José Soares Augusto
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
José Soares Augusto has a total of 26 co-authors. Here are the top co-authors by number of shared publications:
C.F.B. Almeida
INESC, Lisbon, Portugal
4 shared publications- Carlos Beltrán Almeida
Laboratório de Instrumentação e Física Experimental de Partículas
2 shared publications Alexandra Matos
Department of Electrical and Computer Engineering (DEEC), NOVA School of Science and Technology, Center of Technology and Systems (CTS-UNINOVA), Associated Laboratory of Intelligent Systems (LASI), Lisbon, Portugal
1 shared publication- Amelia Maio
Laboratorio de Instrumentacao e Fisica Experimental de Particulas - LIP
1 shared publication Ana Rita Das Neves Sousa
Dep. de Física da Faculdade de Ciências da Universidade de Lisboa
1 shared publicationC. F. Beltrán Almeida
INESC/IST, Aptd
1 shared publication
Latest Publications
- Open Access
- 5 November 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 13, 189959-189978
Revisiting ZTC and GZTC in CMOS FinFET Using a Five-DC-Parameter MOSFET Model
This paper meticulously revisits the derivation of the MOSFET Zero Temperature Coefficient (ZTC) and the Transconductance Zero Temperature Coefficient (GZTC) conditions, with a focus on a Design-oriented five DC-parameter MOSFET model, which is an extremely useful tool for handling calculations in IC Design Field. This work proposes the incorporation of two short channel effects in the ZTC and GZTC modeling—namely, the Drain Induced Barrier Lowering (DIBL) effect, denoted as σ, and the velocity saturation effect, represented by ζ—enhancing the traditional three DC-parameter model, which includes the slope factor n, the threshold voltage VT, and the specific current IS. In addition, for the first time, this paper proposes a more comprehensive general closed expression for the ZTC and GZTC points in both triode and saturation regimes, leveraging the Lambert function W0(x). By employing the derived expressions for each phenomenon, the ZTC and GZTC dependence concerning each physical parameter is thoroughly investigated. Furthermore, these theoretical findings are compared with simulated data obtained from a mature 16nm FinFET Process Design Kit (PDK). The results demonstrate that the integration of σ and ζ into the ZTC and GZTC calculations yields a significant improvement in accuracy, reducing the error between the simulation and the model values from 8% to less than 2%. This enhancement underscores the importance of considering additional effects when analyzing temperature coefficients in MOSFETs, thus providing valuable insights for professionals engaged in advanced IC design.
- 5 November 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 13, 189959-189978
Open AccessRevisiting ZTC and GZTC in CMOS FinFET Using a Five-DC-Parameter MOSFET Model
This paper meticulously revisits the derivation of the MOSFET Zero Temperature Coefficient (ZTC) and the Transconductance Zero Temperature Coefficient (GZTC) conditions, with a focus on a Design-oriented five DC-parameter MOSFET model, which is an extremely useful tool for handling calculations in IC Design Field. This work proposes the incorporation of two short channel effects in the ZTC and GZTC modeling—namely, the Drain Induced Barrier Lowering (DIBL) effect, denoted as σ, and the velocity saturation effect, represented by ζ—enhancing the traditional three DC-parameter model, which includes the slope factor n, the threshold voltage VT, and the specific current IS. In addition, for the first time, this paper proposes a more comprehensive general closed expression for the ZTC and GZTC points in both triode and saturation regimes, leveraging the Lambert function W0(x). By employing the derived expressions for each phenomenon, the ZTC and GZTC dependence concerning each physical parameter is thoroughly investigated. Furthermore, these theoretical findings are compared with simulated data obtained from a mature 16nm FinFET Process Design Kit (PDK). The results demonstrate that the integration of σ and ζ into the ZTC and GZTC calculations yields a significant improvement in accuracy, reducing the error between the simulation and the model values from 8% to less than 2%. This enhancement underscores the importance of considering additional effects when analyzing temperature coefficients in MOSFETs, thus providing valuable insights for professionals engaged in advanced IC design.
- 1 January 2015
- Published by Springer Nature
- p. 217-227
Arduino Implementation of Automatic Tuning in PID Control of Rotation in DC Motors
- 1 January 2015
- Published by Springer Nature
- p. 217-227
Arduino Implementation of Automatic Tuning in PID Control of Rotation in DC Motors
- Open Access
- 1 January 2014
- Published by Elsevier in Procedia Technology
- Vol. 17, 319-326
Emulation in FPGA of G-Link Chip-set of Tile Calorimeter Electronic System
- 1 January 2014
- Published by Elsevier in Procedia Technology
- Vol. 17, 319-326
Open AccessEmulation in FPGA of G-Link Chip-set of Tile Calorimeter Electronic System
- 1 March 2013
- Published by IOP Publishing in Journal of Instrumentation
- Vol. 8 (03) , C03005
The MiniPET: a didactic PET system
The MiniPET project aims to design and build a small PET system. It consists of two 4 × 4 matrices of 16 LYSO scintillator crystals and two PMTs with 16 channels resulting in a low cost system with the essential functionality of a clinical PET instrument. It is designed to illustrate the physics of the PET technique and to provide a didactic platform for the training of students and nuclear imaging professionals as well as for scientific outreach. The PET modules can be configured to test for the coincidence of 511 keV gamma rays. The model has a flexible mechanical setup [1] and can simulate 14 diferent ring geometries, from a configuration with as few as 18 detectors per ring (ring radius =51 mm), up to a geometry with 70 detectors per ring ( =200 mm). A second version of the electronic system [2] allowed measurement and recording of the energy deposited in 4 detector channels by photons from a 137Cs radioactive source and by photons resulting of the annihilation of positrons from a 22Na radioactive source. These energy spectra are used for detector performance studies, as well as angular dependency studies. In this paper, the mechanical setup, the front-end high-speed analog electronics, the digital acquisition and control electronics implemented in a FPGA, as well as the data-transfer interface between the FPGA board and a host PC are described. Recent preliminary results obtained with the 4 active channels in the prototype are also presented.
- 1 March 2013
- Published by IOP Publishing in Journal of Instrumentation
- Vol. 8 (03) , C03005
The MiniPET: a didactic PET system
The MiniPET project aims to design and build a small PET system. It consists of two 4 × 4 matrices of 16 LYSO scintillator crystals and two PMTs with 16 channels resulting in a low cost system with the essential functionality of a clinical PET instrument. It is designed to illustrate the physics of the PET technique and to provide a didactic platform for the training of students and nuclear imaging professionals as well as for scientific outreach. The PET modules can be configured to test for the coincidence of 511 keV gamma rays. The model has a flexible mechanical setup [1] and can simulate 14 diferent ring geometries, from a configuration with as few as 18 detectors per ring (ring radius =51 mm), up to a geometry with 70 detectors per ring ( =200 mm). A second version of the electronic system [2] allowed measurement and recording of the energy deposited in 4 detector channels by photons from a 137Cs radioactive source and by photons resulting of the annihilation of positrons from a 22Na radioactive source. These energy spectra are used for detector performance studies, as well as angular dependency studies. In this paper, the mechanical setup, the front-end high-speed analog electronics, the digital acquisition and control electronics implemented in a FPGA, as well as the data-transfer interface between the FPGA board and a host PC are described. Recent preliminary results obtained with the 4 active channels in the prototype are also presented.
- 1 August 2011
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 53-56
Efficient time domain analogue fault simulation targeting nonlinear circuits
It is presented an efficient single fault simulation methodology for dynamic analogue circuits with nonlinear resistive elements. It is suitable for the simulation-before-test of thousands of faulty circuits, such as when building fault dictionaries. The proposed strategy merges techniques with efficiency already been demonstrated with prototype simulators: one supports nonlinear resistive circuits; and the other supports linear dynamic circuits. The results obtained with these partial implementations, as well as the expected efficiency of the global implementation are discussed. The partial implementations have shown speed-up in fault simulation better than one order of magnitude (in linear dynamic circuits) and better than two orders of magnitude (in nonlinear resistive circuits).
- 1 August 2011
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 53-56
Efficient time domain analogue fault simulation targeting nonlinear circuits
It is presented an efficient single fault simulation methodology for dynamic analogue circuits with nonlinear resistive elements. It is suitable for the simulation-before-test of thousands of faulty circuits, such as when building fault dictionaries. The proposed strategy merges techniques with efficiency already been demonstrated with prototype simulators: one supports nonlinear resistive circuits; and the other supports linear dynamic circuits. The results obtained with these partial implementations, as well as the expected efficiency of the global implementation are discussed. The partial implementations have shown speed-up in fault simulation better than one order of magnitude (in linear dynamic circuits) and better than two orders of magnitude (in nonlinear resistive circuits).
- Open Access
- 1 January 2008
- Published by Wiley in VLSI Design
- Vol. 2008 (1)
A Tool for Single‐Fault Diagnosis in Linear Analog Circuits with Tolerance Using the T‐Vector Approach
In previous works of these authors, a technique for doing single‐fault diagnosis in linear analog circuits was developed. Under certain conditions, one of them assuming nominal values for the circuit parameters, it was shown that only two measurements taken on two selected circuit nodes, at a single frequency, were needed to detect and diagnose any parametric fault. In this paper, the practical value of the technique is improved by extending the application to the diagnosis of faults in circuits with parameters subject to tolerance. With this in mind, single parametric faults with several strengths are randomly injected in the circuit under study and, afterwards, these faults are diagnosed (or the diagnosis fails). Results are reported on a simple active filter. Conclusions are drawn about the robustness and effectiveness of the technique.
- 1 January 2008
- Published by Wiley in VLSI Design
- Vol. 2008 (1)
Open AccessA Tool for Single‐Fault Diagnosis in Linear Analog Circuits with Tolerance Using the T‐Vector Approach
In previous works of these authors, a technique for doing single‐fault diagnosis in linear analog circuits was developed. Under certain conditions, one of them assuming nominal values for the circuit parameters, it was shown that only two measurements taken on two selected circuit nodes, at a single frequency, were needed to detect and diagnose any parametric fault. In this paper, the practical value of the technique is improved by extending the application to the diagnosis of faults in circuits with parameters subject to tolerance. With this in mind, single parametric faults with several strengths are randomly injected in the circuit under study and, afterwards, these faults are diagnosed (or the diagnosis fails). Results are reported on a simple active filter. Conclusions are drawn about the robustness and effectiveness of the technique.
- 17 December 2002
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 6, 117-120
New algorithms in piecewise linear resistive simulation
This paper presents a piecewise linear (PWL) resistive simulator. It uses an efficient algorithm to obtain the constraint matrix of a linear multiport from the modified nodal analysis (MNA) equations and a novel algorithm to solve the generalized linear complementarity problem (GLCP) that arises from the PWL circuit equations.
- 17 December 2002
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 6, 117-120
New algorithms in piecewise linear resistive simulation
This paper presents a piecewise linear (PWL) resistive simulator. It uses an efficient algorithm to obtain the constraint matrix of a linear multiport from the modified nodal analysis (MNA) equations and a novel algorithm to solve the generalized linear complementarity problem (GLCP) that arises from the PWL circuit equations.
- 28 November 2002
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 1, 125-128
Circuit equations for fast fault simulation and diagnosis of linear circuits
In this paper, we propose a Modified Nodal Analysis (MNA) based method for writing the circuit equations in the presence of a single fault which is suited for the efficient fault simulation and diagnosis using a Fault Dictionary (FD). The fault simulation equations are obtained from a cheap modification of the LU factors of the nominal matrix. The theoretical speed-up in the simulation of one fault, compared to the simulation time of the nominal circuit, is in the order of /spl sim/n for full n/spl times/n matrices. The reported experimental results validate the method.
- 28 November 2002
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 1, 125-128
Circuit equations for fast fault simulation and diagnosis of linear circuits
In this paper, we propose a Modified Nodal Analysis (MNA) based method for writing the circuit equations in the presence of a single fault which is suited for the efficient fault simulation and diagnosis using a Fault Dictionary (FD). The fault simulation equations are obtained from a cheap modification of the LU factors of the nominal matrix. The theoretical speed-up in the simulation of one fault, compared to the simulation time of the nominal circuit, is in the order of /spl sim/n for full n/spl times/n matrices. The reported experimental results validate the method.
- 19 November 2002
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 605
Fully automatic DC fault dictionary construction and test nodes selection for analogue fault diagnosis
Although the Fault Dictionary (FD) is one of the oldest approaches in analogue fault diagnosis, it is the most used in industrial environments. We present a fully automatic system that selects a minimum set of test nodes and gives the range of their voltages for each fault. All the information it uses is in three input files given by the test engineer: the circuit description (similar to the SPICE), the fault list and the tolerance file.
- 19 November 2002
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 605
Fully automatic DC fault dictionary construction and test nodes selection for analogue fault diagnosis
Although the Fault Dictionary (FD) is one of the oldest approaches in analogue fault diagnosis, it is the most used in industrial environments. We present a fully automatic system that selects a minimum set of test nodes and gives the range of their voltages for each fault. All the information it uses is in three input files given by the test engineer: the circuit description (similar to the SPICE), the fault list and the tolerance file.
- 7 November 2002
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 1, 609-616
Analog fault diagnosis in nonlinear DC circuits with an evolutionary algorithm
- 7 November 2002
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 1, 609-616
Analog fault diagnosis in nonlinear DC circuits with an evolutionary algorithm