Karthikeyan Jagannathan
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Karthikeyan Jagannathan has a total of 63 co-authors. Here are the top co-authors by number of shared publications:
- Sivaperuman Kalainathan
Centre for Nanotechnology Research, Vellore Institute of Technology, Vellore, 632014, India
9 shared publications V. Ratchagar
Department of Physics, Theivanai Ammal College for Women (Autonomous), Villupuram 605602, India
6 shared publicationsG. Bhagavannarayana
5 shared publicationsP. Umarani
SRM Univ, Dept Phys, Vadapalani Campus, Madras 600026, Tamil Nadu, India
4 shared publicationsN. Vijayan
CSIR-National Physical Laboratory, New Delhi 110012, India
3 shared publicationsT. Gnanasekaran
3 shared publications
Latest Publications
- 8 July 2025
- Published by Springer Nature in International Journal of Tropical Insect Science
- Vol. 45 (4) , 1881-1891
Characterization of a silver nanoparticle derived from the fruit peel of Myristica fragrans on mosquito control
- 8 July 2025
- Published by Springer Nature in International Journal of Tropical Insect Science
- Vol. 45 (4) , 1881-1891
Characterization of a silver nanoparticle derived from the fruit peel of Myristica fragrans on mosquito control
- 1 July 2025
- Published by Oxford University Press (OUP) in Europhysics Letters
- Vol. 151 (2) , 26005
Tailoring decorated rGO nanocomposite for enhanced pseudocapacitive performance
In this work, a ZnFe 2 O 4 -reduced graphene oxide (ZF-rG) nanocomposite was prepared via a solvothermal method and evaluated for its electrochemical performance in a 1M KOH electrolyte, demonstrating its potential for supercapacitor applications. The results of cyclic voltammetry (CV) show that dominant diffusion-controlled charge storage is responsible for the specific capacitance of 62.9 F/g at 5 mV/s. A maximum energy density of 9.32 Wh/kg and a power density of 4500 W/kg are shown by galvanostatic charge-discharge (GCD) analysis, validating the material's high-rate capacity. A charge transfer resistance of 69.66 Ω and a low equivalent series resistance (ESR) of 3.04 Ω have been obtained in electrochemical impedance spectroscopy (EIS), indicating improved conductivity and effective charge transfer. The combined action of ZnFe 2 O 4 and rGO enhances electrochemical behaviour, which makes ZF-rG as an attractive choice for next-gen supercapacitors.
- 1 July 2025
- Published by Oxford University Press (OUP) in Europhysics Letters
- Vol. 151 (2) , 26005
Tailoring decorated rGO nanocomposite for enhanced pseudocapacitive performance
In this work, a ZnFe 2 O 4 -reduced graphene oxide (ZF-rG) nanocomposite was prepared via a solvothermal method and evaluated for its electrochemical performance in a 1M KOH electrolyte, demonstrating its potential for supercapacitor applications. The results of cyclic voltammetry (CV) show that dominant diffusion-controlled charge storage is responsible for the specific capacitance of 62.9 F/g at 5 mV/s. A maximum energy density of 9.32 Wh/kg and a power density of 4500 W/kg are shown by galvanostatic charge-discharge (GCD) analysis, validating the material's high-rate capacity. A charge transfer resistance of 69.66 Ω and a low equivalent series resistance (ESR) of 3.04 Ω have been obtained in electrochemical impedance spectroscopy (EIS), indicating improved conductivity and effective charge transfer. The combined action of ZnFe 2 O 4 and rGO enhances electrochemical behaviour, which makes ZF-rG as an attractive choice for next-gen supercapacitors.
- Open Access
Impact of the Fly Ash/Alkaline Activator Ratio on the Microstructure and Dielectric Properties of Fly Ash KOH-Based Geopolymer
Geopolymer materials, alternatives to cement that are synthesized using industrial byproducts, have emerged as some of the leading champion materials due to their environmentally friendly attributes. They can significantly reduce pollution by utilizing a plethora of waste products and conserving natural resources that would otherwise be used in the production of conventional cement. Much work is being carried out to study geopolymers’ characteristics under different conditions. Here, a geopolymer derived from fly ash (FA) was synthesized using a combination of sodium silicate and potassium hydroxide (KOH) (2.5:1 ratio) as an alkali activator (AA) liquid. The FA/AA ratios were optimized, resulting in distinct geopolymer samples with ratios of 1.00, 1.25, 1.50, and 1.75. By adjusting the contribution of alkaline liquid, we investigated the impacts of subtle changes in the FA/AA ratio on the morphology and microstructure using X-ray diffraction (XRD) and field emission scanning electron microscopy (FESEM) techniques. The FESEM analysis illustrated a mixed matrix and morphology, with the sample with a ratio of 1.00 displaying consistently fused and homogenous morphology. The XRD results revealed the prevalent amorphous nature of geopolymer with a few crystalline phases of quartz, sodalite, hematite, and mullite. An electrical study confirmed the insulating nature of the geopolymer samples. Insulating geopolymers can provide energy-efficient buildings and resistance to fire, hurricanes, and tornadoes. Additionally, using KOH as a part of the alkali activator introduced a less-explored aspect compared to conventional sodium hydroxide-based activators, highlighting the novelty in the synthesis process.
Open AccessImpact of the Fly Ash/Alkaline Activator Ratio on the Microstructure and Dielectric Properties of Fly Ash KOH-Based Geopolymer
Geopolymer materials, alternatives to cement that are synthesized using industrial byproducts, have emerged as some of the leading champion materials due to their environmentally friendly attributes. They can significantly reduce pollution by utilizing a plethora of waste products and conserving natural resources that would otherwise be used in the production of conventional cement. Much work is being carried out to study geopolymers’ characteristics under different conditions. Here, a geopolymer derived from fly ash (FA) was synthesized using a combination of sodium silicate and potassium hydroxide (KOH) (2.5:1 ratio) as an alkali activator (AA) liquid. The FA/AA ratios were optimized, resulting in distinct geopolymer samples with ratios of 1.00, 1.25, 1.50, and 1.75. By adjusting the contribution of alkaline liquid, we investigated the impacts of subtle changes in the FA/AA ratio on the morphology and microstructure using X-ray diffraction (XRD) and field emission scanning electron microscopy (FESEM) techniques. The FESEM analysis illustrated a mixed matrix and morphology, with the sample with a ratio of 1.00 displaying consistently fused and homogenous morphology. The XRD results revealed the prevalent amorphous nature of geopolymer with a few crystalline phases of quartz, sodalite, hematite, and mullite. An electrical study confirmed the insulating nature of the geopolymer samples. Insulating geopolymers can provide energy-efficient buildings and resistance to fire, hurricanes, and tornadoes. Additionally, using KOH as a part of the alkali activator introduced a less-explored aspect compared to conventional sodium hydroxide-based activators, highlighting the novelty in the synthesis process.
- 15 February 2024
- Published by Elsevier in Physica B: Condensed Matter
- Vol. 679
Synthesis, characterization, and biosensing performance of cobalt sulphide reinforced polyaniline composites
- 15 February 2024
- Published by Elsevier in Physica B: Condensed Matter
- Vol. 679
Synthesis, characterization, and biosensing performance of cobalt sulphide reinforced polyaniline composites
- 14 February 2024
- Published by Elsevier in Ceramics International
- Vol. 50 (9) , 16343-16351
Structural, morphological and optical properties of ZnFe2O4-decorated reduced graphene oxide nanocomposite for antibacterial applications
- 14 February 2024
- Published by Elsevier in Ceramics International
- Vol. 50 (9) , 16343-16351
Structural, morphological and optical properties of ZnFe2O4-decorated reduced graphene oxide nanocomposite for antibacterial applications
- 1 January 2024
- Published by AIP Publishing in AIP Conference Proceedings
- Vol. 2995 (1) , 020174
Facile one-step hydrothermal synthesis of ZnFe2O4 nanoferrites for magnetic hyperthermia
The ZnFe2O4 Nanoferrites are comprehensively employed as leading thermoseeds in biomedical applications remarkably in magnetic hyperthermia treatments owing to
- 1 January 2024
- Published by AIP Publishing in AIP Conference Proceedings
- Vol. 2995 (1) , 020174
Facile one-step hydrothermal synthesis of ZnFe2O4 nanoferrites for magnetic hyperthermia
The ZnFe2O4 Nanoferrites are comprehensively employed as leading thermoseeds in biomedical applications remarkably in magnetic hyperthermia treatments owing to
- Open Access
Optimizing the Fly Ash/Activator Ratio for a Fly Ash-Based Geopolymer through a Study of Microstructure, Thermal Stability, and Electrical Properties
Fly ash (FA)-based geopolymer was prepared using sodium hydroxide and sodium silicate (in 2.5ratio) as an alkali activator liquid (AL). The condition of FA/AL was optimized for achieving 1.00, 1.25, 1.5, and 1.75 ratios by varying the alkali concentrations, which are referred to as GP1, GP2, GP3, and GP4, respectively. The influence of slight variations in the FA/AL ratio on microstructure, morphology, functional groups, and composition was investigated by X-ray diffraction (XRD), field emission scanning electron microscopy (FESEM), X-ray fluorescence (XRF), and Fourier transform infrared spectroscopy (FTIR). FESEM detected a homogeneous fused matrix of fly ash and alkali activator solution up to 1.5 ratios; GP3 showed a dense morphology. FTIR confirmed that the formation of aluminosilicate gel induced a shift in the T–O (T = Si or Al) asymmetric stretching band, nearing a lower frequency. XRD showed an amorphous structure with phases, including quartz, mullite, hematite, and sodalite. The thermogravimetry and differential thermal analysis (TGA–DTA) indicated that the geopolymer samples were thermally stable. The electrical study concluded that the geopolymer possessed insulating properties.
Open AccessOptimizing the Fly Ash/Activator Ratio for a Fly Ash-Based Geopolymer through a Study of Microstructure, Thermal Stability, and Electrical Properties
Fly ash (FA)-based geopolymer was prepared using sodium hydroxide and sodium silicate (in 2.5ratio) as an alkali activator liquid (AL). The condition of FA/AL was optimized for achieving 1.00, 1.25, 1.5, and 1.75 ratios by varying the alkali concentrations, which are referred to as GP1, GP2, GP3, and GP4, respectively. The influence of slight variations in the FA/AL ratio on microstructure, morphology, functional groups, and composition was investigated by X-ray diffraction (XRD), field emission scanning electron microscopy (FESEM), X-ray fluorescence (XRF), and Fourier transform infrared spectroscopy (FTIR). FESEM detected a homogeneous fused matrix of fly ash and alkali activator solution up to 1.5 ratios; GP3 showed a dense morphology. FTIR confirmed that the formation of aluminosilicate gel induced a shift in the T–O (T = Si or Al) asymmetric stretching band, nearing a lower frequency. XRD showed an amorphous structure with phases, including quartz, mullite, hematite, and sodalite. The thermogravimetry and differential thermal analysis (TGA–DTA) indicated that the geopolymer samples were thermally stable. The electrical study concluded that the geopolymer possessed insulating properties.
- 29 September 2023
- Published by Elsevier in Physica B: Condensed Matter
- Vol. 670
Improvement of power conversion efficiency by tailoring of energy band gaps in Ag doped TiO2–SnO2 nanocomposites
- 29 September 2023
- Published by Elsevier in Physica B: Condensed Matter
- Vol. 670
Improvement of power conversion efficiency by tailoring of energy band gaps in Ag doped TiO2–SnO2 nanocomposites
- 6 June 2023
- Published by Taylor & Francis in Polymer-Plastics Technology and Materials
- Vol. 62 (11) , 1424-1434
Preparation and Characterisation of VS4-PANI Composites for Fluorescent Metal Ions Sensing Applications
- 6 June 2023
- Published by Taylor & Francis in Polymer-Plastics Technology and Materials
- Vol. 62 (11) , 1424-1434
Preparation and Characterisation of VS4-PANI Composites for Fluorescent Metal Ions Sensing Applications