ETEtienne Talbot

Etienne Talbot

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Etienne Talbot has a total of 189 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Luminescence of individual strontium vanadate nano-islands for white light

    by Etienne Talbot, Yanis Datti, Axel Rouviller, Chris Leroux, Denis Pelloquin, Sebastien Duguay, Xavier Portier, Fabrice Gourbilleau

  • (Invited) Vanadates Thin Films for Opto-Electronic Applications

    by Marie Dallocchio, Pratibha Nalini Ramesh Sundar, Axel Rouviller, Christian Dufour, Etienne Talbot, Ulrike Lüders, Xavier Portier, Fabrice Gourbilleau

    The influence of pollution on climate change and health, coupled with the depletion of vital resources for the development of new energy technologies and the fabrication of more energy-efficient devices, demands the identification of novel materials with the necessary structural, optical, and electrical characteristics to tackle these critical issues. The Sr-V-O system is a potential solution with on one side the generation of efficient luminous materials, including Sr2V2O7 [1] and Sr3V2O8, and on the other side, SrVO3, which possesses remarkable optical and electrical characteristics. Hence, photoluminescence investigations on bulk Sr2V2O7 materials synthesized from powders have exhibited an intense white emission within the 400-750 nm spectrum. Concerning cubic SrVO3, due to its strongly correlated metallic properties, is considered as a highly attractive candidate for a new generation of transparent conductive oxides (TCO)[2]. Unfortunately, this latter requires to be well crystallized to achieve good optical and electrical properties, complicating its industrial development since the use of pulsed laser technique and/or specific substrates, like SrTiO3, LaAlO3, and (LaAlO3)0.3(Sr2TaAlO6)0.7 (LSAT), can allow to achieve it.

  • Exploring the Dynamics of Sn Droplets on Hydrogenated Amorphous Si and Ge Layers for Nanocrystal Design

    by Xiaoyang Zhang, Xuechun Zhao, Lulu Zheng, Ileana Florea, Fabien Cuvilly, Etienne Talbot, Pere Roca i Cabarrocas, Wanghua Chen


  • Heavily Doped Si Nanocrystals Formed in P-(SiO/SiO2) Multilayers: A Promising Route for Si-Based Infrared Plasmonics

    by Alix Valdenaire, Alaa Eldin Giba, Mathieu Stoffel, Xavier Devaux, Loïc Foussat, Jean-Marie Poumirol, Caroline Bonafos, Sonia Guehairia, Rémi Demoulin, Etienne Talbot, et al.


  • Atomic-scale and optical investigation of nanostructured Er disilicates in silica

    by S. Guehairia, R. Demoulin, H. Merabet, P. Pareige, J. Cardin, C. Labbé, M. Carrada, F. Gourbilleau, E. Talbot

  • Impact of Nanosecond Laser Annealing on the Electrical Properties of Highly Boron-Doped Ultrathin Strained Si0.7Ge0.3 Layers

    by Richard Daubriac, Rémi Demoulin, Sebastien Kerdiles, Pablo Acosta Alba, Jean-Michel Hartmann, Jean-Paul Barnes, Pawel Michałowski, Fransesca Chiodi, Etienne Talbot, Emmanuel Scheid, et al.

    The CMOS scaling beyond 10 nm technology node requires high active dopant concentrations in source/drain modules to minimize contact resistance. Pulsed laser annealing has been targeted by chip manufacturers as a future option to enhance the activation level inside highly doped SiGe:B and Si:P regions, mostly used in PMOS and NMOS transistor fabrication, respectively. Indeed, this annealing process allows reaching high temperatures (above melt threshold), locally (~100nm below the surface) and with extremely fast temperature ramp rates (>109 °C/s), so that high doping levels have been demonstrated both in pure Si and Ge [1]. In a recent study, structural investigations allowed identifying the best conditions to obtain fully strained and defect-free undoped SiGe layers by liquid phase epitaxial regrowth (LPER) [2]. In this work, we report an analysis on the activation of boron dopants in similar layers. In-situ boron-doped 30 nm thick pseudomorphic Si0.7Ge0.3 layers were grown on p-type bulk Si (100) by CVD. Three different boron concentrations were incorporated inside these layers: 7.8x1019 (A), 1.4x1020 (B) and 2.3x1020 cm-3 (C). By combining the boron chemical profiles with the corresponding Hall effect measurements (Hall scattering factor: 0.35), it was possible to estimate the activation rate inside the as-grown strained SiGe layers and the impact of the possible inactive dopants on the transport properties. From the lowest to the highest boron chemical concentration, we found activation rates of ~100%, ~80% and ~60%, with no significant carrier mobility degradation, even in the sample with the highest fraction of inactive dopants. The SiGe layers were subsequently laser annealed in a SCREEN-LT3100 platform operating at 308 nm (XeCl laser) with a pulse duration around 160 ns. The laser energy densities (ED) ranged from 1.20 to 2.40 J/cm2 in order to investigate all the various annealing regimes. Results obtained using several characterization techniques were combined to determine the laser annealing regimes, quantify surface roughness and assess the layers’ composition, strain and crystalline quality. These results were compared to electrical measurements performed to analyse the evolution of the electrical parameters as a function of the laser anneal conditions, particularly the activation rate. For the lowly-doped and fully activated layer (A), the sheet resistance increases rapidly at the melt threshold (1.5 J/cm2, cf. Fig. 1, red curve), concomitantly with the appearance of a partial relaxation inside the layer (Fig. 2) and the formation of extended defects. The defects may induce a local dopant deactivation, while strain relaxation can result in a modification of the transport properties of the material (modified Hall scattering factor). Both phenomena can be therefore responsible for the observed increase of the sheet resistance. In contrast, for laser EDs allowing complete melt of the layer (i.e. beyond 2.0 J/cm2), the sheet resistance decreases with increasing ED and full activation is achieved (Fig. 3, red curve) together with strain recovery (Fig. 2) and no observable defects. For the highly-doped and partially activated layer (C), partial relaxation also occurs at the melt threshold (Fig. 2). However, thanks to the strain compensation effect of the small boron atoms, the relaxation level is lower compared to the lowly-doped sample and more quickly recovered when increasing the ED (no defects observed at 1.95 J/cm2, Fig. 4). In addition, the sheet resistance is found to continuously decrease as a function of the ED (Fig. 1, blue curve) independently of the strain state of the structure. This suggests that, in addition to the previously described phenomena, the initially inactive dopants are progressively incorporated into substitutional positions by LPER. Indeed, when full melt and strain recovery is achieved, a 100% dopant activation is also observed (Fig. 3, blue curve). Characterizations made on sample B suggest a similar behaviour to that of sample C. Finally, further results will be reported from additional experiments aiming at (i) better understanding the impact of strain relaxation on dopant activation and (ii) optimizing the laser annealing process to avoid relaxation. These experiments include the use of a shorter laser pulse for the annealing of the strained SiGe layers, as well as the comparison with results obtained from fully-relaxed boron-doped SiGe annealed under similar laser conditions. Acknowledgements: This work was supported by the European Union’s Horizon 2020 research and innovation program under grant agreement No. 871813 MUNDFAB. References: [1] F. Cristiano, A. La Magna, Laser annealing processes in semiconductor technology: Theory, modeling, and applications in nanoelectronics, Elsevier 2021 (9780128202555). [2] L. Dagault & al., Investigation of recrystallization and stress relaxation in nanosecond laser annealed Si1−xGex/Si epilayers, ASS, Vol. 527, 146752 (10.1016/j.apsusc.2020.146752). Figure 1

  • Open Access

    Infrared nanoplasmonic properties of hyperdoped embedded Si nanocrystals in the few electrons regime

    by Meiling Zhang, Jean-Marie Poumirol, Nicolas Chery, Clment Majorel, Rémi Demoulin, Etienne Talbot, Hervé Rinnert, Christian Girard, Filadelfo Cristiano, Peter R. Wiecha, et al.

    Using Localized Surface Plasmon Resonance (LSPR) as an optical probe we demonstrate the presence of free carriers in phosphorus doped silicon nanocrystals (SiNCs) embedded in a silica matrix. In small SiNCs, with radius ranging from 2.6 to 5.5 nm, the infrared spectroscopy study coupled to numerical simulations allows us to determine the number of electrically active phosphorus atoms with a precision of a few atoms. We demonstrate that LSP resonances can be supported with only about 10 free electrons per nanocrystal, confirming theoretical predictions and probing the limit of the collective nature of plasmons. We reveal a phenomenon, unique to embedded nanocrystals, with the appearance of an avoided crossing behavior linked to the hybridization between the localized surface plasmon in the doped nanocrystals and the silica matrix phonon modes. Finally, a careful analysis of the scattering time dependence versus carrier density in the small size regime allows us to detect the appearance of a new scattering process at high dopant concentration.

  • Correlated Structural and Luminescence Analysis of B‐Doped Si‐Nanocrystals Embedded in Silica

    by Rémi Demoulin, Dominique Muller, Daniel Mathiot, Philippe Pareige, Etienne Talbot

    Structural characteristics and luminescence properties of B‐doped silicon nanocrystals (Si‐ncs) embedded in a SiO2 matrix elaborated by ion beam synthesis are investigated. The use of atom probe tomography gives a unique opportunity to experimentally evidence the exact location and composition of B atoms in doped Si‐ncs. These experiments allow to conclude about a favored B location at the periphery of the Si‐ncs depending on their size. In this way, two categories of Si‐ncs can be described: 1) largest Si‐ncs that are B‐doped and where B atoms are located at the Si‐ncs/SiO2 interface, and 2) smallest Si‐ncs that remain undoped but seem to be surrounded by a B‐rich SiO2 shell. These structural characteristics (composition and diameters) are correlated to the photoluminescence properties of these Si‐ncs. These measurements show the well‐known quenching of Si‐ncs luminescence due to high B doping, which allows us to conclude about the environment changes brought by the presence of B in Si‐ncs or of B‐rich shell around Si‐ncs.


  • Characterization of p-type Doping in Silicon Nanocrystals Embedded in SiO2

    by R. Demoulin, M. Roussel, S. Duguay, D. Muller, D. Mathiot, P. Pareige, E. Talbot