Nitin Kumar Jaiswal
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Nitin Kumar Jaiswal has a total of 49 co-authors. Here are the top co-authors by number of shared publications:
Franco Lucarelli
Associate Professor, Dept. of Physics, Univ. of Florence and Istituto Nazionale di Fisica Nucleare, I-50019 Florence, Italy
2 shared publicationsHarald Saathoff
Scientist, Institute for Meteorology and Climate Research, Karlsruhe Institute of Technology, Karlsruhe 76131, Germany
2 shared publications- Kamlesh Shrivas
School of Studies in Chemistry, Pt. Ravishankar Shukla University, Raipur, India
2 shared publications Khageshwar Singh Patel
Professer Emeritus, School of Studies in Chemistry, Pt. Ravishankar Shukla Univ., Raipur, Chhattisgarh 492010, India
2 shared publicationsSaroj Sharma
2 shared publicationsShobhana Ramteke
Ph.D. Student, School of Studies in Environmental Science, Pt. Ravishankar Shukla Univ., Raipur 492010, India
2 shared publications
Latest Publications
- 1 June 2026
- Published by Springer Nature in Environmental Geochemistry and Health
- Vol. 48 (8) , 379
Deciphering the geochemical signatures of groundwater quality dynamics in tribal landscapes of the Pairi River Basin
The present study investigated the hydrogeochemical characteristics and spatial variability of subsurface water quality in the Pairi River Basin (≈1305.82 km2), Chhattisgarh, India. A total of 79 groundwater samples were collected during the premonsoon phase (May–June 2024) and analyzed for 13 physicochemical and 5 heavy metal parameters following standard protocols. The suitability of groundwater for drinking purposes was evaluated using the water quality index (WQI) and heavy metal pollution index (HMPI). The results revealed that carbonate‒silicate rock weathering, ionic action, and groundwater residence time regulate mineralization, resulting in predominant Ca2+–Mg2+–Cl––SO42– and mixed ionic facies. The strong association between Ca2+–NO3––Cd–Cr ions resulted from carbonate dissolution and metal mobilization coupled with unsustainable agricultural practices, whereas elevated Mn and Fe levels indicated redox–controlled geogenic release. The WQI classified 49.4% of the samples in the poor to unsuitable category, whereas the HMPI identified 35.4% of the sampling stations as unsuitable for human consumption. This study highlights significant spatial heterogeneity in groundwater quality and associated health risks in vulnerable tribal–dominated terrains of the Pairi River Basin.
- 1 June 2026
- Published by Springer Nature in Environmental Geochemistry and Health
- Vol. 48 (8) , 379
Deciphering the geochemical signatures of groundwater quality dynamics in tribal landscapes of the Pairi River Basin
The present study investigated the hydrogeochemical characteristics and spatial variability of subsurface water quality in the Pairi River Basin (≈1305.82 km2), Chhattisgarh, India. A total of 79 groundwater samples were collected during the premonsoon phase (May–June 2024) and analyzed for 13 physicochemical and 5 heavy metal parameters following standard protocols. The suitability of groundwater for drinking purposes was evaluated using the water quality index (WQI) and heavy metal pollution index (HMPI). The results revealed that carbonate‒silicate rock weathering, ionic action, and groundwater residence time regulate mineralization, resulting in predominant Ca2+–Mg2+–Cl––SO42– and mixed ionic facies. The strong association between Ca2+–NO3––Cd–Cr ions resulted from carbonate dissolution and metal mobilization coupled with unsustainable agricultural practices, whereas elevated Mn and Fe levels indicated redox–controlled geogenic release. The WQI classified 49.4% of the samples in the poor to unsuitable category, whereas the HMPI identified 35.4% of the sampling stations as unsuitable for human consumption. This study highlights significant spatial heterogeneity in groundwater quality and associated health risks in vulnerable tribal–dominated terrains of the Pairi River Basin.
- 29 January 2022
- Published by Elsevier in Materials Today Chemistry
- Vol. 24
Design and development of conductive nanomaterials for electrochemical sensors: a modern approach
- 29 January 2022
- Published by Elsevier in Materials Today Chemistry
- Vol. 24
Design and development of conductive nanomaterials for electrochemical sensors: a modern approach
- 1 October 2019
- Published by American Society of Civil Engineers (ASCE) in Journal of Hazardous, Toxic, and Radioactive Waste
- Vol. 23 (4)
Winter Particulate Pollution over Raipur, India
Particulate air pollution during the winter season in the urban regions of India is severe due to substantial fuel and mineral combustion in adverse climatic conditions. In this work, chemical characteristics and sources of coarse particulate matter ( ) and particulates associated chemicals during winter period of years 2006–2013 in the polluted city of Raipur, Chhattisgarh, India, are reported. The ambient air coarse particulate ( ) concentration during the winter period of 2006–2007 ranged from 221 to . The major fraction of the was composed of organic carbon, elemental carbon, iron, calcium, and sulfate. Their concentrations were remarkably reduced in the rainy season due to high wind speeds (around ) and removal with rain. The concentration variations and sources of PM and associated chemical species (i.e., carbons, ions, and metals) in the ambient air are discussed.- 1 October 2019
- Published by American Society of Civil Engineers (ASCE) in Journal of Hazardous, Toxic, and Radioactive Waste
- Vol. 23 (4)
Winter Particulate Pollution over Raipur, India
Particulate air pollution during the winter season in the urban regions of India is severe due to substantial fuel and mineral combustion in adverse climatic conditions. In this work, chemical characteristics and sources of coarse particulate matter ( ) and particulates associated chemicals during winter period of years 2006–2013 in the polluted city of Raipur, Chhattisgarh, India, are reported. The ambient air coarse particulate ( ) concentration during the winter period of 2006–2007 ranged from 221 to . The major fraction of the was composed of organic carbon, elemental carbon, iron, calcium, and sulfate. Their concentrations were remarkably reduced in the rainy season due to high wind speeds (around ) and removal with rain. The concentration variations and sources of PM and associated chemical species (i.e., carbons, ions, and metals) in the ambient air are discussed.- 7 November 2016
- Published by Springer Nature in Air Quality, Atmosphere & Health
- Vol. 10 (3) , 287-295
Contamination of building roof dust in India
- 7 November 2016
- Published by Springer Nature in Air Quality, Atmosphere & Health
- Vol. 10 (3) , 287-295
Contamination of building roof dust in India
- 17 February 2016
- Published by Royal Society of Chemistry (RSC) in Analytical Methods
- Vol. 8 (9) , 2088-2096
Localized surface plasmon resonance of silver nanoparticles for sensitive colorimetric detection of chromium in surface water, industrial waste water and vegetable samples
Silver nanoparticles capped with tartaric acid (AgNPs/TA) are used as a localized surface plasmon resonance (LSPR) colorimetric sensor for the determination of chromium in real surface water (pond water and tube well water), industrial waste water and vegetable (cauliflower, tomato, spinach, green beans and cabbage) samples. The plasmon colorimetric sensing of chromium (+III and +VI) in samples was performed by measuring the change in the LSPR band in the UV-visible region of spectra. The reason for the change in the LSPR band was due to the aggregation of NPs induced by the coordination complex between chromium ions and tartaric acid present on the surface of NPs. The calibration curve gave a high level of linearity in the range of 5–100 μg L−1 for Cr(III) and 10–100 μg L−1 for Cr(VI) with a correlation coefficient of 0.996 and 0.995, respectively. The limits of detection (LODs) for Cr(III) and Cr(VI) were found to be 2 μg L−1 and 3 μg L−1, respectively, with the relative standard deviation percentage (RSD, %) in the range of 2.3–4.0%. The proposed method is found to be very simple, rapid and sensitive for the determination of trace levels of chromium present in surface water, industrial waste water and vegetable samples.
- 17 February 2016
- Published by Royal Society of Chemistry (RSC) in Analytical Methods
- Vol. 8 (9) , 2088-2096
Localized surface plasmon resonance of silver nanoparticles for sensitive colorimetric detection of chromium in surface water, industrial waste water and vegetable samples
Silver nanoparticles capped with tartaric acid (AgNPs/TA) are used as a localized surface plasmon resonance (LSPR) colorimetric sensor for the determination of chromium in real surface water (pond water and tube well water), industrial waste water and vegetable (cauliflower, tomato, spinach, green beans and cabbage) samples. The plasmon colorimetric sensing of chromium (+III and +VI) in samples was performed by measuring the change in the LSPR band in the UV-visible region of spectra. The reason for the change in the LSPR band was due to the aggregation of NPs induced by the coordination complex between chromium ions and tartaric acid present on the surface of NPs. The calibration curve gave a high level of linearity in the range of 5–100 μg L−1 for Cr(III) and 10–100 μg L−1 for Cr(VI) with a correlation coefficient of 0.996 and 0.995, respectively. The limits of detection (LODs) for Cr(III) and Cr(VI) were found to be 2 μg L−1 and 3 μg L−1, respectively, with the relative standard deviation percentage (RSD, %) in the range of 2.3–4.0%. The proposed method is found to be very simple, rapid and sensitive for the determination of trace levels of chromium present in surface water, industrial waste water and vegetable samples.
- 1 December 2013
- Published by Elsevier in Food Chemistry
- Vol. 141 (3) , 2263-2268
Dispersive liquid–liquid microextraction for the determination of copper in cereals and vegetable food samples using flame atomic absorption spectrometry
- 1 December 2013
- Published by Elsevier in Food Chemistry
- Vol. 141 (3) , 2263-2268
Dispersive liquid–liquid microextraction for the determination of copper in cereals and vegetable food samples using flame atomic absorption spectrometry
- 1 February 2013
- Published by Elsevier in Atmospheric Research
- Vol. 120-121, 312-324
Composition and sources of organic tracers in aerosol particles of industrial central India
- 1 February 2013
- Published by Elsevier in Atmospheric Research
- Vol. 120-121, 312-324
Composition and sources of organic tracers in aerosol particles of industrial central India
- 1 January 2006
- Published by Taylor & Francis in Analytical Letters
- Vol. 39 (1) , 197-205
Flow Injection Analysis Spectrophotometric Determination of Platinum
A new, simple, rapid, and selective procedure for the flow injection analysis (FIA) spectrophotometric determination of platement (Pt) is described. The method is based on the color reaction of Pt(IV) with SnCl2 in the HCl medium. The mixed surfactants, i.e., cetylpyridinium chloride (CPC)+triton X‐100 (TX‐100) are used to enhance sensitivity of the method. The value of apparent molar absorptivity in the term of Pt is (3.00)×103 L mol−1 cm−1 at absorption maximum, 405 nm. The detection limit (causing absorbance greater than 3×std. dev.) of the method is 150 ng/mL−1. The optimum concentration range for the determination of Pt is 0.5–18 µg/mL−1 with slope, intercept and correlation coefficient 0.0086, −0.001, and +0.99, respectively. The sample throughput of the method is 120 samples/h−1 at the flow rate of 3.7 mL/min−1. The composition of the complex, and the reaction mechanism involved are discussed. The effect of FIA and analytical variables on the determination of the metal is optimized. The method has been tested for the analysis of Pt to the catalytic materials.
- 1 January 2006
- Published by Taylor & Francis in Analytical Letters
- Vol. 39 (1) , 197-205
Flow Injection Analysis Spectrophotometric Determination of Platinum
A new, simple, rapid, and selective procedure for the flow injection analysis (FIA) spectrophotometric determination of platement (Pt) is described. The method is based on the color reaction of Pt(IV) with SnCl2 in the HCl medium. The mixed surfactants, i.e., cetylpyridinium chloride (CPC)+triton X‐100 (TX‐100) are used to enhance sensitivity of the method. The value of apparent molar absorptivity in the term of Pt is (3.00)×103 L mol−1 cm−1 at absorption maximum, 405 nm. The detection limit (causing absorbance greater than 3×std. dev.) of the method is 150 ng/mL−1. The optimum concentration range for the determination of Pt is 0.5–18 µg/mL−1 with slope, intercept and correlation coefficient 0.0086, −0.001, and +0.99, respectively. The sample throughput of the method is 120 samples/h−1 at the flow rate of 3.7 mL/min−1. The composition of the complex, and the reaction mechanism involved are discussed. The effect of FIA and analytical variables on the determination of the metal is optimized. The method has been tested for the analysis of Pt to the catalytic materials.