FWFuwei Wang

Fuwei Wang

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Fuwei Wang has a total of 82 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Design of a Broadband Polarization-Insensitive Transmitarray

    by Ke Li, Zhengqi Qu, Zhuang Li, Yuan-Ming Cai, Fuwei Wang, Yuhui Ren

    This letter presents a broadband, polarization-insensitive transmitarray based on a multi-resonance four-arm spiral unit cell. The proposed unit employs four-arm spiral structures in both the receiving and transmitting layers, interconnected by four metallic vias. The unit cell can receive incident waves with arbitrary polarization while maintaining the same polarization in the transmitted waves. The design achieves a wide operating band from 9 GHz to 19 GHz with transmission coefficient better than -2 dB, while maintain a low profile of only 0.23λ0 (where λ0 is the free-space wavelength at 14 GHz). A 16 × 16 transmitarray prototype based on the proposed unit was designed, fabricated and measured. Experimental results show a peak gain of 24.89 dBi, a fractional 3-dB gain bandwidth of 45.16%, and aperture efficiencies up to 44.1%. The proposed design combines the advantages of wide bandwidth, low-profile, and polarization insensitivity, showing significant potential for applications in wireless communication systems.

  • Dual-Broadband Dual-Mode Wearable Antenna for On/Off-Body WBAN Communications

    by Fuwei Wang, Baipeng Chen, Zihao Xu, Yanzheng Liu, Yanyan Li, Chen He

    This paper proposes a dual-broadband dual-mode wearable antenna (DBDMA), designed for ON-body and OFF-body communication modes in wireless body area network (WBAN). The cavity mode theory is applied to the design of the DBDMA. The desired dual-broadband and dual-mode characteristics are then achieved by incorporating metallic vias and slots, combining the TM01 and TM02 modes of a circular patch with the TM01, TM10, and TM03 modes of a rectangular one. In addition, the antenna uses the stacked structure and coupled feeding mechanism to acquire dual-broadband and dual-mode characteristics in a single-port configuration. A prototype of the antenna is manufactured and tested. The obtained results demonstrate that the designed antenna has high electrical performance. The measured S11 bandwidths (S11 < -10 dB) are 23.07% and 26.61%, respectively. Moreover, the gain for horizontal omnidirectional radiation in the ON-body mode is -3.82 dBi, while that for directional radiation in the OFF-body mode is 5.07 dBi. The specific absorption rate (SAR) remains less than the international safety standards in the operating frequency bands, which ensures the safety of the antenna in wearable applications. The DBDMA provides an effective dual-mode multi-frequency broadband solution for WBAN communication, which makes it suitable for various wearable applications in medical and health monitoring.


  • A dual-band dual-polarized wearable antenna for two operating modes of WBAN application

    by Yuhui Ren, Jiaxin Lv, Kemeng Yan, Wei Bai, Feng Cui, Ke Li, Fuwei Wang, Handong Wu

    A dual-band dual-polarized wearable antenna that applies to two different operating modes of wireless body area networks is proposed in this letter. The antenna radiates simultaneously in the ISM band at 2.45 and 5.8 GHz. It consists of a rigid button-like radiator and a flexible fabric radiator. At 2.45 GHz, an omnidirectional circularly polarized pattern is radiated by the flexible radiator, which is suitable for the on-body communication. At the same time, a linearly polarized broadside pattern for off-body communication is generated by button radiator at 5.8 GHz. The antenna has been validated in free space and human body environments. The impedance bandwidth at 2.45 and 5.8 GHz are 5% and 35%, and the gain is measured to be 0.15 and 5.95 dBi, respectively. Furthermore, the specific absorption rates are simulated. At 2.45 and 5.8 GHz, the results averaged over 1 g of body tissue are 0.128 and 0.055 W/kg. The maximum value at both bands is below the IEEE C95.3 standard of 1.6 W/kg.


  • Open Access

    Passive temperature sensing through chipless vanadium dioxide metasurface tags

    by Fuwei Wang, Rong Sun, Xuechen Zhang, Yanzheng Liu, Mei Qi, Chen He

    Passive temperature sensing systems based on the Internet of Things (IoT) present an efficient, reliable, and convenient solution for temperature monitoring with extensive application prospects and market value. This paper introduces a passive, battery-free, chipless, metasurface temperature sensing tag. The key insight is that the sensing tag uses vanadium dioxide (\(\hbox{VO}_{2}\)) to solve the problems of measuring distance, large size, and high cost related to active devices. The sensing tag fabricated with tungsten-doped \(\hbox{VO}_{2}\) powder demonstrated a significant variation in the reflection magnitude within the temperature range of 34–42 °C. It was achieved through coating, sintering, metasurface design, and ion beam etching. Experimental results showed that the square resistance of the prepared coating decreased from 1003 to 90 \({\Omega }/{\square }\) as the temperature increased from 34 to 42 °C. Additionally, the reflection magnitude of the tag significantly increased with the temperature decrease in the 3.5–5.27 GHz frequency band. These results indicate that the passive temperature sensing tags can achieve rapid and accurate temperature sensing within the 34–42 °C range.


  • Open Access

    A Multibeam Solar Grid Antenna Integrated With Monocrystalline Silicon Solar Cell

    by Fuwei Wang, Xuechen Zhang, Rong Sun, Bokai Ding, Ke Li, Chen He

    This paper proposes a multibeam grid antenna integrated with a monocrystalline silicon solar panel first time, which consists of a grid antenna in microstrip form and a monocrystalline silicon solar cell. Multiple feeders are set at different positions of the grid antenna to adjust the current phase on the short side of the grid antenna to achieve beam scanning. The antenna is designed to operate in the 24 GHz radar band and can be installed in field Internet of Things devices for vehicle monitoring and communication, meeting requirements for communication rate, sensing sensitivity, detection, and interconnectivity. The multibeam characteristic can effectively enhance the communication and sensing detection range of the antenna. Meanwhile, the grid-like structure of the antenna ensures good optical transmission, allowing it to be positioned above the solar panel without significantly affecting the performance of the solar cell. The measurement results show that the multibeam solar grid antenna can cover the 24 GHz radar band and achieve beam deflection in four azimuth planes with a gain range of 15.2 to 16.6 dBi at the center frequency of 24.125 GHz. And the solar panel can supply a voltage of 0.56 V. The proposed antenna can realize the power supply and wide-range communication and detection for Internet of Things systems, which has great potential for application.


  • Open Access

    Perfat: Non-contact Abdominal Obesity Assessment System

    by Chaoyi Pan, Dan Xu, Shiyuan Xu, Fuwei Wang, Chao Zheng, Bingyue Liu, Xiaojiang Chen

    Extensive research has revealed a strong correlation between excess abdominal fat and chronic diseases, such as insulin resistance, hypertension and hypercholesterolemia. Therefore, the measurement of abdominal fat in daily life is significant. Many household body fat scales can provide abdominal (trunk) fat value for users, however, these scales require users to stand barefoot, gripping the electrodes with their arms straight, which is not friendly for those users who are unable to stand. Specialized equipment in hospitals, such as computed tomography (CT) and magnetic resonance imaging (MRI) machines, can provide accurate abdominal fat value with less restriction on user's posture, but those machines are costly, bulky and professional, making them impractical for home use. In this paper, we present Perfat, a system that aims to estimate the abdominal fat percentage accurately. The key insight of Perfat is that, as signals pass through the human body, the energy attenuation of signals at different frequencies varies, and the abdominal fat percentage can be calculated based on such attenuation variation. To evaluate the performance of Perfat, we developed a prototype using software-defined radio and conducted experiments with 50 participants. We compared Perfat with the Inbody S10 body composition analyzer and found a correlation of over 96.7%.


  • Tilted-Beam Solar Antenna for Hybrid Energy Harvesting System

    by Ke Li, Jinge Guo, Zhuang Li, Yuan-Ming Cai, Fu-Wei Wang, Yuhui Rena

    A tilted-beam antenna array integrated with solar cells is proposed in this letter. In each unit, four rectangular crystalline silicon solar cells are arranged as superstrate on the top of a slot antenna. By changing the relative position of the superstrate and feeding structure, two modes of the antenna can be observed with tilted beams. A power divider is employed, and the two modes are combined which leads to a dual-beam at +30° and -30° simultaneously. A 1 × 3 antenna array is proposed and fabricated, and the measured fractional bandwidth is 20.8%, with a low profile of 0.025λ0 and a peak gain of 13.2 dBi. The experiment of the solar cell is also carried out to verify the effectiveness of the design. The proposed antenna array has the advantages of wideband, high gain, low profile and tilted beam, which makes it suitable for the hybrid energy harvesting system.


  • Directional High-Gain Liquid Antenna Using Tumbler-Like Dielectric Resonator for Wireless Capsule Endoscope System

    by Fuwei Wang, Wenhui Luo, Zihao Xu, Ke Li, Yuhui Ren

    This paper proposes a directional antenna applied to a wireless capsule endoscope (WCE) system using a tumbler-like liquid dielectric resonator. The liquid dielectric resonator antenna (LDRA) is composed of an upper zone comprising water and a lower zone consisting of the Galinstan liquid metal, and it is stored in a spherical container fabricated using 3D printing technology. The attitude-independent characteristic of the proposed antenna is reached by combining the “tumbler principle” with the hemispherical DRA theory and using appropriate liquid materials. Therefore, this method can provide directional radiation performance to significantly improve the gain of the antenna without affecting the normal communication of the WCE system in the human body. Water with a high dielectric constant is used as the liquid dielectric material in order to miniaturize the antenna. The experimental results demonstrate that the working band of the proposed antenna, which is referred to as TLDRA, is 5.72-5.88 GHz (S11 < -10 dB), with a maximum gain of -12.6 dBi, and thus it covers the Industrial, Scientific, and Medical (ISM) band (5.725-5.875 GHz). TLDRA has a small size and high gain, and therefore it has great potential in the WCE system applications.