Mousa K. Abu Arabi
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Mousa K. Abu Arabi has a total of 35 co-authors. Here are the top co-authors by number of shared publications:
A. Tamimi
Chemical Engineering Department, Jordan University of Science and Technology, P.O. Box 3030, Irbid, Jordan
3 shared publicationsY.H. Zurigat
3 shared publicationsAsem M. Al-Jarrah
Chemical Engineering Department, Jordan University of Science and Technology, P.O. Box 3030, Irbid, Jordan
2 shared publications- Banan Hudaib
Chemical Engineering Department, Faculty of Engineering Technology, Al-Balqa Applied University, Amman 11134, Jordan
2 shared publications - Habis Al-Zoubi
Al-Hussein Bin Talal University
2 shared publications - Hilal Al-Hinai
Sultan Qaboos University
2 shared publications
Latest Publications
- Open Access
- 6 April 2023
- Published by Elsevier in Journal of Engineering Research
- Vol. 11 (3) , 7-12
Greywater treatment using vertical subsurface flow constructed wetland system
- 6 April 2023
- Published by Elsevier in Journal of Engineering Research
- Vol. 11 (3) , 7-12
Open AccessGreywater treatment using vertical subsurface flow constructed wetland system
- Open Access
- 1 May 2016
- Published by Elsevier in Desalination and Water Treatment
- Vol. 57 (21) , 9602-9608
Improving the productivity of a falling film solar desalination unit
- 1 May 2016
- Published by Elsevier in Desalination and Water Treatment
- Vol. 57 (21) , 9602-9608
Open AccessImproving the productivity of a falling film solar desalination unit
- Open Access
- 1 February 2013
- Published by Elsevier in Desalination and Water Treatment
- Vol. 51 (7-9) , 1629-1633
Removal of phosphate from Eshidiya industrial wastewater by sedimentation and enhanced sedimentation
Treatment of industrial wastewater from Eshidiya phosphate mining in Jordan was studied in this work for reuse possibilities. The wastewater resulted from flotation cells contains sediments, mainly phosphate. Sedimentation and enhanced sedimentation using anionic polyelectrolyte and alum were used to remove the sediments. The optimum dosage of anionic polyelectrolyte was found to be 400 ppm corresponding to a turbidity of 3.3 NTU. The measured target zeta potential was found to be −58.7 mv at this dosage. Alum was found to be effective coagulant but after performing a preliminary sedimentation step to reduce the wastewater turbidity.
- 1 February 2013
- Published by Elsevier in Desalination and Water Treatment
- Vol. 51 (7-9) , 1629-1633
Open AccessRemoval of phosphate from Eshidiya industrial wastewater by sedimentation and enhanced sedimentation
Treatment of industrial wastewater from Eshidiya phosphate mining in Jordan was studied in this work for reuse possibilities. The wastewater resulted from flotation cells contains sediments, mainly phosphate. Sedimentation and enhanced sedimentation using anionic polyelectrolyte and alum were used to remove the sediments. The optimum dosage of anionic polyelectrolyte was found to be 400 ppm corresponding to a turbidity of 3.3 NTU. The measured target zeta potential was found to be −58.7 mv at this dosage. Alum was found to be effective coagulant but after performing a preliminary sedimentation step to reduce the wastewater turbidity.
- Open Access
- 1 February 2013
- Published by Elsevier in Desalination and Water Treatment
- Vol. 51 (7-9) , 1634-1640
Chloride removal from Eshidiya phosphate mining wastewater
Treatment of industrial wastewater from Eshidiya phosphate mining was studied in this work for reuse possibilities. The wastewater contains sediments and chloride ions. The removal of chloride from the industrial wastewater by adsorption using Amberlite IRA-402 was investigated via batch and continuous adsorptions. In the batch adsorption, the amount of chloride removal reached about 82.5%. The equilibrium data for chloride removal onto Amberlite IRA-402 were fitted to Langmuir and Freundlich isotherms. The data followed the Langmuir isotherm, but not the Freundlich isotherm. The continuous adsorption of chloride ions on Amberlite IRA-402 using packed column was studied using a glass column (22 cm length and 2 cm diameter). The effect of initial concentration, feed flow rate, bed height, and initial pH on the breakthrough curves was evaluated. A decrease in the influent concentration resulted in a delay in the occurrence of the breakthrough curves. Higher flow rates and higher initial pH resulted in a shorter breakthrough time.
- 1 February 2013
- Published by Elsevier in Desalination and Water Treatment
- Vol. 51 (7-9) , 1634-1640
Open AccessChloride removal from Eshidiya phosphate mining wastewater
Treatment of industrial wastewater from Eshidiya phosphate mining was studied in this work for reuse possibilities. The wastewater contains sediments and chloride ions. The removal of chloride from the industrial wastewater by adsorption using Amberlite IRA-402 was investigated via batch and continuous adsorptions. In the batch adsorption, the amount of chloride removal reached about 82.5%. The equilibrium data for chloride removal onto Amberlite IRA-402 were fitted to Langmuir and Freundlich isotherms. The data followed the Langmuir isotherm, but not the Freundlich isotherm. The continuous adsorption of chloride ions on Amberlite IRA-402 using packed column was studied using a glass column (22 cm length and 2 cm diameter). The effect of initial concentration, feed flow rate, bed height, and initial pH on the breakthrough curves was evaluated. A decrease in the influent concentration resulted in a delay in the occurrence of the breakthrough curves. Higher flow rates and higher initial pH resulted in a shorter breakthrough time.
- 1 December 2011
- Published by Elsevier in Renewable and Sustainable Energy Reviews
- Vol. 15 (9) , 4410-4415
Technology development and application of solar energy in desalination: MEDRC contribution
- 1 December 2011
- Published by Elsevier in Renewable and Sustainable Energy Reviews
- Vol. 15 (9) , 4410-4415
Technology development and application of solar energy in desalination: MEDRC contribution
- Open Access
- 1 March 2009
- Published by Elsevier in Desalination and Water Treatment
- Vol. 3 (1-3) , 58-63
Solar desalination unit with falling film
Desalination of water by a solar unit with falling film was investigated. Even distribution of the water film on the collector plays an important role on the amount of desalinated water that can be produced. Several distribution systems were designed and tested. A combination of water distributor and a wick on the plate surface were needed to achieve uniform film on the plate surface. The effect of various parameters such as feed water flow rate, ambient temperature, water salinity and cooling the outer glass surface on the unit productivity was investigated. A linear relationship between the amount of fresh water produced and time is exhibited. On average about 0.6 L/h.m2 of water was produced by the unit during the hot months. Reducing the feed water flow rate and cooling the outer glass surface improved the unit productivity. Cooling the outer glass surface improved the unit productivity by 30%. On the other hand, water salinity adversely affected the unit productivity. The productivity is reduced by 4...
- 1 March 2009
- Published by Elsevier in Desalination and Water Treatment
- Vol. 3 (1-3) , 58-63
Open AccessSolar desalination unit with falling film
Desalination of water by a solar unit with falling film was investigated. Even distribution of the water film on the collector plays an important role on the amount of desalinated water that can be produced. Several distribution systems were designed and tested. A combination of water distributor and a wick on the plate surface were needed to achieve uniform film on the plate surface. The effect of various parameters such as feed water flow rate, ambient temperature, water salinity and cooling the outer glass surface on the unit productivity was investigated. A linear relationship between the amount of fresh water produced and time is exhibited. On average about 0.6 L/h.m2 of water was produced by the unit during the hot months. Reducing the feed water flow rate and cooling the outer glass surface improved the unit productivity. Cooling the outer glass surface improved the unit productivity by 30%. On the other hand, water salinity adversely affected the unit productivity. The productivity is reduced by 4...
- 1 March 2008
- Published by Elsevier in Desalination
- Vol. 221 (1-3) , 284-293
Characterization and retention of NF membranes using PEG, HS and polyelectrolytes
- 1 March 2008
- Published by Elsevier in Desalination
- Vol. 221 (1-3) , 284-293
Characterization and retention of NF membranes using PEG, HS and polyelectrolytes
- 20 May 2007
- Published by Springer Nature
- p. 163-178
STATUS AND PROSPECTS FOR SOLAR DESALINATION IN THE MENA REGION
- 20 May 2007
- Published by Springer Nature
- p. 163-178
STATUS AND PROSPECTS FOR SOLAR DESALINATION IN THE MENA REGION
- 21 March 2007
- Published by Wiley in Chemical Engineering & Technology
- Vol. 30 (4) , 493-500
Adsorption of Phenol from Aqueous Solutions on Jojoba Nuts Residue
Equilibrium isotherms for the adsorption of phenol from aqueous solutions of three types of Jojoba nuts residue were determined at 30, 40 and 55 °C. Types I and II were the residue after extracting the oil by leaching or by a pressing process, respectively. The third type was obtained by thermally treating the residue remaining after pressing. The phenol concentration ranged from 0–100 ppm in the aqueous solutions. A low adsorption capacity relative to activated carbon was obtained on types I and II, while the adsorption capacity of type III was much higher than types I and II. The results show that Jojoba nuts residue show good potential for adsorption of phenolic compounds if subjected to some type of treatment (activation). As the temperature increased from 30 to 55 °C, the adsorption capacity of types I and II decreased, but the increase had a negligible effect on type III. The experimental data were fitted to the appropriate adsorption models. The models used were Langmuir, Freundlich, Koble‐Corrigan and Redlich‐Peterson.
- 21 March 2007
- Published by Wiley in Chemical Engineering & Technology
- Vol. 30 (4) , 493-500
Adsorption of Phenol from Aqueous Solutions on Jojoba Nuts Residue
Equilibrium isotherms for the adsorption of phenol from aqueous solutions of three types of Jojoba nuts residue were determined at 30, 40 and 55 °C. Types I and II were the residue after extracting the oil by leaching or by a pressing process, respectively. The third type was obtained by thermally treating the residue remaining after pressing. The phenol concentration ranged from 0–100 ppm in the aqueous solutions. A low adsorption capacity relative to activated carbon was obtained on types I and II, while the adsorption capacity of type III was much higher than types I and II. The results show that Jojoba nuts residue show good potential for adsorption of phenolic compounds if subjected to some type of treatment (activation). As the temperature increased from 30 to 55 °C, the adsorption capacity of types I and II decreased, but the increase had a negligible effect on type III. The experimental data were fitted to the appropriate adsorption models. The models used were Langmuir, Freundlich, Koble‐Corrigan and Redlich‐Peterson.
- 4 August 2005
- Published by Wiley in European Journal of Lipid Science and Technology
- Vol. 107 (7-8) , 469-475
Parametric study on the batch leaching process of Jojoba oil
- 4 August 2005
- Published by Wiley in European Journal of Lipid Science and Technology
- Vol. 107 (7-8) , 469-475
Parametric study on the batch leaching process of Jojoba oil