Irving P. Herman
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Irving P. Herman has a total of 64 co-authors. Here are the top co-authors by number of shared publications:
- Brady Pan
Department of Applied Physics and Applied Mathematics, Columbia University, New York, New York 10027, United States
3 shared publications - Jiayang Hu
Department of Applied Physics and Applied Mathematics, Columbia University, New York, New York 10027, United States
3 shared publications - Datong Zhang
Worldwide Application Technology Support, ASML, San Jose, CA, USA
2 shared publications - Eui-Hyeok Yang
Stevens Institute of Technology
2 shared publications - Evan Walter Clark Spotte-Smith
Carnegie Mellon University
2 shared publications James Hone
Department of Mechanical Engineering, Columbia University, New York, New York 10027, United States
2 shared publications
Latest Publications
- Open Access
- 21 January 2022
- Published by American Association for the Advancement of Science (AAAS) in Science Advances
- Vol. 8 (3) , eabj1742
Electroluminescence of atoms in a graphene nanogap
Here, we report light emission from single atoms bridging a graphene nanogap that emit bright visible light based on fluorescence of ionized atoms. Oxygen atoms in the gap shows a peak emission wavelength of 569 nm with a full width at half maximum (FWHM) of 208 nm. The energy states produced by these ionized oxygen atoms bridging carbon atoms in the gap also produce a large negative differential resistance (NDR) in the transport across the gap with the highest peak-to-valley current ratio (PVR = 45) and highest peak current density (~90 kA/cm 2 ) ever reported in a solid-state tunneling device. While tunneling transport has been previously observed in graphene nanogaps, the bridging of ionized oxygen observed here shows a low excess current, leading to the observed PVR. On the basis of the highly reproducible light emission and NDR from these structures, we demonstrate a 65,536-pixel light-emitting nanogap array.
- 21 January 2022
- Published by American Association for the Advancement of Science (AAAS) in Science Advances
- Vol. 8 (3) , eabj1742
Open AccessElectroluminescence of atoms in a graphene nanogap
Here, we report light emission from single atoms bridging a graphene nanogap that emit bright visible light based on fluorescence of ionized atoms. Oxygen atoms in the gap shows a peak emission wavelength of 569 nm with a full width at half maximum (FWHM) of 208 nm. The energy states produced by these ionized oxygen atoms bridging carbon atoms in the gap also produce a large negative differential resistance (NDR) in the transport across the gap with the highest peak-to-valley current ratio (PVR = 45) and highest peak current density (~90 kA/cm 2 ) ever reported in a solid-state tunneling device. While tunneling transport has been previously observed in graphene nanogaps, the bridging of ionized oxygen observed here shows a low excess current, leading to the observed PVR. On the basis of the highly reproducible light emission and NDR from these structures, we demonstrate a 65,536-pixel light-emitting nanogap array.
- 30 December 2021
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 14 (1) , 2255-2262
Improving the Optical Quality of MoSe2 and WS2 Monolayers with Complete h-BN Encapsulation by High-Temperature Annealing
We improved the optical quality and stability of an exfoliated monolayer (ML) MoSe2 and chemical vapor deposition (CVD)-grown WS2 MLs by encapsulating and sealing them with both top and bottom few-layer h-BN, as tested by subsequent high-temperature annealing up to 873 K and photoluminescence (PL) measurements. These transition-metal dichalcogenide (TMD) MLs remained stable up to this maximum temperature, as seen visually. After the heating/cooling cycle, the integrated photoluminescence (PL) intensity at 300 K in the MoSe2 ML was ∼4 times larger than that before heating and that from exciton and trion PL in the analogous WS2 ML sample was ∼14 times and ∼2.5 times larger at 77 K and the exciton peak was ∼9.5 times larger at 300 K. This is attributed to the reduction of impurities, the lateral expulsion of contamination leading to clean and atomically flat surfaces, and the sealing provided by the h-BN layers that prevents the diffusion of molecules such as trace O2 and H2O to the TMD ML. Stability and optical performance are much improved compared to that in earlier work using top h-BN only, in which the WS2 ML PL intensity decreased even for an optimal gas environment. This complete encapsulation is particularly promising for CVD-grown TMD MLs because they have relatively more charge and other impurities than do exfoliated MLs. These results open a new route for improving the optical properties of TMD MLs and their performance and applications both at room and higher temperatures.
- 30 December 2021
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 14 (1) , 2255-2262
Improving the Optical Quality of MoSe2 and WS2 Monolayers with Complete h-BN Encapsulation by High-Temperature Annealing
We improved the optical quality and stability of an exfoliated monolayer (ML) MoSe2 and chemical vapor deposition (CVD)-grown WS2 MLs by encapsulating and sealing them with both top and bottom few-layer h-BN, as tested by subsequent high-temperature annealing up to 873 K and photoluminescence (PL) measurements. These transition-metal dichalcogenide (TMD) MLs remained stable up to this maximum temperature, as seen visually. After the heating/cooling cycle, the integrated photoluminescence (PL) intensity at 300 K in the MoSe2 ML was ∼4 times larger than that before heating and that from exciton and trion PL in the analogous WS2 ML sample was ∼14 times and ∼2.5 times larger at 77 K and the exciton peak was ∼9.5 times larger at 300 K. This is attributed to the reduction of impurities, the lateral expulsion of contamination leading to clean and atomically flat surfaces, and the sealing provided by the h-BN layers that prevents the diffusion of molecules such as trace O2 and H2O to the TMD ML. Stability and optical performance are much improved compared to that in earlier work using top h-BN only, in which the WS2 ML PL intensity decreased even for an optimal gas environment. This complete encapsulation is particularly promising for CVD-grown TMD MLs because they have relatively more charge and other impurities than do exfoliated MLs. These results open a new route for improving the optical properties of TMD MLs and their performance and applications both at room and higher temperatures.
- 25 June 2021
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 13 (26) , 31271-31278
Stabilization of Chemical-Vapor-Deposition-Grown WS2 Monolayers at Elevated Temperature with Hexagonal Boron Nitride Encapsulation
Chemical vapor deposition (CVD)-grown flakes of high-quality monolayers of WS2 can be stabilized at elevated temperatures by encapsulation with several layer hexagonal boron nitride (h-BN), but to different degrees in the presence of ambient air, flowing N2, and flowing forming gas (95% N2, 5% H2). The best passivation of WS2 at elevated temperature occurs for h-BN-covered samples with flowing N2 (after heating to 873 K), as judged by optical microscopy and photoluminescence (PL) intensity after a heating/cooling cycle. Stability is worse for uncovered samples, but best with flowing forming gas. PL from trions, in addition to that from excitons, is seen for covered WS2 only for forming gas, during cooling below ∼323 K; the trion has an estimated binding energy of ∼28 meV. It might occur because of doping level changes caused by charge defect generation by H2 molecules diffusing between the h-BN and the SiO2/Si substrate. The decomposition of uncovered WS2 flakes in air suggests a dissociation and chemisorption energy barrier of O2 on the WS2 surface of ∼1.6 eV. Fitting the high-temperature PL intensities in air gives a binding energy of a free exciton of ∼229 meV.
- 25 June 2021
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 13 (26) , 31271-31278
Stabilization of Chemical-Vapor-Deposition-Grown WS2 Monolayers at Elevated Temperature with Hexagonal Boron Nitride Encapsulation
Chemical vapor deposition (CVD)-grown flakes of high-quality monolayers of WS2 can be stabilized at elevated temperatures by encapsulation with several layer hexagonal boron nitride (h-BN), but to different degrees in the presence of ambient air, flowing N2, and flowing forming gas (95% N2, 5% H2). The best passivation of WS2 at elevated temperature occurs for h-BN-covered samples with flowing N2 (after heating to 873 K), as judged by optical microscopy and photoluminescence (PL) intensity after a heating/cooling cycle. Stability is worse for uncovered samples, but best with flowing forming gas. PL from trions, in addition to that from excitons, is seen for covered WS2 only for forming gas, during cooling below ∼323 K; the trion has an estimated binding energy of ∼28 meV. It might occur because of doping level changes caused by charge defect generation by H2 molecules diffusing between the h-BN and the SiO2/Si substrate. The decomposition of uncovered WS2 flakes in air suggests a dissociation and chemisorption energy barrier of O2 on the WS2 surface of ∼1.6 eV. Fitting the high-temperature PL intensities in air gives a binding energy of a free exciton of ∼229 meV.
- 28 September 2020
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 124 (43) , 23949-23963
Spatiotemporal Study of Iron Oxide Nanoparticle Monolayer Formation at Liquid/Liquid Interfaces by Using In Situ Small-Angle X-ray Scattering
- 28 September 2020
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 124 (43) , 23949-23963
Spatiotemporal Study of Iron Oxide Nanoparticle Monolayer Formation at Liquid/Liquid Interfaces by Using In Situ Small-Angle X-ray Scattering
- Open Access
- 1 June 2019
- Published by AIP Publishing in AIP Advances
- Vol. 9 (6) , 065022
Brewster angle optical reflection observation of self-limiting nanoparticle monolayer self-assembly at a liquid/liquid interface
Real-time optical reflection of incident p-polarized light near Brewster’s angle shows that after drop-casting iron oxide nanoparticles (NPs) in heptane on top of a diethylene glycol (DEG) liquid substrate, an iron oxide NP layer forms at the DEG/heptane interface, and it self-limits to a monolayer even when there are excess NPs dispersed in the upper heptane phase. Most modes of NP self-assembly do not self-limit growth after the formation of a single monolayer. Observations are compared to a reflection model incorporating the reflectances expected at each interface. An effective medium model of the dielectric constant is used to model the reflectance of the NP layer at the DEG/heptane interface.
- 1 June 2019
- Published by AIP Publishing in AIP Advances
- Vol. 9 (6) , 065022
Open AccessBrewster angle optical reflection observation of self-limiting nanoparticle monolayer self-assembly at a liquid/liquid interface
Real-time optical reflection of incident p-polarized light near Brewster’s angle shows that after drop-casting iron oxide nanoparticles (NPs) in heptane on top of a diethylene glycol (DEG) liquid substrate, an iron oxide NP layer forms at the DEG/heptane interface, and it self-limits to a monolayer even when there are excess NPs dispersed in the upper heptane phase. Most modes of NP self-assembly do not self-limit growth after the formation of a single monolayer. Observations are compared to a reflection model incorporating the reflectances expected at each interface. An effective medium model of the dielectric constant is used to model the reflectance of the NP layer at the DEG/heptane interface.
- 29 March 2019
- Published by Springer Nature in Journal of Nanoparticle Research
- Vol. 21 (4) , 1-6
Improved small-angle x-ray scattering of nanoparticle self-assembly using a cell with a flat liquid surface
- 29 March 2019
- Published by Springer Nature in Journal of Nanoparticle Research
- Vol. 21 (4) , 1-6
Improved small-angle x-ray scattering of nanoparticle self-assembly using a cell with a flat liquid surface
- 28 August 2017
- Published by Royal Society of Chemistry (RSC) in Nanoscale
- Vol. 9 (37) , 13910-13914
Passivating 1T′-MoTe2 multilayers at elevated temperatures by encapsulation
The decomposition of 1T′-MoTe2 at high temperatures can be slowed down substantially by encapsulating it with hBN.
- 28 August 2017
- Published by Royal Society of Chemistry (RSC) in Nanoscale
- Vol. 9 (37) , 13910-13914
Passivating 1T′-MoTe2 multilayers at elevated temperatures by encapsulation
The decomposition of 1T′-MoTe2 at high temperatures can be slowed down substantially by encapsulating it with hBN.
- 10 January 2016
- Published by Springer Nature
- p. 491-531
Fluid Pressure, Fluid Flow in the Body, and Motion in Fluids
- 10 January 2016
- Published by Springer Nature
- p. 491-531
Fluid Pressure, Fluid Flow in the Body, and Motion in Fluids