SOSean P. Ogden

Sean P. Ogden

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Sean P. Ogden has a total of 9 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Method to Determine the Root Cause of Low- $\kappa$ SiCOH Dielectric Failure Distributions

    by Sean P. Ogden, Kong Boon Yeap, Tian Shen, Patrick Justison, Toh-Ming Lu, Joel L. Plawsky

    Low-κ SiCOH reliability is a growing concern for integrated circuit reliability. An important consideration for product qualification involves the accurate extrapolation to the low percentile failures based on the results from a group of samples. A method is presented to determine the root cause of failure distributions amongst a group of dielectric samples using voltage ramp data. Samples' leakage current traces and breakdown voltages are compared with each other. Using this method, it was determined that the dielectric spacing variation dominates across-wafer failure, while variation of local breakdown strength affects in-chip failure.


  • Electron transport and dielectric breakdown in silicon nitride using a charge transport model

    by Sean P. Ogden, Toh-Ming Lu, Joel L. Plawsky

    Silicon nitride is an important material used in the electronics industry. As such, the electronic transport and reliability of these materials are important to study and understand. We report on a charge transport model to predict leakage current and failure trends based on previously published data for a stoichiometric silicon nitride dielectric. Failure occurs when the defect density increases to a critical value of approximately 6 × 1025 traps/m3. The model's parameters are determined using voltage ramp data only, and yet, the model is also able to predict constant voltage stress failure over a time scale ranging from minutes to months. The successful fit of the model to the experimental data validates our assumption that the dominant defect in the dielectric is the Si dangling bond, located approximately 2.2 eV below the conduction band. A comparison with previous SiCOH simulations shows SiN and SiCOH have similar defect-related material properties. It is also speculated that, based on the estimated parameter values of 2.75 eV for the defect formation activation energy, the materials' TDDB wear-out are caused by broken Si-H bonds, resulting in Si dangling bond defects.


  • Charge transport model to predict intrinsic reliability for dielectric materials

    by Sean P. Ogden, Juan Borja, Joel L. Plawsky, T.-M. Lu, Kong Boon Yeap, William N. Gill

    Several lifetime models, mostly empirical in nature, are used to predict reliability for low-k dielectrics used in integrated circuits. There is a dispute over which model provides the most accurate prediction for device lifetime at operating conditions. As a result, there is a need to transition from the use of these largely empirical models to one built entirely on theory. Therefore, a charge transport model was developed to predict the device lifetime of low-k interconnect systems. The model is based on electron transport and donor-type defect formation. Breakdown occurs when a critical defect concentration accumulates, resulting in electron tunneling and the emptying of positively charged traps. The enhanced local electric field lowers the barrier for electron injection into the dielectric, causing a positive feedforward failure. The charge transport model is able to replicate experimental I-V and I-t curves, capturing the current decay at early stress times and the rapid current increase at failure. The model is based on field-driven and current-driven failure mechanisms and uses a minimal number of parameters. All the parameters have some theoretical basis or have been measured experimentally and are not directly used to fit the slope of the time-to-failure versus applied field curve. Despite this simplicity, the model is able to accurately predict device lifetime for three different sources of experimental data. The simulation's predictions at low fields and very long lifetimes show that the use of a single empirical model can lead to inaccuracies in device reliability.