Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Alexander I. Shames has a total of 324 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Unexpected Reduction of Eu3+ Ions to Eu2+ on a Nanodiamond Surface: An XPS, NMR, EPR, and Photoluminescence Study

    by Natalya Froumin, Alexander Shames, Anastasiya Chizhikova, Maxim Uchaev, Alexander Panich

    We present the results of a study of europium-grafted detonation nanodiamond using X-ray photoelectron spectroscopy (XPS), nuclear magnetic resonance (NMR), electron paramagnetic resonance (EPR), and photoluminescence techniques. The material was prepared by mixing an aqueous solution of europium(III) nitrate hexahydrate, Eu(NO3)3·6H2O, with a nanodiamond suspension, resulting in ion exchange between Eu3+ ions and protons of surface carboxyl groups and direct grafting of the nanodiamond surface with Eu3+ ions. However, after two years of storage under ambient conditions, the compound exhibits the reduction of ~13% of Eu3+ ions to the paramagnetic Eu2+ state. This unusual finding is discussed in the context of our XPS, EPR, NMR, and photoluminescence data. We propose that this effect can be associated with surface defects and sp2-hybridized graphene-like fragments that act as electron donors to Eu3+ ions. The observed spontaneous partial reduction of Eu3+ to Eu2+ during long-term storage demonstrates that the oxidation state of surface-grafted europium is not completely stable under ambient conditions. This finding is important because even a partial change in the Eu valence may modify the optical and magnetic properties of Eu-grafted nanodiamonds intended for luminescent, sensing, and quantum applications.

  • Open Access

    Optimized Catalytic Degradation of Organic Pollutants with the Ni(II)@SiO2-PDS System

    by Romiyo Justinabraham, Amir Mizrahi, Ariela Burg, Alexander I. Shames, Manoj Nagaraj, Desai Prashant Hanamantrao, Dan Meyerstein

    Fenton-like reactions are broadly employed in advanced oxidation processes (AOPs) for the degradation of organic pollutants through catalytic peroxide activation. In this study, NiO was precipitated on a wrinkled SiO2 to improve catalytic performance. The kinetics and reaction mechanism between the catalyst and S2O82− were studied via following the degradation of methylene blue as a model organic pollutant. The findings indicate that the excellent catalytic activity of Ni/SiO2 and highly active sulfate radicals enhanced the degradation of methylene blue for environmental remediation. Moreover, the cost-effectiveness, and eco-friendly characteristics of the prepared Ni@SiO2-persulfate system represents a substantial advancement in the field of catalytic oxidation, contributing valuable knowledge to the development of next-generation catalytic systems.


  • Open Access

    Vapor‐Phase Synthesis of Potassium‐Doped Polymeric Carbon Nitride Photocatalytic Panels

    by Devesh Garg, Gabriel Mark, Venugopala Rao Battula, Yotam Engel, Rohit Kumar Saini, Alexander I. Shames, Thamaraichelvan Marichelvam, Daniel A. Grave, Michael Volokh, Menny Shalom

    Potassium‐ion (K + )‐doped polymeric carbon nitride (CN) photocatalyst panels (PCPs) with cyano group defects stand out as an easy, low‐cost, and scalable strategy for solar‐driven chemical transformations, particularly for hydrogen peroxide (H 2 O 2 ) production via the oxygen reduction reaction (ORR). However, due to the challenges inherent to the synthetic routes, it is almost impossible to grow alkali‐metal‐doped CN directly on substrates as panels. Here, we introduce a scalable and straightforward vapor‐phase condensation and polymerization of CN precursors over KCl‐coated substrates, achieving K + doping and forming stable layers with enhanced light absorption, which results in the successful formation of charge carriers below the undoped CN's band edge. The optimal PCPs exhibit improved H 2 O 2 production, particularly in 100% ethanol, reaching (3.0 ± 0.4) × 10 2 mM m −2 h −1 , ∼18 times higher than control undoped CN PCPs (17 ± 4 mM m −2 h −1 ) in batch mode. The optimized PCP was evaluated as a large‐scale panel (ca. 46 cm 2 ) in a continuous‐flow configuration for 96 h, yielding ∼39 mM m − 2 h −1 H 2 O 2 during the first 24 h and demonstrating this configuration's scalability.


  • Protective Alumina Nanolayers Enhance Ozone Resistance of Polyamide Reverse Osmosis Membranes

    by Yanji Tian, Leilah Krounbi, Iranna Udachyan, Vijayalakshmi Anandan, Uri Yogev, Alexander I. Shames, Olga Brontvein, Edo Bar-Zeev, Eran Edri, Roy Bernstein

    Water scarcity is an escalating global challenge, leaving billions without consistent access to clean water. Desalination, particularly through reverse osmosis (RO), has become a critical method of producing fresh water from saline sources. However, thin-film composite (TFC) polyamide (PA) RO membranes, the industrial desalination standard, have a high propensity for biofilm formation, which leads to biofouling, reducing efficiency and increasing energy demand. Ozone disinfection is a simple, effective method to control biofilm development; however, PA membranes undergo chemical degradation when exposed to oxidizing disinfectants, even at very low concentrations. This work presents a novel approach to enhancing the durability of TFC-PA membranes against ozone. This was achieved by applying ultrathin alumina coatings via atomic layer deposition (ALD) on the membrane surface, creating a protective layer that provides active and passive defense against oxidative damage. The thin-film alumina-coated membrane at optimal coating demonstrated 5-fold higher tolerance to ozone exposure than uncoated membranes. They also maintained stable water permeate flux and salt rejection after prolonged filtration and effectively prevented biofilm formation. These findings offer a promising pathway to enhancing the sustainability of RO membranes by addressing critical barriers to their long-term desalination performance, thereby contributing to addressing the problem of global water scarcity.


  • Rational Design of Different Morphologies of Ammonium Vanadium–Chromium Oxide Nanostructures: Mechanistic Insights and Ammonium Storage

    by Noa Afik, Sandhiya Murugesan, Mariela J. Pavan, Karam Shreteh, Vladimir Ezersky, Alexander I. Shames, Iman Alkrenawi, Reut Rubinstein, Michael Volokh, Taleb Mokari

    At the nanoscale, control over size, composition, and morphology is paramount, representing the ultimate challenge in material design. In this study, we report a synthesis of ammonium vanadium-chromium oxide nanomaterials by controlling temperature and the precursor addition order. A hydrothermal process enables the formation of three distinct morphologies, nanosheets, nanowires, and nanoflowers, each exhibiting a layered structure with integrated ammonium and oxygen defects. Mechanistic studies reveal that the addition sequence influences the vanadia coordination environment, where a balanced interplay between tetrahedral and square pyramidal configurations directs the formation of either elongated or planar structures. Notably, the nanowires show enhanced specific capacitance for NH4+ ion storage, underscoring the promise of these materials for supercapacitor applications and the critical impact of the synthesis protocol on nanomaterial performance.


  • Open Access

    Testing the Potential of Magnetic Resonance Dosimetry: The Case of Lithium Carbonate

    by Alexander Shames, Alexander Panich, Lonia Friedlander, Olga Iliashevsky, Haim Cohen, Raymond Moreh

    Magnetic resonance techniques are powerful, nondestructive, non-invasive tools with broad applications in radiation dosimetry. Electron paramagnetic resonance (EPR) enables direct quantification of dose-dependent radiation-induced paramagnetic defects, while nuclear magnetic resonance (NMR) reflects the influence of such defects through changes in line width and nuclear spin relaxation. To date, these methods have typically been applied independently. Their combined use to probe radiation damage in the same material offers new opportunities for comprehensive characterization and preferred dosimetry techniques. In this work, we apply both EPR and NMR to investigate radiation damage in lithium carbonate (Li2CO3). A detailed EPR analysis of γ-irradiated samples shows that the concentration of paramagnetic defects increases with dose, following two distinct linear regimes: 10–100 Gy and 100–1000 Gy. A gradual decay of the EPR signal was observed over 40 days, even under cold storage. In contrast, 7Li NMR spectra and spin–lattice relaxation times in Li2CO3 exhibit negligible sensitivity to radiation doses up to 1000 Gy, while 1H NMR results remain inconclusive. Possible mechanisms underlying these contrasting behaviors are discussed.


  • Magnesium( ii )-bicarbonate complexes catalyze the Fenton-like reaction under nearly neutral conditions: kinetics and mechanism

    by Anushka Lucas, Dalia Gitin, Tomer Zidki, Prashant H. Desai, Alexander I. Shames, Virender K. Sharma, Haya Kornweitz, Yael Albo, Dan ---------- Meyerstein

    The results reported herein indicate that solutions containing Mg(H 2 O) 6 2+ + HCO 3 − + H 2 O 2 can replace Fe(H 2 O) 6 2+ + H 2 O 2 , or the use of other transition metal complexes, as catalysts of the Fenton-like processes.


  • Open Access

    Protective Alumina Nanolayers Enhance Ozone Resistance of Polyamide Reverse Osmosis Membranes

    by Yanji Tian, Leilah Krounbi, Iranna Udachyan, Vijayalakshmi Anandan, Uri Yogev, Alexander Shames, Olga Brontvein, Edo Bar-Zeev, Eran Edri, Roy Bernstein

    Water scarcity is an escalating global challenge, leaving billions without consistent access to clean water. Desalination, particularly through reverse osmosis (RO), has become a critical method of producing fresh water from saline sources. However, thin-film composite (TFC) polyamide (PA) RO membranes, which are the standard for industrial desalination, are susceptible to biofouling and chemical degradation by disinfectants, which limits their performance and longevity. Biofouling reduces the efficiency of desalination by increasing the energy demand, while ozone, a commonly used disinfectant, degrades the PA active layer, reducing salt rejection and structural integrity. This work presents a novel approach to enhancing the durability of TFC-PA membranes exposed to ozone disinfection. The atomic layer deposition (ALD) of ultrathin alumina coatings on the membrane surface created a protective layer that provided active and passive defense against oxidative damage. Alumina-coated membranes demonstrated substantially higher tolerance to ozone exposure than uncoated membranes. They also maintained stable water permeability and salt rejection after prolonged filtration and effectively prevented biofilm formation. These findings offer a promising pathway to improving the reliability and sustainability of RO membranes by addressing critical barriers to their long-term desalination performance, thereby contributing to addressing the problem of global water scarcity.

  • Electronic Spin Relaxation and Clustering in High-Pressure High-Temperature Synthesized Microcrystalline Diamond Particles with Reduced Nitrogen Content

    by Nicholas Nunn, Sergey Milikisiyants, Marco D. Torelli, Alexander Healey, Roy Styles, Brett C. Johnson, Jean-Philippe Tetienne, Philipp Reineck, Christopher Long, Timothy Dumm, et al.

    The negatively charged Nitrogen-vacancy (NV−) color center in diamond is widely studied because of numerous applications of this unique quantum system in sensing and quantum information sciences. While substitutional nitrogen is required to form NV− centers, it also yields other paramagnetic defects – primarily the neutrally charged substitutional nitrogen centers (P1) – that decrease NV− spin coherence which in turn degrades performance in applications. Herein, we investigate high-pressure high-temperature synthesized diamond microparticles (ca. 140–185 μm) having lower - ranging from 3 to 38 ppm - than the typical nitrogen content of type 1b diamond (ca. 100 ppm and higher) typically used for production of fluorescent diamond particles with NV− centers. A suite of electron paramagnetic resonance, optically detected magnetic resonance, and nuclear magnetic resonance methods are used to characterize spin properties of P1 and NV− centers in the particles. Upon decreasing the nitrogen content from 29 ppm to 3 ppm, the ensemble NV− T2 relaxation time increased by about 3-fold as measured directly in the Hahn Echo experiment at 1.2 Tesla. Analysis of electronic relaxation of P1 centers revealed the existence of at least two distinct populations of P1 centers, consisting of fast and slower relaxing spins. Even with <10 ppm nitrogen contents, the analysis indicated a highly heterogenous distribution of P1 centers, suggesting the possibility of P1 spin clustering in even at low concentrations. The combined data demonstrate that the particles prepared from HPHT diamond with a low nitrogen content offer improved spin properties that are beneficial for NV− sensing applications.


  • Open Access

    Selective Toluene Oxidation Using Sulfur‐Doped Polymeric Carbon Nitride Photocatalysts

    by Bayan Abed, Venugopala Rao Battula, Michael Volokh, Devesh Garg, Tirza Shmila, Gabriel Mark, Ayelet Tashakory, Alexander I. Shames, Menny Shalom

    Selective traditional oxidation of toluene to high‐value products like benzyl alcohol, benzaldehyde, and benzoic acid faces significant challenges due to high dissociation energy requirements, harsh reaction conditions, and complex product distributions. While photocatalysis using O2 as an oxidant offers a green alternative, developing efficient and durable photocatalysts for selective oxidation in both batch and flow systems remains challenging. Here, sulfur‐doped polymeric carbon nitride (S‐CN) is demonstrated as a versatile photocatalyst for selective toluene oxidation, applicable in both powder form and as binder‐free panels across various reactor configurations and solvents. Tuning S monomer content within supramolecular assemblies that serve as S‐CN precursors, allows enhanced light absorption, optimized band positions, high specific surface area, and tailored structural properties of the ensuing catalysts. The optimized photocatalyst achieves high product selectivity, yielding ∼72% benzaldehyde and ∼26% benzoic acid after 24 h. Mechanistic studies confirm the concurrent oxidation and reduction reactions occurring and the roles of O2·− and 1O2. Extended reaction time (48 h) enables selective benzoic acid production (73.4%) with minimal benzaldehyde formation (<1%), demonstrating excellent product control.