Youssef Tamraoui
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Youssef Tamraoui has a total of 165 co-authors. Here are the top co-authors by number of shared publications:
- Bouchaib Manoun
Center for Study of Matter at Extreme Conditions (CeSMEC), Florida International University, VH-140, University Park, Miami, FL 33199, USA
15 shared publications Bouchaib Manoun
University Hassan 1st, FST
11 shared publicationsHassan Hannache
College of Chemical Sciences and Engineering (CCSE), Department of Materials Science, Energy and Nano-engineering (MSN)
11 shared publicationsP. Lazor
Department of Earth Sciences, Uppsala University, Uppsala, Sweden
11 shared publications- Jones Alami
Materials Science, Energy, and Nano‐engineering Department MSN Mohamed VI Polytechnic University Ben Guerir Morocco
10 shared publications F. Mirinioui
Laboratoire Rayonnement-matière et Instrumentation, Univ Hassan 1er, Settat, Morocco
8 shared publications
Latest Publications
- 28 October 2026
- Published by American Chemical Society (ACS) in ACS Applied Energy Materials
- Vol. 9 (21) , 13921-13932
Tailoring Manganese Oxide Cathodes via Basic-Medium Synthesis for Enhanced Zn2+ Storage: Unraveling Interfacial Kinetics and Transport Limitations
Manganese-based aqueous rechargeable zinc-ion batteries (AZIBs) are emerging as highly viable alternatives to lithium-ion systems for grid-scale energy storage, driven by their cost-effectiveness, intrinsic safety, and high theoretical capacity. However, their commercial deployment is currently hindered by performance degradation stemming from structural instability during prolonged cycling. This study systematically investigates the influence of the synthesis environment on the structural evolution and electrochemical performance of manganese oxide cathodes. By manipulating the reaction medium, we demonstrate that alkaline environments yield Hollandite-type NaxMn8O16 (h-MO) with hierarchical flower-like morphology, whereas near-neutral conditions produce aggregated Mn3O4 (MO) spherical particles. Comprehensive characterization via XRD, ICP-OES, Raman spectroscopy, XPS, SEM, TEM, and BET corroborates this distinct phase and morphological divergence. Electrochemical evaluations reveal that the h-MO cathode delivers a superior reversible capacity (252 mAh·g–1 at 50 mA·g–1) compared to MO counterpart (52 mAh·g–1). Furthermore, h-MO exhibits good cycling stability, displaying an 8% capacity increase over 160 cycles at 200 mA g–1. Ex situ XRD and SEM analyses reveal a reversible H+/Zn2+ co-storage mechanism accompanied by reversible zinc hydroxide sulfate formation. Crucially, operando electrochemical impedance spectroscopy (EIS) coupled with distribution of relaxation times (DRT) analysis was employed to deconvolute the dynamic electrochemical processes of the h-MO cathode during cycling. This advanced diagnostic approach provides profound insights into the evolution of interfacial charge-transfer and ion-transport kinetics. These findings highlight the importance of synthesis-driven control in tailoring manganese oxide cathodes and offer guidance for the rational design of advanced AZIB systems.
- 28 October 2026
- Published by American Chemical Society (ACS) in ACS Applied Energy Materials
- Vol. 9 (21) , 13921-13932
Tailoring Manganese Oxide Cathodes via Basic-Medium Synthesis for Enhanced Zn2+ Storage: Unraveling Interfacial Kinetics and Transport Limitations
Manganese-based aqueous rechargeable zinc-ion batteries (AZIBs) are emerging as highly viable alternatives to lithium-ion systems for grid-scale energy storage, driven by their cost-effectiveness, intrinsic safety, and high theoretical capacity. However, their commercial deployment is currently hindered by performance degradation stemming from structural instability during prolonged cycling. This study systematically investigates the influence of the synthesis environment on the structural evolution and electrochemical performance of manganese oxide cathodes. By manipulating the reaction medium, we demonstrate that alkaline environments yield Hollandite-type NaxMn8O16 (h-MO) with hierarchical flower-like morphology, whereas near-neutral conditions produce aggregated Mn3O4 (MO) spherical particles. Comprehensive characterization via XRD, ICP-OES, Raman spectroscopy, XPS, SEM, TEM, and BET corroborates this distinct phase and morphological divergence. Electrochemical evaluations reveal that the h-MO cathode delivers a superior reversible capacity (252 mAh·g–1 at 50 mA·g–1) compared to MO counterpart (52 mAh·g–1). Furthermore, h-MO exhibits good cycling stability, displaying an 8% capacity increase over 160 cycles at 200 mA g–1. Ex situ XRD and SEM analyses reveal a reversible H+/Zn2+ co-storage mechanism accompanied by reversible zinc hydroxide sulfate formation. Crucially, operando electrochemical impedance spectroscopy (EIS) coupled with distribution of relaxation times (DRT) analysis was employed to deconvolute the dynamic electrochemical processes of the h-MO cathode during cycling. This advanced diagnostic approach provides profound insights into the evolution of interfacial charge-transfer and ion-transport kinetics. These findings highlight the importance of synthesis-driven control in tailoring manganese oxide cathodes and offer guidance for the rational design of advanced AZIB systems.
- 5 June 2026
- Published by American Chemical Society (ACS) in Energy & Fuels
- Vol. 40 (24) , 13108-13121
Oil Shale Upcycling to Battery-Grade Graphitic Carbon with CO 2 -Free H 2 Coproduction
- 5 June 2026
- Published by American Chemical Society (ACS) in Energy & Fuels
- Vol. 40 (24) , 13108-13121
Oil Shale Upcycling to Battery-Grade Graphitic Carbon with CO 2 -Free H 2 Coproduction
- 1 June 2026
- Published by IOP Publishing in Engineering Research Express
- Vol. 8 (12) , 125002
Acid-leaching-derived potassium-free birnessite (Mn 7 O 13 ·5H 2 O) as an efficient cathode for aqueous zinc-ion batteries
Aqueous zinc-ion batteries (AZIBs) have gained considerable attention as a cost-effective and inherently safe technology for large-scale energy storage. However, their practical development remains limited by sluggish Zn 2+ diffusion, structural degradation, and phase transformations of cathode materials, mainly associated with the large hydrated radius of Zn 2+ ions. In this study, a hydrated birnessite-type manganese oxide (Mn 7 O 13 ·5H 2 O), denoted as b- MO, is prepared through a mild acid-leaching treatment of potassium birnessite (KMO, K 0.37 MnO 2 ). Structural and physicochemical analyses confirm the effective removal of potassium ions and the formation of a hydrated layered structure with enlarged interlayer spacing. When employed as a cathode for AZIBs, an application that, to the best of our knowledge, has not been previously reported, b- MO exhibits a high specific capacity of up to 347 mAh g − 1 at 50 mA g − 1 , together with excellent coulombic efficiency (96%–100%), stable cycling, and good rate capability. This straightforward and scalable synthesis strategy offers a promising route for designing advanced manganese-oxide cathodes for high-performance AZIB systems.
- 1 June 2026
- Published by IOP Publishing in Engineering Research Express
- Vol. 8 (12) , 125002
Acid-leaching-derived potassium-free birnessite (Mn 7 O 13 ·5H 2 O) as an efficient cathode for aqueous zinc-ion batteries
Aqueous zinc-ion batteries (AZIBs) have gained considerable attention as a cost-effective and inherently safe technology for large-scale energy storage. However, their practical development remains limited by sluggish Zn 2+ diffusion, structural degradation, and phase transformations of cathode materials, mainly associated with the large hydrated radius of Zn 2+ ions. In this study, a hydrated birnessite-type manganese oxide (Mn 7 O 13 ·5H 2 O), denoted as b- MO, is prepared through a mild acid-leaching treatment of potassium birnessite (KMO, K 0.37 MnO 2 ). Structural and physicochemical analyses confirm the effective removal of potassium ions and the formation of a hydrated layered structure with enlarged interlayer spacing. When employed as a cathode for AZIBs, an application that, to the best of our knowledge, has not been previously reported, b- MO exhibits a high specific capacity of up to 347 mAh g − 1 at 50 mA g − 1 , together with excellent coulombic efficiency (96%–100%), stable cycling, and good rate capability. This straightforward and scalable synthesis strategy offers a promising route for designing advanced manganese-oxide cathodes for high-performance AZIB systems.
- Open Access
- 15 January 2026
- Published by American Chemical Society (ACS) in ACS Omega
- Vol. 11 (3) , 4304-4313
Recovery of Ferromagnetic Hematite Submicron Particles from Pyrrhotite Ash and Comprehensive Study of Their Structural, Morphological, and Magnetic Properties
The rapid advancement of modern civilization has increased the demand for heavy metals, while the exhaustion of high-grade natural ore supplies compels the investigation of alternate metal sources. Simultaneously, industrial activities cause substantial amounts of inorganic solid waste every year globally, and pyrrhotite ash (PA) represents a notable case for study. PA is an inorganic solid waste produced during the manufacture of phosphoric acid from roasted pyrrhotite ore and contains valuable metals, including Fe. Currently, PA is stored in large open spaces without treatment, posing significant environmental challenges. In response, this study aimed to extract iron oxide particles, identified as a potential raw material for the preparation of new materials. In this work, we develop a full synthesis process of ferromagnetic hematite particles from PA, through acid leaching, followed by a hydrothermal and co-precipitation reaction. Both techniques were effective and led to the production of α-Fe2O3 (hematite structure) as confirmed by XRD, SEM, TGA, and Raman spectroscopy techniques, while magnetic properties were determined by using VSM at room temperature. The results revealed that the extracted hematite particles exhibit ferromagnetic behavior.
- 15 January 2026
- Published by American Chemical Society (ACS) in ACS Omega
- Vol. 11 (3) , 4304-4313
Open AccessRecovery of Ferromagnetic Hematite Submicron Particles from Pyrrhotite Ash and Comprehensive Study of Their Structural, Morphological, and Magnetic Properties
The rapid advancement of modern civilization has increased the demand for heavy metals, while the exhaustion of high-grade natural ore supplies compels the investigation of alternate metal sources. Simultaneously, industrial activities cause substantial amounts of inorganic solid waste every year globally, and pyrrhotite ash (PA) represents a notable case for study. PA is an inorganic solid waste produced during the manufacture of phosphoric acid from roasted pyrrhotite ore and contains valuable metals, including Fe. Currently, PA is stored in large open spaces without treatment, posing significant environmental challenges. In response, this study aimed to extract iron oxide particles, identified as a potential raw material for the preparation of new materials. In this work, we develop a full synthesis process of ferromagnetic hematite particles from PA, through acid leaching, followed by a hydrothermal and co-precipitation reaction. Both techniques were effective and led to the production of α-Fe2O3 (hematite structure) as confirmed by XRD, SEM, TGA, and Raman spectroscopy techniques, while magnetic properties were determined by using VSM at room temperature. The results revealed that the extracted hematite particles exhibit ferromagnetic behavior.
- 27 November 2025
- Published by Elsevier in Journal of the European Ceramic Society
- Vol. 46 (5)
Engineered microcracking in alumina/aluminum titanate composites: A pathway to enhance nonlinear mechanical behavior and fracture energy
- 27 November 2025
- Published by Elsevier in Journal of the European Ceramic Society
- Vol. 46 (5)
Engineered microcracking in alumina/aluminum titanate composites: A pathway to enhance nonlinear mechanical behavior and fracture energy
- Open Access
- 16 July 2024
- Published by MDPI AG in Nanomaterials
- Vol. 14 (14) , 1204
Rate-Dependent Stability and Electrochemical Behavior of Na3NiZr(PO4)3 in Sodium-Ion Batteries
In advancing sodium-ion battery technology, we introduce a novel application of Na3NiZr(PO4)3 with a NASICON structure as an anode material. This research unveils, for the first time, its exceptional ability to maintain high specific capacity and unprecedented cycle stability under extreme current densities up to 1000 mA·g−1, within a low voltage window of 0.01–2.5 V. The core of our findings lies in the material’s remarkable capacity retention and stability, which is a leap forward in addressing long-standing challenges in energy storage. Through cutting-edge in situ/operando X-ray diffraction analysis, we provide a perspective on the structural evolution of Na3NiZr(PO4)3 during operation, offering deep insights into the mechanisms that underpin its superior performance.
- 16 July 2024
- Published by MDPI AG in Nanomaterials
- Vol. 14 (14) , 1204
Open AccessRate-Dependent Stability and Electrochemical Behavior of Na3NiZr(PO4)3 in Sodium-Ion Batteries
In advancing sodium-ion battery technology, we introduce a novel application of Na3NiZr(PO4)3 with a NASICON structure as an anode material. This research unveils, for the first time, its exceptional ability to maintain high specific capacity and unprecedented cycle stability under extreme current densities up to 1000 mA·g−1, within a low voltage window of 0.01–2.5 V. The core of our findings lies in the material’s remarkable capacity retention and stability, which is a leap forward in addressing long-standing challenges in energy storage. Through cutting-edge in situ/operando X-ray diffraction analysis, we provide a perspective on the structural evolution of Na3NiZr(PO4)3 during operation, offering deep insights into the mechanisms that underpin its superior performance.
- 30 January 2024
- Published by Elsevier in Journal of the European Ceramic Society
- Vol. 44 (7) , 4761-4771
Crystallography and anisotropy of crystals shape in dense aluminum titanate ceramics
- 30 January 2024
- Published by Elsevier in Journal of the European Ceramic Society
- Vol. 44 (7) , 4761-4771
Crystallography and anisotropy of crystals shape in dense aluminum titanate ceramics
- 3 July 2022
- Published by Elsevier in Ceramics International
- Vol. 48 (20) , 30031-30040
Phosphate waste rocks recycling in ceramic wall tiles: Technical performances
- 3 July 2022
- Published by Elsevier in Ceramics International
- Vol. 48 (20) , 30031-30040
Phosphate waste rocks recycling in ceramic wall tiles: Technical performances