Zlatan Aksamija
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Research Interests
Zlatan Aksamija has a total of 153 co-authors. Here are the top co-authors by number of shared publications:
- Cameron J. Foss
Electrical and Computer Engineering Department, University of Massachusetts Amherst, Amherst, MA, 01003, USA
12 shared publications - Arnab K. Majee
Electrical and Computer Engineering Department University of Massachusetts Amherst Amherst MA 01003 USA
10 shared publications Umberto Ravaioli
University of Illinois at Urbana-Champaign, United States
8 shared publications- Dhandapani Venkataraman
University of Massachusetts Amherst
7 shared publications - Meenakshi Upadhyaya
Department of Electrical and Computer Engineering, University of Massachusetts-Amherst, Amherst, Massachusetts 01003, USA
7 shared publications - Adithya Kommini
University of Massachusetts Amherst, Amherst, Massachusetts 01003, USA
6 shared publications
Latest Publications
- Open Access
Beyond Integer Charge Transfer: A New Design Rule Linking Dopant Strength and Counterion Separation to Efficient Carrier Transport in Conjugated Polymers
Organic semiconductors, particularly conjugated polymers, are critical for advancing flexible electronics. Their electrical conductivity is enhanced by increasing carrier concentration through doping by blending small atoms or molecules, which can introduce Coulombic traps and disrupt packing. Here, we elucidate a molecular design principle that leverages dopant energy depth quantified by Δ E , which is the difference between appropriate frontier orbital energies of the doped polymer and its counterion, to mitigate disorder and simultaneously improve conductivity and the Seebeck coefficient. Using a modified Gaussian disorder model that incorporates carrier screening, we simulate the density of states and validate our findings experimentally with iodine‐ and Magic Blue‐doped poly(3‐hexylthiophene) (P3HT). Our results reveal that deeper dopant frontier energy levels significantly reduce energetic disorder and enhance transport properties when the carrier‐counterion separation is small. We identify a saddle‐point behavior in conductivity as a function of Δ E and show that Δ E can significantly boost conductivity when the dopant is located close to the backbone. This work introduces Δ E as a powerful molecular lever for designing high‐performance organic semiconductors, offering a new design rule to overcome the long‐standing trade‐off between conductivity and Seebeck coefficient, thereby increasing thermoelectric efficiency in doped conjugated polymers.
Open AccessBeyond Integer Charge Transfer: A New Design Rule Linking Dopant Strength and Counterion Separation to Efficient Carrier Transport in Conjugated Polymers
Organic semiconductors, particularly conjugated polymers, are critical for advancing flexible electronics. Their electrical conductivity is enhanced by increasing carrier concentration through doping by blending small atoms or molecules, which can introduce Coulombic traps and disrupt packing. Here, we elucidate a molecular design principle that leverages dopant energy depth quantified by Δ E , which is the difference between appropriate frontier orbital energies of the doped polymer and its counterion, to mitigate disorder and simultaneously improve conductivity and the Seebeck coefficient. Using a modified Gaussian disorder model that incorporates carrier screening, we simulate the density of states and validate our findings experimentally with iodine‐ and Magic Blue‐doped poly(3‐hexylthiophene) (P3HT). Our results reveal that deeper dopant frontier energy levels significantly reduce energetic disorder and enhance transport properties when the carrier‐counterion separation is small. We identify a saddle‐point behavior in conductivity as a function of Δ E and show that Δ E can significantly boost conductivity when the dopant is located close to the backbone. This work introduces Δ E as a powerful molecular lever for designing high‐performance organic semiconductors, offering a new design rule to overcome the long‐standing trade‐off between conductivity and Seebeck coefficient, thereby increasing thermoelectric efficiency in doped conjugated polymers.
- 30 June 2026
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 130 (28) , 9879-9887
2D Materials Enhance Thermal Conductance at van der Waals Interfaces of β-Ga 2 O 3
- 30 June 2026
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 130 (28) , 9879-9887
2D Materials Enhance Thermal Conductance at van der Waals Interfaces of β-Ga 2 O 3
- 13 May 2026
- Published by American Physical Society (APS) in Physical Review B
- Vol. 113 (19)
Carrier screening reduces radiative bimolecular recombination below the Langevin rate
- 13 May 2026
- Published by American Physical Society (APS) in Physical Review B
- Vol. 113 (19)
Carrier screening reduces radiative bimolecular recombination below the Langevin rate
- 16 March 2026
- Published by AIP Publishing in Applied Physics Letters
- Vol. 128 (11)
In situ XRD study of strain evolution in AlGaN/GaN HEMT at high temperatures up to 1000 °C
The thermal stability and structural evolution of a GaN high-electron mobility transistor (HEMT) heterostructure grown on a Si (111) substrate were investigated using in situ high-temperature x-ray diffraction, reciprocal space mapping (RSM), Raman spectroscopy, and rocking-curve (RC) analysis at varying temperatures. The heterostructure, consisting of a p-GaN cap, an AlGaN barrier, and a GaN channel supported by two AlGaN/AlGaN superlattice buffer layers, maintained clear and periodic satellite peaks up to a temperature of 1000 °C, confirming structural integrity. Symmetric and asymmetric RSM results reveal that both the Si and GaN diffraction peaks shift with increasing temperature, consistent with thermal expansion, and show no significant broadening or relaxation throughout the heating process. The c-lattice constant follows the theoretical expansion predicted by the multi-frequency Einstein model, whereas the a-lattice expansion is slower due to in-plane strain constraints imposed by the underlying Si substrate and buffer layers. Irreversible strain relaxation and thermal mismatch-induced stress redistribution induce a residual compressive strain of roughly 0.3% in the GaN channel after cooling, which has been further confirmed in Raman spectra through a blue shift (∼1 cm−1) of the GaN E2 (high) phonon mode, corresponding to an in-plane strain of −0.15% ± 0.16%. RC analysis revealed an increase in both screw and edge dislocation densities of 28% and 12%, respectively. These results collectively demonstrate that the GaN HEMT heterostructure exhibits robust crystalline stability up to 1000 °C without cracking due to strain relaxation, with only minor strain redistribution and limited dislocation activity, providing experimental evidence for GaN devices' applications under high-temperature conditions.
- 16 March 2026
- Published by AIP Publishing in Applied Physics Letters
- Vol. 128 (11)
In situ XRD study of strain evolution in AlGaN/GaN HEMT at high temperatures up to 1000 °C
The thermal stability and structural evolution of a GaN high-electron mobility transistor (HEMT) heterostructure grown on a Si (111) substrate were investigated using in situ high-temperature x-ray diffraction, reciprocal space mapping (RSM), Raman spectroscopy, and rocking-curve (RC) analysis at varying temperatures. The heterostructure, consisting of a p-GaN cap, an AlGaN barrier, and a GaN channel supported by two AlGaN/AlGaN superlattice buffer layers, maintained clear and periodic satellite peaks up to a temperature of 1000 °C, confirming structural integrity. Symmetric and asymmetric RSM results reveal that both the Si and GaN diffraction peaks shift with increasing temperature, consistent with thermal expansion, and show no significant broadening or relaxation throughout the heating process. The c-lattice constant follows the theoretical expansion predicted by the multi-frequency Einstein model, whereas the a-lattice expansion is slower due to in-plane strain constraints imposed by the underlying Si substrate and buffer layers. Irreversible strain relaxation and thermal mismatch-induced stress redistribution induce a residual compressive strain of roughly 0.3% in the GaN channel after cooling, which has been further confirmed in Raman spectra through a blue shift (∼1 cm−1) of the GaN E2 (high) phonon mode, corresponding to an in-plane strain of −0.15% ± 0.16%. RC analysis revealed an increase in both screw and edge dislocation densities of 28% and 12%, respectively. These results collectively demonstrate that the GaN HEMT heterostructure exhibits robust crystalline stability up to 1000 °C without cracking due to strain relaxation, with only minor strain redistribution and limited dislocation activity, providing experimental evidence for GaN devices' applications under high-temperature conditions.
- 1 January 2026
- Published by AIP Publishing in Review of Scientific Instruments
- Vol. 97 (1)
A frequency-modulated 3ω method (FM-3ω) for thermal conductivity measurements
The 3ω technique is a prominent thermal conductivity measurement methodology for thin films, substrates, nanowires, and thermal boundary conductance. The extraction of the thermal conductivity typically relies on measuring the thermal response across a wide range of frequencies and determining the slope within acceptable limiting conditions, which can be a time-consuming process prone to error from the amplification of noise when taking the derivative of discrete temperature data to determine thermal conductivity. Here, we develop and demonstrate a frequency-modulated 3ω method (FM-3ω) with which we directly measure the derivative of the 3ω signal by varying the center frequency ω, eliminating the need to postprocess the data, thereby reducing the time to take such measurements from hours to minutes. Our modulation approach is a frequency modulation method in which the frequency ω of the excitation current is sinusoidally varied over time. We show that our new method produces results with similar accuracy to the traditional method on bulk sapphire and borofloat 33 samples, and we further explore the limitations of modulation depth and center frequency on the results. We find that thermal conductivity measurements from the FM-3ω method agree well with thermal conductivities extracted through linear fits to temperature data over similar frequency windows of the traditional method. Our method provides a new strategy using frequency modulation and tandem demodulation to directly measure the derivative of temperature, thus contributing to the advancement of thermal transport sciences by increasing the ease and pace of measuring the thermal conductivity of thin films and multilayer structures.
- 1 January 2026
- Published by AIP Publishing in Review of Scientific Instruments
- Vol. 97 (1)
A frequency-modulated 3ω method (FM-3ω) for thermal conductivity measurements
The 3ω technique is a prominent thermal conductivity measurement methodology for thin films, substrates, nanowires, and thermal boundary conductance. The extraction of the thermal conductivity typically relies on measuring the thermal response across a wide range of frequencies and determining the slope within acceptable limiting conditions, which can be a time-consuming process prone to error from the amplification of noise when taking the derivative of discrete temperature data to determine thermal conductivity. Here, we develop and demonstrate a frequency-modulated 3ω method (FM-3ω) with which we directly measure the derivative of the 3ω signal by varying the center frequency ω, eliminating the need to postprocess the data, thereby reducing the time to take such measurements from hours to minutes. Our modulation approach is a frequency modulation method in which the frequency ω of the excitation current is sinusoidally varied over time. We show that our new method produces results with similar accuracy to the traditional method on bulk sapphire and borofloat 33 samples, and we further explore the limitations of modulation depth and center frequency on the results. We find that thermal conductivity measurements from the FM-3ω method agree well with thermal conductivities extracted through linear fits to temperature data over similar frequency windows of the traditional method. Our method provides a new strategy using frequency modulation and tandem demodulation to directly measure the derivative of temperature, thus contributing to the advancement of thermal transport sciences by increasing the ease and pace of measuring the thermal conductivity of thin films and multilayer structures.
- 15 November 2025
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 129 (47) , 21112-21120
From DOS Tails to Urbach Energies: Mitigating Radiative Losses in Photovoltaics
- 15 November 2025
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 129 (47) , 21112-21120
From DOS Tails to Urbach Energies: Mitigating Radiative Losses in Photovoltaics
- 28 March 2025
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 129 (14) , 6991-6999
Impact of Substrate Roughness on the Thermal Boundary Conductance in 2D Materials
- 28 March 2025
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 129 (14) , 6991-6999
Impact of Substrate Roughness on the Thermal Boundary Conductance in 2D Materials
- 28 August 2024
- Published by Springer Nature in MRS Communications
- Vol. 14 (5) , 1054-1061
Beneath the disorder: Unraveling the impacts of doping on organic electronics and thermoelectrics
- 28 August 2024
- Published by Springer Nature in MRS Communications
- Vol. 14 (5) , 1054-1061
Beneath the disorder: Unraveling the impacts of doping on organic electronics and thermoelectrics
- 8 August 2024
- Published by American Physical Society (APS) in Physical Review Applied
- Vol. 22 (2)
Enhanced field emission of electrons from wrinkled graphene: A unified approach
- 8 August 2024
- Published by American Physical Society (APS) in Physical Review Applied
- Vol. 22 (2)
Enhanced field emission of electrons from wrinkled graphene: A unified approach
- Open Access
- 27 June 2024
- Published by Springer Nature in Journal of Computational Electronics
- Vol. 23 (5) , 1135
Correction: Electrothermal properties of 2D materials in device applications
- 27 June 2024
- Published by Springer Nature in Journal of Computational Electronics
- Vol. 23 (5) , 1135
Open AccessCorrection: Electrothermal properties of 2D materials in device applications