KCKil-Byoung Chai

Kil-Byoung Chai

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Kil-Byoung Chai has a total of 60 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Miniature microwave-driven plasma thruster with magnetic nozzle for low-power space applications

    by Kyungtae Kim, Kil-Byoung Chai, Gunsu S Yun

    A microwave-driven Coaxial Transmission Line Resonator (CTLR) generates a high-density plasma plume by concentrating input power into a confined volume while consuming only a few watts of power. Furthermore, the CTLR operates stably in the low-pressure regime below the mTorr range, owing to the strong electric field formed at the open end of its resonant electrode, making it a promising miniature plasma source for small-satellite propulsion modules. In this study, we investigate the performance of a CTLR integrated with a magnetic nozzle composed of annular permanent magnets (CTLR–MN), designed to efficiently accelerate ions in high-density plasma at minimal argon flow rates. At a flow rate of 2 sccm (0.06 mg/s), with 10 W input power and an axial magnetic field strength of approximately 140 G at the exit, the CTLR–MN produces an ion beam with an energy of about 48 eV, corresponding to a velocity of 15 km/s. The measured electron density and temperature in the acceleration region reach up to 6×10 19 m -3 and 3 eV, respectively. Based on both model-based estimation and direct thrust measurements, we confirm that the total thrust of the present CTLR–MN prototype is at least 0.13 mN, corresponding to a thrust-to-power ratio of approximately 13 mN/kW and a specific impulse exceeding 220 s. These performance metrics indicate that the CTLR–MN offers viable propulsion capability under extremely low-power conditions. The results suggest that the CTLR–MN represents a promising micro-propulsion concept for small satellites, satisfying stringent power and volume constraints without requiring complex configurations or costly components or propellants.

  • Cryogenic etching device based on the conductive cooling method using liquid nitrogen bath

    by Kil-Byoung Chai, Eun-Beom Choi, Hyo-Chang Lee, Woongsub Song

    We developed a cryogenic etching device capable of precise temperature control utilizing liquid nitrogen conductive cooling. This device achieves electrode temperatures as low as −170 °C and enables real-time electrode temperature control, providing a reliable alternative to existing cryogenic etching techniques. To demonstrate the performance of our device, we conducted etching experiments on trench-patterned SiO2 thin films, successfully achieving anisotropic etching under cryogenic conditions. Compared with conventional methods such as flowing liquid nitrogen and chillers, our apparatus has a simple electrode structure, eliminates the risk of coolant leakage, and enables real-time temperature control. With these advantages, it is expected that our device based on the liquid nitrogen conductive cooling can be widely used in cryogenic etching research.

  • Open Access

    Effects of applied magnetic fields on the performance of magnetoplasmadynamic thrusters

    by Haewon Shin, Jeongho Kim, Jaeyeon Hwang, Kil-Byoung Chai, Holak Kim

    Since the performance of MPD thrusters is highly dependent on the applied magnetic field, we experimentally investigated the effects of magnetic field geometry. Thrust, specific impulse, and ion energy distribution were measured under various operating conditions. The results indicate that the magnetic field configuration of ring–type permanent magnets with a magnetic null point may limit effective ion acceleration, leading to reduced thrust while the permanent magnet produces a stronger applied magnetic field (BA: 0.175 T) than the electromagnet (BA: 0.016–0.065 T). This reduction could be attributed to disrupted axial electron mobility and shortened magnetic field line lengths near the magnetic null point. For the electromagnet configuration, thrust increased more significantly with discharge current at a lower argon flow rate (500 sccm) and a higher electromagnetic coil current (40 A). When the discharge current was increased to 300 A under the aforementioned conditions with an input power of 15 kW, the maximum thrust of 436 mN and the specific impulse of 2935 s were obtained. In the permanent magnet configuration, at a flow rate of 600 sccm and an input power of 10 kW, the thrust and specific impulse were 234 mN and 1340 s, respectively. In the comparable operating ranges, these values were approximately 28% and 15% lower, respectively, than those obtained with the electromagnet configuration. Besides these observations, the current-voltage (I–V) characteristics also show a dependence on the magnetic field configuration. The permanent magnet configuration exhibited a higher discharge voltage at a given discharge current, leading to reduced current levels under the same input power relative to the electromagnet configuration. The findings highlight the dominant influence of the magnetic field geometry on the thruster performance, along with the contributions of the discharge current and the argon flow rate.


  • Open Access

    Performance study on the low-power RF ion thruster with an optimized grid system

    by Kil-Byoung Chai, Min Park, Hyo-Chang Lee

    A low-power 13.56 MHz radio frequency (RF) ion thruster with an optimized grid system was developed and its performance was experimentally evaluated. The thruster employs an inductively coupled plasma (ICP) source and a two-grid ion optics system. Optimization of the screen grid (SG) and acceleration grid (AG) was performed using ion beam trajectory simulations. The performance measurement demonstrated a maximum thrust of 1.2 mN and a specific impulse of 1250 s at an RF power of 100 W and a xenon flow rate of 1 SCCM (0.1 mg/s). The study also investigated the influence of SG voltage and RF power on thruster performance, and simulation results confirmed the experimentally observed ion beam current behavior. The developed RF ion thruster shows a promising potential for mini- and microsatellite propulsion system.


  • Open Access

    Determination of the tungsten gross erosion rate based on the multiple atomic spectral lines

    by C. Shin, D.-H. Kwon, H. Shin, K.-B. Chai, Wonho Choe

    Measuring the in situ erosion rate of tungsten using an optical emission spectroscopic diagnostic technique, so called the S/XB method, has recently gained attention in current fusion research. This method calculates the erosion rate by multiplying the S/XB value, which represents ionization per photon emission, with the intensity of the specific spectral line. The S/XB value was given by the ionization rates (S) and the excitation rates (X) from the ground and the metastable levels and the branching ratio (B) for the specific radiative transition of neutral tungsten (W I), assuming a corona equilibrium among the ground, metastable, and upper resonance levels. The conventional S/XB method assumes a Boltzmann distribution for metastable level densities and introduces the free parameter of the tungsten atomic characteristic temperature ( T W ). Herein, we propose an improved S/XB method to measure the erosion rates of tungsten in a divertor to eliminate the ambiguity caused by T W . Our approach directly calculates the densities of ground and metastable levels using a set of photon emission equations that relate their densities to multiple spectral line intensities within the framework of coronal equilibrium. Subsequently, the sputtered flux is obtained from the matrix operator form of S/XB and the multiple spectral line intensities given by the measurement. Our proposed method was experimentally tested using the plasma beam irradiation facility by comparing the gross tungsten erosion rates calculated using our method with those obtained from conventional approaches and those determined through the sputtering yield by the Ar+ ion beam flux. From the experiment, we obtained the sputtered tungsten flux of 4.0 × 1020 m−2 s−1 ( ± 2.1 × 1020) using our method at a discharge current of 150 A from the plasma source and an ion incident energy of 100 eV, while the previous method yielded a range from 1.4 × 1020 m−2 s−1–1.9 × 1021 m−2 s−1 by varying T W and spectral lines. Using the sputtering yield method, a sputtered flux of 4.1 × 1020 m−2 s−1 ( ± 1.1 × 1019) was measured as a reference value. The results demonstrate that our S/XB method significantly reduces ambiguity in the selection of spectral lines and the T W parameter, and closely agrees with the reference values, offering a more accurate and consistent approach for measuring tungsten erosion in fusion reactors.


  • Open Access

    Analysis in microwave-driven plasma for miniature space propulsion

    by Kyungtae Kim, Kil-Byoung Chai, Gunsu S Yun

    Microwave-driven Coaxial Transmission Line Resonator (µ-CTLR) produces a small-volume high density plasma plume. In the previous study, we discovered that the plasma generated by the µ-CTLR remains stable even at low pressure around tens of mTorr, while consuming minimal power below 10 W (Kim et al 2022 Plasma Sources Sci. Technol. 31 105006). In this study, we have investigated the capability of the µ-CTLR plasma operating at 900 MHz for micro-propulsion applications. At the argon gas flow rate of 100 SCCM (3 mg s−1), and the power of 8 W, the plasma plume attains high gas temperature ( > 3000 K), high electron density ( > 10 20   m − 3 ), and electron temperature of about 2 eV. The estimated thrust is about 3.4 mN, demonstrating that the µ-CTLR has high thrust desirable for space micro propulsion systems, together with the other merits of low power consumption and small size.


  • Open Access

    Observation of fast Alfvén wave in KAERI plasma beam irradiation facility using an applied-field MPD thruster

    by Kil-Byoung Chai, Changmin Shin, Young Dae Yoon, Minuk Seung, Inyong Kwon

    Electromagnetic fluctuations between 300 and 500 kHz were observed in both ion saturation current and magnetic field measurements in the KAERI plasma beam irradiation facility where the applied-field magnetoplasmadynamic (MPD) thruster is used as a plasma source. In this study, the plasmas were ignited with deuterium gas and the plasma current (input power) was varied from 55 A (2 kW) to 155 A (6 kW). The electron temperature and density measured downstream of the MPD thruster plasma were ∼5 eV and (2–4) × 1012 cm−3, respectively. To identify the fluctuations, the dispersion relation and the phase velocity were experimentally obtained using the Beall method and were compared to the theoretical values under warm plasma conditions. It was revealed that the observed fluctuations were fast Alfvén waves with a circularly polarized magnetic field. In addition to the fast Alfvén waves, we also observed electrostatic fluctuations at a higher frequency that was similar to the lower-hybrid frequency.


  • Erosion resistance test of SiC mirror sample for ITER divertor VUV spectrometer

    by Boseong Kim, Kil-Byoung Chai, Jae-Sun Park, Changrae Seon, YoungHwa An, Yoo Kwan Kim, MunSeong Cheon, Xavier Bonnin