SASadulla R. Allayarov

Sadulla R. Allayarov

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Sadulla R. Allayarov has a total of 149 co-authors. Here are the top co-authors by number of shared publications:

  • D. A. Dixon

    University of Alabama

    27 shared publications
  • S. V. Demidov

    Federal Research Center on Problems of Chemical Physics and Medicinal Chemistry, Russian Academy of Sciences, Chernogolovka, Russia

    26 shared publications
  • Yu. A. Ol’KHov

    Russian Academy of Sciences

    16 shared publications
  • U. Yu. Allayarova

    Federal Research Center on Problems of Chemical Physics and Medicinal Chemistry, Russian Academy of Sciences, Chernogolovka, Russia

    15 shared publications
  • Yu. A. Olkhov

    Institute of Problems of Chemical Physics, Russian Academy of Sciences, 142432, Chernogolovka, Moscow oblast, Russia

    14 shared publications
  • David A. Dixon

    Department of Chemistry and Biochemistry The University of Alabama Tuscaloosa Alabama USA

    13 shared publications

Latest Publications

  • The Effect of Gamma Irradiation on the Toxicity of the Lightly Crosslinked Polyacrylic Acid “Carbomer 940”

    by U. Yu. Allayarova, E. N. Klimanova, T. E. Sashenkova, V. N. Varfolomeev, S. V. Demidov, S. S. Fedulin, S. R. Allayarov

    The impact of gamma irradiation in the range of 500 to 2000 kGy on the toxicological profile of Carbomer 940 was evaluated. Irradiation at a dose of 500 kGy increased the toxicity of aqueous dispersions of the carbomer by 20% compared to its unirradiated sample, whereas increasing the dose to 1000–2000 kGy led to a subsequent decrease in toxicity by 7%. It was also found that gamma irradiation affected the dynamics of animal body weight. When the unirradiated carbomer was administered to animals, the maximum body weight loss reached 3.5 g over a 3 day period. In the case of irradiated carbomer, the weight loss was as low as 0.5–2.2 g and recovery occurred faster due to a reduction in dispersion viscosity and the loss of carbomer gelling properties. Structural degradation caused by irradiation allowed for single dose administration above 1400 mg per kg, unlike the unirradiated material, which required repeated dosing. Absence of residual abdominal fluid in animals treated with the carbomer irradiated at 1000 to 2000 kGy confirmed the loss of gelling capacity. Carbomer 940 retained moderate toxicity corresponding to hazard class 3 according to GOST 12.1.007 76 after intraperitoneal administration.

  • The Effect of Gamma Irradiation in a Wide Dose Range on the Functional Composition of Lightly Crosslinked Polyacrylic Acid (Carbomer 940)

    by M. A. Gorbunova, A. T. Kapasharov, S. V. Demidov, S. S. Fedulin, G. V. Malkov, S. R. Allayarov

    The effect of γ-irradiation in the dose range from 5 to 1700 kGy on the structural changes of the lightly crosslinked polyacrylic acid Carbomer 940 has been studied using IR spectroscopy to analyze the features of radiation-chemical transformations in the polymer matrix. It has been established that irradiation causes a stepwise change in the functional composition of the polymer, including redistribution of hydrogen bonds and rupture of crosslinks followed by modification of functional groups at high doses. At doses up to 400 kGy, a reformation of intermole cular interactions without degradation of the polymer backbone is observed. In the 400–800 kGy range, irreversible oxidative degradation occurs, forming anhydride structures. High doses lead to polymer carbonization. Characteristic spectral indicators of each step of radiation-induced transformations have been identified, including the appearance of new absorption bands and changes in the intensity of the existing ones. Importantly, the integrity of the polymer backbone is maintained even at maximum radiation doses, despite significant changes in its functional composition.

  • The Effect of Gamma Irradiation on the Thermal Stability of Lightly Crosslinked Polyacrylic Acid Carbomer 940

    by M. A. Gorbunova, A. T. Kapasharov, S. V. Demidov, S. S. Fedulin, G. V. Malkov, S. R. Allayarov

    Changes in the thermal properties of carbomer after gamma irradiation have been analyzed using differential scanning calorimetry and thermogravimetric analysis. A multistep mechanism of thermal degradation of the polymer has been revealed upon heating in the range from 25 to 500°C. The most intense polymer degradation occurs at temperatures above 270°C. Thermogravimetric analysis revealed a shift in the peaks on the differential thermogravimetric curves, a decrease in their area, and an increase in the thermal degradation temperature, confirming an increase in post-irradiation thermal stability. It can be hypothesized that the increase in carbomer thermal stability under high radiation doses is associated with a decrease in the number of unsaturated bonds of pentaerythritol allyl ether that are not involved in primary crosslinking. The obtained data expand our understanding of the processes occurring in polyacrylates under the influence of ionizing radiation. This study has implications for the development of polymeric materials with controlled thermal and radiation properties.

  • Effect of bremsstrahlung radiation from accelerated electrons on the structure and surface morphology of low-density polyethylene

    by M. Yu. Tashmetov, N. B. Ismatov, S. R. Allayarov

    A comprehensive study of the structural and morphological changes in low-density polyethylene induced by bremsstrahlung irradiation in the dose range of 0–900[ ]kGy is presented. The observed effects are compared with those resulting from Co-60 gamma irradiation. The novelty of this work lies in the identification of specific features of structural modifications occurring in the near-surface layer of low-density polyethylene under bremsstrahlung irradiation with a continuous energy spectrum (with a maximum energy up to 4.5[ ]MeV), applied for polymer modification. It is shown that at a dose of 100[ ]kGy, the degree of crystallinity increases from [ ] to [ ], indicating the predominance of radiation-induced structural ordering processes. With a further increase in dose up to 900[ ]kGy, the crystallinity decreases to [ ]. At the same time, new bands appear in the Raman spectra at [ ]1672 and [ ]1720[ ]cm[ ], corresponding to the formation of carbon–carbon double bonds and carbonyl groups, which indicate the dominance of degradation and oxidative processes. The study of surface microrelief reveals smoothing effects at high doses. The average surface roughness ([ ]) changes from [ ] to [ ] [ ]nm ([ ]400[ ]kGy), followed by a decrease to [ ] [ ]nm ([ ]900[ ]kGy). Comparison with gamma irradiation results demonstrates the specific nature of bremsstrahlung effects, associated with its continuous energy spectrum and the near-surface character of energy absorption, leading to the formation of inhomogeneous structural modifications in the surface layer.


  • The Effect of Gamma Irradiation on the Swelling Process of Carbomers and the Functional Properties of Gels Based on Them

    by A. R. Gataullin, S. A. Bogdanova, V. A. Abramov, M. S. Zhvaeva, S. V. Demidov, S. R. Allayarov

    The swelling processes of carbomers—various modifications of lightly crosslinked polyacrylic acid—in water have been studied depending on the γ-irradiation dose. It has been found that the swelling kinetics are primarily described by second-order rate equations. Irradiation was shown to reduce the degree of swelling and increase the crosslink density; these effects were less pronounced in the case of irradiation in a vacuum. Rheological tests of gels based on irradiated carbomers demonstrated a decrease in viscosity with increasing dose, which can be explained by both radiation destruction and modification of carboxyl groups that weakens the polyelectrolyte effect. The carbomer structural features are noted to influence swelling and the properties of gel systems. A study of diclofenac sodium release from gels has shown that irradiation of Carbomer 141G with a dose of 30 kGy significantly increases the yield of the drug, indicating the potential of using ionizing radiation to enhance the delivery of biologically active substances.

  • Surface Energy Properties of Polylactic Acid Treated with a Gamma Radiation Dose Used for Sterilization

    by S. A. Bogdanova, A. R. Gataullin, I. F. Shaimukhametova, D. R. Khisamieva, Yu. N. Khakimullin, R. Yu. Galimzyanova, A. A. Nikiforov, S. V. Demidov, U. Yu. Allayarova, T. A. Raevskaya, et al.

    The effect of γ-irradiation on polylactic acid samples obtained by injection molding has been studied depending on the dose in the range of 10−100 kGy. Determination of the surface energy characteristics of polylactic acid (surface free energy and its components, as well as surface polarity) has shown that with an increase in the radiation dose, all parameters first decrease to a minimum value and then begin to increase. Obviously, processes of carbonization and radiation-induced oxidation caused by crosslinking and degradation, respectively, occur in the surface layer. According to the differential thermal and thermogravimetric analysis data, the determined physical and mechanical characteristics, and the melt flow index, competing radiation-chemical processes of crosslinking and degradation take place in polylactic acid, with the latter process prevailing with increasing radiation dose.


  • Effect of Thermal Annealing and Gamma Radiation Dose on the Mechanical and Dielectric Properties of Kapton and PM-BU Polyimide Films

    by M. V. Gapanovich, D. S. Lutsenko, S. V. Demidov, E. N. Koltsov, D. S. Polikarpov, E. V. Rabenok, D. R. Kalimullina, V. V. Rakitin, S. R. Allayarov

    Effect of annealing temperature and γ-radiation dose on the mechanical and dielectric properties of PM-BU and Kapton polyimide films has been studied. These films exhibit significantly different mechanical properties; however, they are characterized by thermal and radiation resistance and have similar dielectric properties.

  • The Effect of Gamma Irradiation of Papain on the Physicochemical Properties of Its Aqueous Solutions

    by A. R. Gataullin, S. A. Bogdanova, A. E. Shevyakova, S. V. Demidov, S. R. Allayarov

    The effect of γ-irradiation of papain with doses from 30 to 700 kGy on the absorption of ultraviolet and visible light, isoelectric state, viscosity, surface tension, and electrical conductivity of its aqueous solutions has been studied. It has been shown that an increase in the papain irradiation dose, on one hand, is accompanied by an increase in UV and visible absorption and an enhancement in conductivity and, on the other hand, leads to a decrease in the viscosity and surface tension of papain solutions. The main reasons for such changes are the destruction of peptide bonds in papain during radiolysis and a decrease in its molecular weight, radiation-induced oxidation of amino acid residues, the formation of carbonyl derivatives, and the formation and accumulation in papain macromolecules of various terminal primary amino groups that carry a positive charge.

  • EPR Spectra and Antioxidant Activity of Gamma-Irradiated Papain

    by S. V. Tokarev, I. I. Faingold, D. A. Poletaeva, A. V. Smolina, S. V. Demidov, A. V. Akimov, U. Yu. Allayarova, T. A. Raevskaya, S. R. Allayarov

    The structure and number of paramagnetic centers (PC) trapped in papain γ-irradiated with a dose of 50 to 2300 kGy have been studied using EPR spectroscopy. The radiation-chemical yield G ≈ 6 PC/100 eV during radiolysis at 77 K is six times greater than that in the samples irradiated at 300 K. In the case of radiolysis at 300 K, the maximum PC concentration is achieved at doses of 200 kGy at еру level of 8 × 1018 PC/g, whereas paramagnetic centers in papain radiolyzed at 77 K accumulate up to 2300 kGy and reach 2.2 × 1020 PC/g. During papain radiolysis at 77 K, the cleavage of the peptide bonds prevail over the scission of bonds in molecular groups of amino acid residues, including the sulfur-containing ones. As a result, \( - {\text{C}}( {=} {\text{O}}){-} \mathop {\text{C}}\limits^\bullet {\text{H}}{-} {\text{C}}{{{\text{H}}}_{{\text{2}}}}{\text{R}}\) radicals are mainly recorded in the EPR spectra. In the multicomponent spectrum of papain irradiated at 300 K, a doublet with splittings of 1.77 mT is distinguished, which is attributed to the \( - {\text{C}}( {=} {\text{O}}){-} \mathop {\text{C}}\limits^\bullet {\text{H}}{-} {\text{NH}}{-} \) radical formed by hydrogen abstraction from the glycine residue. Peroxide radicals formed during radiation-induced oxidation at 300 K are not retained as trapped radicals in the matrix of irradiated papain and, most likely, participate in secondary radiation-chemical processes with the formation of oxygen-containing products. A tendency for the antiradical and antioxidant activity of papain to increase with increasing radiation dose is noted as a result of radiation-induced destruction of the peptide bond with the formation of amino acid fragments that are hydrogen atom donors.


  • Strength and Deformation Properties of Polyester Resins Subjected to Gamma Irradiation and Microwave Treatment

    by S. V. Demidov, A. N. Ilyin, E. Nurullaev, A. N. Kozlov, O. V. Chelnokova, S. N. Petrova, S. R. Allayarov

    The effect of 60Co γ-rays and microwave radiation on industrial polyester resins of the Kamfest-05I and Kamfest-15 VES brands has been studied. It has been shown that the mechanical characteristics of these resins improve with an increase in the γ-radiation dose up to 2000 kGy and worsen with a further increase in the absorbed dose. At the same time, in terms of the intensity of the tensile strength enhancement effect due to irradiation, the samples of the Kamfest-15I resin are superior to the Kamfest-05VES sample; in the case of bending strength, the opposite is observed, Kamfest-15 VES has higher strength than Kamfest-15I. Both brands of resins are characterized by a slight increase and further decline in strength characteristics with an increase in the time of microwave treatment. It is shown that the radiation resistance of resins depends on their composition and that γ-radiation doses up to 2000 kGy can be used to increase their strength.