Dong Zhang
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Dong Zhang has a total of 47 co-authors. Here are the top co-authors by number of shared publications:
- Luis. D. Couto
Flemish Institute for Technological Research (VITO), Mol, Belgium
9 shared publications - Scott Moura
Department of Civil and Environmental Engineering, University of California, Berkeley, CA, USA
7 shared publications - Jorge Espin
Universidad Tecnica Federico Santa Maria
2 shared publications - Michel Kinnaert
Control Engineering and System Analysis Department, Universit Libre de Bruxelles, Brussels, Belgium
2 shared publications - Ross Drummond
University of Sheffield
2 shared publications - Saehong Park
Energy, Controls and Applications Laboratory (eCAL), University of California at Berkeley, Berkeley, CA, USA
2 shared publications
Latest Publications
- 23 September 2026
- Published by Elsevier in Energy Storage Materials
- Vol. 91
When voltage sensors fail: Electrochemically constrained fault-tolerant state estimation for flat-plateau LFP batteries
- 23 September 2026
- Published by Elsevier in Energy Storage Materials
- Vol. 91
When voltage sensors fail: Electrochemically constrained fault-tolerant state estimation for flat-plateau LFP batteries
- 4 February 2026
- Published by Elsevier in Journal of Energy Storage
- Vol. 153
Physics-enhanced data-driven charging strategies for lithium-ion batteries with safety consciousness
- 4 February 2026
- Published by Elsevier in Journal of Energy Storage
- Vol. 153
Physics-enhanced data-driven charging strategies for lithium-ion batteries with safety consciousness
- 9 January 2026
- Published by Elsevier in Journal of Energy Storage
- Vol. 148
Rapid state of health diagnosis of used lithium-ion batteries using mechanical and electrochemical measurements
- 9 January 2026
- Published by Elsevier in Journal of Energy Storage
- Vol. 148
Rapid state of health diagnosis of used lithium-ion batteries using mechanical and electrochemical measurements
- 15 November 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Control Systems Technology
- Vol. 33 (1) , 189-206
Degradation Monitoring and Characterization in Lithium-Ion Batteries via the Asymptotic Local Approach
Degradation mechanisms affecting the long-term performance of lithium-ion batteries should be monitored and characterized. Such mechanisms, such as loss of lithium inventory (LLI) or active material, can be translated into parameter variations in electrochemical battery models. Here, a reduced-order model (the equivalent hydraulic model) is considered as it provides a good tradeoff between physical interpretability and complexity. The aim is to detect and characterize degradation, namely, to indicate the parameters subject to change, from standard (dis)charge data. To this end, change indicators (or residuals) are computed by combining a state observer and a local statistical approach. Model parameter changes induce changes in the mean of the residual vector which is asymptotically normally distributed with a specified variance. Degradation detection and characterization is achieved by processing the latter residual by statistical tests relying on log-likelihood ratios between multiple simple hypotheses. Results indicate the long-term changes in the main degradation modes affect battery performance. Most degradation modes considered are active at the 0.1% relative parametric change level, but active material loss reaches the 1% parametric change level over the battery lifetime, and 10% parametric change levels are obtained for sluggish diffusion and impedance rise. We show how the proposed methodology could be a useful alternative to methods based only on parameter identification.
- 15 November 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Control Systems Technology
- Vol. 33 (1) , 189-206
Degradation Monitoring and Characterization in Lithium-Ion Batteries via the Asymptotic Local Approach
Degradation mechanisms affecting the long-term performance of lithium-ion batteries should be monitored and characterized. Such mechanisms, such as loss of lithium inventory (LLI) or active material, can be translated into parameter variations in electrochemical battery models. Here, a reduced-order model (the equivalent hydraulic model) is considered as it provides a good tradeoff between physical interpretability and complexity. The aim is to detect and characterize degradation, namely, to indicate the parameters subject to change, from standard (dis)charge data. To this end, change indicators (or residuals) are computed by combining a state observer and a local statistical approach. Model parameter changes induce changes in the mean of the residual vector which is asymptotically normally distributed with a specified variance. Degradation detection and characterization is achieved by processing the latter residual by statistical tests relying on log-likelihood ratios between multiple simple hypotheses. Results indicate the long-term changes in the main degradation modes affect battery performance. Most degradation modes considered are active at the 0.1% relative parametric change level, but active material loss reaches the 1% parametric change level over the battery lifetime, and 10% parametric change levels are obtained for sluggish diffusion and impedance rise. We show how the proposed methodology could be a useful alternative to methods based only on parameter identification.
- 7 December 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Control Systems Technology
- Vol. 32 (3) , 849-861
On Electrochemical Model-Based State Estimation for Lithium–Sulfur Batteries
The high theoretical specific energy density of lithium–sulfur (Li–S) batteries positions them as an advanced next-generation battery system to overcome the limitations of conventional Li-ion batteries. Accurate estimation of the mass evolution of active sulfur species in Li–S cells is required, not only to monitor degradation mechanisms inside the cell but also to enable safe and efficient operation. The state estimation problem for electrochemical models (EMs) of Li–S cells is challenging, mainly due to the complex dynamics during discharge/charge processes. In this work, we consider a three-step 0-D EM with the “shuttle effect” for state estimation. The model’s state observability is analyzed and the parameters are identified using experimental data. An extended Kalman filter is directly applied to the nonlinear differential-algebraic equation (DAE) system to estimate the differential and algebraic states from the measurements of voltage and current only. The simulation and experimental results demonstrate the effectiveness of the proposed observer design.
- 7 December 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Control Systems Technology
- Vol. 32 (3) , 849-861
On Electrochemical Model-Based State Estimation for Lithium–Sulfur Batteries
The high theoretical specific energy density of lithium–sulfur (Li–S) batteries positions them as an advanced next-generation battery system to overcome the limitations of conventional Li-ion batteries. Accurate estimation of the mass evolution of active sulfur species in Li–S cells is required, not only to monitor degradation mechanisms inside the cell but also to enable safe and efficient operation. The state estimation problem for electrochemical models (EMs) of Li–S cells is challenging, mainly due to the complex dynamics during discharge/charge processes. In this work, we consider a three-step 0-D EM with the “shuttle effect” for state estimation. The model’s state observability is analyzed and the parameters are identified using experimental data. An extended Kalman filter is directly applied to the nonlinear differential-algebraic equation (DAE) system to estimate the differential and algebraic states from the measurements of voltage and current only. The simulation and experimental results demonstrate the effectiveness of the proposed observer design.
- 9 August 2023
- Published by Elsevier in Applied Energy
- Vol. 349
Determination of half-cell open-circuit potential curve of silicon-graphite in a physics-based model for lithium-ion batteries
- 9 August 2023
- Published by Elsevier in Applied Energy
- Vol. 349
Determination of half-cell open-circuit potential curve of silicon-graphite in a physics-based model for lithium-ion batteries
- 14 July 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Transportation Electrification
- Vol. 9 (4) , 4846-4861
Beyond Battery State of Charge Estimation: Observer for Electrode-Level State and Cyclable Lithium With Electrolyte Dynamics
This paper presents a provably convergent battery estimation scheme based on a single particle model with electrolyte dynamics (SPMe), by proposing a systematic methodology to estimate critical information such as electrode-level states, electrolyte dynamics, and cyclable lithium. Electrode-level state estimation suffers from weak observability originating from two standalone electrode dynamics, which is then aggravated by the addition of electrolyte dynamics. This lack of observability can be alleviated by exploiting lithium inventory conservation enabled by Kalman decomposition, allowing one to separate out the unobservable subspace. Assuming the knowledge of cyclable lithium, a nonlinear state observer with provable convergence can be constructed for the SPMe model, using voltage and current measurements. To relax this strong assumption, a sensitivity-based parameter estimation scheme is also deployed to track cyclable lithium – a crucial physical variable for capacity fade. Ultimately, the estimation framework can perform finer monitoring and diagnosis of battery charge and health down to the level of individual electrode and the electrolyte. Experimental validation demonstrates <1% estimation error for cyclable lithium inventory. Solid phase lithium concentration estimates, especially in the negative electrode, can be sensitive to disturbances in cyclable lithium.
- 14 July 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Transportation Electrification
- Vol. 9 (4) , 4846-4861
Beyond Battery State of Charge Estimation: Observer for Electrode-Level State and Cyclable Lithium With Electrolyte Dynamics
This paper presents a provably convergent battery estimation scheme based on a single particle model with electrolyte dynamics (SPMe), by proposing a systematic methodology to estimate critical information such as electrode-level states, electrolyte dynamics, and cyclable lithium. Electrode-level state estimation suffers from weak observability originating from two standalone electrode dynamics, which is then aggravated by the addition of electrolyte dynamics. This lack of observability can be alleviated by exploiting lithium inventory conservation enabled by Kalman decomposition, allowing one to separate out the unobservable subspace. Assuming the knowledge of cyclable lithium, a nonlinear state observer with provable convergence can be constructed for the SPMe model, using voltage and current measurements. To relax this strong assumption, a sensitivity-based parameter estimation scheme is also deployed to track cyclable lithium – a crucial physical variable for capacity fade. Ultimately, the estimation framework can perform finer monitoring and diagnosis of battery charge and health down to the level of individual electrode and the electrolyte. Experimental validation demonstrates <1% estimation error for cyclable lithium inventory. Solid phase lithium concentration estimates, especially in the negative electrode, can be sensitive to disturbances in cyclable lithium.
- 25 December 2021
- Published by Seventh Sense Research Group Journals in International Journal of Engineering Trends and Technology
- Vol. 69 (12) , 56-65
Analysis of the Design of Lifting and Transporting Vehicles with a Variable Center of Gravity – A Literature and Patent Overview
Analysis of the Design of Lifting and Transporting Vehicles with a Variable Center of Gravity – A Literature and Patent Overview
- 25 December 2021
- Published by Seventh Sense Research Group Journals in International Journal of Engineering Trends and Technology
- Vol. 69 (12) , 56-65
Analysis of the Design of Lifting and Transporting Vehicles with a Variable Center of Gravity – A Literature and Patent Overview
Analysis of the Design of Lifting and Transporting Vehicles with a Variable Center of Gravity – A Literature and Patent Overview
- 23 December 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Control Systems Technology
- Vol. 30 (5) , 2220-2227
Resolving Kirchhoff’s Laws for Parallel Li-Ion Battery Pack State-Estimators
A state-space model for Li-ion battery packs with parallel-connected cells is introduced. The key feature of the model is an explicit solution to Kirchhoff’s laws for parallel-connected packs, which expresses the branch currents directly in terms of the model’s states, applied current, and cell resistances. This avoids the need to solve these equations numerically. To illustrate the potential of the proposed model for pack-level control and estimation, a method to bound the error of a state-estimator is introduced and the modeling framework is generalized to a class of electrochemical models. It is hoped that the insight brought by this model formulation will allow the wealth of results developed for series-connected packs to be applied to those with parallel connections.
- 23 December 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Control Systems Technology
- Vol. 30 (5) , 2220-2227
Resolving Kirchhoff’s Laws for Parallel Li-Ion Battery Pack State-Estimators
A state-space model for Li-ion battery packs with parallel-connected cells is introduced. The key feature of the model is an explicit solution to Kirchhoff’s laws for parallel-connected packs, which expresses the branch currents directly in terms of the model’s states, applied current, and cell resistances. This avoids the need to solve these equations numerically. To illustrate the potential of the proposed model for pack-level control and estimation, a method to bound the error of a state-estimator is introduced and the modeling framework is generalized to a class of electrochemical models. It is hoped that the insight brought by this model formulation will allow the wealth of results developed for series-connected packs to be applied to those with parallel connections.