RRRoger D. De Roo

Roger D. De Roo

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Roger D. De Roo has a total of 209 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • L-Band Full-Wave Simulations of the Effective Permittivity of Bi/Tri-Continuous Media With Applications to Firn Aquifer in Polar Regions and Terrestrial Wet Snow

    by Zhenming Huang, Haokui Xu, Firoz Borah, Leung Tsang, Brooke Medley, Joel T. Johnson, Roger D. De Roo

    Full wave simulations of the effective permittivity of firn aquifer and wet snow at L Band are reported. The Monte Carlo simulations are carried out for bicontinuous media embedded in a sphere and the scattering cross section and absorption cross section are calculated. By averaging over realizations, the effective permittivity is extracted by comparing with Mie solutions. The simulations are validated by using three numerical methods of 3D solutions of Maxwell equations: Finite difference Frequency domain (FDFD), Finite element method (FEM) and the discrete dipole approximation (DDA). Full wave simulation results are compared with those from the classical Maxwell Garnett and Polder van Santen mixing formulas. The results show large differences from mixing formulas when there are large permittivity contrasts between the background medium and the scatterers which are scenarios in aquifer and wet snow. The significance of these results is examined for the L-band microwave remote sensing of terrestrial wet snow and aquifer in polar regions.


  • RFI Mitigation in Time Domain Wideband Autocorrelation Radiometry (WiBAR) Using a Comb Filter

    by Maryam Salim, Roger de Roo, Mohammad Mousavi, Kamal Sarabandi, Anthony W. England

    This letter presents a new hardware setup to suppress radio frequency interference (RFI) for a recently developed microwave radiometer technique, known as wideband autocorrelation radiometry (WiBAR). WiBAR is a method that can directly measure the thickness of a low-loss layer like lake ice or dry snow on the ground by finding the lag time that corresponds to the transit time of layer in the autocorrelation function (ACF) of the received signal. However, RFI increases the noise floor of the ACF and results in a decreased signal-to-noise ratio (SNR) of the WiBAR delay peak in the ACF. We enhanced a WiBAR instrument with a tunable comb filter having a frequency response with many evenly spaced alternating pass and stop bands. We show the RFI mitigation performance of a WiBAR set-up with a comb filter in the laboratory with a simulation circuit that creates a spectrum polluted with RFI.


  • Open Access

    The influence of tree transmissivity variations in winter on satellite snow parameter observations

    by Qinghuan Li, Richard Kelly, Juha Lemmetyinen, Roger D. De Roo, Jinmei Pan, Yubao Qiu

    The ability to correct for the influence of forest cover is crucial for retrieval of surface geophysical parameters such as snow cover and soil properties from microwave remote sensing. Existing correction approaches to brightness temperatures for northern boreal forest regions consider forest transmissivity constant during wintertime. However, due to biophysical protection mechanisms, below freezing air temperatures freeze the water content of northern tree species only gradually. As a consequence, the permittivity of many northern tree species decreases with the decrease of air temperature under sub-zero temperature conditions. This results in a monotonic increase of the tree vegetation transmissivity, as the permittivity contrast to the surrounding air decreases. The influence of this tree temperature-transmissivity relationship on the performance of the frequency difference passive microwave snow retrieval algorithms has not been considered. Using ground-based observations and an analytical model simulation based on Mätzler’s approach (1994), the influence of the temperature-transmissivity relationship on the snow retrieval algorithms, based on the spectral difference of two microwave channels, is characterized. A simple approximation approach is then developed to successfully characterize this influence (the RMSE between the analytical model simulation and the approximation approach estimation is below 0.3 K). The approximation is applied to spaceborne observations, and demonstrates the capacity to reduce the influence of the forest temperature-transmissivity relationship on passive microwave frequency difference brightness temperature.


  • Calibration of a Wideband Autocorrelation Radiometer (WiBAR) Enhanced with a Comb Filter in Time Domain Mode

    by Maryam Salim, Roger De Roo, Kamal Sarabandi

    This paper presents calibration procedure for time domain and frequency domain mode of wideband autocorrelation radiometry, (TD-WiBAR) and (FD-WiBAR), enhanced with a comb filter for RFI mitigation. WiBAR is a novel microwave method for measuring the thickness of low-loss layers, such as snow and ice packs. The time domain mode is faster than the FD-WiBAR, but requires its own calibration. We investigated a WiBAR enhanced with a comb filter in the laboratory with a data collected from a simulation circuit using a Keysight Spectrum Analyzer. The data are further post-processed for the time and frequency domain calibration. The comb filter is provided to mitigate radio frequency interference (RFI). RFI increases the noise floor and results in a decreased signal to noise ratio (SNR) delay peak in the autocorrelation function of the WiBAR from which the snow depth is extracted.


  • Passive and Active Multiple Scattering of Forests Using Radiative Transfer Theory With an Iterative Approach and Cyclical Corrections

    by Maryam Salim, Shurun Tan, Roger D. De Roo, Andreas Colliander, Kamal Sarabandi

    In this article, a unified framework of vegetation scattering using radiative transfer (RT) theory for passive and active remote sensing of vegetated land surfaces, especially those associated with moderate-to-large vegetation water contents (VWCs), e.g., forest field, is presented. The framework allows for modeling passive and active microwave signatures of the vegetated field with the same physical parameters describing the vegetation structure. RT equations are solved by a numerical iterative approach for both passive and active configurations. This approach allows including higher order scattering, which represents multiple scattering. In fields such as forests with large VWCs, associated with large scattering albedo and optical thickness, multiple scattering effects are critical. In the active iterative approach, cyclical terms are identified and backscattering enhancement is included by doubling contributions from cyclical terms. The method is applied to aspen trees in forest fields to compute the brightness temperatures and backscattering coefficients for passive and active remote sensing configurations, respectively. In the passive configuration, for forest field with VWC of 15 kg/m², the deviation between the zeroth-order brightness temperature, i.e., the tau-omega model results, and multiple scattering results around 40°observation angle, can be as large as 50 K for vertical polarization and 35 K for horizontal polarization. In the active configuration, the deviation between first-order results, which is identical to the distorted Born approximation, and the multiple scattering results around 40°incidence angle, is about 1.6 dB for VV and 0.7 dB for HH polarization. Multiple scattering is shown to be crucial for accurate forward modeling, especially over forested areas. The proposed approach is thus suitable for vegetation scattering with large VWCs. Furthermore, the proposed model is validated with the passive and active L-band sensor (PALS) acquired in SMAPVEX12 measurements in 2012, which demonstrates the applicability of this model.


  • Open Access

    Can Land Surface Models Capture the Observed Soil Moisture Control of Water and Carbon Fluxes in Temperate‐To‐Boreal Forests?

    by T. dos Santos, G. Keppel‐Aleks, R. De Roo, A. L. Steiner

    The reservoir of soil water is exchanged with the atmosphere through evaporative processes, which are mediated via vegetation through transpiration. Carbon uptake is closely coupled to transpiration, and most process‐based models link transpiration and photosynthesis explicitly. Here, we evaluate the simulation of water and carbon fluxes in forested areas of North America using point‐based simulations of the Community Land Model version 5 (CLM5) with Soil Moisture Active/Passive (SMAP) satellite derived soil moisture measurements and in situ measurements at eight Fluxnet and two United States Climate Research Network (CRN) sites. Compared to observations, there is a broad site‐to‐site variability in simulated soil moisture, with some sites exhibiting wet biases and others dry biases. The bias sign does not depend on ecosystem or other environmental drivers such as radiation and temperature. Compared to Fluxnet latent heat (LH) and gross primary production (GPP) flux tower observations, simulated LH flux biases at deciduous broadleaf forests are linked with soil moisture biases, and the model captures the observed seasonal cycle and parabolic seasonal relationship with soil moisture. The parabolic shape is driven by high soil moisture and low LH fluxes in June, peak LH and drier soil conditions in July, followed by further soil moisture drawdown in August. GPP is underestimated at most sites, and the model exhibits a linear relationship between soil moisture and GPP. Because the photosynthesis parameterizations are similar in most Earth system models, further model development that incorporates observations and observed relationships is needed to accurately capture the GPP‐soil moisture relationship.


  • Open Access

    Microwave Radiometry at Frequencies From 500 to 1400 MHz: An Emerging Technology for Earth Observations

    by Joel T. Johnson, Kenneth C. Jezek, Giovanni Macelloni, Marco Brogioni, Leung Tsang, Emmanuel P. Dinnat, Jeffrey P. Walker, Nan Ye, Sidharth Misra, Jeffrey R. Piepmeier, et al.

    Microwave radiometry has provided valuable spaceborne observations of Earth's geophysical properties for decades. The recent SMOS, Aquarius, and SMAP satellites have demonstrated the value of measurements at 1400 MHz for observing surface soil moisture, sea surface salinity, sea ice thickness, soil freeze/thaw state, and other geophysical variables. However, the information obtained is limited by penetration through the subsurface at 1400 MHz and by a reduced sensitivity to surface salinity in cold or wind-roughened waters. Recent airborne experiments have shown the potential of brightness temperature measurements from 500-1400 MHz to address these limitations by enabling sensing of soil moisture and sea ice thickness to greater depths, sensing of temperature deep within ice sheets, improved sensing of sea salinity in cold waters, and enhanced sensitivity to soil moisture under vegetation canopies. However, the absence of significant spectrum reserved for passive microwave measurements in the 500-1400 MHz band requires both an opportunistic sensing strategy and systems for reducing the impact of radio-frequency interference. Here, we summarize the potential advantages and applications of 500-1400 MHz microwave radiometry for Earth observation and review recent experiments and demonstrations of these concepts. We also describe the remaining questions and challenges to be addressed in advancing to future spaceborne operation of this technology along with recommendations for future research activities.


  • A Novel Frequency Tunable RF Comb Filter

    by Maryam Salim, Seyedmohammad Mousavi, Line Van Nieuwstadt, Roger De Roo, Kamal Sarabandi

    This letter presents a new filter to suppress radio frequency interference (RFI) in microwave remote sensing instruments, particularly a wideband autocorrelation radiometer (WiBAR). RFI increases the noise floor and results in a decreased signal-to-noise ratio (SNR) of the WiBAR delay peak. The proposed filter operates like a Fabry-Perot interferometer (FPI) in optics and has the frequency response of a comb filter with many evenly spaced alternating pass and stop bands. The frequencies of these bands are varied with an electrically adjustable phase shifter. The design of a comb filter with an airy finesse value of 20 has been verified by simulation and measurement.


  • Retrieval of Snow or Ice Pack Thickness Variation Within a Footprint of Correlation Radiometers

    by Seyedmohammad Mousavi, Roger De Roo, Kamal Sarabandi, Anthony W. England

    A new passive microwave remote sensing technique, wideband autocorrelation radiometry (WiBAR), directly measures the microwave propagation time difference of multipath microwave emission from low-loss layered surfaces such as a dry snowpack and a freshwater lake icepack. The microwave propagation time difference through the pack yields a measure of its vertical extent. However, the presence of variable pack thicknesses within a footprint of the radiometer's antenna will add complexity to the retrieved time delay. This issue is more severe for WiBAR on airborne and spaceborne platforms than WiBAR on ground-based platforms since the footprint for a given radiometer antenna is larger. From a simple forward model for a layer having distinct thickness values within one footprint (pixel), the system requirements for resolving these distinct thickness values are derived. A subpixel lake ice thickness distinction of 3.7 cm is demonstrated with an X-band WiBAR instrument at an incidence angle of $70°.


  • Wideband Autocorrelation Radiometry for Lake Icepack Thickness Measurement With Dry Snow Cover

    by Seyedmohammad Mousavi, Roger De Roo, Kamal Sarabandi, Anthony W. England

    Wideband autocorrelation radiometry (WiBAR) is a recently developed microwave radiometric technique to measure the lake icepack or snowpack thickness. This technique offers a direct method to remotely measure the microwave propagation time difference of multipath microwave emission from low-loss layered surfaces such as dry snowpack and freshwater lake icepack. The microwave propagation time difference through the pack yields a measure of its vertical extent. However, the lake icepack thickness measurement can be affected by the presence of a dry snowpack, which introduces another multipath interference. We present a simple geophysical forward model considering this effect and derive the WiBAR system requirements needed to correctly measure the icepack thickness. An X-band instrument fabricated from commercial-off-the-shelf (COTS) components is used to measure the thickness of fresh water lake ice at the University of Michigan Biological Station. The WiBAR was able to directly measure the icepack of about 36 cm with a snowpack of about 4 cm on top at incidence angle of 69.4° with an accuracy of 2 cm.