Bastian Zielinski
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Bastian Zielinski has a total of 42 co-authors. Here are the top co-authors by number of shared publications:
- Thomas Baumert
Institut für Physik and CINSaT Universität Kassel Heinrich‐Plett‐Str. 40 34132 Kassel Germany
9 shared publications - Arne Senftleben
Institut für Physik and CINSaT Universität Kassel Heinrich‐Plett‐Str. 40 34132 Kassel Germany
6 shared publications - Thomas Winkler
Cavendish Laboratory, University of Cambridge, Cambridge, UK
6 shared publications Cristian Sarpe
Institute of Physics and CINSaT, University of Kassel, Heinrich-Plett-Str. 40, 34132 Kassel, Germany
5 shared publicationsNadine Götte
Institute of Physics and CINSaT, University of Kassel, Heinrich-Plett-Strasse 40, D-34132 Kassel, Germany
4 shared publications- Cristian Sarpe
Department of Physics, Faculty of Sciences , University of Craiova , Str. Alexandru Ioan Cuza 13, 200585 Craiova , Romania
3 shared publications
Latest Publications
- 2 August 2026
- Published by Springer Nature
- p. 1359-1399
Surface Functionalization with Lasers: From Nanostructures to Applications
- 2 August 2026
- Published by Springer Nature
- p. 1359-1399
Surface Functionalization with Lasers: From Nanostructures to Applications
- 14 November 2024
- Published by Walter de Gruyter GmbH in Zeitschrift für Physikalische Chemie
Temporal airy pulses efficiency in thin glass dicing
Ultrashort pulse laser sources are useful tools for micro- and nano-processing large band gap dielectric materials. One of the biggest advantages of these pulses is the possibility to reach high intensity peaks that promote absorption even in materials transparent to the laser wavelength. In addition, if the pulse temporal distribution is modified, energy absorption enables the ablation of small diameter holes with large depths. In this work, we present preliminary results that implement three types of pulses as precursors for glass dicing: Bandwidth-limited (30 fs at 785 nm), positively, and negatively dispersed Temporal Airy Pulses (TAP). The material of choice was 170 μm thick soda-lime glass, inscribed at 1 kHz repetition rate in tight (50× objective) and loose (20× objective) focusing conditions for different laser energies and scanning speeds. After laser processing, the glass was diced by mechanical stress, with a home built four-point bending stage. We analyzed the quality of the scribed lines at the surface and in cross-section after breaking, as well as the necessary breaking force for all three types of laser pulses. We report that positive TAP produced a neat, flat-cut edge on the glass samples compared with the other implemented pulses.
- 14 November 2024
- Published by Walter de Gruyter GmbH in Zeitschrift für Physikalische Chemie
Temporal airy pulses efficiency in thin glass dicing
Ultrashort pulse laser sources are useful tools for micro- and nano-processing large band gap dielectric materials. One of the biggest advantages of these pulses is the possibility to reach high intensity peaks that promote absorption even in materials transparent to the laser wavelength. In addition, if the pulse temporal distribution is modified, energy absorption enables the ablation of small diameter holes with large depths. In this work, we present preliminary results that implement three types of pulses as precursors for glass dicing: Bandwidth-limited (30 fs at 785 nm), positively, and negatively dispersed Temporal Airy Pulses (TAP). The material of choice was 170 μm thick soda-lime glass, inscribed at 1 kHz repetition rate in tight (50× objective) and loose (20× objective) focusing conditions for different laser energies and scanning speeds. After laser processing, the glass was diced by mechanical stress, with a home built four-point bending stage. We analyzed the quality of the scribed lines at the surface and in cross-section after breaking, as well as the necessary breaking force for all three types of laser pulses. We report that positive TAP produced a neat, flat-cut edge on the glass samples compared with the other implemented pulses.
- Open Access
- 15 June 2023
- Published by Wiley in Chemphyschem
- Vol. 24 (12)
Cover Feature: Observation of a Long‐lived Electronic Coherence Modulated by Vibrational Dynamics in Molecular Nd3+‐Complexes at Room Temperature (ChemPhysChem 12/2023)
- 15 June 2023
- Published by Wiley in Chemphyschem
- Vol. 24 (12)
Open AccessCover Feature: Observation of a Long‐lived Electronic Coherence Modulated by Vibrational Dynamics in Molecular Nd3+‐Complexes at Room Temperature (ChemPhysChem 12/2023)
- Open Access
- 15 June 2020
- Published by American Physical Society (APS) in Physical Review Research
- Vol. 2 (2) , 023341
Unveiling nonlinear regimes of light amplification in fused silica with femtosecond imaging spectroscopy
We observe and characterize two nonlinear light-amplification regimes with unique spectral properties and fluence dependencies in laser-excited fused silica using ultrafast pump-probe imaging spectroscopy. The two underlying mechanisms are switchable within 150 fs via the time delay between an intense near-infrared femtosecond pump and an ultraviolet femtosecond probe pulse. While the earlier amplification regime is linked to the effect of laser amplification in excited dielectrics, and thus to the presence of conduction-band electrons, the latter can be directly related to the ultrafast formation of extremely long-lived self-trapped excitons. It is shown that, locally, the amplification can reach one order of magnitude. We discuss the temporal and spectral characteristics of the amplification as well as its dependencies on pump and probe fluences and form a complete picture within a tentative model.
- 15 June 2020
- Published by American Physical Society (APS) in Physical Review Research
- Vol. 2 (2) , 023341
Open AccessUnveiling nonlinear regimes of light amplification in fused silica with femtosecond imaging spectroscopy
We observe and characterize two nonlinear light-amplification regimes with unique spectral properties and fluence dependencies in laser-excited fused silica using ultrafast pump-probe imaging spectroscopy. The two underlying mechanisms are switchable within 150 fs via the time delay between an intense near-infrared femtosecond pump and an ultraviolet femtosecond probe pulse. While the earlier amplification regime is linked to the effect of laser amplification in excited dielectrics, and thus to the presence of conduction-band electrons, the latter can be directly related to the ultrafast formation of extremely long-lived self-trapped excitons. It is shown that, locally, the amplification can reach one order of magnitude. We discuss the temporal and spectral characteristics of the amplification as well as its dependencies on pump and probe fluences and form a complete picture within a tentative model.
- Open Access
- 1 December 2018
- Published by AIP Publishing in AIP Advances
- Vol. 8 (12) , 125105
Live cells assessment of opto-poration by a single femtosecond temporal Airy laser pulse
We report on the first study of live cell opto-poration by single temporally shaped femtosecond laser pulses. Based on an ad hoc developed cell staining protocol, we demonstrate the influence of the pulse temporal profile on the efficiency of poration and on cell viability at four hours comparing the results obtained for four different temporal pulse shapes: positive and negative temporal Airy, positively chirped, and 30 fs bandwidth limited pulses. Each pulse has been tested on a thousand cells. The most suitable pulses for opto-poration are the positive Temporal Airy Pulses (TAP+), likely because they enhance avalanche ionization compared to bandwidth-limited shorter pulses. We discuss the results in the context of previous studies, highlighting the differences between single and multi-pulse opto-poration strategies.
- 1 December 2018
- Published by AIP Publishing in AIP Advances
- Vol. 8 (12) , 125105
Open AccessLive cells assessment of opto-poration by a single femtosecond temporal Airy laser pulse
We report on the first study of live cell opto-poration by single temporally shaped femtosecond laser pulses. Based on an ad hoc developed cell staining protocol, we demonstrate the influence of the pulse temporal profile on the efficiency of poration and on cell viability at four hours comparing the results obtained for four different temporal pulse shapes: positive and negative temporal Airy, positively chirped, and 30 fs bandwidth limited pulses. Each pulse has been tested on a thousand cells. The most suitable pulses for opto-poration are the positive Temporal Airy Pulses (TAP+), likely because they enhance avalanche ionization compared to bandwidth-limited shorter pulses. We discuss the results in the context of previous studies, highlighting the differences between single and multi-pulse opto-poration strategies.
- 20 September 2018
- Published by Springer Nature
- p. 399-400
Cell Poration of Fixed and Live Cells by Phase Shaped Femtosecond Pulses
- 20 September 2018
- Published by Springer Nature
- p. 399-400
Cell Poration of Fixed and Live Cells by Phase Shaped Femtosecond Pulses
- 18 September 2017
- Published by Springer Nature in Nature Physics
- Vol. 14 (1) , 74-79
Laser amplification in excited dielectrics
- 18 September 2017
- Published by Springer Nature in Nature Physics
- Vol. 14 (1) , 74-79
Laser amplification in excited dielectrics
- Open Access
- 24 June 2016
- Published by AIP Publishing in APL Photonics
- Vol. 1 (4) , 046102
Temporal Airy pulses control cell poration
We show that spectral phase shaping of fs-laser pulses can be used to optimize laser-cell membrane interactions in water environment. The energy and peak intensity thresholds required for cell poration with single pulse in the nJ range can be significantly reduced (25% reduction in energy and 88% reduction in peak intensity) by using temporal Airy pulses, controlled by positive third order dispersion, as compared to bandwidth limited pulses. Temporal Airy pulses are also effective to control the morphology of the induced pores, with prospective applications from cellular to tissue opto-surgery and transfection.
- 24 June 2016
- Published by AIP Publishing in APL Photonics
- Vol. 1 (4) , 046102
Open AccessTemporal Airy pulses control cell poration
We show that spectral phase shaping of fs-laser pulses can be used to optimize laser-cell membrane interactions in water environment. The energy and peak intensity thresholds required for cell poration with single pulse in the nJ range can be significantly reduced (25% reduction in energy and 88% reduction in peak intensity) by using temporal Airy pulses, controlled by positive third order dispersion, as compared to bandwidth limited pulses. Temporal Airy pulses are also effective to control the morphology of the induced pores, with prospective applications from cellular to tissue opto-surgery and transfection.
- Open Access
- 5 April 2016
- Published by Optica Publishing Group in Optica
- Vol. 3 (4) , 389-395
Temporal Airy pulses for controlled high aspect ratio nanomachining of dielectrics
Understanding the interplay between optical pulse parameters and ultrafast material response is critical in achieving efficient and controlled laser nanomachining. In general, the key to initiate material processing is the deposition of a sufficient energy density within the electronic system. In dielectrics this critical energy density corresponds typically to a plasma frequency in the near-IR spectral region. Creating this density instantaneously with ultrashort laser pulses of a few tens of femtoseconds pulse duration in the same spectral region, the penetration depth into the material will strongly decrease with increasing electron density. Consequently, staying below this critical density will allow deep penetration depths. This calls for delayed ionization processes to deposit the energy for processing, thus introducing the temporal structure of the laser pulses as a control parameter. In this contribution we demonstrate this concept experimentally and substantiate the physical picture with numerical calculations. Bandwidth-limited pulses of 30 fs pulse duration are stretched up to 1.5 ps either temporally symmetrically or temporally asymmetrically. The interplay between pulse structure and material response is optimally exploited by the asymmetrically structured temporal Airy pulses leading to the inherently efficient creation of high aspect ratio nanochannels. Depths in the range of several micrometers and diameters around 250 nm are created within a single laser shot and without making use of self-focusing and filamentation processes. In addition to the machining of nanophotonic devices in dielectrics, the technique has the potential to enhance laser-based nanocell surgery and cell poration techniques.
- 5 April 2016
- Published by Optica Publishing Group in Optica
- Vol. 3 (4) , 389-395
Open AccessTemporal Airy pulses for controlled high aspect ratio nanomachining of dielectrics
Understanding the interplay between optical pulse parameters and ultrafast material response is critical in achieving efficient and controlled laser nanomachining. In general, the key to initiate material processing is the deposition of a sufficient energy density within the electronic system. In dielectrics this critical energy density corresponds typically to a plasma frequency in the near-IR spectral region. Creating this density instantaneously with ultrashort laser pulses of a few tens of femtoseconds pulse duration in the same spectral region, the penetration depth into the material will strongly decrease with increasing electron density. Consequently, staying below this critical density will allow deep penetration depths. This calls for delayed ionization processes to deposit the energy for processing, thus introducing the temporal structure of the laser pulses as a control parameter. In this contribution we demonstrate this concept experimentally and substantiate the physical picture with numerical calculations. Bandwidth-limited pulses of 30 fs pulse duration are stretched up to 1.5 ps either temporally symmetrically or temporally asymmetrically. The interplay between pulse structure and material response is optimally exploited by the asymmetrically structured temporal Airy pulses leading to the inherently efficient creation of high aspect ratio nanochannels. Depths in the range of several micrometers and diameters around 250 nm are created within a single laser shot and without making use of self-focusing and filamentation processes. In addition to the machining of nanophotonic devices in dielectrics, the technique has the potential to enhance laser-based nanocell surgery and cell poration techniques.