SMSergey A. Mintairov

Sergey A. Mintairov

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Sergey A. Mintairov has a total of 434 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • 66% efficiency of 850 nm photovoltaic laser power conversion measured under direct laser illumination for single-junction (Al)GaAs upright-growth heterostructures

    by Nikolay A. Kalyuzhnyy, Valery V. Evstropov, Aleksandra V. Malevskaya, Sergei A. Mintairov, Mikhail A. Mintairov, Mariia V. Nakhimovich, Roman A. Salii, Maxim Z. Shvarts, Vyacheslav M. Andreev


  • Material gain and two-state lasing in quantum well-dot lasers

    by Grigoriy Kornyshov, Yuriy Shernyakov, Artem Beckman, Anton Kharchenko, Alexey Payusov, Sergey Mintairov, Nikolay Kalyuzhnyy, Olga Simchuk, Julia Tkach, Vladimir Dubrovskii, et al.

    We report on modal and material gains as well as two-state lasing in lasers based on quantum well-dots (QWDs)–quantum heterostructures of mixed dimensionality (0D/2D). A high ground-state (GS) modal gain of 100 cm−1 is revealed in the device based on a single QWD layer. The upper limit of the GS material gain is estimated as 2.2 × 104 cm−1. In narrow-ridge 200 μm long lasers, pure GS lasing occurs up to a pumping current density that exceeds the threshold value by 17.5 times. A decrease in the optical confinement factor results in lasing via an excited state (ES) at a high pumping current. In the current range corresponding to the GS lasing, the devices operate in the transverse fundamental optical mode, whereas above the ES lasing threshold, they operate in the second order mode. In narrow-ridge lasers, the ES lasing is observed in longer cavities and at lower threshold current densities than in broad-area lasers.


  • Ultra-short stripe microlasers fabricated with a focused ion beam etching technique

    by Ivan Makhov, Sergey Komarov, Nikita Fominykh, Anna Obraztsova, Veronica Voitovich, Nikolay Derkach, Ivan Melnichenko, Nikita Shandyba, Natalia Chernenko, Maxim Solodovnik, et al.

    Fabry–Perot (FP) lasers with a cavity length shorten down to 50 µm were investigated. One or two laser mirrors were formed by focused ion beam etching. InGaAs quantum dots of high density were used as the laser active region. The lasers operate in a pulsed regime up to at least 105°С. A comparison with lasers formed by the facet cleaving method (minimum length is 100 µm) reveals the similarity of the emission wavelength and the threshold current depending on the cavity length. This allows us to conclude that the etched facets do not significantly affect the non-radiative recombination rate and provide a reflection coefficient close to that of the cleaved facet. The maximum modal gain was estimated to be not less than 240 cm−1. No evidence of the excited-state lasing was found.


  • Impact of modal gain and waveguide design on two-state lasing in quantum well-dot lasers

    by Mikhail Maximov, Yu. M. Shernyakov, Grigoriy Kornyshov, A. A. Beckman, F. I. Zubov, A. A. Kharchenko, Alexey Payusov, Sergey Mintairov, Nikolay Kalyuzhnyy, Vladimir Dubrovskii, et al.

    We study the current-controlled lasing switching from the ground state (GS) to the excited state (ES) transition in broad-area (stripe width 100 µm) InGaAs/GaAs quantum well-dot (QWD) and quantum well (QW) lasers. In the lasers with one QWD layer and a 0.45 µm-thick GaAs waveguide, pure GS lasing takes place up to an injection current as high as 8 A (40 kA/cm2). In contrast, in QW lasers with a similar design, ES lasing emerges already at 3 A (15 kA/cm2). The ES lasing in the QWD lasers is observed only in the devices with a waveguide thickness of 0.78 µm that supports a 2nd order transverse mode at the wavelength of the ES transition. Increasing the modal gain in the lasers with 0.78 µm-thick waveguide by using two QWD layers in the active region suppresses the ES lasing.


  • Improved power and temperature performance of half-disk diode microlasers

    by Fedor Zubov, Artem Beckman, Yuri Shernyakov, Nikolay Kalyuzhnyy, Sergey Mintairov, Yulia Guseva, Marina Kulagina, Vladimir G. Dubrovskii, Mikhail Maximov

    The power and temperature characteristics of Ø200 µm half-disk microlasers with a half-ring metal contact and high-density InGaAs/GaAs quantum dots are studied. In a continuous wave (CW) mode, the maximal optical power at 20°C was 134 mW, and the maximal CW lasing temperature reached 113°C. In a pulsed regime the maximal optical power of 1.6 W, limited by catastrophic degradation, was achieved. By comparing the CW and pulsed current–voltage characteristics, the dependence of a microlaser temperature on CW pumping current was determined. At CW currents corresponding to the maximal wall-plug efficiency, the maximal optical power, and complete lasing quenching, the laser temperatures were 60, 99, and 149°C, respectively.

  • Investigation of a p–i–n Photodetector with an Absorbing Medium Based on InGaAs/GaAs Quantum Well-Dots

    by N. V. Kryzhanovskaya, S. A. Blokhin, I. S. Makhov, E. I. Moiseev, A. M. Nadtochiy, N. A. Fominykh, S. A. Mintairov, N. A. Kaluyzhnyy, Yu. A. Guseva, M. M. Kulagina, et al.

    The static and dynamic characteristics of waveguide photodetectors with an absorbing region based on InGaAs/GaAs quantum well-dots were studied at room temperature. The absorption band of InGaAs/GaAs quantum well-dots is in the spectral range from 900 to 1100 nm. The waveguide photodetectors have a width of 50 μm and a length of the absorbing region from 92 μm to 400 μm. A low dark current density (1.1 and 22 μA/cm2 at –1 and –20 V) and cut off frequency of 5.6 GHz, limited by the time constant of a parasitic equivalent electric RC-circuit, were obtained.

  • Model for Speed Performance of Quantum-Dot Waveguide Photodiode

    by A. E. Zhukov, N. V. Kryzhanovskaya, I. S. Makhov, E. I. Moiseev, A. M. Nadtochiy, N. A. Fominykh, S. A. Mintairov, N. A. Kalyuzhyy, F. I. Zubov, M. V. Maximov

    A model is proposed that makes it possible to analytically analyze the speed performance of a waveguide p–i–n photodiode with a light-absorbing region representing a multilayered array of quantum dots separated by undoped spacers. It is shown that there is an optimal number of layers of quantum dots, as well as an optimal thickness of the spacers, which provide the widest bandwidth. The possibility of achieving a frequency range (at the level of –3 dB) above 20 GHz for waveguide photodiodes based on InGaAs/GaAs quantum well-dots is shown.


  • A GalnP-Based Photo-Converter of Laser Radiation with an Efficiency of 46.7% at a Wavelength of 600 nm

    by S. A. Mintairov, V. V. Evstropov, M. A. Mintairov, M. V. Nakhimovich, R. A. Salii, M. Z. Shvarts, N. A. Kalyuzhnyy

    GalnP-based laser power converters (LPC) structure grown by MOVPE and device chip design have been optimized for operation under high-power lasers of the green–red spectral range. Light I–V curves records have shown the performance of the LPC at up to 40–50 W/cm2 of incident power densities. The highest level data were obtained for 532, 600, and 633 nm power laser lines: 44.3, 46.7, and 40.6% under 13–16 W/cm2, respectively. LPC demonstrated an efficiency of more than 40% at the incident laser radiation power density elevated up to 40–50 W/cm2.


  • High-Efficiency GaInP/GaAs Photoconverters of the 600 nm Laser Line

    by S. A. Mintairov, A. V. Malevskaya, M. A. Mintairov, M. V. Nakhimovich, R. A. Salii, M. Z. Shvarts, N. A. Kalyuzhnyy

    Optimized photoconverters for operation under high-power laser radiation in the green-red spectral range based on MOCVD-grown GaInP/GaAs heterostructures are fabricated. The Au(Ge)/Ni/Au and Pd/Ge/Au contact systems have been studied to form the front contact grid of devices. As a result, the laser photoconverter with a Pd/Ge/Au contact showed an efficiency of more than 50% up to an incident radiation power density of 30 W/cm2 with a maximum value of 54.4% under 7 W/cm2 for laser line with wavelength of 600 nm.


  • Open Access

    Superluminescent Diodes Based on Chirped InGaAs/GaAs Quantum Well-Dot Layers

    by Mikhail V. Maximov, Nikita Yu. Gordeev, Yuri M. Shernyakov, Grigoriy O. Kornyshov, Artem A. Beckman, Alexey S. Payusov, Sergey A. Mintairov, Nikolay A. Kalyuzhnyy, Marina M. Kulagina, Alexey E. Zhukov

    We study the applicability of InGaAs/GaAs quantum well-dots (QWDs) for active regions of broadband superluminescent diodes (SLDs) emitting in the 950–1150 nm spectral range; 2 mm long SLDs with a bent section and an active region based on seven chirped QWD layers show emission spectra centered at 1030 nm with a full-width at half-maximum of 80 nm and an output power of 2 mW. In a 250 µm long SLD with a tilted stripe that has an increased output loss, the width of the emission spectra is 113 nm at 20 °C and 120 nm at 60 °C.