MTMika Torkkeli

Mika Torkkeli

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Mika Torkkeli has a total of 316 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Interfacial structure of 70% fish oil-in-water emulsions stabilized with combinations of sodium caseinate and phosphatidylcholine

    by Betül Yesiltas, Mika Torkkeli, László Almásy, Zoltán Dudás, András Ferenc Wacha, Robert Dalgliesh, Pedro J. García-Moreno, Ann-Dorit M. Sørensen, Charlotte Jacobsen, Matti Knaapila


  • Structural Evaluation of 5,5′-Bis(naphth-2-yl)-2,2′-bithiophene in Organic Field-Effect Transistors with n-Octadecyltrichlorosilane Coated SiO2 Gate Dielectric

    by Andreas Ejdrup Lauritzen, Mika Torkkeli, Oier Bikondoa, Jes Linnet, Luciana Tavares, Jakob Kjelstrup-Hansen, Matti Knaapila

    We report on the structure and morphology of 5,5'-bis(naphth-2-yl)- 2,2'-bithiophene (NaT2) films in bottom-contact organic field-effect transistors (OFETs) with octadecyltrichlorosilane (OTS) coated SiO2 gate dielectric, characterized by atomic force microscopy (AFM), grazing-incidence X-ray diffraction (GIXRD) and electrical transport measurements. Three types of devices were investigated with the NaT2 thin-film deposited either on (1) pristine SiO2 (corresponding to higher surface energy, 47 mJ/m2) or on OTS deposited on SiO2 under (2) anhydrous or (3) humid conditions (corresponding to lower surface energies, 20-25 mJ/m2). NaT2 films grown on pristine SiO2 form nearly featureless 3-dimensional islands. NaT2 films grown on OTS/SiO2 deposited under anhydrous conditions form staggered pyramid islands where the interlayer spacing corresponds to the size of the NaT2 unit cell. At the same time, the grain size measured by AFM increases from hundreds of nanometers to micrometers and the crystal size measured by GIXRD from 30 nm to more than 100 nm. NaT2 on OTS/SiO2 deposited under humid conditions also promotes staggered pyramids but with smaller crystals 30-80 nm. The NaT2 unit cell parameters in OFETs differ 1-2% from those in bulk. Carrier mobilities tends to be higher for NaT2 layers on SiO2 (2-3E-4 cm2/Vs) compared to NaT2 on OTS (2E-5-1E-4 cm2/Vs). An applied voltage does not influence the unit cell parameters when probed by GIXRD in operando.


  • Open Access

    Hydrophobin Film Structure for HFBI and HFBII and Mechanism for Accelerated Film Formation

    by Aniket Magarkar, Nawel Mele, Noha Abdel-Rahman, Sarah Butcher, Mika Torkkeli, Ritva Serimaa, Arja Paananen, Markus Linder, Alex Bunker

    Hydrophobins represent an important group of proteins from both a biological and nanotechnological standpoint. They are the means through which filamentous fungi affect their environment to promote growth, and their properties at interfaces have resulted in numerous applications. In our study we have combined protein docking, molecular dynamics simulation, and electron cryo-microscopy to gain atomistic level insight into the surface structure of films composed of two class II hydrophobins: HFBI and HFBII produced by Trichoderma reesei. Together our results suggest a unit cell composed of six proteins; however, our computational results suggest P6 symmetry, while our experimental results show P3 symmetry with a unit cell size of 56 Å. Our computational results indicate the possibility of an alternate ordering with a three protein unit cell with P3 symmetry and a smaller unit cell size, and we have used a Monte Carlo simulation of a spin model representing the hydrophobin film to show how this alternate metastable structure may play a role in increasing the rate of surface coverage by hydrophobin films, possibly indicating a mechanism of more general significance to both biology and nanotechnology. Filamentous fungi release a specific type of protein, belonging to a protein family known as “hydrophobins” into their environment to control interfaces in a fashion that promotes growth. Such protein coatings are the mechanism that allows for the mycelia to grow out of the water and into the air. When these hydrophobins form films at the air-water interface and on the surface of solid objects immersed in water, they impart properties to those surfaces that has led to their use in a wide range of industrial applications. Of particular interest is the properties they impart to air liquid interfaces, and as a mechanism to bring protective materials to coat nanoparticles in nanotechnology applications. A more detailed knowledge of the structure of these surfaces will allow for augmentation of their function that is possible through genetic engineering of the hydrophobins themselves. In this study we have combined computational and experimental methods to develop atomistic level insight into the structure of this surface for two important hydrophobins: HFBI and HFBII of Trichoderma reesei. In addition to insight into the surface structure, we have uncovered an intriguing possible new mechanism for film formation, which may explain some of the striking properties of hydrophobin films, and could be extended to a more general mechanism.


  • Persistence of nematic liquid crystalline phase in a polyfluorene-based organic semiconductor: A high pressure study

    by Suchismita Guha, Matti Knaapila, Dhanashree Moghe, Zuzana Konôpková, Mika Torkkeli, Martin Fritsch, Ullrich Scherf


  • Open Access

    Nanostructuring of the conjugated polyelectrolyte poly[9,9-bis(4-sulfonylbutoxyphenyl)fluorene-2,7-diyl-2,2′-bithiophene] in liquid crystalline C12E4 in bulk water and aligned thin films

    by M. Knaapila, S. M. Fonseca, B. Stewart, M. Torkkeli, J. Perlich, S. Pradhan, U. Scherf, R. A. E. Castro, H. D. Burrows

    We report on the conjugated polyelectrolyte 12 mM poly[9,9-bis(4-sulfonylbutoxyphenyl) fluorene-2,7-diyl-2,2′-bithiophene] (PBS-PF2T) mixed in concentrated aqueous 680 mM tetraethylene glycol monododecyl ether (C12E4) in bulk and thin films. A blue-shift in the fluorescence spectrum demonstrates breakup of PBS-PF2T aggregates in bulk aqueous C12E4. Small-angle X-ray scattering data indicate that this mixture follows a very similar phase behaviour to binary mixtures of a pure surfactant with water, including a micellar phase below about 20 °C, a lamellar phase in between about 20 and 70 °C and a proposed coexistence of water and the liquid surfactant solution above 70 °C. Molecular dynamics simulations reproduce these transitions and suggest that PBS-PF2T is incorporated into the surfactant headgroup region, and is, on average, perpendicular to the alkyl chains. In wet thin films, grazing-incidence small-angle X-ray scattering shows that the phase window for the lamellar phase becomes much narrower, located at about 30–34 °C. Weakly ordered phases exist both below and above these temperatures. These phases are isotropic, but lamellae become aligned in a stacked manner on the surface whether approached from low or high temperatures. Dry films are disordered but can be reversibly ordered and disordered and aligned and misaligned by maintaining the temperature at 30–34 °C and switching relative outside humidity between 32% and 100%.


  • Measuring Structural Inhomogeneity of Conjugated Polymer at High Pressures up to 30 GPa

    by Matti Knaapila, Mika Torkkeli, Zuzana Konôpková, Dörthe Haase, Hanns-Peter Liermann, Ullrich Scherf, Suchismita Guha


  • Drug release from nanoparticles embedded in four different nanofibrillar cellulose aerogels

    by Hanna Valo, Suvi Arola, Päivi Laaksonen, Mika Torkkeli, Leena Peltonen, Markus B. Linder, Ritva Serimaa, Shigenori Kuga, Jouni Hirvonen, Timo Laaksonen


  • Structural and Functional Roles of Carotenoids in Chlorosomes

    by Jakub Pšenčík, Juan B. Arellano, Aaron M. Collins, Pasi Laurinmäki, Mika Torkkeli, Benita Löflund, Ritva E. Serimaa, Robert E. Blankenship, Roman Tuma, Sarah J. Butcher

    Chlorosomes are large light-harvesting complexes found in three phyla of anoxygenic photosynthetic bacteria. Chlorosomes are primarily composed of self-assembling pigment aggregates. In addition to the main pigment, bacteriochlorophyll c , d , or e , chlorosomes also contain variable amounts of carotenoids. Here, we use X-ray scattering and electron cryomicroscopy, complemented with absorption spectroscopy and pigment analysis, to compare the morphologies, structures, and pigment compositions of chlorosomes from Chloroflexus aurantiacus grown under two different light conditions and Chlorobaculum tepidum . High-purity chlorosomes from C. aurantiacus contain about 20% more carotenoid per bacteriochlorophyll c molecule when grown under low light than when grown under high light. This accentuates the light-harvesting function of carotenoids, in addition to their photoprotective role. The low-light chlorosomes are thicker due to the overall greater content of pigments and contain domains of lamellar aggregates. Experiments where carotenoids were selectively extracted from intact chlorosomes using hexane proved that they are located in the interlamellar space, as observed previously for species belonging to the phylum Chlorobi . A fraction of the carotenoids are localized in the baseplate, where they are bound differently and cannot be removed by hexane. In C. tepidum , carotenoids cannot be extracted by hexane even from the chlorosome interior. The chemical structure of the pigments in C. tepidum may lead to π-π interactions between carotenoids and bacteriochlorophylls, preventing carotenoid extraction. The results provide information about the nature of interactions between bacteriochlorophylls and carotenoids in the protein-free environment of the chlorosome interior.


  • Structural study of helical polyfluorene under high quasihydrostatic pressure

    by M. Knaapila, Z. Konôpková, M. Torkkeli, D. Haase, H.-P. Liermann, S. Guha, U. Scherf

    We report on an x-ray diffraction (XRD) study of helical poly[9,9-bis(2-ethylhexyl)fluorene] (PF2/6) under high quasihydrostatic pressure and show an effect of pressure on the torsion angle (dihedral angle) between adjunct repeat units and on the hexagonal unit cell. A model for helical backbone conformation is constructed. The theoretical position for the most prominent 00l x-ray reflection is calculated as a function of torsion angle. The XRD of high molecular weight PF2/6 (Mn=30 kg/mol) is measured through a diamond anvil cell upon pressure increase from 1 to 10 GPa. The theoretically considered 00l reflection is experimentally identified, and its shift with the increasing pressure is found to be consistent with the decreasing torsion angle between 2 and 6 GPa. This indicates partial backbone planarization towards a more open helical structure. The h00 peak is identified, and its shift together with the broadening of 00l implies impairment of the ambient hexagonal order, which begins at or below 2 GPa. Previously collected high-pressure photoluminescence data are reanalyzed and are found to be qualitatively consistent with the XRD data. This paper provides an example of how the helical π-conjugated backbone structure can be controlled by applying high quasihydrostatic pressure without modifications in its chemical structure. Moreover, it paves the way for wider use of high-pressure x-ray scattering in the research of π-conjugated polymers.


  • Crystalline and Noncrystalline Forms of Poly(9,9-diheptylfluorene)

    by Matti Knaapila, Mika Torkkeli, Frank Galbrecht, Ullrich Scherf