting setting. On the off chance, the necessities can be propose, for instance the Water Erosion Prediction Project (WEPP) can be required to discover expanded application in delivering quantitative appraisals of soil erosion and residue yield in Jordan.


  • Optical characterization of SixGe1x films grown on nanostructured Si substrates

    by Ayu Wazira Azhari, Adnan Ali, Kamaruzzaman Sopian, Uda Hashim, Saleem H. Zaidi

    High quality Ge and Si x Ge 1-x films grown on Si substrates are attractive for a wide range of applications in optics, optoelectronics, and high efficiency solar cells. In this study, heteroepitaxial growth of Ge on nanostructured Si surfaces has been investigated. Thermally evaporated amorphous Ge films are vacuum-deposited and crystallized by thermal annealing at 1000 °C. Scanning electron microscope (SEM), spectroscopy (RS), infrared (IR) transmission, and Raman methods are used to characterize amorphous and crystalline Ge films. SEM analysis reveals presence of dominant features including cracks, microscopic roughness, and islands. RS exhibits strong multiple peaks attributed to crystalline structures related to Si-Ge at ~ 444 cm -1 and Ge at 300 cm -1 ; narrow and stronger peaks are observed in thermally annealed films. A comparison of IR transmission measurements in 900-1700-nm spectral range shows that amorphous film absorption is significantly higher than that of crystalline films consistent with respective bandgaps. A more detailed analysis including EDX and XRD measurements will be presented at the conference.