JCJyoti Chawla

Jyoti Chawla

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Jyoti Chawla has a total of 38 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Chemical and Statistical Analysis for the Mitigation of Acid Red 18 dyes from Aqueous Systems Using Natural Adsorbent

    by Sheela Choudhary, Rajeev Kumar, Jyoti Chawla

    Statistical analysis, along with batch studies, was performed for the mitigation of AR 18 dye from water using pomegranate carpellary membrane powder (PCMP) as a sustainable, eco-friendly natural adsorbent. The analysis is supported by the chemical batch studies using various variables. Single-layer mitigation of AR 18 on PCMP was best described by the Langmuir model, having Qmax = 47.61 mg/g. Two statistical methodologies were applied to identify the optimal AR 18 mitigation conditions. The BBD model exhibited superior performance, demonstrated by a higher F-value (133.99) and R² (0.992), in contrast to CCD (F = 37.87, R² = 0.972), indicating better predictive accuracy and model significance. The optimal adsorption conditions derived from BBD resulted in equilibrium adsorption capacity (Qe) of 38.18 mg/g at 89.95 mg/L, AR 18 concentration, pH 4.19, 142.38 minutes, and 0.12 g/L PCMP dose. CCD optimization yielded a slightly lower Qe of 37.63 mg/g.

  • Open Access

    Evaluating the Electronic Waste Management System by Using Technique for Order Performance by Similarity to Ideal Solution

    by Vijay Kumar, Jyoti Chawla, Rajeev Kumar

    The waste created after the useful life of electronic or electrical products is labeled as electronic waste. Introduction of better and upgraded options into market increase the rate of disposal of obsolete discarded products from the consumer side. Electronic waste contains many toxic ingredients and major toxicants are heavy metal ions that may find the way to environment matrix after improper disposal of products. In recent years due to rapid technological development and industrialization; electronic waste management has become a major challenge throughout the world and receiving an attention from researchers, governments, and public. Poor management of waste may adversely affect the environment and human health. Thus, it is necessary to segregate all e-waste materials at the point of generation, for appropriate treatment/disposal. The assessment of the most suitable and appropriate framework has been a subject of extreme research interest as it involves many conflicting factors such as cost, type of waste, energy consumption, environmental impact of waste residue, rate of waste generation, treatment efficiency, and practical feasibility, consumer awareness, occupational hazards etc. There are numerous constraints and knowledge gaps to plan a feasible strategy in realistic scenario. The exact amount of disposed of e-waste is very difficult to predict because of many reasons including the unavailability of collection units for e-waste as well lack of awareness to consumer regarding its proper way of disposal. Various approaches that have been proposed needs to be analyzed with respect to every individual factor. To address this problem, we have proposed multi-criteria decision-making(MCDM) based Technique for Order Preference by Similarity to Ideal Solution (TOPSIS) method to develop framework that determine the interdependency among different factors and obtained the priority value of each e-waste treatment method for appropriate selection and successful implementation in real scenario. From the results of the given information gathered from 3 sources, it is observed that re-use method is the preferred over recycle and landfill methods. The findings of this study will support the organizations and stakeholders to take suitable steps for the disposal of electronic waste strategies.

  • Comparative studies of conventional and AI methods for wastewater treatment in the sugar, food, textile, and pharmaceutical industries: a review

    by Shagufta Jabin, Ritu Bir, Sadiqa Abbas, Jyoti Chawla, Anisha, Sapana Jadoun

    The use of traditional methodologies in combination with artificial intelligence (AI) has attracted much interest for the treatment of industrial wastewater in different sectors, such as food, sugar, textiles, and pharmaceuticals.


  • Open Access

    Study on Adsorption and Confinement Factors of Non-polar Amino Acids in Alkaline Sandy Loam Soil in the Presence of Fungicide

    by Ankita Nagar, Shagufta Jabin, Jyoti Chawla

    Amino acids are major sources of nitrogen in plants and soil. Amino acids areone of the most important parameter for growth of plants and health of soil. In the present study, fungicide Zole (tebuconazole 18.3% + Azoxytrobin 11%) has been added in soil and its effect on soil has been studied in presence of selected amino acids. All the selected amino acids are non-polar and different techniques used in current study include soil thin layer chromatography, X-ray diffraction (XRD) and scanning electron microscopy (SEM). It has been found that the mobility of amino acid decrease with the increase in concentration of fungicidezole in the soil. Theresults also confirmed the improvement of soil quality in terms of amino acid adsorption in presence of fungicide Zole.

  • Open Access

    Studies on Minimization of Pollutants from Sugar Industry Effluent by Using a Combination of Metal Coagulant and Polymer

    by Payal Kaushish, Drishti D, Shagufta Jabin, Jyoti Chawla, Priti Gupta

    World is facing lot of health issues due to industrial wastewater pollution. Increasing population and industrialization are one of the main causes of water pollution. In general, industrial wastewater contains suspended, colloidal and dissolved impurities. Industrial effluent may be either excessively acidic or alkaline and may contain high concentration of coloured matter. In this study, coagulation-flocculation method has been used for minimization of contaminants from sugar industry effluent. Lime has been used in conjunction with poly diallyl dimethyl ammonium chloride (PDADMAC) for reduction of chemical oxygen demand (COD), total dissolved solids (TDS), total suspended solids (TSS) and turbidity. It could remove 97% turbidity, 92.8 % TSS, 95.5% TDS and 90.5% COD from sugar industry wastewater. Scanning electron microscopy (SEM) studies were also performed to support the formation of flocs.


  • N-Substituted 2-Sulfanylacetamide Prunus Armeniaca: Synthesis, Characterization, and Adsorption Studies for As(III) Remediation

    by Madhvi Nayyar, Jyoti Chawla, Rajeev Kumar

    Aromatic amino acid or primary aliphatic acid available on prunus armeniaca seed coat (PASC) powder is modified (MPASC) using thioglycolic acid and 1-ethyl-3-(3-dimethylaminopropyl) carbodiimide hydrochloride (EDC) in the form of N-substituted 2-sulfanylacetamide derivative. Infrared (FTIR), scanning electron microscopy, EDX, and XRD techniques are used for characterization of PASC and MPASC. Synthesized material is identified by the change in peak position and deformation of N–H bending vibration of primary amines peak. Peak at 1601 cm−1 due to N–H bending vibration is deformed at1656 cm–1 due to change of the primary amine into amide by thioglycolic acid. Both PASC and MPASC are then utilized for removal of As(III) form water. Adsorption experiments were conducted at different values of adsorbent dose, contact time and pH values in order to study their influence on the uptake of arsenic by the PASC and MPASC adsorbents. The Langmuir maximum adsorption capacity for PASC and MPASC were found to be 125 and 142.85 mg/g, respectively. Sulfhydryl groups on MPASC indicate high affinity for As(III) ions.

  • N-Substituted 2-Sulfanylacetamide Prunus armeniaca: Synthesis, Characterization, and Adsorption Studies for As(III) Remediation

    by Madhvi Nayyar, Jyoti Chawla, Rajeev Kumar

    Aromatic amino acid or primary aliphatic acid available on Prunus armeniaca seed coat (PASC) powder is modified (MPASC) using thioglycolic acid and 1-ethyl-3-(3-dimethylaminopropyl) carbodiimide hydrochloride (EDC) in the form of N-substituted 2-sulfanylacetamide derivative. Infrared (FTIR), scanning electron microscopy, EDX, and XRD techniques are used for characterization of PASC and MPASC. Synthesized material is identified by the change in peak position and deformation of N–H bending vibration of primary amines peak. Peak at 1601 cm–1 due to N–H bending vibration is deformed at1656 cm–1 due to change of the primary amine into amide by thioglycolic acid. Both PASC and MPASC are then utilized for removal of As(III) form water. Adsorption experiments were conducted at different values of adsorbent dose, contact time and pH values in order to study their influence on the uptake of arsenic by the PASC and MPASC adsorbents. The Langmuir maximum adsorption capacity for PASC and MPASC were found to be 125 and 142.85 mg/g respectively. Sulfhydryl groups on MPASC indicate high affinity for As(III) ions.


  • Open Access

    PAVO CRISTATUS FEATHER POWDER AS AN ECO-FRIENDLY AND LOW COST MATERIAL FOR MITIGATION OF Pb(II) IONS FROM WATER

    by Suman Saini, Jyoti Chawla, Rajeev Kumar, Inderpreet Kaur

    Mitigation of Pb(II) ions from water using economic method is an important research area to combat the pollution due to lead ions Pb(II) in water as it  have severe toxic effects in human beings. In present work, Pristine Pavo Cristatus feather powder (PCFP) has been employed for removal of Pb(II) ions and the process of adsorption was optimized through four level Box Behnken design (BBD) of response surface methodology (RSM) over a broad range of pH (3.0–9.0), initial lead ion concentration (20–100 mg/L), contact time (20–180 min) and temperature (297 K to 333 K). Different isotherms were applied to confirm the type of adsorption. Langmuir maximum removal efficiency was 121.95 mg/g for lead ions adsorption onto PCPF at optimal values of pH 6; adsorbent dose 20 mg/L; temperature 303 K and contact time 120 minutes obtained from batch studies. Pseudo-second-order reaction model showed good applicability for kinetic studies. Thermodynamic parameters were also evaluated to check feasibility and nature of adsorption. The optimal parameters obtained for maximum Pb(II) ions adsorption were at pH = 6.31, initial Pb(II) ion = 43.79 mg/L, contact time = 119.51 minutes and temperature = 59.67 oC. The experimental and predicted values were found to be in good agreement with each other.