Raquel A. B. Almeida

Even though the design of vibration isolators is well-established for many engineering applications, their efficiency in wide and multiple frequency ranges is still a challenge. In these cases, the use of Phononic-Based Vibration Isolators (PBVIs) may be advantageous as they present different Attenuation Regions (ARs) in which the elastic waves are strongly attenuated. Therefore, the present paper is devoted to the experimental evaluation, in terms of force transmissibility, of different types of supporting devices tested on a load mass and a motor of a Hermetic Compressor (HC). Those devices are the original Helical Coil Spring (HS) that equips the HC, the PBVI, and the Combined Structure (CS) which is composed of a PBVI combined in series with the HS. Results evidentiate the capability of the CSs to isolate vibrations, where the PBVI contributes with its ARs, thus operating as a “filter” in specific frequency ranges, while the HSs maintain the flexibility of the CSs, which is advantageous for impact-loads and/or transient-case scenarios. Hence, the capability, relevance and impact that these PBVIs present for force transmissibility reduction applications is highlighted here, which should capture the attention of and motivate the industry, e.g., producers of isolation systems, since it has wide-ranging engineering applications.

Testing is a very important task in structural dynamics and on its applications, namely on the characterization of the dynamic behaviour of structures or on the use of the structural responses to indirectly determine dynamic properties or parameters. The increasing availability of sensors, capable of measuring rotational responses, leads to the improvement of existing methods and to the development of new ones in several fields of application. In this work, an evaluation of the applicability and performance of the use of rotational responses is carried out considering applications ranging from the determination of rigid body properties to damage identification. Data acquisition using MEMS and piezoelectric sensors is covered and a set of results is discussed.

The development of new sensors that are available at more accessible prices may lead to the spread of their use on common studies in structural dynamics. One of areas of interest is the experimental determination of rigid body properties that are mandatory when the vibration response is to be calculated at low frequency ranges. In this work, a comparison of the experimental determination of rigid body properties is carried out to evaluate the performance of the commonly used tri-axial piezoelectric accelerometers and their equivalent MEMS sensors. Although their prices are quite different, both sensors can measure the inertia restraint line that is related to the inertia properties of the tested object. An identification algorithm is applied to the frequency response functions obtained by using both sensors, leading to the estimation of the body mass value, as well as the three coordinates of the centre of mass and the six elements of the inertia tensor. An experimental example supports the use of the referred low-cost sensors.