Tukaram J. Shinde
Research Subjects
Tukaram J. Shinde has a total of 38 co-authors. Here are the top co-authors by number of shared publications:
Pramod N. Vasambekar
12 shared publicationsAshok B. Gadkari
Department of Physics, GKG College, Kolhapur-416012, India
9 shared publicationsA.B. Gadkari
8 shared publicationsP.N. Vasambekar
8 shared publicationsP. N. Vasambekar
Shivaji University
5 shared publicationsA. B. Gadkari
GKG College
4 shared publications
Latest Publications
- Open Access
- 9 May 2019
- Published by Springer Nature in Journal of Nanostructure in Chemistry
- Vol. 9 (2) , 119-128
Effect of La3+ substitution on structural and magnetic parameters of Ni–Cu–Zn nano-ferrites
- 9 May 2019
- Published by Springer Nature in Journal of Nanostructure in Chemistry
- Vol. 9 (2) , 119-128
Open AccessEffect of La3+ substitution on structural and magnetic parameters of Ni–Cu–Zn nano-ferrites
- 1 March 2016
- Published by Elsevier in Journal of Magnetism and Magnetic Materials
- Vol. 401, 938-942
Magnetic and microwave absorbing properties of Co 2+ substituted nickel–zinc ferrites with the emphasis on initial permeability studies
- 1 March 2016
- Published by Elsevier in Journal of Magnetism and Magnetic Materials
- Vol. 401, 938-942
Magnetic and microwave absorbing properties of Co 2+ substituted nickel–zinc ferrites with the emphasis on initial permeability studies
- 12 August 2015
- Published by Springer Nature in Journal of Materials Science: Materials in Electronics
- Vol. 26 (11) , 9016-9025
Ni–Zn ferrite thick film gas sensors
- 12 August 2015
- Published by Springer Nature in Journal of Materials Science: Materials in Electronics
- Vol. 26 (11) , 9016-9025
Ni–Zn ferrite thick film gas sensors
- 1 April 2015
- Published by Elsevier in Journal of Magnetism and Magnetic Materials
- Vol. 379, 179-185
Study of conduction phenomena in indium substituted Mn–Zn nano-ferrites
- 1 April 2015
- Published by Elsevier in Journal of Magnetism and Magnetic Materials
- Vol. 379, 179-185
Study of conduction phenomena in indium substituted Mn–Zn nano-ferrites
- 1 March 2015
- Published by Elsevier in Journal of Magnetism and Magnetic Materials
- Vol. 378, 436-439
Initial permeability of Zn–Ni–Co ferrite
- 1 March 2015
- Published by Elsevier in Journal of Magnetism and Magnetic Materials
- Vol. 378, 436-439
Initial permeability of Zn–Ni–Co ferrite
- 1 January 2015
- Published by AIP Publishing in AIP Conference Proceedings
Nanocrystalline NiNd0.01Fe1.99O4 as a gas sensor
Nanocrystalline NiNd0.01Fe1.99O4 has been synthesized by oxalate co-precipitation method and was characterized by X-ray diffraction technique. X-ray diffraction analysis confirms the formation of single phase cubic spinel structure. Crystallite size of the ferrite lies in the nano-particle range. The gas sensing properties of nanocrystalline ferrite were studied for gases like Cl2, LPG and C2H5OH. It was observed that NiNd0.01Fe1.99O4 is more sensitive towards chlorine followed by LPG at an operating temperature 277 °C compared to ethanol.
- 1 January 2015
- Published by AIP Publishing in AIP Conference Proceedings
Nanocrystalline NiNd0.01Fe1.99O4 as a gas sensor
Nanocrystalline NiNd0.01Fe1.99O4 has been synthesized by oxalate co-precipitation method and was characterized by X-ray diffraction technique. X-ray diffraction analysis confirms the formation of single phase cubic spinel structure. Crystallite size of the ferrite lies in the nano-particle range. The gas sensing properties of nanocrystalline ferrite were studied for gases like Cl2, LPG and C2H5OH. It was observed that NiNd0.01Fe1.99O4 is more sensitive towards chlorine followed by LPG at an operating temperature 277 °C compared to ethanol.
- 14 October 2014
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Magnetics
- Vol. 51 (4) , 1-8
Chemical Synthesis and Magnetic Properties of Indium-Substituted Manganese-Zinc Nanoferrites
Nanocrystalline ferrites with composition Mn0.2Zn0.8InyFe2-yO4, (y = 0.00, 0.035, 0.070, 0.100) were prepared by oxalate co-precipitation technique followed by microwave heating of precursors. The phase purity of the samples was confirmed by X-ray diffraction technique. Full profile Rietveld refinement of the powder diffraction pattern was carried out by using General Structure Analysis System II to obtain cation distribution in the spinel lattice. In3+ ions were distributed in tetrahedral as well as octahedral sites. Magnetization of ferrite samples was studied with vibrating sample magnetometer. In lower concentration, indium substitution increased saturation magnetization; at higher concentration of indium, saturation magnetization decreased substantially. This was due to higher fraction of indium ions occupying octahedral sites. AC susceptibility and Loria-Sinha techniques were used to study Curie temperature of nanoferrites.
- 14 October 2014
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Magnetics
- Vol. 51 (4) , 1-8
Chemical Synthesis and Magnetic Properties of Indium-Substituted Manganese-Zinc Nanoferrites
Nanocrystalline ferrites with composition Mn0.2Zn0.8InyFe2-yO4, (y = 0.00, 0.035, 0.070, 0.100) were prepared by oxalate co-precipitation technique followed by microwave heating of precursors. The phase purity of the samples was confirmed by X-ray diffraction technique. Full profile Rietveld refinement of the powder diffraction pattern was carried out by using General Structure Analysis System II to obtain cation distribution in the spinel lattice. In3+ ions were distributed in tetrahedral as well as octahedral sites. Magnetization of ferrite samples was studied with vibrating sample magnetometer. In lower concentration, indium substitution increased saturation magnetization; at higher concentration of indium, saturation magnetization decreased substantially. This was due to higher fraction of indium ions occupying octahedral sites. AC susceptibility and Loria-Sinha techniques were used to study Curie temperature of nanoferrites.
- 18 September 2014
- Published by Taylor & Francis in Journal of the Chinese Advanced Materials Society
- Vol. 2 (4) , 259-272
Microwave synthesis and electrical properties of indium-substituted Mn–Zn ferrites
- 18 September 2014
- Published by Taylor & Francis in Journal of the Chinese Advanced Materials Society
- Vol. 2 (4) , 259-272
Microwave synthesis and electrical properties of indium-substituted Mn–Zn ferrites
- 7 August 2014
- Published by Wiley in International Journal of Applied Ceramic Technology
- Vol. 12 (4) , 851-859
Engineering High Permeability: M n– Z n and N i– Z n Ferrites
Magnetic properties of polycrystalline spinel ferrites are of significant interest in scientific community. Of all, initial permeability is most important magnetic property for device fabrication. M n– Z n and N i– Z n ferrites are commercially most successful class of ferrites. Ferrites accommodate variety of cations in interstitial sites; type of cations, their occupancy at interstitial sites, grain size, pores, defects, or other imperfections in ferrites regulate their response to external magnetic stimulus. These factors are influenced by composition and preparation method. The failure of initial permeability of ferrites, to withstand variation in frequency of applied signal has fueled intense efforts in scientific community to optimize frequency stability of permeability. Therefore, improvement in their permeability is important from commercial perspective, and it further enables deeper insight into the dynamical link between microstructure and magnetic properties. This work presents a review of initial permeability in M n– Z n and N i– Z n ferrites with a focus on influence of intrinsic factors and frequency of applied signal. The work is an analytical assessment to provide framework for engineering high permeability in ferrites.
- 7 August 2014
- Published by Wiley in International Journal of Applied Ceramic Technology
- Vol. 12 (4) , 851-859
Engineering High Permeability: M n– Z n and N i– Z n Ferrites
Magnetic properties of polycrystalline spinel ferrites are of significant interest in scientific community. Of all, initial permeability is most important magnetic property for device fabrication. M n– Z n and N i– Z n ferrites are commercially most successful class of ferrites. Ferrites accommodate variety of cations in interstitial sites; type of cations, their occupancy at interstitial sites, grain size, pores, defects, or other imperfections in ferrites regulate their response to external magnetic stimulus. These factors are influenced by composition and preparation method. The failure of initial permeability of ferrites, to withstand variation in frequency of applied signal has fueled intense efforts in scientific community to optimize frequency stability of permeability. Therefore, improvement in their permeability is important from commercial perspective, and it further enables deeper insight into the dynamical link between microstructure and magnetic properties. This work presents a review of initial permeability in M n– Z n and N i– Z n ferrites with a focus on influence of intrinsic factors and frequency of applied signal. The work is an analytical assessment to provide framework for engineering high permeability in ferrites.
- Open Access
- 4 October 2013
- Published by Springer Nature in Bulletin of Materials Science
- Vol. 36 (5) , 919-922
Structural properties of Cd–Co ferrites
- 4 October 2013
- Published by Springer Nature in Bulletin of Materials Science
- Vol. 36 (5) , 919-922
Open AccessStructural properties of Cd–Co ferrites