Enrique Ruiz-Trejo
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Enrique Ruiz-Trejo has a total of 88 co-authors. Here are the top co-authors by number of shared publications:
Nigel P. Brandon
10 shared publicationsMarina Lomberg
6 shared publicationsMasashi Kishimoto
5 shared publications- Paul Boldrin
Imperial College London
5 shared publications - Adriana Benítez-Rico
Universidad La Salle México
3 shared publications - Alan Atkinson
Imperial College London
3 shared publications
Latest Publications
- 26 February 2021
- Published by Cambridge University Press (CUP) in Journal of Fluid Mechanics
- Vol. 913
Optimising the flow through a concertinaed filtration membrane
Membrane filtration is a vital industrial process, with applications including air purification and blood filtration. In this paper, we study the optimal design for a concertinaed filtration membrane composed of angled porous membranes and dead ends. The geometry of the filter motivates a lubrication scaling for the flow, leading to a system of coupled (modified) Reynolds equations. By analysing this reduced system, we examine how the filter performance depends on the angle, position, thickness and permeance of the membrane, using a combination of numerical and asymptotic approaches, the latter in the limit of a slightly angled membrane. We find that, for a membrane of fixed angle and physical properties, there can exist multiple membrane positions that maximise the flux for an applied pressure difference. More generally, this shows how coupled problems in lubrication flow can exhibit non-trivial bifurcating optima. For the particular application on which we focus, we show that, while the maximal flux achievable depends on the membrane thickness and permeance, the optimal membrane configuration is always in one of two set-ups: centred and diagonal across the full domain; or angled and in the corner of the domain.
- 26 February 2021
- Published by Cambridge University Press (CUP) in Journal of Fluid Mechanics
- Vol. 913
Optimising the flow through a concertinaed filtration membrane
Membrane filtration is a vital industrial process, with applications including air purification and blood filtration. In this paper, we study the optimal design for a concertinaed filtration membrane composed of angled porous membranes and dead ends. The geometry of the filter motivates a lubrication scaling for the flow, leading to a system of coupled (modified) Reynolds equations. By analysing this reduced system, we examine how the filter performance depends on the angle, position, thickness and permeance of the membrane, using a combination of numerical and asymptotic approaches, the latter in the limit of a slightly angled membrane. We find that, for a membrane of fixed angle and physical properties, there can exist multiple membrane positions that maximise the flux for an applied pressure difference. More generally, this shows how coupled problems in lubrication flow can exhibit non-trivial bifurcating optima. For the particular application on which we focus, we show that, while the maximal flux achievable depends on the membrane thickness and permeance, the optimal membrane configuration is always in one of two set-ups: centred and diagonal across the full domain; or angled and in the corner of the domain.
- Open Access
- 16 February 2018
- Published by Royal Society of Chemistry (RSC) in Sustainable Energy & Fuels
- Vol. 2 (4) , 862-875
Amorphous-cathode-route towards low temperature SOFC
Lowering the operating temperature of solid oxide fuel cell (SOFC) devices is one of the major challenges limiting the industrial breakthrough of this technology. In this study we explore a novel approach to electrode preparation employing amorphous cathode materials. La0.8Sr0.2CoO3−δ dense films have been deposited at different temperatures using pulsed laser deposition on silicon substrates. Depending on the deposition temperature, textured polycrystalline or amorphous films have been obtained. Isotope exchange depth profiling experiments reveal that the oxygen diffusion coefficient of the amorphous film increased more than four times with respect to the crystalline materials and was accompanied by an increase of the surface exchange coefficient. No differences in the surface chemical composition between amorphous and crystalline samples were observed. Remarkably, even if the electronic conductivities measured by the Van Der Pauw method indicate that the conductivity of the amorphous material was reduced, the overall catalytic properties of the cathode itself were not affected. This finding suggests that the rate limiting step is the oxygen mobility and that the local electronic conductivity in the amorphous cathode surface is enough to preserve its catalytic properties. Different cathode materials have also been tested to prove the more general applicability of the amorphous-cathode route.
- 16 February 2018
- Published by Royal Society of Chemistry (RSC) in Sustainable Energy & Fuels
- Vol. 2 (4) , 862-875
Open AccessAmorphous-cathode-route towards low temperature SOFC
Lowering the operating temperature of solid oxide fuel cell (SOFC) devices is one of the major challenges limiting the industrial breakthrough of this technology. In this study we explore a novel approach to electrode preparation employing amorphous cathode materials. La0.8Sr0.2CoO3−δ dense films have been deposited at different temperatures using pulsed laser deposition on silicon substrates. Depending on the deposition temperature, textured polycrystalline or amorphous films have been obtained. Isotope exchange depth profiling experiments reveal that the oxygen diffusion coefficient of the amorphous film increased more than four times with respect to the crystalline materials and was accompanied by an increase of the surface exchange coefficient. No differences in the surface chemical composition between amorphous and crystalline samples were observed. Remarkably, even if the electronic conductivities measured by the Van Der Pauw method indicate that the conductivity of the amorphous material was reduced, the overall catalytic properties of the cathode itself were not affected. This finding suggests that the rate limiting step is the oxygen mobility and that the local electronic conductivity in the amorphous cathode surface is enough to preserve its catalytic properties. Different cathode materials have also been tested to prove the more general applicability of the amorphous-cathode route.
- Open Access
- 1 January 2018
- Published by Elsevier in Journal of Power Sources
- Vol. 374, 61-68
Quantification of the degradation of Ni-YSZ anodes upon redox cycling
- 1 January 2018
- Published by Elsevier in Journal of Power Sources
- Vol. 374, 61-68
Open AccessQuantification of the degradation of Ni-YSZ anodes upon redox cycling
- Open Access
- 28 June 2017
- Published by The Electrochemical Society in Journal of the Electrochemical Society
- Vol. 164 (10) , F3045-F3054
Oxygen Reduction, Transport and Separation in Low Silver Content Scandia-Stabilized Zirconia Composites
Dense composites of silver and Sc-stabilized ZrO2 (Ag-ScSZ) are manufactured from ScSZ sub-micrometric particles coated with silver using Tollens’ reagent. A composite with 8.6 vol % of silver exhibits metallic conductivity of 186 S cm−1 and oxygen flux of 0.014 μmol cm−2 s−1 at 600°C for a 1-mm thick membrane when used as a pressure-driven separation membrane between air and argon. To gain insight into the role of oxygen transport in Ag and ScSZ, a dense non-percolating sample (Ag 4.7 vol%) is analyzed by impedance spectroscopy and the transport of oxygen through both phases is modelled. Oxygen transport takes place in both silver and ScSZ but it is still dominated by transport in the ionic conductor and therefore a large volume fraction of the ion conductor is beneficial for the separation. The oxygen transport in the silver clusters inside the composite is dominated by diffusion of neutral species and not by the charge transfer reaction at the interface between ScSZ and Ag, yet small silver particles on the surface improve the reduction of oxygen. Oxygen reduction is highly promoted by silver on the surface and there are no limitations of charge transfer at the interface between silver and ScSZ.
- 28 June 2017
- Published by The Electrochemical Society in Journal of the Electrochemical Society
- Vol. 164 (10) , F3045-F3054
Open AccessOxygen Reduction, Transport and Separation in Low Silver Content Scandia-Stabilized Zirconia Composites
Dense composites of silver and Sc-stabilized ZrO2 (Ag-ScSZ) are manufactured from ScSZ sub-micrometric particles coated with silver using Tollens’ reagent. A composite with 8.6 vol % of silver exhibits metallic conductivity of 186 S cm−1 and oxygen flux of 0.014 μmol cm−2 s−1 at 600°C for a 1-mm thick membrane when used as a pressure-driven separation membrane between air and argon. To gain insight into the role of oxygen transport in Ag and ScSZ, a dense non-percolating sample (Ag 4.7 vol%) is analyzed by impedance spectroscopy and the transport of oxygen through both phases is modelled. Oxygen transport takes place in both silver and ScSZ but it is still dominated by transport in the ionic conductor and therefore a large volume fraction of the ion conductor is beneficial for the separation. The oxygen transport in the silver clusters inside the composite is dominated by diffusion of neutral species and not by the charge transfer reaction at the interface between ScSZ and Ag, yet small silver particles on the surface improve the reduction of oxygen. Oxygen reduction is highly promoted by silver on the surface and there are no limitations of charge transfer at the interface between silver and ScSZ.
- Open Access
- 1 June 2016
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 41 (22) , 9627-9637
Anode fabrication for solid oxide fuel cells: Electroless and electrodeposition of nickel and silver into doped ceria scaffolds
- 1 June 2016
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 41 (22) , 9627-9637
Open AccessAnode fabrication for solid oxide fuel cells: Electroless and electrodeposition of nickel and silver into doped ceria scaffolds
- Open Access
- 1 May 2016
- Published by Elsevier in Solid State Ionics
- Vol. 288, 82-87
Conductivity and structure of sub-micrometric SrTiO3–YSZ composites
- 1 May 2016
- Published by Elsevier in Solid State Ionics
- Vol. 288, 82-87
Open AccessConductivity and structure of sub-micrometric SrTiO3–YSZ composites
- 1 February 2016
- Published by Elsevier in Electrochimica Acta
- Vol. 190, 178-185
Numerical modeling of nickel-infiltrated gadolinium-doped ceria electrodes reconstructed with focused ion beam tomography
- 1 February 2016
- Published by Elsevier in Electrochimica Acta
- Vol. 190, 178-185
Numerical modeling of nickel-infiltrated gadolinium-doped ceria electrodes reconstructed with focused ion beam tomography
- Open Access
- 1 January 2016
- Published by Elsevier in Computational Materials Science
- Vol. 111, 101-106
On the mechanism of electrical conductivity in Ce 1/3 NbO 3
- 1 January 2016
- Published by Elsevier in Computational Materials Science
- Vol. 111, 101-106
Open AccessOn the mechanism of electrical conductivity in Ce 1/3 NbO 3
- 1 October 2015
- Published by Elsevier in Sensors and Actuators A: Physical
- Vol. 234, 339-345
A detailed characterization of BaMgAl10O17:Eu phosphor as a thermal history sensor for harsh environments
- 1 October 2015
- Published by Elsevier in Sensors and Actuators A: Physical
- Vol. 234, 339-345
A detailed characterization of BaMgAl10O17:Eu phosphor as a thermal history sensor for harsh environments
- Open Access
- 1 September 2015
- Published by Elsevier in Acta Materialia
- Vol. 97, 413-418
Influence of manganite powder grain size and Ag-particle coating on the magnetocaloric effect and the active magnetic regenerator performance
- 1 September 2015
- Published by Elsevier in Acta Materialia
- Vol. 97, 413-418
Open AccessInfluence of manganite powder grain size and Ag-particle coating on the magnetocaloric effect and the active magnetic regenerator performance