David Cleaver
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
David Cleaver has a total of 18 co-authors. Here are the top co-authors by number of shared publications:
Ismet Gursul
University of Bath
10 shared publicationsZ. Wang
8 shared publications- Ismet Gursul
University of Bath
7 shared publications I. Gursul
6 shared publicationsZhi-Jin Wang
University of Bath
4 shared publicationsZhijin Wang
University of Bath
4 shared publications
Latest Publications
- 6 January 2019
- Published by American Institute of Aeronautics and Astronautics (AIAA)
Dynamic Stall Alleviation through Mini-tabs
- 6 January 2019
- Published by American Institute of Aeronautics and Astronautics (AIAA)
Dynamic Stall Alleviation through Mini-tabs
- 1 March 2017
- Published by American Institute of Aeronautics and Astronautics (AIAA) in Journal of Aircraft
- Vol. 54 (2) , 408-854
Stall Delay of Two-Wing Configurations with Decalage at Low Reynolds Numbers
- 1 March 2017
- Published by American Institute of Aeronautics and Astronautics (AIAA) in Journal of Aircraft
- Vol. 54 (2) , 408-854
Stall Delay of Two-Wing Configurations with Decalage at Low Reynolds Numbers
- Open Access
- 1 July 2016
- Published by Elsevier in Journal of Fluids and Structures
- Vol. 64, 27-45
Lift enhancement through flexibility of plunging wings at low Reynolds numbers
- 1 July 2016
- Published by Elsevier in Journal of Fluids and Structures
- Vol. 64, 27-45
Open AccessLift enhancement through flexibility of plunging wings at low Reynolds numbers
- 2 January 2016
- Published by American Institute of Aeronautics and Astronautics (AIAA)
Aerodynamic Load Control through Blowing
- 2 January 2016
- Published by American Institute of Aeronautics and Astronautics (AIAA)
Aerodynamic Load Control through Blowing
- Open Access
- 2 January 2016
- Published by American Institute of Aeronautics and Astronautics (AIAA)
An Experimental Study of Mini-Tabs for Aerodynamic Load Control
- 2 January 2016
- Published by American Institute of Aeronautics and Astronautics (AIAA)
Open AccessAn Experimental Study of Mini-Tabs for Aerodynamic Load Control
- 3 June 2015
- Published by Springer Nature in Experiments in Fluids
- Vol. 56 (6) , 1-25
Aerodynamics of biplane and tandem wings at low Reynolds numbers
- 3 June 2015
- Published by Springer Nature in Experiments in Fluids
- Vol. 56 (6) , 1-25
Aerodynamics of biplane and tandem wings at low Reynolds numbers
- 3 January 2015
- Published by American Institute of Aeronautics and Astronautics (AIAA)
Fluid-Structure Interactions for Flexible and Rigid Tandem-Wings at Low Reynolds Numbers
Force, Particle Image Velocimetry, Digital Image Correlation and hot-wire measurements were performed for two flat rectangular wings of semi-aspect-ratio 2 in tandem configurations. The wings were separated by a streamwise distance of 1.5 chord lengths at 30° angle of attack and Reynolds number 100,000. The crosswise wing separation was varied systematically from -1.5 to 1.5 chord lengths. A rigid-leading rigid-trailing (R-R) wing configuration and a flexible-leading rigid-trailing (F-R) wing configuration were considered. Crosswise wing separations for the F-R case between 0.0 to 0.4 chord lengths were shown to increase lift coefficient relative to the R-R case; the main benefit in lift generation was noted for the trailing-wing. For the F-R configuration, spanwise deformation of the leading-flexible wing shifted the impingement point of the trailing-edge shear layer on the trailing-wing thus affecting lift generation. Deformation measurements showed that the presence of the rigid-trailing-wing had a profound influence on the flow-induced vibrations of the leading-flexible-wing, peaking at a crosswise separation of 0.32 chord lengths which also provided the largest unsteady forces. Velocity spectra measurements revealed that cases producing increased unsteady forces possessed distinct inter-wing velocity fluctuations which were coupled with the wing vibrations. The results demonstrate that the time-averaged forces and unsteady fluid-structure interactions are strongly determined by the crosswise wing separation and the spanwise flexibility of the leading-wing in tandem configurations
- 3 January 2015
- Published by American Institute of Aeronautics and Astronautics (AIAA)
Fluid-Structure Interactions for Flexible and Rigid Tandem-Wings at Low Reynolds Numbers
Force, Particle Image Velocimetry, Digital Image Correlation and hot-wire measurements were performed for two flat rectangular wings of semi-aspect-ratio 2 in tandem configurations. The wings were separated by a streamwise distance of 1.5 chord lengths at 30° angle of attack and Reynolds number 100,000. The crosswise wing separation was varied systematically from -1.5 to 1.5 chord lengths. A rigid-leading rigid-trailing (R-R) wing configuration and a flexible-leading rigid-trailing (F-R) wing configuration were considered. Crosswise wing separations for the F-R case between 0.0 to 0.4 chord lengths were shown to increase lift coefficient relative to the R-R case; the main benefit in lift generation was noted for the trailing-wing. For the F-R configuration, spanwise deformation of the leading-flexible wing shifted the impingement point of the trailing-edge shear layer on the trailing-wing thus affecting lift generation. Deformation measurements showed that the presence of the rigid-trailing-wing had a profound influence on the flow-induced vibrations of the leading-flexible-wing, peaking at a crosswise separation of 0.32 chord lengths which also provided the largest unsteady forces. Velocity spectra measurements revealed that cases producing increased unsteady forces possessed distinct inter-wing velocity fluctuations which were coupled with the wing vibrations. The results demonstrate that the time-averaged forces and unsteady fluid-structure interactions are strongly determined by the crosswise wing separation and the spanwise flexibility of the leading-wing in tandem configurations
- 1 November 2014
- Published by Elsevier in Journal of Fluids and Structures
- Vol. 51, 401-412
Thrust enhancement due to flexible trailing-edge of plunging foils
- 1 November 2014
- Published by Elsevier in Journal of Fluids and Structures
- Vol. 51, 401-412
Thrust enhancement due to flexible trailing-edge of plunging foils
- 1 July 2014
- Published by AIP Publishing in Physics of Fluids
- Vol. 26 (7) , 071907
On the absence of asymmetric wakes for periodically plunging finite wings
It has previously been shown that, at high Strouhal numbers, oscillating airfoils can produce deflected jets that can create very high lift-coefficients for otherwise symmetric scenarios. These deflected jets form through pairing of the trailing-edge vortices to create asymmetric vortex couples that self-propel at an angle to the freestream, resulting in an asymmetric flow field and non-zero lift. In this paper results are presented that indicate these high-lift deflected jets cannot form for finite wings. Instead of the straight vortex tubes that pair and convect at an angle to the freestream observed for effectively infinite wings, finite wings exhibit vortex tubes that break into two branches near the tip forming double helix structures. One branch connects with the last vortex; one branch connects with the next vortex. This creates a long “daisy chain” of interconnected trailing edge vortices forming a long series of vortex loops. These symmetric flow fields are shown to persist for finite wings even to Strouhal numbers more than twice those required to produce asymmetric wakes on plunging airfoils. Two contributing reasons are discussed for why deflected jets are not observed. First the tip vortex creates three-dimensionality that discourages vortex coupling. Second, the symmetry of the circulation of the interconnected vortex loops, which has been confirmed by the experiments, is a natural consequence of the vortex topology. Therefore, the asymmetry in trailing edge vortex strength previously observed as characteristic of deflected jets cannot be supported for finite wings.
- 1 July 2014
- Published by AIP Publishing in Physics of Fluids
- Vol. 26 (7) , 071907
On the absence of asymmetric wakes for periodically plunging finite wings
It has previously been shown that, at high Strouhal numbers, oscillating airfoils can produce deflected jets that can create very high lift-coefficients for otherwise symmetric scenarios. These deflected jets form through pairing of the trailing-edge vortices to create asymmetric vortex couples that self-propel at an angle to the freestream, resulting in an asymmetric flow field and non-zero lift. In this paper results are presented that indicate these high-lift deflected jets cannot form for finite wings. Instead of the straight vortex tubes that pair and convect at an angle to the freestream observed for effectively infinite wings, finite wings exhibit vortex tubes that break into two branches near the tip forming double helix structures. One branch connects with the last vortex; one branch connects with the next vortex. This creates a long “daisy chain” of interconnected trailing edge vortices forming a long series of vortex loops. These symmetric flow fields are shown to persist for finite wings even to Strouhal numbers more than twice those required to produce asymmetric wakes on plunging airfoils. Two contributing reasons are discussed for why deflected jets are not observed. First the tip vortex creates three-dimensionality that discourages vortex coupling. Second, the symmetry of the circulation of the interconnected vortex loops, which has been confirmed by the experiments, is a natural consequence of the vortex topology. Therefore, the asymmetry in trailing edge vortex strength previously observed as characteristic of deflected jets cannot be supported for finite wings.